Öznur Begüm Gökçek
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Öznur Begüm Gökçek has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
Aslı Bozdağ
Department of Geomatics Engineering, Nigde Omer Halisdemir University, Nigde, Turkey
2 shared publicationsBilal Yıldırım
Faculty of Engineering, Department of Environmental Engineering Nigde Ömer Halisdemir University Nigde Turkey
1 shared publicationBuğse Büşra Vural
Department of Environmental Engineering, Faculty of Engineering, Niğde Ömer Halisdemir University, Niğde, Türkiye
1 shared publicationDeniz Uçar
Faculty of Engineering and Natural Sciences, Department of Environmental Engineering Bursa Technical University Bursa Turkey
1 shared publication- Fatma Muratçobanoğlu
Erciyes University
1 shared publication Hamdi Muratçobanoğlu
Faculty of Engineering, Department of Environmental Engineering Nigde Ömer Halisdemir University Nigde Turkey
1 shared publication
Latest Publications
- Open Access
- 7 February 2026
- Published by Springer Nature in Biodegradation
- Vol. 37 (2) , 27
Highly efficient biomethane production from chicken manure and municipal organic solid waste using magnetite: converting waste into energy
The aim of this study is to investigate the effect of magnetite (Fe 3 O 4 ) addition on biogas and biomethane production in the anaerobic treatment of chicken manure (CM) and municipal organic solid waste (MOSW). Batch experiments were conducted under mesophilic conditions using different substrate-to-inoculum (S/I) ratios (0, 1, 2, and 4 g VS-S/g VS-I) and magnetite concentrations (50, 100, 200, 400, and 600 mg L⁻ 1 ). The highest biogas and biomethane production was obtained in the S/I = 1 gVS-S/gVS-I, 2:1 (CM: MOSW) reactor and were 2910.5 ± 199.4 mL CH 4 /gVS and 1718.03 ± 117.73 mL CH 4 /gVS, respectively. At different magnetite concentrations, the highest biogas and biomethane production occurred at 200 mgL −1 magnetite loading rate, 1842.7 ± 112.0 mL CH 4 /gVS and 1081.99 ± 65.78 mL CH 4 /gVS, respectively. The highest total organic carbon (TOC) and total nitrogen (TN) concentrations were determined at S/I = 4, 2:1 (CM: MOSW) gVS-S/gVS-I loading ratio, while the highest TS and VS removal efficiency was determined at S/I = 1 gVS-S/gVS-I, 2:1 (CM: MOSW) ratio and 100 mgL −1 magnetite loading ratio. When the microbial distribution was examined, the first five dominant species ( W5, S1, Coprothermobacter, Treponema and Fervidobacterium ) did not change after the addition of magnetite. The findings demonstrate the positive effects of magnetite addition on biogas and biomethane production, providing significant insights for the development of new strategies to enhance anaerobic digestion processes.
- 7 February 2026
- Published by Springer Nature in Biodegradation
- Vol. 37 (2) , 27
Open AccessHighly efficient biomethane production from chicken manure and municipal organic solid waste using magnetite: converting waste into energy
The aim of this study is to investigate the effect of magnetite (Fe 3 O 4 ) addition on biogas and biomethane production in the anaerobic treatment of chicken manure (CM) and municipal organic solid waste (MOSW). Batch experiments were conducted under mesophilic conditions using different substrate-to-inoculum (S/I) ratios (0, 1, 2, and 4 g VS-S/g VS-I) and magnetite concentrations (50, 100, 200, 400, and 600 mg L⁻ 1 ). The highest biogas and biomethane production was obtained in the S/I = 1 gVS-S/gVS-I, 2:1 (CM: MOSW) reactor and were 2910.5 ± 199.4 mL CH 4 /gVS and 1718.03 ± 117.73 mL CH 4 /gVS, respectively. At different magnetite concentrations, the highest biogas and biomethane production occurred at 200 mgL −1 magnetite loading rate, 1842.7 ± 112.0 mL CH 4 /gVS and 1081.99 ± 65.78 mL CH 4 /gVS, respectively. The highest total organic carbon (TOC) and total nitrogen (TN) concentrations were determined at S/I = 4, 2:1 (CM: MOSW) gVS-S/gVS-I loading ratio, while the highest TS and VS removal efficiency was determined at S/I = 1 gVS-S/gVS-I, 2:1 (CM: MOSW) ratio and 100 mgL −1 magnetite loading ratio. When the microbial distribution was examined, the first five dominant species ( W5, S1, Coprothermobacter, Treponema and Fervidobacterium ) did not change after the addition of magnetite. The findings demonstrate the positive effects of magnetite addition on biogas and biomethane production, providing significant insights for the development of new strategies to enhance anaerobic digestion processes.
