Jean-Philippe Perez
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jean-Philippe Perez has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Philippe Christol
IES, Univ. Montpellier, CNRS, F-34000 Montpellier, France
4 shared publications - Isabelle Ribet-Mohamed
ONERA, Chemin de la Hunière, F-91761 Palaiseau, France
3 shared publications - Rodolphe Alchaar
Sorbonne Université, CNRS, Institut des NanoSciences de Paris, INSP, F-75005 Paris, France
3 shared publications - Clara Bataillon
Institut dElectronique et des Systmes (IES), Centre National de la Recherche Scientifique (CNRS), Universit de Montpellier, Montpellier, France
2 shared publications - Maxime Bouschet
Institute of Electronics and Systems (IES), University Montpellier, CNRS, F-34000 Montpellier, France
2 shared publications - Nicolas Péré-Laperne
LYNRED, BP 21, 38113 Veurey-Voroize, France
2 shared publications
Latest Publications
- 17 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 70 (4) , 541-548
Irradiation Temperature Influence on the Degradation of the Electrical Performances of Midwave Infrared Type-II Superlattice Detectors
In this work, we present the influence of the irradiation temperature on electrical characterization of MidWave infrared (MWIR) InAs/GaSb type-II superlattice (T2SL) photodetector, showing cut-off wavelength equal to 5μm at 90K. The proton irradiations were performed with 60 MeV protons and fluences up to 8x10 11 H + /cm² at cryogenic (100K) or room temperature (300K). The gamma irradiation, from a Cobalt-60 source, allows to reach a dose up to 50 krad(Si). We observed that degradation of the dark current under proton or gamma irradiations is strongly dependent on the temperature of the detector during irradiation but also on the protection layer used during the detector’s technological process.
- 17 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 70 (4) , 541-548
Irradiation Temperature Influence on the Degradation of the Electrical Performances of Midwave Infrared Type-II Superlattice Detectors
In this work, we present the influence of the irradiation temperature on electrical characterization of MidWave infrared (MWIR) InAs/GaSb type-II superlattice (T2SL) photodetector, showing cut-off wavelength equal to 5μm at 90K. The proton irradiations were performed with 60 MeV protons and fluences up to 8x10 11 H + /cm² at cryogenic (100K) or room temperature (300K). The gamma irradiation, from a Cobalt-60 source, allows to reach a dose up to 50 krad(Si). We observed that degradation of the dark current under proton or gamma irradiations is strongly dependent on the temperature of the detector during irradiation but also on the protection layer used during the detector’s technological process.
- Open Access
- 14 October 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (20) , 10358
Temperature Dependence Study of Electrical and Electro-Optical Performances of Midwave Infrared Ga-Free T2SL Barrier Photodetector
In this paper, we report on temperature dependence performances of a midwave infrared (MWIR) Ga-free InAs/InAsSb type-II superlattice (T2SL) barrier (XBn) photodetector grown by molecular beam epitaxy on n-type GaSb substrate. The T2SL structure, with a 3 µm thick active region, was processed in a mesa device in order to perform dark current measurements and spectral photoresponse as a function of temperature. Analyses of these temperature dependence characterizations help us to improve the design of Ga-free T2SL MWIR XBn detectors.
- 14 October 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (20) , 10358
Open AccessTemperature Dependence Study of Electrical and Electro-Optical Performances of Midwave Infrared Ga-Free T2SL Barrier Photodetector
In this paper, we report on temperature dependence performances of a midwave infrared (MWIR) Ga-free InAs/InAsSb type-II superlattice (T2SL) barrier (XBn) photodetector grown by molecular beam epitaxy on n-type GaSb substrate. The T2SL structure, with a 3 µm thick active region, was processed in a mesa device in order to perform dark current measurements and spectral photoresponse as a function of temperature. Analyses of these temperature dependence characterizations help us to improve the design of Ga-free T2SL MWIR XBn detectors.
- Open Access
Influence of Pixel Etching on Electrical and Electro-Optical Performances of a Ga-Free InAs/InAsSb T2SL Barrier Photodetector for Mid-Wave Infrared Imaging
In this paper, the influence of etching depth on the dark current and photo-response of a mid-wave infrared Ga-free T2SL XBn pixel detector is investigated. Two wet chemical etching depths have been considered for the fabrication of a non-passivated individual pixel detector having a cut-off wavelength of 5 µm at 150 K. This study shows the strong influence of the lateral diffusion length of a shallow-etched pixel on the electro-optical properties of the device. The lowest dark current density was recorded for the deep-etched detector, on the order of 1 × 10−5 A/cm2 at 150 K and a bias operation equal to −400 mV. The corresponding quantum efficiency was measured at 60% (without anti-reflection coating) for a 3 µm thick absorbing layer. A comparison of experimental results obtained on the two kinds of etched pixels demonstrates the need for a deep-etching process combined with efficient passivation for FPA manufacturing.
Open AccessInfluence of Pixel Etching on Electrical and Electro-Optical Performances of a Ga-Free InAs/InAsSb T2SL Barrier Photodetector for Mid-Wave Infrared Imaging
In this paper, the influence of etching depth on the dark current and photo-response of a mid-wave infrared Ga-free T2SL XBn pixel detector is investigated. Two wet chemical etching depths have been considered for the fabrication of a non-passivated individual pixel detector having a cut-off wavelength of 5 µm at 150 K. This study shows the strong influence of the lateral diffusion length of a shallow-etched pixel on the electro-optical properties of the device. The lowest dark current density was recorded for the deep-etched detector, on the order of 1 × 10−5 A/cm2 at 150 K and a bias operation equal to −400 mV. The corresponding quantum efficiency was measured at 60% (without anti-reflection coating) for a 3 µm thick absorbing layer. A comparison of experimental results obtained on the two kinds of etched pixels demonstrates the need for a deep-etching process combined with efficient passivation for FPA manufacturing.
- Open Access
Structural, Optical and Electrical Characterizations of Midwave Infrared Ga-Free Type-II InAs/InAsSb Superlattice Barrier Photodetector
In this paper, a full set of structural, optical and electrical characterizations performed on midwave infrared barrier detectors based on a Ga-free InAs/InAsSb type-II superlattice, grown by molecular beam epitaxy (MBE) on a GaSb substrate, are reported and analyzed. a Minority carrier lifetime value equal to 1 µs at 80 K, carried out on dedicated structure showing photoluminescence peak position at 4.9 µm, is extracted from a time resolved photoluminescence measurement. Dark current density as low as 3.2 × 10−5 A/cm2 at 150 K is reported on the corresponding device exhibiting a 50% cut-off wavelength around 5 µm. A performance analysis through normalized spectral response and dark current density-voltage characteristics was performed to determine both the operating bias and the different dark current regimes.
Open AccessStructural, Optical and Electrical Characterizations of Midwave Infrared Ga-Free Type-II InAs/InAsSb Superlattice Barrier Photodetector
In this paper, a full set of structural, optical and electrical characterizations performed on midwave infrared barrier detectors based on a Ga-free InAs/InAsSb type-II superlattice, grown by molecular beam epitaxy (MBE) on a GaSb substrate, are reported and analyzed. a Minority carrier lifetime value equal to 1 µs at 80 K, carried out on dedicated structure showing photoluminescence peak position at 4.9 µm, is extracted from a time resolved photoluminescence measurement. Dark current density as low as 3.2 × 10−5 A/cm2 at 150 K is reported on the corresponding device exhibiting a 50% cut-off wavelength around 5 µm. A performance analysis through normalized spectral response and dark current density-voltage characteristics was performed to determine both the operating bias and the different dark current regimes.