Deirdre Luyckx
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Deirdre Luyckx has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
J.A. Thas
4 shared publications- Geert Potters
Antwerp Maritime Academy, Noordkasteel Oost 6, 2030 Antwerp, Belgium
2 shared publications J. A. Thas
2 shared publications- Kris De Baere
Antwerp Maritime Academy, Antwerp, Belgium
2 shared publications A. Aguglia
1 shared publication- Alexandra Silinski
GIS and Remote Sensing Section Institute of Geography Cartography, Georg‐August University Göttingen Göttingen Germany
1 shared publication
Latest Publications
- Open Access
- 18 August 2020
- Published by SAGE Publications in Corrosion Engineering, Science and Technology: The International Journal of Corrosion Processes and Corrosion Control
- Vol. 56 (1) , 71-80
The influence of concretion on the long-term corrosion rate of steel shipwrecks in the Belgian North Sea
Some three hundred mainly steel shipwrecks from both World Wars lie buried at shallow depths along the Belgian North Sea coast. They were examined recently to estimate corrosion rates over periods in excess of 100 years. The rate was estimated by comparing the measured in-situ steel plate thicknesses with archived ship information. The estimates show distinctly lower long-term corrosion rate compared to that predicted by the Melchers (Modeling of marine immersion corrosion for mild and low alloy steels – part 1: phenomenological model. Corrosion. 2003;59(4):319–334) corrosion model, when parameterised for local North Sea conditions. Concretion after 50 years has a multi-layer structure for which SEM-EDS and XRD measurements show the innermost layer, close to the metal surface, consisting of akaganeite, and the outer layer mostly of calcium carbonates, silicates, and some siderite. In between there is a considerable layer of hard magnetite. The latter is proposed as the reason for the low long-term corrosion rate (0.016 mm y–1) in an environment with calcium carbonate available in abundance.
- 18 August 2020
- Published by SAGE Publications in Corrosion Engineering, Science and Technology: The International Journal of Corrosion Processes and Corrosion Control
- Vol. 56 (1) , 71-80
Open AccessThe influence of concretion on the long-term corrosion rate of steel shipwrecks in the Belgian North Sea
Some three hundred mainly steel shipwrecks from both World Wars lie buried at shallow depths along the Belgian North Sea coast. They were examined recently to estimate corrosion rates over periods in excess of 100 years. The rate was estimated by comparing the measured in-situ steel plate thicknesses with archived ship information. The estimates show distinctly lower long-term corrosion rate compared to that predicted by the Melchers (Modeling of marine immersion corrosion for mild and low alloy steels – part 1: phenomenological model. Corrosion. 2003;59(4):319–334) corrosion model, when parameterised for local North Sea conditions. Concretion after 50 years has a multi-layer structure for which SEM-EDS and XRD measurements show the innermost layer, close to the metal surface, consisting of akaganeite, and the outer layer mostly of calcium carbonates, silicates, and some siderite. In between there is a considerable layer of hard magnetite. The latter is proposed as the reason for the low long-term corrosion rate (0.016 mm y–1) in an environment with calcium carbonate available in abundance.
- 10 October 2017
- Published by Wiley in Limnology and Oceanography
- Vol. 63 (2) , 799-815
Coping with waves: Plasticity in tidal marsh plants as self‐adapting coastal ecosystem engineers
Tidal marsh vegetation is increasingly valued for its role in ecosystem‐based coastal protection due to its wave dissipating capacity. As the efficiency of wave dissipation is known to depend on specific vegetation properties, we quantified how these morphological, biochemical, and biomechanical properties of tidal marsh vegetation are, in turn, affected by wave exposure. This was achieved by field measurements at two locations, with contrasting wave exposure, in the brackish part of the Scheldt Estuary (SW Netherlands), where Scirpus maritimus is the dominant pioneer species. Our results show that shoots from more wave‐exposed conditions developed significantly shorter and thicker stems than the ones growing in more sheltered conditions. Furthermore, we show that the more exposed shoots are more flexible whereas the shoots growing in more sheltered conditions are stiffer. This may indicate plasticity in response to wave exposure following a stress‐avoidance strategy. Increasing stiffness was shown to be related to enhanced biogenic silica and lignin contents of the shoot tissue. These properties might affect the wave‐attenuating capacity of the marsh as stiff plants are known to mitigate waves more effectively than flexible ones. However, we also found higher shoot densities on the exposed site, which may partly explain why higher relative wave attenuation rates were found on the exposed site, despite the presence of more flexible individual shoots. This study highlights that the efficiency of wave attenuation by tidal marsh vegetation ultimately depends on mutual interactions between waves and plasticity in morphological, biochemical, and biomechanical plant properties.
- 10 October 2017
- Published by Wiley in Limnology and Oceanography
- Vol. 63 (2) , 799-815
Coping with waves: Plasticity in tidal marsh plants as self‐adapting coastal ecosystem engineers
Tidal marsh vegetation is increasingly valued for its role in ecosystem‐based coastal protection due to its wave dissipating capacity. As the efficiency of wave dissipation is known to depend on specific vegetation properties, we quantified how these morphological, biochemical, and biomechanical properties of tidal marsh vegetation are, in turn, affected by wave exposure. This was achieved by field measurements at two locations, with contrasting wave exposure, in the brackish part of the Scheldt Estuary (SW Netherlands), where Scirpus maritimus is the dominant pioneer species. Our results show that shoots from more wave‐exposed conditions developed significantly shorter and thicker stems than the ones growing in more sheltered conditions. Furthermore, we show that the more exposed shoots are more flexible whereas the shoots growing in more sheltered conditions are stiffer. This may indicate plasticity in response to wave exposure following a stress‐avoidance strategy. Increasing stiffness was shown to be related to enhanced biogenic silica and lignin contents of the shoot tissue. These properties might affect the wave‐attenuating capacity of the marsh as stiff plants are known to mitigate waves more effectively than flexible ones. However, we also found higher shoot densities on the exposed site, which may partly explain why higher relative wave attenuation rates were found on the exposed site, despite the presence of more flexible individual shoots. This study highlights that the efficiency of wave attenuation by tidal marsh vegetation ultimately depends on mutual interactions between waves and plasticity in morphological, biochemical, and biomechanical plant properties.
