Alex Friedman
Research Subjects
Alex Friedman has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
Yeshaiahu Fainman
Peer Review Publications Department Optica 2010 Massachusetts Avenue NW 20036 Washington DC USA
6 shared publications- Hani Nejadriahi
Jet Propulsion Laboratoryhttps://ror.org/027k65916, California Institute of Technology, Pasadena, California 91109, USA
3 shared publications Rajat Sharma
University of California
3 shared publicationsAndrew Grieco
Peer Review Publications Department Optica 2010 Massachusetts Avenue NW 20036 Washington DC USA
2 shared publicationsDmitrii Belogolovskii
Peer Review Publications Department Optica 2010 Massachusetts Avenue NW 20036 Washington DC USA
2 shared publicationsSteve Pappert
2 shared publications
Latest Publications
- Open Access
A systematic evaluation of Silicon-rich Nitride Electro-optic Modulator design and tradeoffs
We present a study of linearized \c{hi}^((3)) based electro-optic modulation beginning with an analysis of the nonlinear polarizability, and how to linearize a modulator based on the quadratic third order DC-Kerr effect. Then we perform a numerical study, designing a linearized \c{hi}^((3)) phase modulator utilizing Silicon-rich Nitride where we show that a phase modulator with a V_π L_π metric of 1 Vcm or a V_π L_π α metric of 37VdB is achievable and a V_π L_π as low as 0.5Vcm in a push-pull Mach Zehnder Interferometer. This numerical study argues that linearized modulation exploiting the \c{hi}^((3)), and \c{hi}^((2)) as applicable, is possible and can allow for high-speed modulation using a CMOS compatible material platform.
Open AccessA systematic evaluation of Silicon-rich Nitride Electro-optic Modulator design and tradeoffs
We present a study of linearized \c{hi}^((3)) based electro-optic modulation beginning with an analysis of the nonlinear polarizability, and how to linearize a modulator based on the quadratic third order DC-Kerr effect. Then we perform a numerical study, designing a linearized \c{hi}^((3)) phase modulator utilizing Silicon-rich Nitride where we show that a phase modulator with a V_π L_π metric of 1 Vcm or a V_π L_π α metric of 37VdB is achievable and a V_π L_π as low as 0.5Vcm in a push-pull Mach Zehnder Interferometer. This numerical study argues that linearized modulation exploiting the \c{hi}^((3)), and \c{hi}^((2)) as applicable, is possible and can allow for high-speed modulation using a CMOS compatible material platform.
- 30 November 2022
- Published by Optica Publishing Group in Optics Express
- Vol. 30 (25) , 45340-45349
Optical bistability in PECVD silicon-rich nitride
We present a study of optical bi-stability in a 3.02 refractive index at 1550nm plasma enhanced chemical vapor deposition (PECVD) silicon-rich nitride (SRN) film, as it pertains to bi-stable switching, memory applications, and thermal sensing applications. In this work we utilize an SRN ring resonator device, which we first characterize at low-power and then compare thermo-optic coefficients, (2.12 ± 0.125) × 10−4/°C, obtained from thermal-heating induced resonance shifts to optically induced resonance shifts as well as estimated propagation loss and absorption. We then measure the time response of this nonlinearity demonstrating the relaxation time to be 18.7 us, indicating the mechanism to be thermal in nature. Finally, we demonstrate bi-stable optical switching.
- 30 November 2022
- Published by Optica Publishing Group in Optics Express
- Vol. 30 (25) , 45340-45349
Optical bistability in PECVD silicon-rich nitride
We present a study of optical bi-stability in a 3.02 refractive index at 1550nm plasma enhanced chemical vapor deposition (PECVD) silicon-rich nitride (SRN) film, as it pertains to bi-stable switching, memory applications, and thermal sensing applications. In this work we utilize an SRN ring resonator device, which we first characterize at low-power and then compare thermo-optic coefficients, (2.12 ± 0.125) × 10−4/°C, obtained from thermal-heating induced resonance shifts to optically induced resonance shifts as well as estimated propagation loss and absorption. We then measure the time response of this nonlinearity demonstrating the relaxation time to be 18.7 us, indicating the mechanism to be thermal in nature. Finally, we demonstrate bi-stable optical switching.
