Michele Urbani
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Michele Urbani has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Matteo Brunelli
University of Trento
4 shared publications - Mikael Collan
Lappeenranta-Lahti University of Technology, Finland
2 shared publications Andrea Bendazzoli
1 shared publicationAntti Punkka
1 shared publication- Behzad Najafi
Politecnico di Milano
1 shared publication - Dario Petri
Department of Industrial Engineering, University of Trento, Trento, Italy
1 shared publication
Latest Publications
- Open Access
- 23 March 2026
- Published by Aalborg University in International Journal of Sustainable Energy Planning and Management
- Vol. 48, 55-73
A multi-objective optimization approach in defining the decarbonization strategy of a district heating network: A case study of Oslo
This study investigates the decarbonization of the Oslo district heating network by, firstly, modeling its current framework using EnergyPLAN and, afterwards, exploring optimized solutions, in terms of CO2 emissions and total annual cost, combining EnergyPLAN with a multi-objective evolutionary algorithm. Alternative scenarios are explored based on nine decision variables (energy technologies), each constrained by upper and lower boundaries defined by a specific set of criteria. In this work, the exploration of 20,000 solutions is performed following a four-step approach that starting from a broad availability of the decision variables, step by step adds new constraints. In the first step, heat pumps and waste heat recovery were recognized as the most cost-effective decarbonization solutions. The second step, avoiding the use of heat pumps, shifted the focus to more costly electric boilers. The third step, excluding also electric boilers, resulted in favoring biomass boilers, but with an additional cost increase. In the final step, carbon capture and storage became the only feasible decarbonization option and highlighted the difficult decarbonization with a steep Pareto front. Overall, this study confirms that, in line with recent system-oriented literature but extending beyond technology- or case-specific studies, waste heat recovery and electrification-based sector coupling emerge as the dominant cost-optimal decarbonization pathways at the system level.
- 23 March 2026
- Published by Aalborg University in International Journal of Sustainable Energy Planning and Management
- Vol. 48, 55-73
Open AccessA multi-objective optimization approach in defining the decarbonization strategy of a district heating network: A case study of Oslo
This study investigates the decarbonization of the Oslo district heating network by, firstly, modeling its current framework using EnergyPLAN and, afterwards, exploring optimized solutions, in terms of CO2 emissions and total annual cost, combining EnergyPLAN with a multi-objective evolutionary algorithm. Alternative scenarios are explored based on nine decision variables (energy technologies), each constrained by upper and lower boundaries defined by a specific set of criteria. In this work, the exploration of 20,000 solutions is performed following a four-step approach that starting from a broad availability of the decision variables, step by step adds new constraints. In the first step, heat pumps and waste heat recovery were recognized as the most cost-effective decarbonization solutions. The second step, avoiding the use of heat pumps, shifted the focus to more costly electric boilers. The third step, excluding also electric boilers, resulted in favoring biomass boilers, but with an additional cost increase. In the final step, carbon capture and storage became the only feasible decarbonization option and highlighted the difficult decarbonization with a steep Pareto front. Overall, this study confirms that, in line with recent system-oriented literature but extending beyond technology- or case-specific studies, waste heat recovery and electrification-based sector coupling emerge as the dominant cost-optimal decarbonization pathways at the system level.
- Open Access
- 28 November 2023
- Published by Elsevier in Computers & Operations Research
- Vol. 163
A cooperative team orienteering optimisation model and a customised resolution metaheuristic
- 28 November 2023
- Published by Elsevier in Computers & Operations Research
- Vol. 163
Open AccessA cooperative team orienteering optimisation model and a customised resolution metaheuristic
- Open Access
- 15 July 2023
- Published by Association for Computing Machinery (ACM)
- p. 415-418
A multi-policy sequence-based selection hyper-heuristic for multi-objective optimization
- 15 July 2023
- Published by Association for Computing Machinery (ACM)
- p. 415-418
Open AccessA multi-policy sequence-based selection hyper-heuristic for multi-objective optimization
- Open Access
- 28 April 2023
- Published by Elsevier in Information Sciences
- Vol. 639
A numerical comparative study of uncertainty measures in the Dempster–Shafer evidence theory
- 28 April 2023
- Published by Elsevier in Information Sciences
- Vol. 639
Open AccessA numerical comparative study of uncertainty measures in the Dempster–Shafer evidence theory
- 18 May 2022
- Published by Elsevier in European Journal of Operational Research
- Vol. 305 (1) , 101-113
An approach for bi-objective maintenance scheduling on a networked system with limited resources
- 18 May 2022
- Published by Elsevier in European Journal of Operational Research
- Vol. 305 (1) , 101-113
An approach for bi-objective maintenance scheduling on a networked system with limited resources
- Open Access
- 22 February 2021
- Published by Springer Nature in Journal of Intelligent Manufacturing
- Vol. 32 (7) , 1953-1973
Maintenance optimization for a multi-unit system with digital twin simulation
Optimization of operations and maintenance (O&M) in the industry is a topic that has been largely studied in the literature. Many authors focused on reliability-based approaches to optimize O&M, but little attention has been given to study the influence of macroeconomic variables on the long-term maintenance policy. This work aims to optimize time-based maintenance (TBM) policy in the mining industry. The mine environment is reproduced employing a virtual model that resembles a digital twin (DT) of the system. The effect of maintenance decisions is replicated by a discrete event simulation (DES), whereas a model of the financial operability of the mine is realized through System Dynamics (SD). The simultaneous use of DES and the SD allows us to reproduce the environment with high-fidelity and to minimize the cost of O&M. The selected illustrative case example demonstrates that the proposed approach is feasible. The issues of using high dimensional simulation data from DT-models in managerial decision making is identified and discussed.