- 1 September 2017
- Published by Royal Institution of Naval Architects in International Journal of Maritime Engineering
- Vol. 159 (A3) , A237-A247
The Economics of a Long Term Coating
An important challenge during ship construction is the protection against corrosion of the ballast tanks. These tanks have many compartments, contain multiple structural elements and play a critical role in the seaworthiness. The majority of the ballast tanks are prepared and coated according to IMO Performance Standard for Protective Coating regulations (PSPC), using a light colored epoxy coating that, when maintenance is being performed by the crew, must remain in a “good” condition for 15 years. This method is set next to a protection system applied by a given owner who keeps its ships in an excellent condition for their complete lifetime using a long term coating. More attention is paid to the preparation and application of the coating and consequently it protects the ballast tanks for more than 25 years. These coating strategies are compared in an economic analysis, supplemented with a sensitivity analysis to evaluate the outcomes due to variable parameters. The results indicate that a long term coating only pays off for owners willing to keep the ballast tanks of their vessels in a good condition for the complete lifetime. The decisive factor is that a long term coating entails no recoating in dry dock. The latter results in less toxic components in the atmosphere.
- 1 September 2017
- Published by Royal Institution of Naval Architects in International Journal of Maritime Engineering
- Vol. 159 (A3) , A237-A247
The Economics of a Long Term Coating
An important challenge during ship construction is the protection against corrosion of the ballast tanks. These tanks have many compartments, contain multiple structural elements and play a critical role in the seaworthiness. The majority of the ballast tanks are prepared and coated according to IMO Performance Standard for Protective Coating regulations (PSPC), using a light colored epoxy coating that, when maintenance is being performed by the crew, must remain in a “good” condition for 15 years. This method is set next to a protection system applied by a given owner who keeps its ships in an excellent condition for their complete lifetime using a long term coating. More attention is paid to the preparation and application of the coating and consequently it protects the ballast tanks for more than 25 years. These coating strategies are compared in an economic analysis, supplemented with a sensitivity analysis to evaluate the outcomes due to variable parameters. The results indicate that a long term coating only pays off for owners willing to keep the ballast tanks of their vessels in a good condition for the complete lifetime. The decisive factor is that a long term coating entails no recoating in dry dock. The latter results in less toxic components in the atmosphere.
- 1 February 2008
- Published by Elsevier in Discrete Mathematics
- Vol. 308 (2-3) , 375-379
On maximal partial spreads of- 1 February 2008
- Published by Elsevier in Discrete Mathematics
- Vol. 308 (2-3) , 375-379
On maximal partial spreads of- 31 August 2007
- Published by Elsevier in European Journal of Combinatorics
- Vol. 28 (6) , 1626-1636
On the geometry of regular hyperbolic fibrations
- 31 August 2007
- Published by Elsevier in European Journal of Combinatorics
- Vol. 28 (6) , 1626-1636
On the geometry of regular hyperbolic fibrations
- 1 May 2006
- Published by Springer Nature in Designs, Codes and Cryptography
- Vol. 39 (2) , 281-288
A Geometric Construction of the Hyperbolic Fibrations Associated with a Flock, q Even
- 1 May 2006
- Published by Springer Nature in Designs, Codes and Cryptography
- Vol. 39 (2) , 281-288
A Geometric Construction of the Hyperbolic Fibrations Associated with a Flock, q Even
- Open Access
- 1 January 2006
- Published by The Belgian Mathematical Society in Bulletin of the Belgian Mathematical Society - Simon Stevin
- Vol. 12 (5) , 641-650
On partial ovoids of Hermitian surfaces
Project Euclid - mathematics and statistics online
- 1 January 2006
- Published by The Belgian Mathematical Society in Bulletin of the Belgian Mathematical Society - Simon Stevin
- Vol. 12 (5) , 641-650
Open AccessOn partial ovoids of Hermitian surfaces
Project Euclid - mathematics and statistics online
- 1 June 2005
- Published by Springer Nature in Designs, Codes and Cryptography
- Vol. 35 (3) , 337-352
Trialities and 1-Systems of Q +(7,q)
- 1 June 2005
- Published by Springer Nature in Designs, Codes and Cryptography
- Vol. 35 (3) , 337-352
Trialities and 1-Systems of Q +(7,q)
- 1 April 2005
- Published by Elsevier in Discrete Mathematics
- Vol. 294 (1-2) , 133-138
The uniqueness of the 1-system of , q even- 1 April 2005
- Published by Elsevier in Discrete Mathematics
- Vol. 294 (1-2) , 133-138
The uniqueness of the 1-system of , q even- 6 May 2004
- Published by Elsevier in Discrete Mathematics
- Vol. 282 (1-3) , 223-231
Locally hermitian 1-systems of Q+(7,q)
- 6 May 2004
- Published by Elsevier in Discrete Mathematics
- Vol. 282 (1-3) , 223-231
Locally hermitian 1-systems of Q+(7,q)