Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ali Saud has a total of 6 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Environmental Performance of Nitrogen Recovery from Reject Water of Sewage Sludge Treatment Based on Life Cycle Assessment

    by Ali Saud, Jouni Havukainen, Petteri Peltola, Mika Horttanainen

    Recovering and recycling nitrogen available in waste streams would reduce the demand for conventional fossil-based fertilizers and contribute toward food security. Based on life cycle assessment (LCA), this study aimed to evaluate the environmental performance of nitrogen recovery for fertilizer purposes from sewage sludge treatment in a municipal wastewater treatment plant (WWTP). Utilizing either air stripping or pyrolysis-derived biochar adsorbent, nitrogen was recovered from ammonium-rich reject streams generated during mechanical dewatering and thermal drying of anaerobically digested sewage sludge. A wide range of results was obtained between different scenarios and different impact categories. Biochar-based nitrogen recovery showed the lowest global warming potential with net negative GHG (greenhouse gas) emissions of −22.5 kt CO2,eq/FU (functional unit). Ammonia capture through air stripping caused a total GHG emission of 2 kt CO2,eq/FU; while in the base case scenario without nitrogen recovery, a slightly lower GHG emission of 0.2 kt CO2,eq/FU was obtained. This study contributes an analysis promoting the multifunctional nature of wastewater systems with integrated resource recovery for potential environmental and health benefits.


  • Open Access

    Integrating Pyrolysis or Combustion with Scrubbing to Maximize the Nutrient and Energy Recovery from Municipal Sewage Sludge

    by Ali Saud, Jouni Havukainen, Petteri Peltola, Mika Horttanainen

    Based on mass and energy balance calculations, this work investigates the possibility of recovering heat and nutrients (nitrogen and phosphorus) from municipal sewage sludge using pyrolysis or combustion in combination with a gas scrubbing technology. Considering a wastewater treatment plant (WWTP) with 65,000 t/a of mechanically dewatered digestate (29% total solids), 550 t/a nitrogen and 500 t/a phosphorus were recovered from the 4900 t/a total nitrogen and 600 t/a total phosphorus that entered the WWTP. Overall, 3600 t/a (73%) of total nitrogen was lost to the air (as N2) and clean water, while 90 t/a (15%) of total phosphorus was lost to clean water released by the WWTP. Both in combustion and in pyrolysis, the nitrogen (3%) released within thermal drying fumes was recovered through condensate stripping and subsequent gas scrubbing, and together with the recovery of nitrogen from WWTP reject water, a total of 3500 t/a of ammonium sulfate fertilizer can be produced. Furthermore, 120 GWh/a of district heat and 9700 t/a of ash with 500 t/a phosphorus were obtained in the combustion scenario and 12,000 t/a of biochar with 500 t/a phosphorus was obtained in the pyrolysis scenario. The addition of a stripper and a scrubber for nitrogen recovery increases the total electricity consumption in both scenarios. According to an approximate cost estimation, combustion and pyrolysis require annual investment costs of 2–4 M EUR/a and 2–3 M EUR/a, respectively, while 3–5 M EUR/a and 3–3.5 M EUR/a will be generated as revenues from the products.


  • Open Access

    Evaluation and techno-economic analysis of packed bed scrubber for ammonia recovery from drying fumes produced during the thermal drying of sewage sludge

    by Ali Saud, Jouni Havukainen, Mika Mänttäri, Mika Horttanainen

    This study investigates the recovery of ammonia from drying fumes during thermal drying of sewage sludge with packed bed acid scrubbers to recover ammonia and to produce ammonium sulfate. The process is modelled for two concentrations, 75 and 100 ppm, and 1000m3/h inlet flowrate of drying fumes containing air and ammonia gas. It results in finding optimal parameters for scale-up of drying fumes during thermal drying of 7700t/a sewage sludge of Lappeenranta city. It is found that a single scrubber, with a 24000 m3/h of inlet gas and an ammonia concentration of 75 ppm, liquid to gas ratio of 1.5, temperature and pH of liquid acid as 100°C and 3 respectively, gives the efficiency of more than 99%, and reduces ammonia concentration in the outlet stream to 0.2 ppm. The capital cost is 290 k€, operating cost is 113k€/a, removal cost with and without revenue of ammonium sulfate is 20 €/t and 18 €/t of sludge. The packed bed acid scrubber would be suitable to remove ammonia in the drying fumes to recover ammonia from the drying fumes, but the initial economic analysis highlights that the production of commercial grade ammonium sulfate fertilizer would be an expensive option.