Heleen V. M. Kibbelaar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Heleen V. M. Kibbelaar has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
A. Deblais
Van der Waals-Zeeman Institute, Institute of Physics, University of Amsterdam, 1098 XH Amsterdam, The Netherlands
2 shared publicationsDaniel Bonn
2 shared publications- Daniel Bonn
Van der Waals-Zeeman Institute, University of Amsterdam, Science Park 904, 1098 XH Amsterdam, The Netherlands
2 shared publications Krassimir P. Velikov
2 shared publications- Krassimir Petkov Velikov
Unilever Innovation Centre Wageningen, Bronland 14, 6708 WH Wageningen, the Netherlands
2 shared publications A. Gaillard
Van der Waals-Zeeman Institute, Institute of Physics, University of Amsterdam, 1098 XH Amsterdam, The Netherlands
1 shared publication
Latest Publications
- 7 December 2023
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 8 (12) , 123301
Towards a constitutive relation for emulsions exhibiting a yield stress
Constitutive relations are needed to predict the behavior of complex fluids in nonviscometric flows. This is an area that is largely unexplored for yield stress materials because of the difficulty describing the elastoviscoplastic behavior for arbitrary flows. Here, we measure the shear and extensional rheology of a simple tunable yield stress system: emulsions with different oil volume fractions that allow one to vary the flow properties over a large range. We propose universal concentration scaling laws that produce master curves for the shear and extensional rheology with a minimal number of known emulsion parameters. The extensional viscosity is obtained experimentally using a theory for inelastic shear-thinning materials, demonstrating that elastic stresses are unimportant in the pinching dynamics, and the elastic normal stress differences contribute minimally to the von Mises yield surface. Hence, this shows that material elasticity is unimportant, and an explicit constitutive equation of, for example, Criminale-Ericksen-Filby type, with a Herschel-Bulkley viscosity and a modulus equal to the Laplace pressure is adequate to describe the behavior of such concentrated soft-sphere systems in general steady and low Deborah number unsteady Eulerian and Lagrangian flows.
- 7 December 2023
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 8 (12) , 123301
Towards a constitutive relation for emulsions exhibiting a yield stress
Constitutive relations are needed to predict the behavior of complex fluids in nonviscometric flows. This is an area that is largely unexplored for yield stress materials because of the difficulty describing the elastoviscoplastic behavior for arbitrary flows. Here, we measure the shear and extensional rheology of a simple tunable yield stress system: emulsions with different oil volume fractions that allow one to vary the flow properties over a large range. We propose universal concentration scaling laws that produce master curves for the shear and extensional rheology with a minimal number of known emulsion parameters. The extensional viscosity is obtained experimentally using a theory for inelastic shear-thinning materials, demonstrating that elastic stresses are unimportant in the pinching dynamics, and the elastic normal stress differences contribute minimally to the von Mises yield surface. Hence, this shows that material elasticity is unimportant, and an explicit constitutive equation of, for example, Criminale-Ericksen-Filby type, with a Herschel-Bulkley viscosity and a modulus equal to the Laplace pressure is adequate to describe the behavior of such concentrated soft-sphere systems in general steady and low Deborah number unsteady Eulerian and Lagrangian flows.