- 25 August 2021
- Published by Optica Publishing Group in Optics Letters
- Vol. 46 (17) , 4236-4239
Demonstration of the DC-Kerr effect in silicon-rich nitride
We demonstrate the DC-Kerr effect in plasma enhanced chemical vapor deposition (PECVD) silicon-rich nitride (SRN) and use it to demonstrate a third order nonlinear susceptibility, χ ( 3 ) , as high as ( 6 ± 0.58 ) × 10 − 19 m 2 / V 2 . We employ spectral shift versus applied voltage measurements in a racetrack resonator as a tool to characterize the nonlinear susceptibilities of these films. In doing so, we demonstrate a χ ( 3 ) larger than that of silicon and argue that PECVD SRN can provide a versatile platform for employing optical phase shifters while maintaining a low thermal budget using a deposition technique readily available in CMOS process flows.
- 25 August 2021
- Published by Optica Publishing Group in Optics Letters
- Vol. 46 (17) , 4236-4239
Demonstration of the DC-Kerr effect in silicon-rich nitride
We demonstrate the DC-Kerr effect in plasma enhanced chemical vapor deposition (PECVD) silicon-rich nitride (SRN) and use it to demonstrate a third order nonlinear susceptibility, χ ( 3 ) , as high as ( 6 ± 0.58 ) × 10 − 19 m 2 / V 2 . We employ spectral shift versus applied voltage measurements in a racetrack resonator as a tool to characterize the nonlinear susceptibilities of these films. In doing so, we demonstrate a χ ( 3 ) larger than that of silicon and argue that PECVD SRN can provide a versatile platform for employing optical phase shifters while maintaining a low thermal budget using a deposition technique readily available in CMOS process flows.
- 1 January 2021
- Published by Optica Publishing Group
- p. NW2B.3
Electro-Optic Switching in Silicon-Rich Nitride
We demonstrate electro-optic switching using the DC-Kerr effects in a bus-coupled integrated photonic racetrack ring resonator made of Silicon-rich Nitride and find its third order nonlinear susceptibility, χ(3), of 6x10-19 m2/v2.
- 1 January 2021
- Published by Optica Publishing Group
- p. NW2B.3
Electro-Optic Switching in Silicon-Rich Nitride
We demonstrate electro-optic switching using the DC-Kerr effects in a bus-coupled integrated photonic racetrack ring resonator made of Silicon-rich Nitride and find its third order nonlinear susceptibility, χ(3), of 6x10-19 m2/v2.
- Open Access
- 29 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 39 (12) , 4201-4208
A Non-Mechanical Multi-Wavelength Integrated Photonic Beam Steering System
In this work we experimentally demonstrate a fully packaged one-dimensional beam steering system that is based on a fully CMOS compatible silicon photonics platform. This configuration enables multi-wavelength operation and is suitable for short-wavelength infrared (SWIR) applications from light detection and ranging (LIDAR) to telecommunication and sensing applications. The switching fabric in this system employs a 1x9 array of add/drop ring resonators that are fed by a common waveguide through a single etch input grating. The switching fabric re-directs the resonance wavelengths at each drop waveguide to the output facet at the edge of the chip and into free space. The divergent beams that exit the waveguides along the output facet are then collimated and magnified using an array of micro-lenses (pitch = 750 μm, Diameter = 700 μm) in addition to a two lens afocal system in order to enhance the fill factor and diminish any blind zones between adjacent beams. Each one of these drop waveguides is used to address portion of the steering aperture. Combined together they enable steering across the entire aperture. Multi-wavelength operation is obtained by placing individual titanium tungsten alloy (TiW) heaters on top of each ring resonator to enable wavelength tuning.
- 29 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 39 (12) , 4201-4208
Open AccessA Non-Mechanical Multi-Wavelength Integrated Photonic Beam Steering System
In this work we experimentally demonstrate a fully packaged one-dimensional beam steering system that is based on a fully CMOS compatible silicon photonics platform. This configuration enables multi-wavelength operation and is suitable for short-wavelength infrared (SWIR) applications from light detection and ranging (LIDAR) to telecommunication and sensing applications. The switching fabric in this system employs a 1x9 array of add/drop ring resonators that are fed by a common waveguide through a single etch input grating. The switching fabric re-directs the resonance wavelengths at each drop waveguide to the output facet at the edge of the chip and into free space. The divergent beams that exit the waveguides along the output facet are then collimated and magnified using an array of micro-lenses (pitch = 750 μm, Diameter = 700 μm) in addition to a two lens afocal system in order to enhance the fill factor and diminish any blind zones between adjacent beams. Each one of these drop waveguides is used to address portion of the steering aperture. Combined together they enable steering across the entire aperture. Multi-wavelength operation is obtained by placing individual titanium tungsten alloy (TiW) heaters on top of each ring resonator to enable wavelength tuning.
