Vera van Beek
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Vera van Beek has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Adam Bezuijen
Ghent University
5 shared publications - Bryant A. Robbins
U.S. Army Engineer Research and Development Center
4 shared publications - Esther Rosenbrand
Unit Geo-Engineering, Deltares, Delft, the Netherlands
4 shared publications - Jarno Terwindt
Unit Geo-Engineering, Deltares, Delft, the Netherlands
3 shared publications - Johannes C. Pol
Department of Hydraulic Engineering, Delft University of Technology, Delft, The Netherlands
3 shared publications - Sepideh Akrami
Department of Civil Engineering, Ghent University, Ghent, Belgium
3 shared publications
Latest Publications
- Open Access
- 18 August 2026
- Published by TU Delft OPEN Publishing in Journal of Coastal and Hydraulic Structures
- Vol. 6
The effect of a suspended cut-off wall on backward erosion piping
The effect of a suspended cut-off wall on susceptibility of a water retaining structure to backward erosion piping (BEP) was investigated in a small-scale model test. The critical head was tested without and with a cut-off wall. The piezometric head in the model was measured at different locations in the with standpipes. One was located in the lower end of the cut-off wall to measure the vertical gradient on the downstream side of the cut-off wall. The maximum difference in piezometric head that could be resisted by the model was 4.9 times higher in the presence of a suspended cut-off wall over half the depth of the permeable sand layer compared to the test without a cut-off wall. The measured distribution of piezometric head agrees with the results of 2 D numerical calculations with D-Geo Flow and with the results of analytical calculations following the exit gradient method. The stability against BEP is significant. A vertical gradient downstream of the suspended cut-off wall of 1.7 was necessary to reach failure while normally a gradient of 1 is assumed. Possible causes for this high stability are discussed.
- 18 August 2026
- Published by TU Delft OPEN Publishing in Journal of Coastal and Hydraulic Structures
- Vol. 6
Open AccessThe effect of a suspended cut-off wall on backward erosion piping
The effect of a suspended cut-off wall on susceptibility of a water retaining structure to backward erosion piping (BEP) was investigated in a small-scale model test. The critical head was tested without and with a cut-off wall. The piezometric head in the model was measured at different locations in the with standpipes. One was located in the lower end of the cut-off wall to measure the vertical gradient on the downstream side of the cut-off wall. The maximum difference in piezometric head that could be resisted by the model was 4.9 times higher in the presence of a suspended cut-off wall over half the depth of the permeable sand layer compared to the test without a cut-off wall. The measured distribution of piezometric head agrees with the results of 2 D numerical calculations with D-Geo Flow and with the results of analytical calculations following the exit gradient method. The stability against BEP is significant. A vertical gradient downstream of the suspended cut-off wall of 1.7 was necessary to reach failure while normally a gradient of 1 is assumed. Possible causes for this high stability are discussed.
- 26 June 2022
- Published by Elsevier in Geomechanics for Energy and the Environment
- Vol. 31
3D modelling of backward erosion piping experiments
- 26 June 2022
- Published by Elsevier in Geomechanics for Energy and the Environment
- Vol. 31
3D modelling of backward erosion piping experiments
- 1 June 2022
- Published by Emerald Publishing in Géotechnique
- Vol. 72 (6) , 522-531
Numerical modelling of the resistance of the coarse sand barrier against backward erosion piping
The coarse sand barrier (CSB) is a novel remediation measure to reinforce embankments against the internal erosion mechanism of backward erosion piping (BEP). The feasibility of the CSB is investigated in a research programme consisting of experiments at different scales, numerical analysis and application at a pilot site in the Netherlands. Laboratory experiments showed that the CSB increased the critical head drop for BEP by one order of magnitude. In this paper, the strength of the CSB is quantified using numerical modelling of the experiments. A local, scale-independent, strength criterion for the CSB is derived based on medium-scale experiments. The application of this local criterion is illustrated for a field-scale model, in which the critical head drop that can be retained increases by a factor two to three with the CSB.
- 1 June 2022
- Published by Emerald Publishing in Géotechnique
- Vol. 72 (6) , 522-531
Numerical modelling of the resistance of the coarse sand barrier against backward erosion piping
The coarse sand barrier (CSB) is a novel remediation measure to reinforce embankments against the internal erosion mechanism of backward erosion piping (BEP). The feasibility of the CSB is investigated in a research programme consisting of experiments at different scales, numerical analysis and application at a pilot site in the Netherlands. Laboratory experiments showed that the CSB increased the critical head drop for BEP by one order of magnitude. In this paper, the strength of the CSB is quantified using numerical modelling of the experiments. A local, scale-independent, strength criterion for the CSB is derived based on medium-scale experiments. The application of this local criterion is illustrated for a field-scale model, in which the critical head drop that can be retained increases by a factor two to three with the CSB.
- Open Access
- 6 April 2022
- Published by Springer Nature in Acta Geotechnica
- Vol. 17 (10) , 4555-4576
Temporal evolution of backward erosion piping in small-scale experiments
Backward erosion piping (BEP) is a form of internal erosion which can lead to failure of levees and dams. Most research focused on the critical head difference at which piping failure occurs. Two aspects have received less attention, namely (1) the temporal evolution of piping and (2) the local hydraulic conditions in the pipe and at the pipe tip. We present small-scale experiments with local pressure measurements in the pipe during equilibrium and pipe progression for different sands and degrees of hydraulic loading. The experiments confirm a positive relation between progression rate and grain size as well as the degree of hydraulic overloading. Furthermore, the analysis of local hydraulic conditions shows that the rate of BEP progression can be better explained by the bed shear stress and sediment transport in the pipe than by the seepage velocity at the pipe tip. The experiments show how different processes contribute to the piping process and these insights provide a first empirical basis for modeling pipe development using coupled seepage-sediment transport equations.
