Jingying Chen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Jingying Chen has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
Bart Reuvers
2 shared publicationsCor Koning
2 shared publications- Francesco Picchioni
Department of Chemical Product Engineering, Engineering and Technology Institute Groningen (ENTEG), University of Groningen, Nijenborgh 4, 9747AG Groningen, The Netherlands
2 shared publications Jing Wu
2 shared publications- Patrizio Raffa
Smart and Sustainable Polymeric Products, Engineering and Technology Institute Groningen, University of Groningen, Nijenborgh 4, 9747 AG, The Netherlands
2 shared publications Theo Veldhuis
2 shared publications
Latest Publications
- Open Access
- 25 October 2025
- Published by Elsevier in European Polymer Journal
- Vol. 240
Optimizing biodegradable SAPs: A Systematic study of monovalent counterion effects on citrate-based networks
- 25 October 2025
- Published by Elsevier in European Polymer Journal
- Vol. 240
Open AccessOptimizing biodegradable SAPs: A Systematic study of monovalent counterion effects on citrate-based networks
- Open Access
- 20 August 2025
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 7 (17) , 11105-11116
Fully Biobased, Biodegradable Superabsorbent Polymers Based on Citric Acid and Sorbitol
- 20 August 2025
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 7 (17) , 11105-11116
Open AccessFully Biobased, Biodegradable Superabsorbent Polymers Based on Citric Acid and Sorbitol
- 17 October 2022
- Published by Wiley in Chemistry & Biodiversity
- Vol. 19 (11) , e202200117
Red Phosphorus/P25 Nanophotosensitizers Coated with Platelet Membrane for Enhancing Cancer Cells Photodynamic Therapy
Photodynamic therapy (PDT), which uses targeted photosensitizing drugs, has been regarded as a promising method for cancer therapy. In the present study, photosensitizer red phosphorus modified P25 nanophotosensitizers (P25‐RP) were generated, which were coated with platelet membrane (P25‐RP@PLT) extracted from platelet rich plasma. The biocompatibility of P25‐RP was demonstrated by cell counting kit‐8 (CCK‐8) and optical microscope assay, more than 93 % cells in the concentration of 100 μg/ml of P25‐RP suspension after co‐incubation for 24 h were still kept alive. The antitumor performance of P25‐RP@PLT was evaluated via CCK‐8 assay, flow cytometry and fluorescence staining of live/dead cells. The experiment results showed that P25‐RP@PLT could ablate 55 % malignant tumor cells upon laser irradiation within 5 min, which was 10 % higher than P25‐RP alone against cancer cells. Mechanistically, the cancer cell toxicity of P25‐RP@PLT nanophotosensitizers was attributed to its heterojunction structure that broadens the absorption spectra, whereas PLT membrane coating technology allows for immune escape and selective adhesion capacity to cancer cells. This work provided a novel pathway on the design of novel visible‐light‐driven photosensitizer for cancer therapy.
- 17 October 2022
- Published by Wiley in Chemistry & Biodiversity
- Vol. 19 (11) , e202200117
Red Phosphorus/P25 Nanophotosensitizers Coated with Platelet Membrane for Enhancing Cancer Cells Photodynamic Therapy
Photodynamic therapy (PDT), which uses targeted photosensitizing drugs, has been regarded as a promising method for cancer therapy. In the present study, photosensitizer red phosphorus modified P25 nanophotosensitizers (P25‐RP) were generated, which were coated with platelet membrane (P25‐RP@PLT) extracted from platelet rich plasma. The biocompatibility of P25‐RP was demonstrated by cell counting kit‐8 (CCK‐8) and optical microscope assay, more than 93 % cells in the concentration of 100 μg/ml of P25‐RP suspension after co‐incubation for 24 h were still kept alive. The antitumor performance of P25‐RP@PLT was evaluated via CCK‐8 assay, flow cytometry and fluorescence staining of live/dead cells. The experiment results showed that P25‐RP@PLT could ablate 55 % malignant tumor cells upon laser irradiation within 5 min, which was 10 % higher than P25‐RP alone against cancer cells. Mechanistically, the cancer cell toxicity of P25‐RP@PLT nanophotosensitizers was attributed to its heterojunction structure that broadens the absorption spectra, whereas PLT membrane coating technology allows for immune escape and selective adhesion capacity to cancer cells. This work provided a novel pathway on the design of novel visible‐light‐driven photosensitizer for cancer therapy.
