Alla Pustovalova
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Alla Pustovalova has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Anatoly E. Antipov
Mendeleev University of Chemical Technology of Russia Miusskaya sq. 9 125047 Moscow Russia
5 shared publications - Pavel Loktionov
Delft University of Technology Van der Maasweg 9
5 shared publications - Roman Pichugov
Mendeleev University of Chemical Technology of Russia Miusskaya sq. 9 125047 Moscow Russia
5 shared publications - Aleksei Yu. Grishko
Laboratory of New Materials for Solar Energetics, Department of Materials Science, Lomonosov Moscow State University, Lenin Hills, 119991 Moscow, Russia
2 shared publications - Artem M. Abakumov
Skolkovo Institute of Science and Technology
2 shared publications - Dmitrii Vladimirovich Konev
Federal Research Center of Problems of Chemical Physics and Medicinal Chemistry, Russian Academy of Sciences, Chernogolovka, Russia
2 shared publications
Latest Publications
- 7 May 2026
- Published by Wiley in Energy Technology
- Vol. 14 (5)
Evolution of Natural Graphite Morphology Through Sequential Spheroidization in the Impact Mill
Most commercial lithium‐ion batteries employ graphite as the active material of negative electrode (anode). If natural graphite is used, it should be preliminarily purified and spheroidized, i.e., crystalline graphite flakes should be converted into rounded particles. In this paper, the spheroidization process of natural graphite has been studied using advanced scanning electron microscopy and X‐ray powder diffraction. For the spheroidization, an impact mill equipped with three‐stage rotor of the original design has been employed, in which the rounding process occurs through the number of successive runs of the graphite material through the mill. The morphology study demonstrates that the most significant change in the particle morphology occurs within the first run, when the original flakes are crushed and split, and the “potato‐shape” particles are formed. During the subsequent mill runs, these rounded particles undergo compaction; their porosity decreases and sphericity increases, while the median size remains nearly constant. On the macroscopic scale, the repeated mill runs result in an increase in the graphite tap density. On the basis of the obtained experimental results, two‐stage scheme of the spheroidization process has been proposed.
- 7 May 2026
- Published by Wiley in Energy Technology
- Vol. 14 (5)
Evolution of Natural Graphite Morphology Through Sequential Spheroidization in the Impact Mill
Most commercial lithium‐ion batteries employ graphite as the active material of negative electrode (anode). If natural graphite is used, it should be preliminarily purified and spheroidized, i.e., crystalline graphite flakes should be converted into rounded particles. In this paper, the spheroidization process of natural graphite has been studied using advanced scanning electron microscopy and X‐ray powder diffraction. For the spheroidization, an impact mill equipped with three‐stage rotor of the original design has been employed, in which the rounding process occurs through the number of successive runs of the graphite material through the mill. The morphology study demonstrates that the most significant change in the particle morphology occurs within the first run, when the original flakes are crushed and split, and the “potato‐shape” particles are formed. During the subsequent mill runs, these rounded particles undergo compaction; their porosity decreases and sphericity increases, while the median size remains nearly constant. On the macroscopic scale, the repeated mill runs result in an increase in the graphite tap density. On the basis of the obtained experimental results, two‐stage scheme of the spheroidization process has been proposed.
- 10 June 2025
- Published by Elsevier in Materials Research Bulletin
- Vol. 192
The role of solvent during solvothermal synthesis of amorphous SiOx anode materials for advanced Li-ion batteries
- 10 June 2025
- Published by Elsevier in Materials Research Bulletin
- Vol. 192
The role of solvent during solvothermal synthesis of amorphous SiOx anode materials for advanced Li-ion batteries
- 21 October 2024
- Published by Wiley in Chempluschem
- Vol. 89 (12) , e202400372
Sensitivity of Capacity Fade in Vanadium Redox Flow Battery to Electrolyte Impurity Content
The gradual capacity decrease of vanadium redox flow battery (VRFB) over long‐term charge‐discharge cycling is determined by electrolyte degradation. While it was initially believed that this degradation was solely caused by crossover, recent research suggests that oxidative imbalance induced by hydrogen evolution reaction (HER) also plays a significant role. In this work by using vanadium pentoxides with different impurities content, we prepared three grades of vanadium electrolyte. By measuring electrochemical properties on carbon felt electrode in three‐electrode cell and VRFB membrane‐electrode assembly we evaluate the influence of impurity content on battery polarization and rate of side reactions which is indicated by the increase of average oxidation state (AOS) during charge‐discharge tests and varies from 0.061 to 0.027 day−1 for electrolytes made from 99.1 and 99.9 wt % V2O5. We found that increase of AOS correlates with the increase of open‐circuit voltage of VRFB in the discharged state ranging from 9.6 to 14.9 mV day−1 for highest and lowest electrolyte purity levels, respectively. While AOS increase is significant, it does not solely determine capacity fade. It is demonstrated that the presence of vanadium crossover decreases capacity fade, i. e. levels the contribution of side reactions on capacity drop.
