Павел Владимирович Фурсиков
Павел Владимирович Фурсиков has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Boris P. Tarasov
Federal Research Center of Problems of Chemical Physics and Medicinal Chemistry, Russian Academy of Sciences, Chernogolovka, Russia
4 shared publications - Artem A. Arbuzov
Federal Research Center of Problems of Chemical Physics and Medicinal Chemistry, Russian Academy of Sciences, Chernogolovka, Russia
2 shared publications - Mykhaylo Volodymyrovich Lototskyy
HySA Systems, South African Institute for Advanced Materials, University of the Western Cape, Robert Sobukwe Road, Bellville 7535, South Africa
2 shared publications - Валентин Назарович Фокин
Федеральный исследовательский центр проблем химической физики и медицинской химии РАН
2 shared publications Михаил Владимирович Лотоцкий
Федеральный исследовательский центр проблем химической физики и медицинской химии РАН
2 shared publications- Эвелина Эрнестовна Фокина
Федеральный исследовательский центр проблем химической физики и медицинской химии РАН
2 shared publications
Latest Publications
- Open Access
- 5 September 2025
- Published by IOP Publishing in Journal of Physics: Energy
- Vol. 7 (4) , 045016
Metal–organic frameworks and their derivatives as catalysts of magnesium hydrogenation
This article presents the results of an experimental study on the preparation and characterisation of metal–organic frameworks (MOFs) formed by coordination polymers of Ni(II) and Co(II) itaconates (Ni–IA and Co–IA), as well as the products of thermolysis of their mixtures. It is found that the thermolysis results in the formation of heterometallic CoNi nanoparticles enveloped in a porous carbonaceous matrix (CoNi@C core-shell structures). The catalytic effect of the as-synthesised MOFs and their CoNi@C derivatives on the hydrogenation of Mg during high-energy reactive ball milling (HRBM) in hydrogen has been studied. These catalysts were shown to increase the rate of hydrogenation of Mg during HRBM by about ninefold as compared with non-catalysed magnesium. The kinetic improvements are superior to those observed earlier for other catalysts, including Pd-doped UiO-66 MOF and Ni nanoparticles deposited onto graphene-like materials. At the same time, the achieved reacted fractions when using MOFs and their derivatives as catalysts for magnesium hydrogenation were incomplete. It was found that the use of the as-synthesised MOFs as additives to Mg during HRBM results in the slow hydrogenation of pristine magnesium at room temperature during pauses between the first milling sessions. Almost full conversion of Mg into MgH2 was achieved when the milling vial was kept during these pauses until pressure stabilisation. Based on this observation, it was assumed that the intermediate products of MOF decomposition are more active catalysts of magnesium hydrogenation than the CoNi@C core–shell structures formed as the final MOF decomposition product.
- 5 September 2025
- Published by IOP Publishing in Journal of Physics: Energy
- Vol. 7 (4) , 045016
Open AccessMetal–organic frameworks and their derivatives as catalysts of magnesium hydrogenation
This article presents the results of an experimental study on the preparation and characterisation of metal–organic frameworks (MOFs) formed by coordination polymers of Ni(II) and Co(II) itaconates (Ni–IA and Co–IA), as well as the products of thermolysis of their mixtures. It is found that the thermolysis results in the formation of heterometallic CoNi nanoparticles enveloped in a porous carbonaceous matrix (CoNi@C core-shell structures). The catalytic effect of the as-synthesised MOFs and their CoNi@C derivatives on the hydrogenation of Mg during high-energy reactive ball milling (HRBM) in hydrogen has been studied. These catalysts were shown to increase the rate of hydrogenation of Mg during HRBM by about ninefold as compared with non-catalysed magnesium. The kinetic improvements are superior to those observed earlier for other catalysts, including Pd-doped UiO-66 MOF and Ni nanoparticles deposited onto graphene-like materials. At the same time, the achieved reacted fractions when using MOFs and their derivatives as catalysts for magnesium hydrogenation were incomplete. It was found that the use of the as-synthesised MOFs as additives to Mg during HRBM results in the slow hydrogenation of pristine magnesium at room temperature during pauses between the first milling sessions. Almost full conversion of Mg into MgH2 was achieved when the milling vial was kept during these pauses until pressure stabilisation. Based on this observation, it was assumed that the intermediate products of MOF decomposition are more active catalysts of magnesium hydrogenation than the CoNi@C core–shell structures formed as the final MOF decomposition product.
