ABAndreas Bader

Andreas Bader

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Andreas Bader has a total of 46 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    High optical anisotropy of the GaSb/GaxIn1−xAsySb1−y interface

    by Michał Rygała, Jakub Ziembicki, Tristan Smołka, Andreas Bader, Georg Knebl, Andreas Pfenning, Krzysztof Ryczko, Fabian Hartmann, Paweł Scharoch, Grzegorz Sęk, et al.

    We present the investigation of optical transitions in an Ga Sb / Ga In As Sb -based heterostructure through different experimental and numerical methods. The transitions had high-temperature stability, with them being observed in the 10–300 K temperature range. Four pronounced optical transitions are observed at low temperature with three of them being nonpolarized and one showing a degree of linear polarization higher than 60%. Time-resolved measurements of the transitions showed a complex carrier dynamics with several distinct processes related to the investigated interface. Using several numerical methods, we identified that the highly polarized transition originates from the first electron state in the Ga In As Sb layer and a two-dimensional hole gas created within a triangular quantum well at the interface with the -type doped Ga Sb layer. The optical polarization of the signal originates in directional elongation of the atomic bonds enhanced by possible local composition fluctuations and the inheritance of these properties by the signal from the triangular quantum well. Such physical phenomena have the potential to be used as an internal polarizing filter in structures designed for midinfrared optoelectronics.


  • 5.0 μm emitting interband cascade lasers with superlattice and bulk AlGaAsSb claddings

    by B. Petrović, A. Bader, J. Nauschütz, T. Sato, S. Birner, R. Weih, F. Hartmann, S. Höfling

    We present a comparison between interband cascade lasers (ICLs) with a six-stage active region emitting at 5 μm with AlSb/InAs superlattice claddings and with bulk Al0.85Ga0.15As0.07Sb0.93 claddings. Utilizing bulk AlGaAsSb claddings with their lower refractive index compared to the more commonly used AlSb/InAs superlattice claddings, the mode-confinement in the active region increases by 14.4% resulting in an improvement of the lasing threshold current density. For broad area laser and under pulsed excitation, the ICL with AlGaAsSb claddings shows a lower threshold current density of Jth=396A/cm2 compared to Jth=521A/cm2 of the ICL with superlattice claddings. Additionally, a higher characteristic temperature was obtained for the ICL with bulk claddings. Emission in pulsed operation is observed up to 65 °C.


  • GaSb-based interband cascade laser with hybrid superlattice plasmon-enhanced claddings

    by B. Petrović, A. Bader, J. Nauschütz, T. Sato, S. Birner, R. Weih, F. Hartmann, S. Höfling

    We present an interband cascade laser (ICL) emitting at 5.2 µm consisting of an 8-stage active region and a hybrid cladding composed of outer plasmon-enhanced InAs0.915Sb0.085 and inner InAs/AlSb superlattice claddings. The hybrid cladding architecture shows an increase in mode confinement in the active region by 11.2% according to the simulation. This is a consequence of a significantly lower refractive index of plasmon-enhanced claddings. The threshold current density is 242 A/cm2 in pulsed operation at room temperature. This is the lowest value reported to date for ICLs emitting at wavelengths longer than 5 µm. We also report close to record value threshold power density of 840 W/cm2 for ICLs at such wavelengths.


  • Emerging current-voltage plateaus caused by high internal electric potentials in interband cascade photodetectors

    by A. Bader, F. Rothmayr, N. Khan, J. Koeth, A. Pfenning, G. Bastard, S. Höfling, F. Hartmann

    We observe that under illumination and at cryogenic temperatures, plateaus emerge in the current-voltage characteristic of non-photocurrent-matched interband cascade infrared photodetectors (ICIPs) with identical thickness of individual superlattice absorbers. We attribute these plateaus to the formation of internal electric potentials on the order of multiple millivolts originating from a gradually decreasing photocurrent in optically deeper stages caused by light attenuation. At elevated temperatures, the plateaus vanish once the dark current exceeds the maximum photocurrent. Contrarily, in a photocurrent-matched ICIP architecture, with individual absorber thicknesses increasing towards optically deeper stages, no additional internal potentials are formed under illumination. The plateaus are found to show a strong wavelength and bias dependence related to the dispersion of the absorption coefficient of the type-II-InAs/GaSb-superlattice absorbers used. This could potentially be implemented in a two-color-detector approach that allows separation of different spectral bands by biasing of the ICIP.


  • Open Access

    Strain‐Free GaSb Quantum Dots as Single‐Photon Sources in the Telecom S‐Band

    by Johannes Michl, Giora Peniakov, Andreas Pfenning, Joonas Hilska, Abhiroop Chellu, Andreas Bader, Mircea Guina, Sven Höfling, Teemu Hakkarainen, Tobias Huber‐Loyola

    Generating single photons in the telecommunication wavelength range from semiconductor quantum dots (QDs) and interfacing them with spins of electrons or holes is of high interest in recent years, with research mainly focusing on indium‐based QDs. However, there is not much data on the optical and spin properties of gallium antimonide (GaSb) QDs, despite it being a physically rich system with an indirect to direct bandgap crossover in the telecom wavelength range. This work investigates the (quantum‐) optical properties of GaSb QDs, which are fabricated by filling droplet‐etched nanoholes in an aluminum gallium antimonide (AlGaSb) matrix. Photoluminescence (PL) features from isolated and highly symmetric QDs are observed that exhibit narrow linewidth in the telecom S‐band and show an excitonic fine structure splitting of up to µeV. Moreover, time‐resolved measurements of the decay characteristics of an exciton are performed and the second‐order photon autocorrelation function of the charge complex is measured to , revealing clear antibunching and thus proving the capability of this material platform to generate non‐classical light.


