Zhiwei Qiu

Wide swath near-nadir interferometric altimetry is a newly developed technology for sea surface height (SSH) measurement. However, the absence of actual measurement data makes this novel SSH mapping technique difficult to verify and apply for wide swath interferometric altimeters. To verify the designed performance of the scheduled wide swath single-pass interferometric altimeter in the "Guanlan Mission", an airborne campaign was carried out off the coast of Rizhao, China on November 16, 2020. An airborne dual-frequency interferometric radar altimeter system (ADIRAS) with a single-pass mode was utilized for SSH measurement as the first flight. Two pioneering and fundamental works have been conducted: an intensive altimetry error analysis according to the ADIRAS parameter settings along the incident direction, an effective SSH reconstruction approach based on a multichannel likelihood (ML) function, and detailed validation procedures through airborne campaigns illustrated in this study. The results indicated that the difference between the wave-induced sea surface elevation (WSSE) variances derived by the ML approach and GNSS buoy was 2 cm ² , which was smaller than the results of the single band on Ku (11 cm ² ) and Ka (6 cm ² ). Moreover, the estimated Significant Waves Height (SWH) bias of joint bands was 10 cm, which was also superior to that of Ku (39 cm) and Ka (24 cm). Both simulated data and real airborne dual-frequency InSAR data were employed in this study for cross-validation of the proposed method. This approach represents an effective technique for SSH reconstruction of future spaceborne/airborne interferometric altimeters.

Persistent scatterer interferometry (PSI) has been proved to be an advanced Interferometric Synthetic Aperture Radar (InSAR) technique used to measure and monitor terrain deformation. Two of the critical problems with InSAR have been the effect of the refractive atmosphere and decorrelation on the interferometric phases due to long spatial-temporal baseline. The low density of persistent scatterers (PS) in non-urban areas affected by spatial-temporal decoherence more seriously has inspired the development of alternative approaches. Sentinel-1 (S1) has improved the data acquisition throughout, and compared to previous sensors, increased considerably the differential interferometric SAR (DInSAR) and PSI deformation monitoring potential. This paper describes an innovative methodology to process S1 SAR data. Different with PSI, its most original part includes two key processing stages: high and low frequency splitting from wrapped phases, prior to atmospheric filtering, and final direct integration to generate the complete deformation with time series containing linear and nonlinear components. The proposed method has two fundamental advantages compared with traditional PSI approach: the final monitoring results with excellent coverage of coherent points and the generation of active maps even for the areas with serious deformation in short term to break through the inherent limitation of PSI. The effectiveness of the proposed tools is illustrated using a case study located in Catalonia (Spain). This methodology has supposed a definitive step towards the implementation of DInSAR based techniques to support decision makers against geohazards. In this work, the deformation procedures happened in three different areas of the Catalonia (Spain) are presented and analysed. The maximum accumulated subsidence of over – 60 cm induced by mining activity can be detected by proposed methodology with nice coverage from January 2017 to January 2019. These reported cases illustrate how DInSAR based techniques can provide detailed terrain deformation for geohazard activity with complex topographical conditions. The active deformation areas map can be generated in fast aimed at geohazard risk early warning and management.

Ground-based synthetic aperture radar (GB-SAR) has been proved to be one of the cutting-edge techniques for the timely detection of slope failures in both natural and engineered slopes. This paper focuses on the structure deformation monitoring on the dams using GB-SAR data. Temporal sequence data was collected by ground SAR equipment from 29 July to 1 August for the Geheyan dam and the SAR images with high quality were selected through the exhaustive spatial-temporal coherence analysis based on permanent scatterer (PS) theory in this paper. A practical solution for dam structure deformation extraction after the atmospheric effect reduction is proposed in depth. The deformation of the dam spillway gates is greater than that of the dam body monitored by this GB-SAR campaign, and with the increase of the water level in the reservoir area, the displacement increases along the direction of water flow gradually. The surface deformation rate of the dam body is fitted by linear regression analysis, and the interpolated rate results are compared and verified with the plumb line measurements. Finally, the consistency of the dam deformation average rate based on the PS time series analysis technology by GB-SAR and plumb lines is verified in this article, demonstrated the excellent performance of the proposed method for remote multipoint displacement measurements of the dam.