- Open Access
- 26 October 2022
- Published by Elsevier in Journal of Non-Newtonian Fluid Mechanics
- Vol. 310
Rheology of emulsions with polymer solutions as the continuous phase
- 26 October 2022
- Published by Elsevier in Journal of Non-Newtonian Fluid Mechanics
- Vol. 310
Open AccessRheology of emulsions with polymer solutions as the continuous phase
- Open Access
- 1 December 2021
- Published by Elsevier in Food Hydrocolloids
- Vol. 121
Comparing rheological, tribological and sensory properties of microfibrillated cellulose dispersions and xanthan gum solutions
- 1 December 2021
- Published by Elsevier in Food Hydrocolloids
- Vol. 121
Open AccessComparing rheological, tribological and sensory properties of microfibrillated cellulose dispersions and xanthan gum solutions
- Open Access
- 19 May 2021
- Published by Wiley in International Journal of Cosmetic Science
- Vol. 43 (4) , 458-465
Stringiness of hyaluronic acid emulsions
Objective: Cosmetic emulsions containing hyaluronic acid are ubiquitous in the cosmetic industry. However, the addition of (different molecular weight) hyaluronic acid can affect the filament stretching properties of concentrated emulsions. This property is often related to the “stringiness” of an emulsion, which can affect the consumer's choice for a product. It is thus very important to investigate and predict the effect of hyaluronic acid on the filament stretching properties of cosmetic emulsions.Methods: Model emulsions and emulsions with low and high molecular weights are prepared and their filament stretching properties are studied by the use of an extensional rheometer. Two different stretching speeds are employed during the stretching of the emulsions, a low speed at 10 µm/s and a high speed at 10 mm/s. The shear rheology of the samples is measured by rotational rheology.Results: We find that filament formation only occurs at high stretching speeds when the emulsion contains high molecular weight hyaluronic acid. The formation of this filament, which happens at intermediate states of the break‐up, coincides with an exponential decay in the break‐up dynamics. The beginning and end of the break‐up of high molecular weight hyaluronic acid emulsions show a power law behaviour, where the exponent depends on the initial stretching rate. At a lower stretching speed, no filament is observed for both high molecular weight and low molecular weight hyaluronic acid emulsions and the model emulsion. The emulsions show a power law behaviour over the whole break‐up range, where the exponent also depends on the stretching rate. No significant difference is observed between the shear flow properties of the emulsions containing different molecular weights hyaluronic acid.Conclusion: In this work, we underline the importance of the molecular weight of hyaluronic acid on the elongational properties of concentrated emulsions. The filament formation properties, for example the stringiness, of an emulsion is a key determinant of a product liking and repeat purchase. Here, we find that high molecular weight hyaluronic acid and a high stretching speed are the control parameters affecting the filament formation of an emulsion.
- 19 May 2021
- Published by Wiley in International Journal of Cosmetic Science
- Vol. 43 (4) , 458-465
Open AccessStringiness of hyaluronic acid emulsions
Objective: Cosmetic emulsions containing hyaluronic acid are ubiquitous in the cosmetic industry. However, the addition of (different molecular weight) hyaluronic acid can affect the filament stretching properties of concentrated emulsions. This property is often related to the “stringiness” of an emulsion, which can affect the consumer's choice for a product. It is thus very important to investigate and predict the effect of hyaluronic acid on the filament stretching properties of cosmetic emulsions.Methods: Model emulsions and emulsions with low and high molecular weights are prepared and their filament stretching properties are studied by the use of an extensional rheometer. Two different stretching speeds are employed during the stretching of the emulsions, a low speed at 10 µm/s and a high speed at 10 mm/s. The shear rheology of the samples is measured by rotational rheology.Results: We find that filament formation only occurs at high stretching speeds when the emulsion contains high molecular weight hyaluronic acid. The formation of this filament, which happens at intermediate states of the break‐up, coincides with an exponential decay in the break‐up dynamics. The beginning and end of the break‐up of high molecular weight hyaluronic acid emulsions show a power law behaviour, where the exponent depends on the initial stretching rate. At a lower stretching speed, no filament is observed for both high molecular weight and low molecular weight hyaluronic acid emulsions and the model emulsion. The emulsions show a power law behaviour over the whole break‐up range, where the exponent also depends on the stretching rate. No significant difference is observed between the shear flow properties of the emulsions containing different molecular weights hyaluronic acid.Conclusion: In this work, we underline the importance of the molecular weight of hyaluronic acid on the elongational properties of concentrated emulsions. The filament formation properties, for example the stringiness, of an emulsion is a key determinant of a product liking and repeat purchase. Here, we find that high molecular weight hyaluronic acid and a high stretching speed are the control parameters affecting the filament formation of an emulsion.
