TNThanh H. Nguyen

Thanh H. Nguyen

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Thanh H. Nguyen has a total of 5 co-authors. Here are the top co-authors by number of shared publications:

  • William P. Ball

    Department of Geography and Environmental Engineering, Johns Hopkins University, 3400 North Charles Street, Baltimore, Maryland 21218, Analytical Chemistry Division, National Institute of Standards and Technology, Gaithersburg, Maryland 20899-8392

    5 shared publications
  • Isam Sabbah

    Department of Geography and Environmental Engineering, Johns Hopkins University, 3400 North Charles Street, Baltimore, Maryland 21218

    2 shared publications
  • Dianne L. Poster

    Department of Geography and Environmental Engineering, Johns Hopkins University, 3400 North Charles Street, Baltimore, Maryland 21218, Analytical Chemistry Division, National Institute of Standards and Technology, Gaithersburg, Maryland 20899-8392

    1 shared publication
  • Hyun-Hee Cho

    Department of Geography and Environmental Engineering, Johns Hopkins University, 3400 North Charles Street, Baltimore, Maryland 21218, Analytical Chemistry Division, National Institute of Standards and Technology, Gaithersburg, Maryland 20899-8392

    1 shared publication
  • Kai-Uwe Goss

    Department of Geography and Environmental Engineering, Johns Hopkins University, 3400 North Charles Street, Baltimore, Maryland 21218, and Swiss Federal Institute for Environmental Science and Technology (EAWAG) and Swiss Federal Institute of Technology (ETH), Zurich, Switzerland

    1 shared publication

Latest Publications

  • Evidence for a Pore-Filling Mechanism in the Adsorption of Aromatic Hydrocarbons to a Natural Wood Char

    by Thanh H. Nguyen, Hyun-Hee Cho, Dianne L. Poster, William P. Ball

    Sorption isotherms for five aromatic hydrocarbons were obtained with a natural wood char (NC1) and its residue after solvent extraction (ENC1). Substantial isotherm nonlinearity was observed in all cases. ENC1 showed higher BET surface area, higher nitrogen-accessible micropore volume, and lower mass of extractable organic chemicals, including quantifiable polycyclic aromatic hydrocarbons (PAHs), while the two chars showed identical surface oxygen/carbon (O/C) ratio. For two chlorinated benzenes that normally condense as liquids at the temperatures used, sorption isotherms with NC1 and ENC1 were found to be statistically identical. For the solid-phase compounds (1,4-dichlorobenzene (1,4-DCB) and two PAHs), sorption was statistically higher with ENC1, thus demonstrating sorption effects due to both (1) authigenic organic content in the sorbent and (2) the sorbate's condensed state. Polanyi-based isotherm modeling, pore size measurements, and comparisons with activated carbon show the relative importance of adsorptive pore filling and help explain results. With both chars, maximum sorption increased in the order of decreasing molecular diameter: phenanthrene < naphthalene <1,2-dichlorobenzene/1,2,4-trichlorobenzene <1,4-DCB. Comparison of 1,4- and 1,2-DCB shows that the critical molecular diameter was apparently more important than the condensed state, suggesting that 1,4-DCB sorbed in the liquid state for ENC1.


  • Absorption and Adsorption of Hydrophobic Organic Contaminants to Diesel and Hexane Soot

    by Thanh H. Nguyen, William P. Ball

    Soot particles vary in pore structure, surface properties, and content of authigenic (native) extractable organic chemicals. To better understand the effects of these properties on sorption, aqueous sorption isotherms for 14C-labeled phenanthrene and 1,2,4-trichlorobenzene were obtained for four soots of varying properties: two diesel reference soots, a hexane soot, and an ozonated hexane soot. Substantial isotherm nonlinearity was observed. In comparison to diesel soot SRM 2975, diesel soot SRM 1650b had a much higher content of extractable authigenic organic chemicals, showed less sorption of 14C-labeled sorbate at low relative concentrations (Ce/Sw), and showed higher sorption at high Ce/Sw. In comparison to normal hexane soot, the ozonated hexane soot had a higher surface O/C ratio and showed substantially less sorption at all concentrations studied. The sorption differences were attributed to the noted differences in properties, and results were interpreted through a dual-mode sorption model that included the possibility of both surface adsorption (modeled using a Polanyi-based approach) and simple phase partitioning (linear absorption). Generally, such modeling indicated that overall uptake at low concentrations in all four soots was dominated by surface adsorption but that sorption at higher sorbate concentrations in SRM 1650b was heavily influenced by linear absorption within the natively bound organic phase.