- 18 July 2024
- Published by The Russian Academy of Sciences in Žurnal prikladnoj himii
- Vol. 97 (1) , 37-44
Гидрирование интерметаллического соединения TiFe в присутствии твердого раствора водорода TiFeH ~0.1
Исследовано гидрирование сплава TiFe, приготовленного в условиях, близких к условиям крупномасштабного производства. Показано, что данный сплав в условиях эксперимента (дегазация при комнатной температуре, выдержка в водороде под давлением до 3.5 МПа и температуре до 350°C в течение 14 ч с последующим охлаждением до комнатной температуры под давлением водорода) водород не поглощает. В то же время смесь исходного сплава с добавкой предварительно синтезированного твердого раствора водорода в интерметаллиде TiFe (TiFeH~0.1), взятой в количестве от 20 до 30 мас%, эффективно гидрируется в близких условиях — количество водорода в продукте гидрирования смеси приближается к 95% от содержания водорода в дигидриде TiFeH2. Установлены оптимальные условия гидрирования сплава: температуры дегазации и гидрирования 20 и 280°C соответственно, давление водорода 3.0 МПа при общей продолжительности процесса 6 ч в присутствии 20 мас% TiFeH~0.1. Разработанную методику можно использовать для гидрирования водород-аккумулирующих сплавов на основе TiFe, производимых в крупных масштабах.
- 18 July 2024
- Published by The Russian Academy of Sciences in Žurnal prikladnoj himii
- Vol. 97 (1) , 37-44
Гидрирование интерметаллического соединения TiFe в присутствии твердого раствора водорода TiFeH ~0.1
Исследовано гидрирование сплава TiFe, приготовленного в условиях, близких к условиям крупномасштабного производства. Показано, что данный сплав в условиях эксперимента (дегазация при комнатной температуре, выдержка в водороде под давлением до 3.5 МПа и температуре до 350°C в течение 14 ч с последующим охлаждением до комнатной температуры под давлением водорода) водород не поглощает. В то же время смесь исходного сплава с добавкой предварительно синтезированного твердого раствора водорода в интерметаллиде TiFe (TiFeH~0.1), взятой в количестве от 20 до 30 мас%, эффективно гидрируется в близких условиях — количество водорода в продукте гидрирования смеси приближается к 95% от содержания водорода в дигидриде TiFeH2. Установлены оптимальные условия гидрирования сплава: температуры дегазации и гидрирования 20 и 280°C соответственно, давление водорода 3.0 МПа при общей продолжительности процесса 6 ч в присутствии 20 мас% TiFeH~0.1. Разработанную методику можно использовать для гидрирования водород-аккумулирующих сплавов на основе TiFe, производимых в крупных масштабах.
- 15 May 2024
- Published by The Russian Academy of Sciences in Žurnal prikladnoj himii
- Vol. 97 (5) , 410-416
Гидрирование TiFe в присутствии интерметаллида CeCo3 как активирующей добавки
Гидрирование TiFe в присутствии интерметаллида CeCo 3 как активирующей добавки Гидрирование TiFe в присутствии интерметаллида CeCo 3 как активирующей добавки
- 15 May 2024
- Published by The Russian Academy of Sciences in Žurnal prikladnoj himii
- Vol. 97 (5) , 410-416
Гидрирование TiFe в присутствии интерметаллида CeCo3 как активирующей добавки
Гидрирование TiFe в присутствии интерметаллида CeCo 3 как активирующей добавки Гидрирование TiFe в присутствии интерметаллида CeCo 3 как активирующей добавки
- Top Cited Papers
- 1 April 2021
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 46 (25) , 13647-13657
Metal hydride hydrogen storage and compression systems for energy storage technologies
- 1 April 2021
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 46 (25) , 13647-13657
Top Cited PapersMetal hydride hydrogen storage and compression systems for energy storage technologies
- 1 July 2018
- Published by Pleiades Publishing Ltd in Journal of Structural Chemistry
- Vol. 59 (4) , 830-838
Composite Materials with 2D Graphene Structures: Applications for Hydrogen Energetics and Catalysis with Hydrogen Participation
The work presents the results of studies concerning preparation of graphene-like nanomaterials by graphite oxide reduction, preparation of nickel-graphene catalysts, magnesium-graphene, and...
- 1 July 2018
- Published by Pleiades Publishing Ltd in Journal of Structural Chemistry
- Vol. 59 (4) , 830-838
Composite Materials with 2D Graphene Structures: Applications for Hydrogen Energetics and Catalysis with Hydrogen Participation
The work presents the results of studies concerning preparation of graphene-like nanomaterials by graphite oxide reduction, preparation of nickel-graphene catalysts, magnesium-graphene, and...