The surface subsidence in Nanjing has become increasingly apparent because of the influence of geological conditions and the rapid progress of urbanization. Here, the theory of synthetic aperture radar interferometry is analysed, and a method based on the short baseline subset (SBAS) technology is proposed. The method can overcome time and baseline decorrelation and other factors, and it can extract points with high coherence from interferograms have short spatio-temporal baselines when the atmospheric delay phase and the noise phase in the frequency domain are used to differentiate the corresponding characteristics. The slow deformation ratio of the monitoring area over long periods can also be calculated by this method. In this study, the 16 advanced land observing satellite (ALOS) data acquired from 2007 to 2011 in Nanjing are processed by the SBAS technology and compared with levelling result. This work emphasizes that the SBAS technology could derive the cumulative deformations of surfaces and deformation fields accurately.

Ground-based synthetic aperture radar (GBSAR) is a powerful tool used in monitoring structures, such as bridges and dams. However, despite the extremely short range of GBSAR interferometry, the atmosphere effects cannot be neglected. The permanent scatterer technique is an effective operational tool that utilizes a long series of SAR data and detects information with high accuracy. An algorithm based on the permanent scatterer technique is developed in accordance with the phase model used in GBSAR interferometry. In this study, atmospheric correction is carried out on a real campaign (Geheyan Dam, China). The atmosphere effects created using this method, which utilizes SAR data, can be reduced effectively compared to when plumb line data are used.

Precise topographical information has a very important role in geology, hydrology, natural resources survey and deformation monitoring. The extracting DEM technology based on synthetic aperture radar interferometry (InSAR) obtains the three-dimensional elevation of the target area through the phase information of the radar image data. The technology has large-scale, high-precision, all-weather features. By changing track in the location of the ground radar system up and down, it can form spatial baseline. Then we can achieve the DEM of the target area by acquiring image data from different angles. Three-dimensional laser scanning technology can quickly, efficiently and accurately obtain DEM of target area, which can verify the accuracy of DEM extracted by GBInSAR. But research on GBInSAR in extracting DEM of the target area is a little. For lack of theory and lower accuracy problems in extracting DEM based on GBInSAR now, this article conducted research and analysis on its principle deeply. The article extracted the DEM of the target area, combined with GBInSAR data. Then it compared the DEM obtained by GBInSAR with the DEM obtained by three-dimensional laser scan data and made statistical analysis and normal distribution test. The results showed the DEM obtained by GBInSAR was broadly consistent with the DEM obtained by three-dimensional laser scanning. And its accuracy is high. The difference of both DEM approximately obeys normal distribution. It indicated that extracting the DEM of target area based on GBInSAR is feasible and provided the foundation for the promotion and application of GBInSAR. © (2016) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.

In this paper, a ground-based SAR interferometry technology was used to monitor major enginerring. This technology has been recognized as a powerful tool for terrain monitoring and structural change detecting. Deformation monitoring for large project has been a hot issue among them. According to GBSAR interferometry principle and characteristics of IBIS system, the authors analysis the error sources of deformation monitoring, and experimentally extract atmospheric phase which should removed based on permanent scatterer analysis. Atmospheric disturbance effect analysis is discussed in this paper, and an atmospheric correction method is proposed to remove atmospheric effect, then the effective displacement can be retrieved. Results from this approach have been compared with that from traditional method in this campaign, GBInSAR technology can be exploited successfully in deformation monitoring for major projects with high accuracy ^1-3.

This paper proposes SAR imaging algorithm with largest coherence based on the existing SAR imaging algorithm. The basic idea of SAR imaging algorithm in imaging processing is that output signal can have maximum signal-to-noise ratio (SNR) by using the optimal imaging parameters. Traditional imaging algorithm can acquire the best focusing effect, but would bring the decoherence phenomenon in subsequent interference process. Algorithm proposed in this paper is that SAR echo adopts consistent imaging parameters in focusing processing. Although the SNR of the output signal is reduced slightly, their coherence is ensured greatly, and finally the interferogram with high quality is obtained. In this paper, two scenes of Envisat ASAR data in Zhangbei are employed to conduct experiment for this algorithm. Compared with the interferogram from the traditional algorithm, the results show that this algorithm is more suitable for SAR interferometry (InSAR) research and application.