  • Detectivity enhancement by double radiation pass in interband cascade infrared photodetectors

    by A. Bader, F. Rothmayr, N. Khan, J. Koeth, F. Hartmann, S. Höfling

    The detectivity enhancement in a double-pass architecture in an interband cascade infrared photodetector (ICIP) is investigated. The ICIP consists of twelve identically thick absorbers composed of an InAs/GaSb type-II superlattice. To achieve a double-pass of radiation, a multilayer backside mirror was sputter-deposited after thinning the undoped GaSb substrate. At room temperature, a differential resistance area product of R0A= 1.37 Ω cm2 was achieved and the ICIP has a cutoff wavelength of 6.5 μm. By adding a backside mirror to the device, the responsivity was increased by 47% caused by the double radiation pass through the absorber. This resulted in a room temperature zero-bias detectivity of 8.3 × 108 Jones at a wavelength of 5.27 μm. Furthermore, oscillations are observed in the detectivity due to light interference from the reflected beam at the semiconductor/metal interface, which manifests the reflected double-pass device functionality unequivocally in the device characteristics.


  • Interband Cascade Infrared Photodetectors Based on Ga-Free Superlattice Absorbers

    by A. Bader, F. Rothmayr, N. Khan, F. Jabeen, J. Koeth, S. Höfling, F. Hartmann

    We present interband cascade infrared photodetectors based on InAs/InAsSb superlattice absorbers employing an alternative extraction path for photogenerated carriers. At 300 K specific detectivities ∗ ≈1⋅108 Jones were achieved for a cut-off wavelength of 9 µm.

  • Interband cascade infrared photodetectors based on Ga-free InAs/InAsSb superlattice absorbers

    by A. Bader, F. Rothmayr, N. Khan, F. Jabeen, J. Koeth, S. Höfling, F. Hartmann

    We present an interband cascade infrared photodetector based on Ga-free type-II superlattice absorbers. Substituting the more standard InAs/GaSb superlattice for a Ga-free superlattice with InAs/InAsSb requires an inverted carrier extraction path. A hole-ladder in the electron-barrier, instead of an electron-ladder in the hole-barrier, is employed to achieve photovoltaic operation. At elevated temperatures, seven negative-differential-conductance (NDC) regions are observed that arise from electrons tunneling through the electron barriers of the seven cascade stages. The detector operates in the photovoltaic mode at room temperature with a cutoff wavelength of 8.5 μm. At the NDC regions, the device features responsivity peaks under laser illumination reaching 0.45 A/W at room temperature at λ = 5.27 μm. This exceeds its highest measured low-temperature value of 0.22 A/W at this wavelength by a factor of 2.


  • Mid-infrared detectors based on resonant tunneling diodes and interband cascade structures

    by Martin Kamp, Fabian Hartmann, Lukas Worschech, Sven Höfling, Andreas Pfenning, Georg Knebl, Anne Schade, Robert Weih, Andreas Bader, Manuel Meyer, et al.

    Molecule and gas sensing is a key technology that is applied in multiple environmental, industrial and medical fields. In particular optical detection technologies enable contactless, nondestructive, highly sensitive and fast detection of even smallest concentrations of trace gases and molecules. During the past years, an increasing demand for mid-infrared (MIR) light sources suitable for, e.g. molecule or gas sensing applications, has driven the development and optimization of novel MIR lasers and light sources, such as quantum cascade lasers (QCL) or interband cascade lasers (ICL). Despite the progress on MIR light sources, there is still a lack in appropriate MIR detectors. Here, we present and discuss two promising and novel GaSb/InAs-based detector concepts. First, resonant tunneling diode (RTD) photodetectors as an alternative to avalanche photodetectors. In RTDs, amplification of photogenerated minority charge carriers is based on modulation of a majority charge carrier resonant tunneling current. Second, interband cascade photodetectors (ICD), in which a cascading scheme allows for fast carrier extraction and a compensation of the diffusion length limitation.


  • Open Access

    GaSb/AlAsSb resonant tunneling diodes with GaAsSb emitter prewells

    by Andreas Pfenning, Georg Knebl, Fabian Hartmann, Robert Weih, Manuel Meyer, Andreas Bader, Monika Emmerling, Lukas Worschech, Sven Höfling

    We investigate the electronic transport properties of GaSb/AlAsSb double barrier resonant tunneling diodes with pseudomorphically grown ternary GaAsxSb1-x emitter prewells over a broad temperature range. At room temperature, resonant tunneling is observed and the peak-to-valley current ratio (PVCR) is enhanced with the increasing As mole fraction from 1.88 (GaAs0.07Sb0.93 prewell), to 2.08 (GaAs0.09Sb0.91 prewell) up to 2.36 (GaAs0.11Sb0.89 prewell). The rise in PVCR is attributed to an enhanced carrier density at the Γ -valley within the emitter prewell. On the contrary at cryogenic temperatures, increasing the As mole fractions reduces the PVCR. At a temperature of T=4.2  K, reference samples without incorporation of an emitter prewell containing As show PVCRs up to 20.4 . We attribute the reduced PVCR to a degraded crystal quality of the resonant tunneling structure caused by As incorporation and subsequently an enhanced defect scattering at the interfaces.