- 11 August 2022
- Published by Taylor & Francis in Environmental Technology
- Vol. 45 (2) , 315-328
Study on interface thermodynamic mechanism of membrane fouling in flat sheet ceramic membrane treating oilfield produced water
In this study, a flat sheet ceramic membrane experimental device was constructed, and the thermodynamics of membrane fouling interface was studied for oilfield produced water. The flux of ceramic membrane in three kinds of model solutions were measured with time, as well as the surface tension, contact Angle and Zeta potential of solid. The thermodynamic mechanism of membrane fouling interface combined with XDLVO theory were explored for three kinds of model solutions. The thermodynamic study of the interface of ceramic plate membrane shows that the total interaction energy between membrane and oil droplets decreases with the increase of the distance between two interfaces at initial stage of membrane fouling, and finally transforms from the mutual attraction to the mutual repulsion. The total interaction energy between reservoir and oil droplet is shown as mutual attraction, and the total interaction energy decreases with the increase of the distance between reservoir and oil droplet interface. The zeta potential of crude oil was affected by salinity to some extent. The electrostatic shielding effect of the salt ions leads to a decrease in the ζ-potential of the three solutions. They are in the order: model solution A > model solution B > model solution C. This leads to a decrease in the electrostatic interaction (EL). And since the oil layer has the same composition as the oil droplets, the EL interactions in the three solutions can behave as mutual repulsion. GRAPHICAL ABSTRACT
- 11 August 2022
- Published by Taylor & Francis in Environmental Technology
- Vol. 45 (2) , 315-328
Study on interface thermodynamic mechanism of membrane fouling in flat sheet ceramic membrane treating oilfield produced water
In this study, a flat sheet ceramic membrane experimental device was constructed, and the thermodynamics of membrane fouling interface was studied for oilfield produced water. The flux of ceramic membrane in three kinds of model solutions were measured with time, as well as the surface tension, contact Angle and Zeta potential of solid. The thermodynamic mechanism of membrane fouling interface combined with XDLVO theory were explored for three kinds of model solutions. The thermodynamic study of the interface of ceramic plate membrane shows that the total interaction energy between membrane and oil droplets decreases with the increase of the distance between two interfaces at initial stage of membrane fouling, and finally transforms from the mutual attraction to the mutual repulsion. The total interaction energy between reservoir and oil droplet is shown as mutual attraction, and the total interaction energy decreases with the increase of the distance between reservoir and oil droplet interface. The zeta potential of crude oil was affected by salinity to some extent. The electrostatic shielding effect of the salt ions leads to a decrease in the ζ-potential of the three solutions. They are in the order: model solution A > model solution B > model solution C. This leads to a decrease in the electrostatic interaction (EL). And since the oil layer has the same composition as the oil droplets, the EL interactions in the three solutions can behave as mutual repulsion. GRAPHICAL ABSTRACT
- 11 September 2020
- Published by Wiley in Polymer International
- Vol. 70 (5) , 536-545
Low‐crystallinity to highly amorphous copolyesters with high glass transition temperatures based on rigid carbohydrate‐derived building blocks
The current trend of developing novel biobased polymeric materials is focused more on utilizing the unique structural/physical properties of renewable building blocks towards niche market applications. In this work, with the aim of developing low‐crystallinity to amorphous polyesters with enhanced thermal properties, a series of copolyesters based on rigid and structurally asymmetric carbohydrate‐derived building blocks, namely furan‐2,5‐dicarboxylic acid and isosorbide, and 1,4‐butanediol were successfully synthesized using melt polycondensation. The copolyesters were obtained with varied chemical compositions and rather high molecular weights ( M n = 24 000–31 000 g mol −1 ) and intrinsic viscosities ([ η ] = 0.56–0.72 dL g −1 ). Incorporation of both building blocks significantly enhances the glass transition temperatures ( T g = 38–107 °C) of polyesters, and also efficiently inhibits the crystallization of the copolyesters. A low content of isosorbide ( ca 10 mol%) leads to complete transition of the homopolyester to nearly fully amorphous materials. Detailed characterizations of the chemical structures and thermal properties of the synthesized copolyesters were conducted using various analytical techniques. In addition, hydrolytic and enzymatic degradations of the copolymers in the presence of porcine pancreatic lipase and cutinase were also investigated. © 2020 Society of Industrial Chemistry
- 11 September 2020
- Published by Wiley in Polymer International
- Vol. 70 (5) , 536-545
Low‐crystallinity to highly amorphous copolyesters with high glass transition temperatures based on rigid carbohydrate‐derived building blocks
The current trend of developing novel biobased polymeric materials is focused more on utilizing the unique structural/physical properties of renewable building blocks towards niche market applications. In this work, with the aim of developing low‐crystallinity to amorphous polyesters with enhanced thermal properties, a series of copolyesters based on rigid and structurally asymmetric carbohydrate‐derived building blocks, namely furan‐2,5‐dicarboxylic acid and isosorbide, and 1,4‐butanediol were successfully synthesized using melt polycondensation. The copolyesters were obtained with varied chemical compositions and rather high molecular weights ( M n = 24 000–31 000 g mol −1 ) and intrinsic viscosities ([ η ] = 0.56–0.72 dL g −1 ). Incorporation of both building blocks significantly enhances the glass transition temperatures ( T g = 38–107 °C) of polyesters, and also efficiently inhibits the crystallization of the copolyesters. A low content of isosorbide ( ca 10 mol%) leads to complete transition of the homopolyester to nearly fully amorphous materials. Detailed characterizations of the chemical structures and thermal properties of the synthesized copolyesters were conducted using various analytical techniques. In addition, hydrolytic and enzymatic degradations of the copolymers in the presence of porcine pancreatic lipase and cutinase were also investigated. © 2020 Society of Industrial Chemistry