- 22 September 2020
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 5 (9) , 092001
Capillary thinning of elastic and viscoelastic threads: From elastocapillarity to phase separation
The formation and destabilization of viscoelastic filaments are of importance in many industrial and biological processes. Filament instabilities have been observed for viscoelastic fluids but recently also for soft elastic solids. In this work, we address the central question of how to connect the dynamical behavior of viscoelastic liquids to that of soft elastic solids. We take advantage of a biopolymer material whose viscoelastic properties can be tuned over a very large range by its pH, and study the destabilization and ensuing instabilities in uniaxial extensional deformation. In agreement with very recent theory, we find that the interface shapes dictated by the instabilities converge to an identical similarity solution for low-viscosity viscoelastic fluids and highly elastic gels. We thereby bridge the gap between very fluid and strongly elastic materials. In addition, we provide direct evidence that at late times an additional filament instability occurs due to a dynamical phase separation.
- 22 September 2020
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 5 (9) , 092001
Capillary thinning of elastic and viscoelastic threads: From elastocapillarity to phase separation
The formation and destabilization of viscoelastic filaments are of importance in many industrial and biological processes. Filament instabilities have been observed for viscoelastic fluids but recently also for soft elastic solids. In this work, we address the central question of how to connect the dynamical behavior of viscoelastic liquids to that of soft elastic solids. We take advantage of a biopolymer material whose viscoelastic properties can be tuned over a very large range by its pH, and study the destabilization and ensuing instabilities in uniaxial extensional deformation. In agreement with very recent theory, we find that the interface shapes dictated by the instabilities converge to an identical similarity solution for low-viscosity viscoelastic fluids and highly elastic gels. We thereby bridge the gap between very fluid and strongly elastic materials. In addition, we provide direct evidence that at late times an additional filament instability occurs due to a dynamical phase separation.
- Open Access
- 5 February 2018
- Published by Wiley in Chemnanomat
- Vol. 4 (3) , 301-308
Size and Optically Tunable Ethyl Cellulose Nanoparticles as Carriers for Organic UV Filters
Optically active nanoparticles (NPs) are potential building blocks for bottom‐up functional technology in applications such as displays, sensors, and sunscreens. For sunscreens in particular, NPs can be used as delivery systems for organic UV filters in order to minimise skin exposure to these molecules. Here, we investigate the synthesis of size‐tunable ethyl cellulose NPs (ECNPs) and their application as carriers for multiple organic UV filters. We prepared ECNPs with sizes of 50 to 165 nm via an antisolvent precipitation technique and investigate the incorporation of three commonplace organic UV filters – oxybenzone, avobenzone, and octinoxate – into the ECNPs. We found the particle loading varied greatly with each UV filter. Photodegradation of the UV filters remained unchanged upon incorporation into ECNPs and was not affected by co‐encapsulating the antioxidant α‐tocopherol. These results can significantly advance the development of environmentally friendly functionalized nanoparticles and UV‐protective coatings.
- 5 February 2018
- Published by Wiley in Chemnanomat
- Vol. 4 (3) , 301-308
Open AccessSize and Optically Tunable Ethyl Cellulose Nanoparticles as Carriers for Organic UV Filters
Optically active nanoparticles (NPs) are potential building blocks for bottom‐up functional technology in applications such as displays, sensors, and sunscreens. For sunscreens in particular, NPs can be used as delivery systems for organic UV filters in order to minimise skin exposure to these molecules. Here, we investigate the synthesis of size‐tunable ethyl cellulose NPs (ECNPs) and their application as carriers for multiple organic UV filters. We prepared ECNPs with sizes of 50 to 165 nm via an antisolvent precipitation technique and investigate the incorporation of three commonplace organic UV filters – oxybenzone, avobenzone, and octinoxate – into the ECNPs. We found the particle loading varied greatly with each UV filter. Photodegradation of the UV filters remained unchanged upon incorporation into ECNPs and was not affected by co‐encapsulating the antioxidant α‐tocopherol. These results can significantly advance the development of environmentally friendly functionalized nanoparticles and UV‐protective coatings.