- 30 October 2021
- Published by Springer Nature in Arabian Journal of Geosciences
- Vol. 14 (21) , 1-12
Deep learning-based long-term prediction of air quality parameters
- 30 October 2021
- Published by Springer Nature in Arabian Journal of Geosciences
- Vol. 14 (21) , 1-12
Deep learning-based long-term prediction of air quality parameters
- 23 June 2021
- Published by Wiley in Journal of Chemical Technology & Biotechnology
- Vol. 96 (10) , 2845-2851
The effect of reduced graphene oxide addition on methane production from municipal organic solid waste
- 23 June 2021
- Published by Wiley in Journal of Chemical Technology & Biotechnology
- Vol. 96 (10) , 2845-2851
The effect of reduced graphene oxide addition on methane production from municipal organic solid waste
- 1 March 2021
- Published by Wiley in Journal of Chemical Technology & Biotechnology
- Vol. 96 (7) , 1927-1935
Investigation of the treatability of pre‐coagulated slaughterhouse wastewater using dead‐end filtration
- 1 March 2021
- Published by Wiley in Journal of Chemical Technology & Biotechnology
- Vol. 96 (7) , 1927-1935
Investigation of the treatability of pre‐coagulated slaughterhouse wastewater using dead‐end filtration
- 1 August 2020
- Published by Elsevier in Environmental Pollution
- Vol. 263 (Pt A) , 114635
Spatial prediction of PM10 concentration using machine learning algorithms in Ankara, Turkey
- 1 August 2020
- Published by Elsevier in Environmental Pollution
- Vol. 263 (Pt A) , 114635
Spatial prediction of PM10 concentration using machine learning algorithms in Ankara, Turkey
- 28 June 2020
- Published by Wiley in CLEAN – Soil, Air, Water
- Vol. 48 (7-8)
Optimization of the Coagulation–Flocculation Process for Slaughterhouse Wastewater Using Response Surface Methodology
Slaughterhouse wastewater is one of the main sources of environmental pollutants, containing a high amount of organic matter (chemical oxygen demand (COD), biochemical oxygen demand (BOD)), total nitrogen (TN), total suspended solids (TSS), total phosphorus (TP), grease, and oil. The main aim of the present research is optimizing the coagulation–flocculation process and examining the effects of experimental factors with each other, for example, pH, the concentration of two different coagulants (FeCl3 and alum), rapid mixing rate, and settling time. Therefore, it is aimed to treat slaughterhouse wastewater using the coagulation–flocculation process with the optimization of the response surface methodology (RSM). COD, turbidity, and suspended solids (SS) of the treated wastewater are chosen as the response variables. Furthermore, the optimal conditions for three responses are acquired by employing the desirability function approach. When the experimental results of two coagulants are compared, it is observed that the alum coagulant gave better results for the three responses. The alum coagulant utilized in the present research is able to increase COD, SS, and turbidity removal efficiency by 75.25%, 90.16%, and 91.18%, respectively. It is possible to optimize coagulation–flocculation by utilizing the RSM analysis, which proves that coagulation can pre‐treat slaughterhouse wastewater.
