Neda Meshksar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Neda Meshksar has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
Davor Mance
Department of Earth Sciences, ETH Zürich, Sonneggstrasse 5, 8092 Zurich, Switzerland
2 shared publicationsDomenico Giardini
Department of Earth Sciences, ETH Zürich, Sonneggstrasse 5, 8092 Zurich, Switzerland
2 shared publicationsJan Ten Pierick
Physik-Institut, University of Zurich, Winterthurerstr. 190, 8057 Zurich, Switzerland
2 shared publicationsLisa Pathfinder Colaboration
2 shared publicationsLuigi Ferraioli
Department of Earth Sciences, ETH Zürich, Sonneggstrasse 5, 8092 Zurich, Switzerland
2 shared publicationsPeter Zweifel
Department of Earth Sciences, ETH Zürich, Sonneggstrasse 5, 8092 Zurich, Switzerland
2 shared publications
Latest Publications
- Open Access
Applying Differential Wave-Front Sensing and Differential Power Sensing for Simultaneous Precise and Wide-Range Test-Mass Rotation Measurements
We propose to combine differential wave-front sensing (DWS) and differential power sensing (DPS) in a Mach-Zehnder type interferometer for measuring the rotational dynamics of a test-mass. Using the DWS method, a high sensitive measurement of 6 nrad Hz−1/2 in sub-Hz frequencies can be provided around the test-mass nominal position ( mrad), whereas the measurement of a wide rotation range ( mrad) is realized by the DPS method. The interferometer can be combined with deep frequency modulation (DFM) interferometry for measurement of the test-mass translational dynamics. The setup and the resulting interferometric signals are verified by simulations. An optimization algorithm is applied to find suitable positions of the lenses and the waist size of the input laser in order to determine the best trade of between the slope of DWS, dynamic range of DPS, and the interferometric contrast. Our simulation further allows to investigate the layout for robustness and design tolerances. We compare our device with a recent experimental realization of a DFM interferometer and find that a practical implementation of the interferometer proposed here has the potential to provide translational and rotational test-mass tracking with state-of-the-art sensitivity. The simple and compact design, and especially the capability of sensing the test-mass rotation in a wide range and simultaneously providing a high-precision measurement close to the test-mass nominal position makes the design especially suitable for example for employment in torsion pendulum setups.Open AccessApplying Differential Wave-Front Sensing and Differential Power Sensing for Simultaneous Precise and Wide-Range Test-Mass Rotation Measurements
We propose to combine differential wave-front sensing (DWS) and differential power sensing (DPS) in a Mach-Zehnder type interferometer for measuring the rotational dynamics of a test-mass. Using the DWS method, a high sensitive measurement of 6 nrad Hz−1/2 in sub-Hz frequencies can be provided around the test-mass nominal position ( mrad), whereas the measurement of a wide rotation range ( mrad) is realized by the DPS method. The interferometer can be combined with deep frequency modulation (DFM) interferometry for measurement of the test-mass translational dynamics. The setup and the resulting interferometric signals are verified by simulations. An optimization algorithm is applied to find suitable positions of the lenses and the waist size of the input laser in order to determine the best trade of between the slope of DWS, dynamic range of DPS, and the interferometric contrast. Our simulation further allows to investigate the layout for robustness and design tolerances. We compare our device with a recent experimental realization of a DFM interferometer and find that a practical implementation of the interferometer proposed here has the potential to provide translational and rotational test-mass tracking with state-of-the-art sensitivity. The simple and compact design, and especially the capability of sensing the test-mass rotation in a wide range and simultaneously providing a high-precision measurement close to the test-mass nominal position makes the design especially suitable for example for employment in torsion pendulum setups. - 1 September 2020
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 91 (9) , 095003
Analysis of the accuracy of actuation electronics for the laser interferometer space antenna
Electrostatic actuation of a free-floating test-mass was tested in the Laser Interferometer Space Antenna (LISA) Pathfinder mission, and it will be integrated into the LISA. We have investigated the LISA Pathfinder actuation accuracy with respect to the precision of fractional digits in the field programmable gate array (FPGA) code of actuation electronics. The LISA Pathfinder data showed that the rounding errors in the FPGA code result in an erroneous force that contaminated the main mission observable, and this error was compensated in the post-processing of the LISA Pathfinder data. To avoid a similar issue for the LISA, the LISA actuation accuracy can be improved by increasing the number of fractional digits in the FPGA code. However, this is restricted by some hardware limitations. In this paper, we investigate the necessary enlargement of the FPGA to fulfill the LISA acceleration requirements and propose a design optimization for LISA actuation electronics.
