Heinz R. Hoenecke
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Heinz R. Hoenecke has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Darryl D. D'LIma
Scripps Health, Shiley Center for Orthopaedic Research and Education at Scripps Clinic, 10666 North Torrey Pines Road, La Jolla, CA 92037, USA
4 shared publications Jan Fronek
Scripps Clinic La Jolla California U.S.A.
2 shared publicationsLisa M. Tibor
2 shared publications- Shantanu Patil
SRM Institute of Science and Technology SRM Innovation, Incubation, and Entrepreneurship Center, Kattankulathur-603203, Chengalpattu District, Tamil Nadu, India., Chennai, Chennai, --- Select One ---, 603203, INDIA
2 shared publications Cesar Flores-Hernandez
1 shared publicationDavid W. Elias
1 shared publication
Latest Publications
- 1 October 2012
- Published by Elsevier in Journal of Shoulder and Elbow Surgery
- Vol. 21 (10) , 1377-1383
A quantitative three-dimensional templating method for shoulder arthroplasty: biomechanical validation in cadavers
- 1 October 2012
- Published by Elsevier in Journal of Shoulder and Elbow Surgery
- Vol. 21 (10) , 1377-1383
A quantitative three-dimensional templating method for shoulder arthroplasty: biomechanical validation in cadavers
- 1 September 2012
- Published by Elsevier in Journal of Shoulder and Elbow Surgery
- Vol. 21 (9) , 1136-1141
Glenoid morphology rather than version predicts humeral subluxation: a different perspective on the glenoid in total shoulder arthroplasty
- 1 September 2012
- Published by Elsevier in Journal of Shoulder and Elbow Surgery
- Vol. 21 (9) , 1136-1141
Glenoid morphology rather than version predicts humeral subluxation: a different perspective on the glenoid in total shoulder arthroplasty
- 31 August 2008
- Published by Elsevier in Journal of Shoulder and Elbow Surgery
- Vol. 17 (4) , 637-641
Optimizing glenoid component position using three-dimensional computed tomography reconstruction
- 31 August 2008
- Published by Elsevier in Journal of Shoulder and Elbow Surgery
- Vol. 17 (4) , 637-641
Optimizing glenoid component position using three-dimensional computed tomography reconstruction
- 19 May 2008
- Published by SAGE Publications in The American Journal of Sports Medicine
- Vol. 36 (9) , 1726-1732
Effect of Osteochondral Graft Insertion Forces on Chondrocyte Viability
Because chondrocytes are responsible for articular cartilage matrix synthesis and maintenance, reduced chondrocyte viability could compromise graft survival, healing, and clinical outcome. Typical forces used in osteochondral grafting reduce the viability of the chondrocytes in the graft. Study Design: Controlled laboratory study. Osteochondral grafting was performed in 4 fresh-frozen cadaver knees (n = 16 per knee). Impact force was measured during extrusion of the donor graft from the harvester into the recipient site, seating the graft flush with the articular surface of the surrounding cartilage using a tamp, and recessing the graft surface below the recipient articular surface. The magnitudes of forces measured during cadaver surgery (200,400, and 800 N) were reproduced using a drop-tower apparatus on 80 fresh osteochondral grafts harvested from knee blocks provided by tissue banks. Cell viability and glycosaminoglycan release in media were measured at 48 hours after injury. Forces were relatively low (range, 124-356 N) during graft extrusion from the harvester into the recipient defect or during flush seating (range, 191-418 N) of the graft. Attempts to recess the graft generated significantly greater force (range, 147-685- P < .01). When the donor graft length was 2 mm longer than the depth of the recipient hole, the mean impact force generated was even higher (range, 240-1114 N) than the force seen in a donor graft of equal length. No reduction in viability was seen at 200-N and 400-N impacts. However, a significant decrease in chondrocyte viability was seen in the group impacted with 800 N (only 50% of cells were viable, compared with 91 % in the sham group; P < .01). Glycosaminoglycan levels in culture media did not correlate significantly with insertion force. Typical graft insertion forces did not significantly reduce chondrocyte viability. However, increased graft length relative to the depth of the recipient hole and attempts to recess the graft generated higher forces, which reduced chondrocyte viability. Any theoretical benefits of cancellous bone compaction that may occur in grafts that are recessed or are longer than the recipient holes must be balanced against the potential reduction in chondrocyte viability.