- 10 August 2020
- Published by Optica Publishing Group in Optics Express
- Vol. 28 (17) , 24951-24960
Thermo-optic properties of silicon-rich silicon nitride for on-chip applications
We demonstrate the thermo-optic properties of silicon-rich silicon nitride (SRN) films deposited using plasma-enhanced chemical vapor deposition (PECVD). Shifts in the spectral response of Mach-Zehnder interferometers (MZIs) as a function of temperature were used to characterize the thermo-optic coefficients of silicon nitride films with varying silicon contents. A clear relation is demonstrated between the silicon content and the exhibited thermo-optic coefficient in silicon nitride films, with the highest achievable coefficient being as high as (1.65±0.08) ×10−4 K-1. Furthermore, we realize an SRN multi-mode interferometer (MMI) based thermo-optic switch with over 20 dB extinction ratio and total power consumption for two-port switching of 50 mW.
- 10 August 2020
- Published by Optica Publishing Group in Optics Express
- Vol. 28 (17) , 24951-24960
Thermo-optic properties of silicon-rich silicon nitride for on-chip applications
We demonstrate the thermo-optic properties of silicon-rich silicon nitride (SRN) films deposited using plasma-enhanced chemical vapor deposition (PECVD). Shifts in the spectral response of Mach-Zehnder interferometers (MZIs) as a function of temperature were used to characterize the thermo-optic coefficients of silicon nitride films with varying silicon contents. A clear relation is demonstrated between the silicon content and the exhibited thermo-optic coefficient in silicon nitride films, with the highest achievable coefficient being as high as (1.65±0.08) ×10−4 K-1. Furthermore, we realize an SRN multi-mode interferometer (MMI) based thermo-optic switch with over 20 dB extinction ratio and total power consumption for two-port switching of 50 mW.
- Open Access
Thermo-Optic Properties of Silicon-Rich Silicon Nitride for On-chip Applications
We demonstrate the thermo-optic properties of silicon-rich silicon nitride (SRN) films deposited using plasma-enhanced chemical vapor deposition (PECVD). Shifts in the spectral response of Mach-Zehnder Interferometers (MZIs) as a function of temperature were used to characterize the thermo-optic coefficients of silicon nitride films with varying silicon contents. A clear relation is demonstrated between the silicon content and the exhibited thermo-optic coefficient in silicon nitride films, with the highest achievable coefficient being as high as (1.65+/-0.08) x 10-4 K-1. Furthermore, we realize an SRN Multi-Mode Interferometer (MMI) based thermo-optic switch with over 20 dB extinction ratio and total power consumption for two-port switching of 50 mW.
Open AccessThermo-Optic Properties of Silicon-Rich Silicon Nitride for On-chip Applications
We demonstrate the thermo-optic properties of silicon-rich silicon nitride (SRN) films deposited using plasma-enhanced chemical vapor deposition (PECVD). Shifts in the spectral response of Mach-Zehnder Interferometers (MZIs) as a function of temperature were used to characterize the thermo-optic coefficients of silicon nitride films with varying silicon contents. A clear relation is demonstrated between the silicon content and the exhibited thermo-optic coefficient in silicon nitride films, with the highest achievable coefficient being as high as (1.65+/-0.08) x 10-4 K-1. Furthermore, we realize an SRN Multi-Mode Interferometer (MMI) based thermo-optic switch with over 20 dB extinction ratio and total power consumption for two-port switching of 50 mW.
- 1 January 2004
- Published by Elsevier in Physica C: Superconductivity and its Applications
- Vol. 401 (1-4) , 222-226
Estimation of the critical current of BSCCO coils based on the field dependent I–V curves of BSCCO tapes
- 1 January 2004
- Published by Elsevier in Physica C: Superconductivity and its Applications
- Vol. 401 (1-4) , 222-226
Estimation of the critical current of BSCCO coils based on the field dependent I–V curves of BSCCO tapes