- 1 September 2020
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 91 (9) , 095003
Analysis of the accuracy of actuation electronics for the laser interferometer space antenna
Electrostatic actuation of a free-floating test-mass was tested in the Laser Interferometer Space Antenna (LISA) Pathfinder mission, and it will be integrated into the LISA. We have investigated the LISA Pathfinder actuation accuracy with respect to the precision of fractional digits in the field programmable gate array (FPGA) code of actuation electronics. The LISA Pathfinder data showed that the rounding errors in the FPGA code result in an erroneous force that contaminated the main mission observable, and this error was compensated in the post-processing of the LISA Pathfinder data. To avoid a similar issue for the LISA, the LISA actuation accuracy can be improved by increasing the number of fractional digits in the FPGA code. However, this is restricted by some hardware limitations. In this paper, we investigate the necessary enlargement of the FPGA to fulfill the LISA acceleration requirements and propose a design optimization for LISA actuation electronics.
- Open Access
- 1 May 2017
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 840 (1) , 012041
Gravitational Reference Sensor Front-End Electronics Simulator for LISA
At the ETH Zurich we are developing a modular simulator that provides a realistic simulation of the Front End Electronics (FEE) for LISA Gravitational Reference Sensor (GRS). It is based on the GRS FEE-simulator already implemented for LISA Pathfinder. It considers, in particular, the non-linearity and the critical details of hardware, such as the non-linear multiplicative noise caused by voltage reference instability, test mass charging and detailed actuation and sensing algorithms. We present the simulation modules, considering the above-mentioned features. Based on the ETH GRS FEE-simulator for LISA Pathfinder we aim to develop a modular simulator that provides a realistic simulation of GRS FEE for LISA.
- 1 May 2017
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 840 (1) , 012041
Open AccessGravitational Reference Sensor Front-End Electronics Simulator for LISA
At the ETH Zurich we are developing a modular simulator that provides a realistic simulation of the Front End Electronics (FEE) for LISA Gravitational Reference Sensor (GRS). It is based on the GRS FEE-simulator already implemented for LISA Pathfinder. It considers, in particular, the non-linearity and the critical details of hardware, such as the non-linear multiplicative noise caused by voltage reference instability, test mass charging and detailed actuation and sensing algorithms. We present the simulation modules, considering the above-mentioned features. Based on the ETH GRS FEE-simulator for LISA Pathfinder we aim to develop a modular simulator that provides a realistic simulation of GRS FEE for LISA.
- Open Access
- 1 May 2017
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 840 (1) , 012042
GRS vs. OMS Calibration in LISA Pathfinder Data Analysis
On board LISA Pathfinder spacecraft the test mass displacement along the main measurement axis is sensed in two different ways: optically and electrostatically. We have monitored the relative calibration between the two measurements during the mission science phase. The trend sensitivity of the relative calibration has been computed for different physical parameters, such as temperature, magnetic field, test mass bias voltage and current.
- 1 May 2017
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 840 (1) , 012042
Open AccessGRS vs. OMS Calibration in LISA Pathfinder Data Analysis
On board LISA Pathfinder spacecraft the test mass displacement along the main measurement axis is sensed in two different ways: optically and electrostatically. We have monitored the relative calibration between the two measurements during the mission science phase. The trend sensitivity of the relative calibration has been computed for different physical parameters, such as temperature, magnetic field, test mass bias voltage and current.