Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Stanislav Kotaška has a total of 11 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Applicability Limits for Using 2D Shallow-Water Models to Predict Discharge over Fixed-Crest Weirs

    by Jiří Skokan, Miroslav Špano, Stanislav Kotaška, Pavel Zubík, Aleš Dráb

    Fixed-crest weirs are widely used hydraulic structures that control river discharge capacity and influence upstream water surface profiles. Accurate prediction of their rating curves is essential during flood events; however, two-dimensional (2D) shallow-water equation (SWE) models are often applied without clearly established criteria defining their range of reliable use. This study evaluates the performance of a 2D SWE model under varying submergence conditions using laboratory experiments, depth-averaged numerical simulations, theoretical analysis, and velocity measurements. Agreement between measured and simulated hydraulic characteristics met the adopted accuracy criterion only above a transition ratio of submergence depth to critical depth over the weir crest, estimated statistically as 0.70–0.77 for Case A and 0.97 for Case B (95% confidence interval 0.91–1.04). Below this transition, errors increase rapidly due to unresolved vertical contraction and non-hydrostatic effects. In both cases, the transition occurred at a lower relative submergence depth than that required by the classical parallel-flow criterion proposed by earlier researchers, and was closer to the theoretical force-balance estimate, which indicates approximately equal submergence and critical depths. These findings establish a physically supported range of reliable 2D SWE applications and provide practical guidance for hydraulic modelling of submerged weir flows.


  • Open Access

    Spectral analysis of oscillatory wind wave parameters in fetch-limited deep-water conditions at a small reservoir and their prediction: Case Study of the Hulín Reservoir in the Czech Republic

    by Stanislav Kotaška, David Duchan, Petr Pelikán, Miroslav Špano

    The dams and banks of small water reservoirs face significant erosion from wind-generated oscillatory waves. Proper design of structure height is crucial to protect such banks against erosion, considering the maximum characteristics of wind waves. Long-term measurements at the Hulín reservoir revealed that the wave spectrum aligns best with the Bretschneider type. This spectrum serves as a basis for simulating oscillatory waves and their impact on shore protection structure design. Empirical models were evaluated using wind and wave data from Hulín reservoir in the Czech Republic. The measured wind speeds attained a maximum of 8 m/s, and wave heights reached up to 15 cm. The Bretschneider (SMB) empirical formula provided the most accurate estimation of wave height (H m 0), with an average underestimate of RMSE = 0.038 m. On the other hand, Wilson revisited (WIL rev.) performed less effectively, with an average RMSE = 0.304 m. For wave period (T) estimation, Bretschneider (SMB) yielded the best results, with an average RMSE = 0.062 s. Conversely, Wilson revisited (WIL rev.) showed poorer performance, with an average underestimate of RMSE = 2.196 s. The discrepancy between the empirical formulas and measured values, particularly in underestimating H m 0, can be attributed to inaccurate determination of fetch length and wind speed.


  • Open Access

    Simplified dispersion analysis based on dye tests at a small stream

    by Jaromír Říha, Tomáš Julínek, Stanislav Kotaška

    The modelling of solid transport in open channels requires good knowledge about parameters related to basic processes such as hydrodynamic dispersion, advection and decay rates. Such parameters are usually determined by dye tests. Numerous tracer studies have been performed on laboratory flumes and natural rivers. However, on-site sampling is often difficult, expensive and needs special apparatus. The main aim of the study was to justify simplified method based on the monitoring of the dye cloud shape in order to determine both longitudinal and transversal dispersion coefficients. In this study, four dye tests were carried out on a small local stream (the Lipkovsky) using Rhodamine WT fluorescein dye as a tracer. The tests were carried out in such a manner that both longitudinal and horizontal transversal dispersion data were obtained. For this purpose, the visually determined extent of the dye cloud was interpreted via the analytical solution of the advection-dispersion equation. The results obtained by this simplified approach indicated that the longitudinal dispersion coefficient Dx = 0.051–0.057 m2/s and the coefficient of horizontal transversal dispersion Dy = 0.00024–0.00027 m2/s. The method was justified by corresponding root mean square error (RMSE) counting RMSE = 0.65–1.02 m for the dye cloud centre, RMSE = 1.87–2.46 m for the head and tail of the cloud and RMSE = 0.025–0.11 m for the cloud width, the Nash-Sutcliffe efficiency coefficients ranged from 0.9 to 0.998. The comparison of these values with empirical formulae and other tracer studies indicated significant overestimation of the mentioned values of Dx , which can be attributed to the uniform velocity distribution along the width of Lipkovsky Stream. Much better agreement was achieved for Dy .


  • Open Access

    Dam Incidents and Failures – Cases in the Czech Republic

    by Stanislav Kotaška, Jaromír Říha

    Dam incidents and failures mainly occur during extreme floods. In the Czech Republic (CR), large-scale regional floods were recorded in different regions in 1985, 1987, 1997, 2002, 2006, 2010, and 2013, while local floods especially occurred in 1991, 1996, 1997, 1998, 2002, 2004, 2005, 2009, and 2010. During these events, numerous incidents and total breaches of small dams were recorded, and a few large dams were also critically endangered, although they were not completely breached. This paper presents a comprehensive summary of incidents and failures affecting small dams in the CR since 1985. The most significant incidents concerning large dams are listed as well. The statistics show that 62 small dams were completely breached and that 350 were seriously damaged over 35 years in the period 1985–2020. The annual frequency amounts to 1.85 collapsed and 10 small damaged dams per year. The most common causes of the complete breaching of dams were overtopping (85 %) and internal erosion (15 %).


  • Open Access

    Dam Break Modeling in a Cascade of Small Earthen Dams: Case Study of the Čižina River in the Czech Republic

    by Jaromír Říha, Stanislav Kotaška, Lubomír Petrula

    Failures of small dams can pose a serious threat to people and property even if the size of the schemes is relatively low. In many cases, small dams are situated in a cascade along streams, meaning that the failure of the uppermost dam may cause the dams downstream to fail. In this paper, a cascade of three small reservoirs, Lichnov II (14.6 m high), Lichnov III (10 m high), and Pocheň (8.5 m high), is the subject of the dam break analyses carried out via various methods such as empirical formulae, analogy, and hydraulic modeling. The dam-break flood routing was simulated using a shallow water flow hydraulic model. The simulations confirm that the attenuation effect of the peak discharge is governed by the flood volume, slope, and morphology of the floodplain and increases with the distance from the breached dam following an approximately exponential trend. When estimating peak discharge, empirical formulae derived for a single dam break should be applied carefully as they may underestimate the peak outflow by up to 10% in the case of a dam cascade. The attenuation volume of small reservoirs is small when compared to the flood volume, meaning that the attenuation of the peak discharge usually varies between 5–10%.