- 19 May 2008
- Published by SAGE Publications in The American Journal of Sports Medicine
- Vol. 36 (9) , 1726-1732
Effect of Osteochondral Graft Insertion Forces on Chondrocyte Viability
Because chondrocytes are responsible for articular cartilage matrix synthesis and maintenance, reduced chondrocyte viability could compromise graft survival, healing, and clinical outcome. Typical forces used in osteochondral grafting reduce the viability of the chondrocytes in the graft. Study Design: Controlled laboratory study. Osteochondral grafting was performed in 4 fresh-frozen cadaver knees (n = 16 per knee). Impact force was measured during extrusion of the donor graft from the harvester into the recipient site, seating the graft flush with the articular surface of the surrounding cartilage using a tamp, and recessing the graft surface below the recipient articular surface. The magnitudes of forces measured during cadaver surgery (200,400, and 800 N) were reproduced using a drop-tower apparatus on 80 fresh osteochondral grafts harvested from knee blocks provided by tissue banks. Cell viability and glycosaminoglycan release in media were measured at 48 hours after injury. Forces were relatively low (range, 124-356 N) during graft extrusion from the harvester into the recipient defect or during flush seating (range, 191-418 N) of the graft. Attempts to recess the graft generated significantly greater force (range, 147-685- P < .01). When the donor graft length was 2 mm longer than the depth of the recipient hole, the mean impact force generated was even higher (range, 240-1114 N) than the force seen in a donor graft of equal length. No reduction in viability was seen at 200-N and 400-N impacts. However, a significant decrease in chondrocyte viability was seen in the group impacted with 800 N (only 50% of cells were viable, compared with 91 % in the sham group; P < .01). Glycosaminoglycan levels in culture media did not correlate significantly with insertion force. Typical graft insertion forces did not significantly reduce chondrocyte viability. However, increased graft length relative to the depth of the recipient hole and attempts to recess the graft generated higher forces, which reduced chondrocyte viability. Any theoretical benefits of cancellous bone compaction that may occur in grafts that are recessed or are longer than the recipient holes must be balanced against the potential reduction in chondrocyte viability.
- 1 February 2006
- Published by Wiley in Arthroscopy
- Vol. 22 (2) , 232.e1-232.e3
The Posterior‐Medial Portal
Repair of the posterior superior labrum usually involves placing an anchor posterior to the biceps attachment through an anterior‐superior or Wilmington portal. Access to the posterior‐superior labrum can be accomplished by establishing a portal medial to the posterior viewing portal. The initial posterior arthroscopic viewing portal is established slightly lateral to a traditional position to allow viewing of the posterior labrum and maintain separation from the posterior‐medial portal. The suture anchor can be placed behind the biceps attachment through an anterior portal. The posterior‐medial portal is started approximately 3 cm medial to the viewing portal with an 18‐gauge needle. The needle is directed anterolateral into the intra‐articular space under arthroscopic visualization to determine the appropriate course of the suture retriever. The needle is replaced with a sharp suture retrieval device. The suture from the anchor is pulled through the labrum to achieve a simple or mattress type repair. The suture is retrieved through the anterior‐superior portal by finding it medial to the labrum. The sutures can be tied through the anterior‐superior portal. The posterior‐medial portal can be safely established with attention to technical considerations.
- 1 February 2006
- Published by Wiley in Arthroscopy
- Vol. 22 (2) , 232.e1-232.e3
The Posterior‐Medial Portal
Repair of the posterior superior labrum usually involves placing an anchor posterior to the biceps attachment through an anterior‐superior or Wilmington portal. Access to the posterior‐superior labrum can be accomplished by establishing a portal medial to the posterior viewing portal. The initial posterior arthroscopic viewing portal is established slightly lateral to a traditional position to allow viewing of the posterior labrum and maintain separation from the posterior‐medial portal. The suture anchor can be placed behind the biceps attachment through an anterior portal. The posterior‐medial portal is started approximately 3 cm medial to the viewing portal with an 18‐gauge needle. The needle is directed anterolateral into the intra‐articular space under arthroscopic visualization to determine the appropriate course of the suture retriever. The needle is replaced with a sharp suture retrieval device. The suture from the anchor is pulled through the labrum to achieve a simple or mattress type repair. The suture is retrieved through the anterior‐superior portal by finding it medial to the labrum. The sutures can be tied through the anterior‐superior portal. The posterior‐medial portal can be safely established with attention to technical considerations.
- 1 July 2004
- Published by Wiley in Arthroscopy
- Vol. 20 (S2) , 113-115
The modified beachchair position for arthroscopic shoulder surgery: The La Jolla beachchair
Arthroscopic surgery of the shoulder is usually performed in the lateral decubitus or beachchair position. The modified beachchair position described here allows arthroscopic procedures to be performed as in the lateral position yet maintains a semiupright orientation and permits conversion to open procedures as in the beachchair position. The results of this technique are reported for 50 consecutive patients with a variety of diagnoses. This modified beachchair position was found to be quickly and easily accomplished with a minimum of special equipment.
- 1 July 2004
- Published by Wiley in Arthroscopy
- Vol. 20 (S2) , 113-115
The modified beachchair position for arthroscopic shoulder surgery: The La Jolla beachchair
Arthroscopic surgery of the shoulder is usually performed in the lateral decubitus or beachchair position. The modified beachchair position described here allows arthroscopic procedures to be performed as in the lateral position yet maintains a semiupright orientation and permits conversion to open procedures as in the beachchair position. The results of this technique are reported for 50 consecutive patients with a variety of diagnoses. This modified beachchair position was found to be quickly and easily accomplished with a minimum of special equipment.