- 21 October 2024
- Published by Wiley in Chempluschem
- Vol. 89 (12) , e202400372
Sensitivity of Capacity Fade in Vanadium Redox Flow Battery to Electrolyte Impurity Content
The gradual capacity decrease of vanadium redox flow battery (VRFB) over long‐term charge‐discharge cycling is determined by electrolyte degradation. While it was initially believed that this degradation was solely caused by crossover, recent research suggests that oxidative imbalance induced by hydrogen evolution reaction (HER) also plays a significant role. In this work by using vanadium pentoxides with different impurities content, we prepared three grades of vanadium electrolyte. By measuring electrochemical properties on carbon felt electrode in three‐electrode cell and VRFB membrane‐electrode assembly we evaluate the influence of impurity content on battery polarization and rate of side reactions which is indicated by the increase of average oxidation state (AOS) during charge‐discharge tests and varies from 0.061 to 0.027 day−1 for electrolytes made from 99.1 and 99.9 wt % V2O5. We found that increase of AOS correlates with the increase of open‐circuit voltage of VRFB in the discharged state ranging from 9.6 to 14.9 mV day−1 for highest and lowest electrolyte purity levels, respectively. While AOS increase is significant, it does not solely determine capacity fade. It is demonstrated that the presence of vanadium crossover decreases capacity fade, i. e. levels the contribution of side reactions on capacity drop.
- 8 March 2024
- Published by Elsevier in Electrochimica Acta
- Vol. 485
Quantifying effect of faradaic imbalance and crossover on capacity fade of vanadium redox flow battery
- 8 March 2024
- Published by Elsevier in Electrochimica Acta
- Vol. 485
Quantifying effect of faradaic imbalance and crossover on capacity fade of vanadium redox flow battery
- 24 May 2023
- Published by Elsevier in Journal of Power Sources
- Vol. 576
Cost-effective electrodes based on mixed iridium-zirconium oxides for vanadium electrolyte rebalancing cell
- 24 May 2023
- Published by Elsevier in Journal of Power Sources
- Vol. 576
Cost-effective electrodes based on mixed iridium-zirconium oxides for vanadium electrolyte rebalancing cell
- Open Access
Halogen Hybrid Flow Batteries Advances for Stationary Chemical Power Sources Technologies
This review aims to highlight the current advances in hybrid redox flow battery (HRFB) technology, encompassing one of the best combinations of efficiency, cost and flexibility due to its module construction, which offers independent scaling of power density and energy capacity. This work emphasizes the interest of the scientific community both in (i) studying the properties and principles of HRFB operation in order to improve commonly proposed systems, and in (ii) the development of energy storage devices with new reagent types or RFB concepts. The data provided enhances the reader to conclude whether novel concepts in halogen oxidizers utilization could help to overcome the problem of insufficient power and energy densities of common RFB.
Open AccessHalogen Hybrid Flow Batteries Advances for Stationary Chemical Power Sources Technologies
This review aims to highlight the current advances in hybrid redox flow battery (HRFB) technology, encompassing one of the best combinations of efficiency, cost and flexibility due to its module construction, which offers independent scaling of power density and energy capacity. This work emphasizes the interest of the scientific community both in (i) studying the properties and principles of HRFB operation in order to improve commonly proposed systems, and in (ii) the development of energy storage devices with new reagent types or RFB concepts. The data provided enhances the reader to conclude whether novel concepts in halogen oxidizers utilization could help to overcome the problem of insufficient power and energy densities of common RFB.