Jiri Pangrac
Research Subjects
Jiri Pangrac has a total of 214 co-authors. Here are the top co-authors by number of shared publications:
- Eduard Hulicius
Institute of Physics, CAS, v.v.i., 162 00, Cukrovarnická 10, Prague 6, Czech Republic
63 shared publications - Karla Kuldova
Academy of Sciences of the Czech Republic
28 shared publications A. Hospodková
Inst Phys CAS, Vvi, Cukrovarnicka 10, CZ-16200 Prague 6, Czech Republic
22 shared publicationsJ. Oswald
CAS, Inst Phys, Vvi, Cukrovarnicka 10, Prague 16200 6, Czech Republic
22 shared publications- Markéta Zíková
Institute of Physics, CAS, v.v.i., 162 00, Cukrovarnická 10, Prague 6, Czech Republic
22 shared publications Alice Hospodková
13 shared publications
Latest Publications
- Open Access
- 9 October 2026
- Published by Elsevier in SSRN Electronic Journal
Effect of annealing atmosphere on gallium vacancies and vacancy clustering in MOVPE-grown GaN
This study investigates the formation of VGa and its complexes and clusters within a thin GaN layer prepared by metal-organic vapour-phase epitaxy, as well as the influence of annealing on intrinsic point defects. We studied the evolution of VGa-related defects during annealing under different atmospheres, as well as the consequences for the photoluminescence properties of these samples. After annealing, clusters of VGa and VN are often formed. We demonstrate that identical annealing conditions can have a very different impact on GaN layers prepared under different growth conditions. The position of the Fermi level at the surface of the epilayer is crucial for creating new vacancies during annealing. A mid-gap position of the Fermi level significantly suppresses the formation of VGa-related defects during annealing. A deep Fermi level position can be stabilized through high C incorporation or a high concentration of VGa-related defects in the as-grown GaN layer.
- 9 October 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessEffect of annealing atmosphere on gallium vacancies and vacancy clustering in MOVPE-grown GaN
This study investigates the formation of VGa and its complexes and clusters within a thin GaN layer prepared by metal-organic vapour-phase epitaxy, as well as the influence of annealing on intrinsic point defects. We studied the evolution of VGa-related defects during annealing under different atmospheres, as well as the consequences for the photoluminescence properties of these samples. After annealing, clusters of VGa and VN are often formed. We demonstrate that identical annealing conditions can have a very different impact on GaN layers prepared under different growth conditions. The position of the Fermi level at the surface of the epilayer is crucial for creating new vacancies during annealing. A mid-gap position of the Fermi level significantly suppresses the formation of VGa-related defects during annealing. A deep Fermi level position can be stabilized through high C incorporation or a high concentration of VGa-related defects in the as-grown GaN layer.
- Open Access
- 20 July 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 129 (3)
InGaN-based heterostructures for solar water splitting with various mechanisms of photogenerated carrier separation
In this study, we present a photocatalytic application based on three distinct types of three-dimensional (3D) nitride heterostructures: self-assembled core–shell InGaN/GaN microrods, 3D semipolar InxGa1−xN/InyGa1−yN multiple quantum wells, and nanopyramids featuring an InzGa1−zN/InwGa1−wN multilayer periodic structure. These InGaN-based architectures utilize different mechanisms of photogenerated carrier separation, arising from their specific geometric and band profile designs. The structural and optical properties of the fabricated InGaN-based heterostructures were systematically characterized using scanning electron microscopy, photoluminescence, and cathodoluminescence, followed by a comparative evaluation of their photocatalytic hydrogen (H2) evolution performance in a batch photoreactor. H2 was detected as the sole product of the photocatalytic decomposition of a methanol–water solution. The stability of the photocatalyst was verified through repeated use of the same batch, yielding consistent results. Our results demonstrate that the photocatalytic activity of InGaN-based heterostructures strongly dependents on material quality, particularly the suppression of the non-radiative recombination of photogenerated carriers. We propose different carrier separation mechanisms in each structure type and compare their photocatalytic efficiencies. The best results were achieved with the InzGa1−zN/InwGa1−wN multilayer periodic structure. This highlights the benefits of integrating polarization-field engineering with nanostructured architectures for photocatalytic H2 production. This study shows that optimizing carrier separation through band engineering and nanostructure design can significantly improve the performance of InGaN-based photocatalysts.