  • Immobilization of Soot Particles in a Silica Matrix: A Sorbent-Carrier System for Studying Organic Chemical Sorption

    by Thanh H. Nguyen, Isam Sabbah, William P. Ball

    A new method for studying sorption with diesel and hexane soot was developed, tested, and applied. A commercial silica-based chromatography medium was used as an inert inorganic carrier for immobilization (entrapment) of soot particles and their aggregates, thus creating a combined sorbent for sorption of hydrophobic organic chemicals (HOCs). After precombustion to remove potential organic carbon contaminants, the silica particles and soot samples were mixed under dry conditions that allowed the soot to be incorporated within the pore structure of the much larger (>180 μm) carrier particles. Unincorporated soot was removed by multiple rinses with Milli-Q water. Sorption rate and equilibrium experiments were conducted, using phenanthrene as a probe HOC. Strong nonlinear sorption of phenanthrene was observed, in agreement with results previously obtained using air-bridge and flocculation-based methods. Batch kinetic studies suggested that 60 d of prewetting is required to obtain full water saturation, as perhaps needed for proper assessment of phenanthrene uptake rate by soot in aqueous systems. For the determination of equilibrium phenanthrene sorption, however, 1-d prewetting is sufficient so long as final equilibration is for at least 60 d. The new method is a practical approach to sorption measurement that may prove especially useful for study of strongly sorbing chemicals.


  • Polyparameter Linear Free Energy Relationships for Estimating the Equilibrium Partition of Organic Compounds between Water and the Natural Organic Matter in Soils and Sediments

    by Thanh H. Nguyen, Kai-Uwe Goss, William P. Ball

    Values of the organic-carbon-based partition coefficient (Koc) have often been estimated using one-parameter linear free energy relationships (op-LFERs), which include both correlations between log Koc and log Kow, where Kow is the octanol−water partition coefficient, and op-LFERs that are based on first-order molecular connectivity indices. For chemicals with tendencies toward strong hydrogen-bonding or other specific interactions with the organic phase, however, these methods are not sufficiently accurate. Polyparameter LFERs (pp-LFERs) address these shortcomings by explicitly considering contributions toward free energy change from multiple kinds of molecular interactions with both water and bulk organic phases. This paper reviews pp-LFER theory and presents the development of a new pp-LFER for organic chemical partitioning with soil/sediment organic matter (SOM) using a data set of 356 carefully selected experimental values of log Koc for 75 chemicals, including apolar, monopolar, and bipolar compounds. The paradigm of representing SOM by a single pp-LFER is qualitatively supported by our results, and the set of coefficients for the regression log Koc= (1.10 ± 0.10)E − (0.72 ± 0.14)S + (0.15 ± 0.15)A − (1.98 ± 0.14)B + (2.28 ± 0.14)V + (0.14 ± 0.10) represents a proposed set of water−SOM-specific properties for estimating log Koc. The developed correlation outperformed other currently recommended approaches with the given Koc data set and also compared favorably against the use of new multiple class-specific op-LFER regressions. Overall, the pp-LFER approach is recommended over other current methods for the purpose of Koc estimation and especially for polar chemicals.


  • Sorption Nonlinearity for Organic Contaminants with Diesel Soot: Method Development and Isotherm Interpretation

    by Thanh H. Nguyen, Isam Sabbah, William P. Ball

    An experimentally practical and precise flocculation-based method was developed, tested, and applied to determine phenanthrene and 1,2,4-trichlorobenzene sorption with NIST SRM 2975 diesel particulate matter. Following an initial equilibration period, polyaluminum chloride (PACI) solution was added to the sorption tubes in order to facilitate the formation of flocculated aggregates of soot particles. After separation of the solids through centrifugation, supernatant concentrations were determined as with conventional batch methods. The flocculation-based method was tested on three kinds of soot and then used to evaluate sorption kinetics and equilibrium with SRM 2975. Kinetic results showed that wetting of the soot required more than 20 days, but that 60 days was sufficient to achieve equilibration with both water and phenanthrene. Sixty-day isotherms for both phenanthrene and 1,2,4-trichlorobenzene were strongly nonlinear. At approximate 10(-3) of solubility, carbon-normalized distribution coefficients (Koc) were 10-20 times higher than those for absorption to sediment organic matter. Measurements at closer to solubility indicated much lower Koc, suggesting a total sorption capacity at aqueous solubility that is of similar magnitude to that in sediment organic matter. Independent analysis of extractable hydrocarbons suggests that absorption into a native hydrocarbon phase was not a major component of sorption.