Hongtao Fu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hongtao Fu has a total of 89 co-authors. Here are the top co-authors by number of shared publications:
- Jun Wang
Wenzhou University
11 shared publications Jun Wang
College of Architecture and Civil Engineering, Wenzhou University, Wenzhou, China
6 shared publications- Junfeng Ni
College of Civil Engineering and Architecture, Wenzhou University, Wenzhou, China
6 shared publications Xiuqing Hu
College of Architecture and Civil Engineering, Wenzhou University, Wenzhou, Zhejiang, China
6 shared publicationsYuanqiang Cai
Zhejiang University of Technology, Hangzhou, China
6 shared publicationsYing Cai
College of Architecture and Civil Engineering, Wenzhou University, Wenzhou, China
4 shared publications
Latest Publications
- 6 April 2026
- Published by Emerald Publishing in Geosynthetics International
- Vol. 33 (6) , 931-941
Reinforcement and microseismic monitoring of slopes with a self-sensing smart geosynthetic
Conventional geosynthetics have been extensively employed in slope reinforcement, yet they primarily offer mechanical stabilization without the capability to monitor internal damage within reinforced soil, thereby limiting post-seismic stability assessment. This study employed a sensor-enabled piezoelectric geobelt (SPGB) with dual monitoring and reinforcement functions as a geogrid for soil slope stabilization. By collecting SPGB voltage vibration signals through shake table tests, dynamic slip plane localization and slope stability assessment were achieved. Test results indicate that the peak ground acceleration (PGA) amplification factors at heights of 400 mm and 600 mm for reinforced slopes are significantly lower than those of unreinforced natural soil slopes. At 0.5 g, unreinforced slopes exhibited amplification factors 46.09% and 31.79% higher than those of reinforced slopes, respectively. These findings confirm that the SPGB reinforcement structure significantly suppresses acceleration amplification effects, enhancing the slope’s seismic performance. When SPGBs in high-risk zones experience unstable stress states due to soil disturbance, their voltage signal amplitudes increase dramatically, with both RMS voltage and real-time voltage exceeding 100 mV. This behavior demonstrates that SPGBs enable real-time monitoring of dynamic responses within slopes and serve as effective indicators for assessing soil stability.
- 6 April 2026
- Published by Emerald Publishing in Geosynthetics International
- Vol. 33 (6) , 931-941
Reinforcement and microseismic monitoring of slopes with a self-sensing smart geosynthetic
Conventional geosynthetics have been extensively employed in slope reinforcement, yet they primarily offer mechanical stabilization without the capability to monitor internal damage within reinforced soil, thereby limiting post-seismic stability assessment. This study employed a sensor-enabled piezoelectric geobelt (SPGB) with dual monitoring and reinforcement functions as a geogrid for soil slope stabilization. By collecting SPGB voltage vibration signals through shake table tests, dynamic slip plane localization and slope stability assessment were achieved. Test results indicate that the peak ground acceleration (PGA) amplification factors at heights of 400 mm and 600 mm for reinforced slopes are significantly lower than those of unreinforced natural soil slopes. At 0.5 g, unreinforced slopes exhibited amplification factors 46.09% and 31.79% higher than those of reinforced slopes, respectively. These findings confirm that the SPGB reinforcement structure significantly suppresses acceleration amplification effects, enhancing the slope’s seismic performance. When SPGBs in high-risk zones experience unstable stress states due to soil disturbance, their voltage signal amplitudes increase dramatically, with both RMS voltage and real-time voltage exceeding 100 mV. This behavior demonstrates that SPGBs enable real-time monitoring of dynamic responses within slopes and serve as effective indicators for assessing soil stability.
- 1 December 2025
- Published by Springer Nature in Acta Geotechnica
- Vol. 21 (5) , 2747-2759
Experimental study of horizontal displacement monitoring based on a distributed piezoelectric inclinometer tube
- 1 December 2025
- Published by Springer Nature in Acta Geotechnica
- Vol. 21 (5) , 2747-2759
Experimental study of horizontal displacement monitoring based on a distributed piezoelectric inclinometer tube
- 11 November 2025
- Published by Springer Nature in Acta Geotechnica
- Vol. 21 (5) , 2543-2557
Typical engineering properties of ultra-soft soils and their differences with soft soils
- 11 November 2025
- Published by Springer Nature in Acta Geotechnica
- Vol. 21 (5) , 2543-2557
Typical engineering properties of ultra-soft soils and their differences with soft soils
- 19 March 2025
- Published by Springer Nature in Acta Geotechnica
- Vol. 20 (7) , 3633-3643
Deformation signal response of sensor-enabled piezoelectric geobelt considering the coupling effect of temperature and deformation
- 19 March 2025
- Published by Springer Nature in Acta Geotechnica
- Vol. 20 (7) , 3633-3643
Deformation signal response of sensor-enabled piezoelectric geobelt considering the coupling effect of temperature and deformation
- 9 January 2025
- Published by Springer Nature in Acta Geotechnica
- Vol. 20 (5) , 2483-2496
Evaluation of the effectiveness of monitoring the axial force of anchors based on sensor-enabled piezoelectric geocable (SPGC)
- 9 January 2025
- Published by Springer Nature in Acta Geotechnica
- Vol. 20 (5) , 2483-2496
Evaluation of the effectiveness of monitoring the axial force of anchors based on sensor-enabled piezoelectric geocable (SPGC)
- Open Access
Study on the Effect of Sodium Silicate Solution Injection Timings on Electrochemical Reinforcement of Dredged Sludge