- 20 July 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 129 (3)
Open AccessInGaN-based heterostructures for solar water splitting with various mechanisms of photogenerated carrier separation
In this study, we present a photocatalytic application based on three distinct types of three-dimensional (3D) nitride heterostructures: self-assembled core–shell InGaN/GaN microrods, 3D semipolar InxGa1−xN/InyGa1−yN multiple quantum wells, and nanopyramids featuring an InzGa1−zN/InwGa1−wN multilayer periodic structure. These InGaN-based architectures utilize different mechanisms of photogenerated carrier separation, arising from their specific geometric and band profile designs. The structural and optical properties of the fabricated InGaN-based heterostructures were systematically characterized using scanning electron microscopy, photoluminescence, and cathodoluminescence, followed by a comparative evaluation of their photocatalytic hydrogen (H2) evolution performance in a batch photoreactor. H2 was detected as the sole product of the photocatalytic decomposition of a methanol–water solution. The stability of the photocatalyst was verified through repeated use of the same batch, yielding consistent results. Our results demonstrate that the photocatalytic activity of InGaN-based heterostructures strongly dependents on material quality, particularly the suppression of the non-radiative recombination of photogenerated carriers. We propose different carrier separation mechanisms in each structure type and compare their photocatalytic efficiencies. The best results were achieved with the InzGa1−zN/InwGa1−wN multilayer periodic structure. This highlights the benefits of integrating polarization-field engineering with nanostructured architectures for photocatalytic H2 production. This study shows that optimizing carrier separation through band engineering and nanostructure design can significantly improve the performance of InGaN-based photocatalysts.
- Open Access
Relation between Ga Vacancies, Photoluminescence, and Growth Conditions of MOVPE-Prepared GaN Layers
A set of GaN layers prepared by metalorganic vapor phase epitaxy under different technological conditions (growth temperature carrier gas type and Ga precursor) were investigated using variable energy positron annihilation spectroscopy (VEPAS) to find a link between technological conditions, GaN layer properties, and the concentration of gallium vacancies (VGa). Different correlations between technological parameters and VGa concentration were observed for layers grown from triethyl gallium (TEGa) and trimethyl gallium (TMGa) precursors. In case of TEGa, the formation of VGa was significantly influenced by the type of reactor atmosphere (N2 or H2), while no similar behaviour was observed for growth from TMGa. VGa formation was suppressed with increasing temperature for growth from TEGa. On the contrary, enhancement of VGa concentration was observed for growth from TMGa, with cluster formation for the highest temperature of 1100 °C. From the correlation of photoluminescence results with VGa concentration determined by VEPAS, it can be concluded that yellow band luminescence in GaN is likely not connected with VGa; additionally, increased VGa concentration enhances excitonic luminescence. The probable explanation is that VGa prevent the formation of some other highly efficient nonradiative defects. Possible types of such defects are suggested.
Open AccessRelation between Ga Vacancies, Photoluminescence, and Growth Conditions of MOVPE-Prepared GaN Layers
A set of GaN layers prepared by metalorganic vapor phase epitaxy under different technological conditions (growth temperature carrier gas type and Ga precursor) were investigated using variable energy positron annihilation spectroscopy (VEPAS) to find a link between technological conditions, GaN layer properties, and the concentration of gallium vacancies (VGa). Different correlations between technological parameters and VGa concentration were observed for layers grown from triethyl gallium (TEGa) and trimethyl gallium (TMGa) precursors. In case of TEGa, the formation of VGa was significantly influenced by the type of reactor atmosphere (N2 or H2), while no similar behaviour was observed for growth from TMGa. VGa formation was suppressed with increasing temperature for growth from TEGa. On the contrary, enhancement of VGa concentration was observed for growth from TMGa, with cluster formation for the highest temperature of 1100 °C. From the correlation of photoluminescence results with VGa concentration determined by VEPAS, it can be concluded that yellow band luminescence in GaN is likely not connected with VGa; additionally, increased VGa concentration enhances excitonic luminescence. The probable explanation is that VGa prevent the formation of some other highly efficient nonradiative defects. Possible types of such defects are suggested.