- 28 June 2020
- Published by Wiley in CLEAN – Soil, Air, Water
- Vol. 48 (7-8)
Optimization of the Coagulation–Flocculation Process for Slaughterhouse Wastewater Using Response Surface Methodology
Slaughterhouse wastewater is one of the main sources of environmental pollutants, containing a high amount of organic matter (chemical oxygen demand (COD), biochemical oxygen demand (BOD)), total nitrogen (TN), total suspended solids (TSS), total phosphorus (TP), grease, and oil. The main aim of the present research is optimizing the coagulation–flocculation process and examining the effects of experimental factors with each other, for example, pH, the concentration of two different coagulants (FeCl3 and alum), rapid mixing rate, and settling time. Therefore, it is aimed to treat slaughterhouse wastewater using the coagulation–flocculation process with the optimization of the response surface methodology (RSM). COD, turbidity, and suspended solids (SS) of the treated wastewater are chosen as the response variables. Furthermore, the optimal conditions for three responses are acquired by employing the desirability function approach. When the experimental results of two coagulants are compared, it is observed that the alum coagulant gave better results for the three responses. The alum coagulant utilized in the present research is able to increase COD, SS, and turbidity removal efficiency by 75.25%, 90.16%, and 91.18%, respectively. It is possible to optimize coagulation–flocculation by utilizing the RSM analysis, which proves that coagulation can pre‐treat slaughterhouse wastewater.
- 27 December 2019
- Published by IWA Publishing in Water Supply
- Vol. 20 (2) , 574-585
Arsenic removal by the micellar-enhanced ultrafiltration using response surface methodology
The present research investigates the removal of arsenic (As) from aqueous solutions using micellar-enhanced ultrafiltration (MEUF) by utilizing two different surfactants: benzethonium chloride and dodecyl pyridinium chloride (BCl and DPCl). The impact of the operating variables and maximum removal efficiency were found under different conditions for BCl and DPCl surfactants. The maximum As rejection efficiency for MEUF with BCl and DPCl surfactants is 92.8% and 84.1%, respectively. In addition to this, a statistics-based experimental design with response surface methodology was used for the purpose of examining the impact of operating conditions, including initial pH, initial As concentration (ppb), and surfactant concentration (BCl, mM) in As-removal from aqueous solutions. In the analysis of the experimental data, a second-order polynomial model that was validated by statistical analysis for the BCl surfactant was used. On the basis of the response model created, the removal of As ions was acquired at optimum operating parameters, including the initial As concentration of 150 ppb, surfactant concentration of 5 mM and pH 10 for the BCl surfactant with 92.8% As-removal efficiency.
- 27 December 2019
- Published by IWA Publishing in Water Supply
- Vol. 20 (2) , 574-585
Arsenic removal by the micellar-enhanced ultrafiltration using response surface methodology
The present research investigates the removal of arsenic (As) from aqueous solutions using micellar-enhanced ultrafiltration (MEUF) by utilizing two different surfactants: benzethonium chloride and dodecyl pyridinium chloride (BCl and DPCl). The impact of the operating variables and maximum removal efficiency were found under different conditions for BCl and DPCl surfactants. The maximum As rejection efficiency for MEUF with BCl and DPCl surfactants is 92.8% and 84.1%, respectively. In addition to this, a statistics-based experimental design with response surface methodology was used for the purpose of examining the impact of operating conditions, including initial pH, initial As concentration (ppb), and surfactant concentration (BCl, mM) in As-removal from aqueous solutions. In the analysis of the experimental data, a second-order polynomial model that was validated by statistical analysis for the BCl surfactant was used. On the basis of the response model created, the removal of As ions was acquired at optimum operating parameters, including the initial As concentration of 150 ppb, surfactant concentration of 5 mM and pH 10 for the BCl surfactant with 92.8% As-removal efficiency.
- 1 October 2018
- Published by Elsevier in Journal of Environmental Management
- Vol. 224, 298-309
Investigation of the treatability of molasses and industrial oily wastewater mixture by an anaerobic membrane hybrid system
- 1 October 2018
- Published by Elsevier in Journal of Environmental Management
- Vol. 224, 298-309
Investigation of the treatability of molasses and industrial oily wastewater mixture by an anaerobic membrane hybrid system
- 1 January 2018
- Published by Desalination Publications in Desalination and Water Treatment
- Vol. 105, 83-91
Anaerobic treatment of the mixture of automotive industry and molasses wastewater for different organic loading rates in an upflow
- 1 January 2018
- Published by Desalination Publications in Desalination and Water Treatment
- Vol. 105, 83-91
Anaerobic treatment of the mixture of automotive industry and molasses wastewater for different organic loading rates in an upflow