Oghenevweta Erhuvwu Joseph
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Oghenevweta Erhuvwu Joseph has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
A. Calka
University of Wollongong
1 shared publication- Asuke Ferdinand
Department of Metallurgical and Materials Engineering, Ahmadu Bello University, Zaria, Nigeria
1 shared publication - David Wexler
University of Wollongong
1 shared publication
Latest Publications
- 27 October 2017
- Published by Springer Nature in Journal of Materials Science
- Vol. 53 (4) , 3064-3077
Understanding reaction sequences and mechanisms during synthesis of nanocrystalline Ti2N and TiN via magnetically controlled ball milling of Ti in nitrogen
- 27 October 2017
- Published by Springer Nature in Journal of Materials Science
- Vol. 53 (4) , 3064-3077
Understanding reaction sequences and mechanisms during synthesis of nanocrystalline Ti2N and TiN via magnetically controlled ball milling of Ti in nitrogen
- Open Access
- 1 January 2015
- Published by Science Publishing Group in International Journal of Materials Science and Applications
- Vol. 4 (1) , 59-64
Hardening and Characterisation of 0.45%C Steel Using Clay/Water Media as Quenchant
Hardening and characterization of 0.45%C steels using clay/water media as quenchants were investigated. Different weight percent of clay was added to water to form clay/water quenching media and water was equally use as the control. The steel specimens were heated to the austenizing temperature and quenched in these liquid media. The specific latent heat of vapourization of the liquid media, hardness value, impact energy, yield strength and tensile strength of the specimen were analyzed. The morphologies of the as-quenched steels were observed by using SEM. The results revealed that addition of 2-4wt% clay to water gives the best mechanical properties. This may probably be due to a uniform release of thermal energy in form of latent heat of vapourization across the dimension of the specimen and prevention of the oxide film formation on the surface of the workpiece. However, further addition of clay greater than 4% result to decrease in the mechanical properties of the specimen tested. The specific latent heat of vapourization decreases as the weight fraction of clay in water increases. Results from the microstructural examination indicate predominantly formation of martensite and retained austenite phases.
- 1 January 2015
- Published by Science Publishing Group in International Journal of Materials Science and Applications
- Vol. 4 (1) , 59-64
Open AccessHardening and Characterisation of 0.45%C Steel Using Clay/Water Media as Quenchant
Hardening and characterization of 0.45%C steels using clay/water media as quenchants were investigated. Different weight percent of clay was added to water to form clay/water quenching media and water was equally use as the control. The steel specimens were heated to the austenizing temperature and quenched in these liquid media. The specific latent heat of vapourization of the liquid media, hardness value, impact energy, yield strength and tensile strength of the specimen were analyzed. The morphologies of the as-quenched steels were observed by using SEM. The results revealed that addition of 2-4wt% clay to water gives the best mechanical properties. This may probably be due to a uniform release of thermal energy in form of latent heat of vapourization across the dimension of the specimen and prevention of the oxide film formation on the surface of the workpiece. However, further addition of clay greater than 4% result to decrease in the mechanical properties of the specimen tested. The specific latent heat of vapourization decreases as the weight fraction of clay in water increases. Results from the microstructural examination indicate predominantly formation of martensite and retained austenite phases.