To address the issue of uneven shear strength distribution in dredged sediment during electroosmosis treatment, a grouting system was employed to inject CaCl2 into the anode region and Na2SiO3 solution into the central region. An experimental study was conducted to examine the effect of injection timing on the electrochemical treatment of dredged sediment. Five experimental groups, each with different Na2SiO3 injection timings, were established. The impact of injection timing on the macroscopic electrochemical reinforcement was assessed based on current, drainage volume, settlement, moisture content, and shear strength. Additionally, the ion concentration of effluent from the cathode was measured, and scanning electron microscopy (SEM) and mercury intrusion porosimetry (MIP) were employed to analyze ion migration and pore characteristics. The results indicated that when CaCl2 was injected into the anode at the start of the experiment and Na2SiO3 was injected into the central region after the current had decayed by 70% from its peak, the drainage volume reached its maximum. Under these conditions, the average shear strength increased from nearly 0 kPa to 48.2 kPa, yielding the optimal reinforcement effect. The strength in both the central and cathode regions also improved, and the strength distribution between the anode and cathode became more uniform, with the strength ratio decreasing from 1.91 to 1.65, thereby enhancing the overall soil strength distribution. The Na+ concentration in the cathode effluent was highest, suggesting that Na+ migration played a predominant role in electroosmotic drainage. Furthermore, the electrochemical reactions generated cementitious materials that effectively filled the soil pores. SEM imaging and MIP pore size analysis revealed a reduction in porosity and an increase in soil compaction.
Open AccessStudy on the Effect of Sodium Silicate Solution Injection Timings on Electrochemical Reinforcement of Dredged Sludge
To address the issue of uneven shear strength distribution in dredged sediment during electroosmosis treatment, a grouting system was employed to inject CaCl2 into the anode region and Na2SiO3 solution into the central region. An experimental study was conducted to examine the effect of injection timing on the electrochemical treatment of dredged sediment. Five experimental groups, each with different Na2SiO3 injection timings, were established. The impact of injection timing on the macroscopic electrochemical reinforcement was assessed based on current, drainage volume, settlement, moisture content, and shear strength. Additionally, the ion concentration of effluent from the cathode was measured, and scanning electron microscopy (SEM) and mercury intrusion porosimetry (MIP) were employed to analyze ion migration and pore characteristics. The results indicated that when CaCl2 was injected into the anode at the start of the experiment and Na2SiO3 was injected into the central region after the current had decayed by 70% from its peak, the drainage volume reached its maximum. Under these conditions, the average shear strength increased from nearly 0 kPa to 48.2 kPa, yielding the optimal reinforcement effect. The strength in both the central and cathode regions also improved, and the strength distribution between the anode and cathode became more uniform, with the strength ratio decreasing from 1.91 to 1.65, thereby enhancing the overall soil strength distribution. The Na+ concentration in the cathode effluent was highest, suggesting that Na+ migration played a predominant role in electroosmotic drainage. Furthermore, the electrochemical reactions generated cementitious materials that effectively filled the soil pores. SEM imaging and MIP pore size analysis revealed a reduction in porosity and an increase in soil compaction.
- Open Access
Evaluation of Heating Time on Vacuum Preloading Treatment
A comparative study of the effect of a vacuum preloading combined intermittent heating method and conventional vacuum preloading treatment was designed and carried out through indoor model tests to investigate the optimal intermittent heating time. It is concluded that the mechanism of vacuum preloading combined with the intermittent heating method is to improve the permeability of soil to alleviate the clogging effect, and therefore has a treatment effect far beyond the conventional vacuum preloading method. The results also show that setting a heating time of 120 min and a stopping time of 60 min can obtain the best consolidation effect.
Open AccessEvaluation of Heating Time on Vacuum Preloading Treatment
A comparative study of the effect of a vacuum preloading combined intermittent heating method and conventional vacuum preloading treatment was designed and carried out through indoor model tests to investigate the optimal intermittent heating time. It is concluded that the mechanism of vacuum preloading combined with the intermittent heating method is to improve the permeability of soil to alleviate the clogging effect, and therefore has a treatment effect far beyond the conventional vacuum preloading method. The results also show that setting a heating time of 120 min and a stopping time of 60 min can obtain the best consolidation effect.
- 30 October 2023
- Published by Springer Nature in Acta Geotechnica
- Vol. 19 (5) , 2487-2497
Experimental analysis of a staged vacuum preloading method with PHD-PVD for waste slurry treatment
- 30 October 2023
- Published by Springer Nature in Acta Geotechnica
- Vol. 19 (5) , 2487-2497
Experimental analysis of a staged vacuum preloading method with PHD-PVD for waste slurry treatment
- 11 October 2023
- Published by Taylor & Francis in Marine Georesources & Geotechnology
- Vol. 42 (9) , 1177-1187
Influence of DOC of vacuum preloading on dynamic consolidation for dredged slurry
- 11 October 2023
- Published by Taylor & Francis in Marine Georesources & Geotechnology
- Vol. 42 (9) , 1177-1187
Influence of DOC of vacuum preloading on dynamic consolidation for dredged slurry