- 6 April 2022
- Published by Springer Nature in Acta Geotechnica
- Vol. 17 (10) , 4555-4576
Open AccessTemporal evolution of backward erosion piping in small-scale experiments
Backward erosion piping (BEP) is a form of internal erosion which can lead to failure of levees and dams. Most research focused on the critical head difference at which piping failure occurs. Two aspects have received less attention, namely (1) the temporal evolution of piping and (2) the local hydraulic conditions in the pipe and at the pipe tip. We present small-scale experiments with local pressure measurements in the pipe during equilibrium and pipe progression for different sands and degrees of hydraulic loading. The experiments confirm a positive relation between progression rate and grain size as well as the degree of hydraulic overloading. Furthermore, the analysis of local hydraulic conditions shows that the rate of BEP progression can be better explained by the bed shear stress and sediment transport in the pipe than by the seepage velocity at the pipe tip. The experiments show how different processes contribute to the piping process and these insights provide a first empirical basis for modeling pipe development using coupled seepage-sediment transport equations.
- 1 March 2022
- Published by Emerald Publishing in Géotechnique
- Vol. 72 (3) , 216-226
Multi-scale experiments for a coarse sand barrier against backward erosion piping
Backward erosion piping poses a severe threat for embankments founded on sandy deposits. The physical mechanism by which a pipe progresses upstream beneath the embankment is conceptually understood, and assessments indicate high failure probabilities in the Netherlands. Rising sea levels and economic growth increase the risk of flooding, and the need for remediation measures. Conventional measures have undesired side effects, in terms of costs, maintenance, space requirements and sustainability. The coarse sand barrier (CSB) is a novel nature-based solution lacking these side effects. The CSB is a trench filled with coarse sand that is placed below the downstream toe of the embankment, which prevents the pipe from progressing upstream. The effectiveness of the CSB is based on its higher resistance against erosion and its effect on groundwater flow. This paper presents experimental work that was conducted to test the feasibility of a CSB for application at a pilot site in the Netherlands. This involved experiments with seepage lengths of 0·34, 1·34 and 15 m, using different barrier materials and background sands. A conceptual model is presented for the physical mechanism of pipe formation in the presence of a barrier. As the resistance of the barrier can be characterised by a local scale-independent strength criterion, laboratory results are applicable for design practice.
- 1 March 2022
- Published by Emerald Publishing in Géotechnique
- Vol. 72 (3) , 216-226
Multi-scale experiments for a coarse sand barrier against backward erosion piping
Backward erosion piping poses a severe threat for embankments founded on sandy deposits. The physical mechanism by which a pipe progresses upstream beneath the embankment is conceptually understood, and assessments indicate high failure probabilities in the Netherlands. Rising sea levels and economic growth increase the risk of flooding, and the need for remediation measures. Conventional measures have undesired side effects, in terms of costs, maintenance, space requirements and sustainability. The coarse sand barrier (CSB) is a novel nature-based solution lacking these side effects. The CSB is a trench filled with coarse sand that is placed below the downstream toe of the embankment, which prevents the pipe from progressing upstream. The effectiveness of the CSB is based on its higher resistance against erosion and its effect on groundwater flow. This paper presents experimental work that was conducted to test the feasibility of a CSB for application at a pilot site in the Netherlands. This involved experiments with seepage lengths of 0·34, 1·34 and 15 m, using different barrier materials and background sands. A conceptual model is presented for the physical mechanism of pipe formation in the presence of a barrier. As the resistance of the barrier can be characterised by a local scale-independent strength criterion, laboratory results are applicable for design practice.
- 21 February 2022
- Published by Elsevier in Geomechanics for Energy and the Environment
- Vol. 31
Errors in finite element analysis of backward erosion piping
- 21 February 2022
- Published by Elsevier in Geomechanics for Energy and the Environment
- Vol. 31
Errors in finite element analysis of backward erosion piping
- 26 September 2021
- Published by Springer Nature in Acta Geotechnica
- Vol. 16 (12) , 3881-3898
Influence of a permeable sand layer on the mechanism of backward erosion piping using 3D pipe depth measurements
- 26 September 2021
- Published by Springer Nature in Acta Geotechnica
- Vol. 16 (12) , 3881-3898
Influence of a permeable sand layer on the mechanism of backward erosion piping using 3D pipe depth measurements
- 13 August 2020
- Published by Springer Nature in Acta Geotechnica
- Vol. 16 (2) , 381-397
Analysis of development and depth of backward erosion pipes in the presence of a coarse sand barrier
- 13 August 2020
- Published by Springer Nature in Acta Geotechnica
- Vol. 16 (2) , 381-397
Analysis of development and depth of backward erosion pipes in the presence of a coarse sand barrier
- 1 September 2018
- Published by Springer Nature
- p. 336-346
Databases for Backward Erosion Piping Laboratory Experiments and Field Observations
- 1 September 2018
- Published by Springer Nature
- p. 336-346
Databases for Backward Erosion Piping Laboratory Experiments and Field Observations