PPPavel Purgat

Pavel Purgat

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Pavel Purgat has a total of 14 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Protection Framework for Low Voltage DC Grids

    by Nils H. van der Blij, Pavel Purgat, Thiago B. Soeiro, Laura M. Ramirez-Elizondo, Matthijs T. J. Spaan, Pavol Bauer

    This paper presents a protection framework for low voltage dc grids, which segments these grids into zones and tiers according to their fault current potential and provided protection. Furthermore, the technology and applications of different protection devices are examined. It is demonstrated that the utilization of fast fault interruption and fault limiting inductors are vital for the protection of low voltage dc grids. Moreover, a design of a solid-state circuit breaker is presented, and this devices is experimentally verified. The experimental results showed that the total time for the detection and interruption of faults can be lower than $1 \mu \mathrm{s}$ with solid-state protection devices.


  • Fault Protection and Coordinated Controls of Power Flow Controller in a Flexible DC Grid

    by Jianquan Liao, Zian Qin, Pavel Purgat, Niancheng Zhou, Qianggang Wang, Pavol Bauer

    This paper analyses the fault current characteristics of a flexible DC grid with a power flow controller (PFC) and proposes a coordinated control method for suppression of fault currents between the PFC and the DC circuit breaker (DCCB). The equivalent circuits of the PFC during different stages of the DC fault are analyzed. Moreover, the influence of the output voltage of the PFC on the fault current is studied. After that, the current suppression characteristics of the current limiting reactor (CLR) and PFC are investigated. Due to the output voltage of the PFC can be flexibly adjusted during the DC fault, the fault current can be suppressed significantly by adjusting the output voltage of the PFC when the DC fault is detected. This paper adopts a bang-bang control for PFC during the fault. Finally, a simulation model was built in Matlab/Simulink to verify the fault current characteristics of the DC grid containing the PFC, and the coordinated control of the PFC was verified.


  • Open Access

    Design criteria of solid‐state circuit breaker for low‐voltage microgrids

    by Pavel Purgat, Samad Shah, Nils van der Blij, Zian Qin, Pavol Bauer

    Solid‐state circuit breakers (SSCB) show great promise to become the key element in the protection of low‐voltage direct current microgrids. SSCBs operate in the microsecond range and employ semi‐conductor devices that have strict safe operation area limits. Therefore, the design of the SSCB needs to consider the effects of fault detection delays and semi‐conductor safe operation area limitations. This paper derives SSCB design criteria that consider the effect of different detection methods with different detection delays under varying system constraints. The design space is investigated in a sensitivity analysis, which provides insights into the operation boundaries of SSCB and explains how a combination of fault detection methods can reduce the SSCB size. The insights from the theoretical and sensitivity analysis are used to propose an SSCB design flowchart. SSCB prototype is developed and tested in different scenarios under nominal grid voltage and current. The derived design constraints can be used for efficient SSCB design and also to evaluate the effects of different protection schemes on the required SSCB size.


  • Zero Voltage Switching Criteria of Triple Active Bridge Converter

    by Pavel Purgat, Soumya Bandyopadhyay, Zian Qin, Pavol Gae Bauer

    Triple active bridge (TAB) as an isolated multi-port converter is a promising integrated energy system for smart grids or electric vehicles. This paper aims to derive and analyse zero voltage switching (ZVS) regions of TAB, in which both switching losses are reduced, and EMI issues are mitigated. In the proposed closed-form solution of ZVS criteria, parameters such as the parasitic capacitance of the switches, the leakage inductance of the transformer, the switching frequency, the port voltage, the phase-shift inside and between the full-bridges are all taken into account. The analysis shows how the five degrees of freedom can be used to maintain ZVS operation in various operating points. The analysis and derived closed-form ZVS criteria are experimentally verified using a laboratory prototype. The derived analytical ZVS criteria are a powerful tool to study and optimise the operation of TAB converters.


  • A Multiactive Bridge Converter With Inherently Decoupled Power Flows

    by Soumya Bandyopadhyay, Pavel Purgat, Zian Qin, Pavol Bauer

    Multi-active bridge converters (MAB) have become a widely-researched candidate for the integration of multiple renewable sources, storage and loads for a variety of applications, from robust smart grids to more-electric aircraft. Connecting multiple dc ports reduces power conversion stress, improves efficiency, reduces material billing and increases power density. However, the power flows between the ports of a MAB converter are magnetically coupled via the high-frequency (HF) transformer, making it difficult to control. This paper presents a MAB converter configuration with a rigid voltage source on the magnetizing inductance of the transformer resulting in inherently decoupled power flows. As a result, the configuration allows independent power flow control tuning of the rest of the ports. The theory behind the power flow decoupling of the proposed MAB configuration is analyzed in detail using a reduced-order model. A 2 kW, 100 kHz Si-C based four-port MAB converter laboratory prototype is built and tested, showing completely decoupled control loops with fast transient response regardless of their control bandwidths. The proposed configuration therefore makes the operation and design of the MAB family of converters much more feasible for any number of ports and precludes the need for a high-performance dynamic decoupling controller.


  • Open Access

    Decentralized Plug-and-Play Protection Scheme for Low Voltage DC Grids

    by Nils H. van der Blij, Pavel Purgat, Thiago B. Soeiro, Laura M. Ramirez-Elizondo, Matthijs T. J. Spaan, Pavol Bauer

    Since the voltages and currents in dc grids do not have a natural zero-crossing, the protection of these grids is more challenging than the protection of conventional ac grids. Literature presents several unit and non-unit protection schemes that rely on communication, or knowledge about the system’s topology and parameters in order to achieve selective protection in these grids. However, communication complicates fast fault detection and interruption, and a system’s parameters are subject to uncertainty and change. This paper demonstrates that, in low voltage dc grids, faults propagate fast through the grid and interrupted inductive currents commutate to non-faulted sections of the grid, which both can cause circuit breakers in non-faulted sections to trip. A decentralized plug-and-play protection scheme is proposed that ensures selectivity via an augmented solid-state circuit breaker topology and by utilizing the proposed time-current characteristic. It is experimentally shown that the proposed scheme provides secure and selective fault interruption for radial and meshed low voltage dc grids under various conditions.


  • Partially Rated Power Flow Control Converter Modeling for Low-Voltage DC Grids

    by Pavel Purgat, Nils H. van der Blij, Zian Qin, Pavol Bauer

    Scalable and robust low voltage direct current distribution (lvdc) networks require solutions allowing flexible power flow control and reliable short-circuit protection. In this paper, the continuous full-order large and small signal models of a partially rated power flow control converter (PFCC) are derived utilizing the generalized averaging method. The large signal model of the PFCC is coupled with a model of the lvdc grid. Due to the state-space representation the combined model of the PFCC and the lvdc grid is suitable for easy algorithmization, and efficient simulation. These advantages make them essential tools for studying and optimizing of scalable lvdc systems with decentralized power flow control based on the PFCC. The PFCC models provide insights into controller design and stability analysis. The models are experimentally validated, and the functionality of the PFCC is demonstrated in a laboratoryscale microgrid.