- 22 February 2021
- Published by Springer Nature in Journal of Intelligent Manufacturing
- Vol. 32 (7) , 1953-1973
Open AccessMaintenance optimization for a multi-unit system with digital twin simulation
Optimization of operations and maintenance (O&M) in the industry is a topic that has been largely studied in the literature. Many authors focused on reliability-based approaches to optimize O&M, but little attention has been given to study the influence of macroeconomic variables on the long-term maintenance policy. This work aims to optimize time-based maintenance (TBM) policy in the mining industry. The mine environment is reproduced employing a virtual model that resembles a digital twin (DT) of the system. The effect of maintenance decisions is replicated by a discrete event simulation (DES), whereas a model of the financial operability of the mine is realized through System Dynamics (SD). The simultaneous use of DES and the SD allows us to reproduce the environment with high-fidelity and to minimize the cost of O&M. The selected illustrative case example demonstrates that the proposed approach is feasible. The issues of using high dimensional simulation data from DT-models in managerial decision making is identified and discussed.
- Open Access
- 4 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 143654-143664
A Comparison of Maintenance Policies for Multi-Component Systems Through Discrete Event Simulation of Faults
Finding optimal maintenance policies for complex multi-component systems is a realworld challenge in the industry. This paper compares three maintenance policies for complex systems with non-identical components and economic dependencies in case of fault. Discrete event and Monte Carlo simulation are used to replicate fault occurrences, while a genetic algorithm is used to minimize the cost of maintenance by finding optimal groups of maintenance activities. Low total average maintenance cost and high average availability of the system are considered as desirable objectives and the capacity of the studied policies to achieve these goals is analyzed. None of the policies dominates the others (in a Pareto efficiency sense), thus making the policy choice context dependent and subject to decision makers’ preferences.
- 4 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 143654-143664
Open AccessA Comparison of Maintenance Policies for Multi-Component Systems Through Discrete Event Simulation of Faults
Finding optimal maintenance policies for complex multi-component systems is a realworld challenge in the industry. This paper compares three maintenance policies for complex systems with non-identical components and economic dependencies in case of fault. Discrete event and Monte Carlo simulation are used to replicate fault occurrences, while a genetic algorithm is used to minimize the cost of maintenance by finding optimal groups of maintenance activities. Low total average maintenance cost and high average availability of the system are considered as desirable objectives and the capacity of the studied policies to achieve these goals is analyzed. None of the policies dominates the others (in a Pareto efficiency sense), thus making the policy choice context dependent and subject to decision makers’ preferences.
- Open Access
- 29 July 2020
- Published by Springer Nature
- p. 97-111
Maintenance-Management in Light of Manufacturing 4.0
Global competition is driving the evolution of the Industry 4.0 paradigm in the manufacturing industry. In this context, maintenance can play an increasingly important role in assuring a satisfactory level of asset reliability and availability and in improving organization performance. This chapter gives an overview on maintenance policies commonly used in daily practice and presents the principles of the cutting-edge approach to predictive maintenance—prognostics and health management (PHM). Advanced predictive maintenance approaches and their technical and cost-savings potential in connection with the concept of digital twins are discussed.
- 29 July 2020
- Published by Springer Nature
- p. 97-111
Open AccessMaintenance-Management in Light of Manufacturing 4.0
Global competition is driving the evolution of the Industry 4.0 paradigm in the manufacturing industry. In this context, maintenance can play an increasingly important role in assuring a satisfactory level of asset reliability and availability and in improving organization performance. This chapter gives an overview on maintenance policies commonly used in daily practice and presents the principles of the cutting-edge approach to predictive maintenance—prognostics and health management (PHM). Advanced predictive maintenance approaches and their technical and cost-savings potential in connection with the concept of digital twins are discussed.