- 1 February 2020
- Published by Elsevier in Journal of Crystal Growth
- Vol. 531
Improvement of luminescence properties of n-GaN using TEGa precursor
- 1 February 2020
- Published by Elsevier in Journal of Crystal Growth
- Vol. 531
Improvement of luminescence properties of n-GaN using TEGa precursor
- 1 February 2019
- Published by Elsevier in Journal of Crystal Growth
- Vol. 507, 310-315
Strong suppression of In desorption from InGaN QW by improved technology of upper InGaN/GaN QW interface
- 1 February 2019
- Published by Elsevier in Journal of Crystal Growth
- Vol. 507, 310-315
Strong suppression of In desorption from InGaN QW by improved technology of upper InGaN/GaN QW interface
- 1 February 2019
- Published by Elsevier in Journal of Crystal Growth
- Vol. 507, 246-250
Influence of GaN buffer layer under InGaN/GaN MQWs on luminescent properties
- 1 February 2019
- Published by Elsevier in Journal of Crystal Growth
- Vol. 507, 246-250
Influence of GaN buffer layer under InGaN/GaN MQWs on luminescent properties
- 1 January 2019
- Published by Elsevier in Journal of Crystal Growth
- Vol. 506, 8-13
Influence of Si doping of GaN layers surrounding InGaN quantum wells on structure photoluminescence properties
- 1 January 2019
- Published by Elsevier in Journal of Crystal Growth
- Vol. 506, 8-13
Influence of Si doping of GaN layers surrounding InGaN quantum wells on structure photoluminescence properties
- 26 November 2018
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 21 (2) , 356-362
Advancement toward ultra-thick and bright InGaN/GaN structures with a high number of QWs
InGaN/GaN structures are studied as potential candidates for superfast scintillation detectors and show the leading decay time of around 1 ns and intense luminescence.
- 26 November 2018
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 21 (2) , 356-362
Advancement toward ultra-thick and bright InGaN/GaN structures with a high number of QWs
InGaN/GaN structures are studied as potential candidates for superfast scintillation detectors and show the leading decay time of around 1 ns and intense luminescence.
- 21 December 2017
- Published by Wiley in Physica Status Solidi (b)
- Vol. 255 (5)
InGaN/GaN Structures: Effect of the Quantum Well Number on the Cathodoluminescent Properties
In this work we compare luminescence results obtained on InGaN/GaN multiple quantum well (QW) structures with 10 and 30 QWs. The aim is to increase the intensity of faster blue QW emission and decrease the luminescence of the QW defect band, showing a slower luminescence decay time, which is undesired for fast scintillator applications. We demonstrate that increasing the number of InGaN QWs is an efficient method to reach this goal. The luminescence improvement of the sample with higher number of QWs is explained by the influence of the increased size of V‐pits with increased QW number. Thinner QWs on the side wall of V‐pits serve as barriers which separate carriers from dislocations penetrating through the V‐pit centre, supressing thus the non‐radiative and radiative recombination on defects. Based on cathodoluminescence (CL) results, the scintillator structure design is discussed. Scintillator structures with higher number of QWs can take advantage of both, improved luminescence efficiency and thicker active region.
- 21 December 2017
- Published by Wiley in Physica Status Solidi (b)
- Vol. 255 (5)
InGaN/GaN Structures: Effect of the Quantum Well Number on the Cathodoluminescent Properties
In this work we compare luminescence results obtained on InGaN/GaN multiple quantum well (QW) structures with 10 and 30 QWs. The aim is to increase the intensity of faster blue QW emission and decrease the luminescence of the QW defect band, showing a slower luminescence decay time, which is undesired for fast scintillator applications. We demonstrate that increasing the number of InGaN QWs is an efficient method to reach this goal. The luminescence improvement of the sample with higher number of QWs is explained by the influence of the increased size of V‐pits with increased QW number. Thinner QWs on the side wall of V‐pits serve as barriers which separate carriers from dislocations penetrating through the V‐pit centre, supressing thus the non‐radiative and radiative recombination on defects. Based on cathodoluminescence (CL) results, the scintillator structure design is discussed. Scintillator structures with higher number of QWs can take advantage of both, improved luminescence efficiency and thicker active region.