Xiaohui Jin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Xiaohui Jin has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
Sigrid Peldszus
NSERC Chair in Water Treatment, Department of Civil and Environmental Engineering, University of Waterloo, Waterloo, Ontario N2L 3G1, Canada
3 shared publications- Cynthia Hallé
Department of Civil & Environ. Eng., University of Waterloo, Waterloo, ON, N2L 3G1, Canada;;;;
1 shared publication - D. B. Mosqueda-Jimenez
GE Water and Process Technologies, 3239 Dundas St. West, Oakville, ON L6M 4B2, Canada
1 shared publication Douglas I. Sparkes
Conrad Business, Entrepreneurship and Technology Center, University of Waterloo, Waterloo, Ontario N2L 3G1, Canada
1 shared publication- Gary Amy
Unesco-IHE Institute for Water Education, Westvest 7, 2611 AX, Delft, The Netherlands
1 shared publication - H. Ruiz
Department of Civil & Environ. Eng., University of Waterloo, Waterloo, ON, N2L 3G1, Canada;;;;
1 shared publication
Latest Publications
- 25 June 2014
- Published by Taylor & Francis in Ozone: Science & Engineering
- Vol. 36 (4) , 289-302
Modeling Ozone Reaction Rate Constants of Micropollutants Using Quantitative Structure-Property Relationships
A quantitative structure-property relationship model was developed using piecewise linear regression (with two submodels) to predict second-order rate constants with ozone for a wide range of structurally diverse micropollutants. The model was developed using a set of pre-selected structurally diverse micropollutants for which rate constants had been determined experimentally, and then validated with an external data set. A classification function was developed using linear discriminant analysis to classify micropollutants into high-reactive or low-reactive compounds before using the appropriate submodel. The applicability domain of the model was determined using the Williams plot.
- 25 June 2014
- Published by Taylor & Francis in Ozone: Science & Engineering
- Vol. 36 (4) , 289-302
Modeling Ozone Reaction Rate Constants of Micropollutants Using Quantitative Structure-Property Relationships
A quantitative structure-property relationship model was developed using piecewise linear regression (with two submodels) to predict second-order rate constants with ozone for a wide range of structurally diverse micropollutants. The model was developed using a set of pre-selected structurally diverse micropollutants for which rate constants had been determined experimentally, and then validated with an external data set. A classification function was developed using linear discriminant analysis to classify micropollutants into high-reactive or low-reactive compounds before using the appropriate submodel. The applicability domain of the model was determined using the Williams plot.
- 1 December 2012
- Published by Elsevier in Water Research
- Vol. 46 (19) , 6519-6530
Reaction kinetics of selected micropollutants in ozonation and advanced oxidation processes
- 1 December 2012
- Published by Elsevier in Water Research
- Vol. 46 (19) , 6519-6530
Reaction kinetics of selected micropollutants in ozonation and advanced oxidation processes
- 1 January 2012
- Published by Elsevier in Science of The Total Environment
- Vol. 414, 653-663
Selection of representative emerging micropollutants for drinking water treatment studies: A systematic approach
- 1 January 2012
- Published by Elsevier in Science of The Total Environment
- Vol. 414, 653-663
Selection of representative emerging micropollutants for drinking water treatment studies: A systematic approach
- 1 March 2011
- Published by IWA Publishing in Water Supply
- Vol. 11 (1) , 23-29
Pilot scale evaluation of biofiltration as an innovative pre-treatment for ultrafiltration membranes for drinking water treatment
Fouling remains one of the major constraints on the use of low pressure membranes in drinking water treatment. Work over the last few years has shown the importance of biopolymers (carbohydrates and protein-like material) as foulants for ultrafiltration (UF) membranes. The purpose of this study was to investigate at pilot scale the use of rapid biofiltration (without prior coagulation or ozone addition) as an innovative pretreatment to reduce fouling of UF membranes. The investigation was carried out on a water with a higher than average DOC and significant temperature variation. The biofilters, each operated at a hydraulic loading of 5 m/h, had empty bed contact times of 5, 10 and 15 minutes. The membrane unit was operated at a flux equivalent to 60 LMH at 20°C. The investigation confirmed the encouraging results obtained in an earlier smaller scale study with essentially the same water. Increased biofiltration contact time (i.e. increased bed depth) led to lower rates of hydraulically irreversible fouling. The initial biofiltration backwash procedure, involving air scour as is common in chemically assisted filtration, led in some cases to an increased rate of membrane fouling immediately after the backwash. An alternative backwashing strategy was developed, however the feasibility of operating with this approach over very long periods of time needs to be confirmed. To assist in full-scale implementation of this “green” and simple pretreatment, the design and operating conditions for the biofilters should be optimized for various types of waters. It is expected that biofiltration pretreatment will be of particular interest for small and/or isolated systems where a higher initial capital cost may be acceptable because of operational simplicity and reduced chemical requirements.
- 1 March 2011
- Published by IWA Publishing in Water Supply
- Vol. 11 (1) , 23-29
Pilot scale evaluation of biofiltration as an innovative pre-treatment for ultrafiltration membranes for drinking water treatment
Fouling remains one of the major constraints on the use of low pressure membranes in drinking water treatment. Work over the last few years has shown the importance of biopolymers (carbohydrates and protein-like material) as foulants for ultrafiltration (UF) membranes. The purpose of this study was to investigate at pilot scale the use of rapid biofiltration (without prior coagulation or ozone addition) as an innovative pretreatment to reduce fouling of UF membranes. The investigation was carried out on a water with a higher than average DOC and significant temperature variation. The biofilters, each operated at a hydraulic loading of 5 m/h, had empty bed contact times of 5, 10 and 15 minutes. The membrane unit was operated at a flux equivalent to 60 LMH at 20°C. The investigation confirmed the encouraging results obtained in an earlier smaller scale study with essentially the same water. Increased biofiltration contact time (i.e. increased bed depth) led to lower rates of hydraulically irreversible fouling. The initial biofiltration backwash procedure, involving air scour as is common in chemically assisted filtration, led in some cases to an increased rate of membrane fouling immediately after the backwash. An alternative backwashing strategy was developed, however the feasibility of operating with this approach over very long periods of time needs to be confirmed. To assist in full-scale implementation of this “green” and simple pretreatment, the design and operating conditions for the biofilters should be optimized for various types of waters. It is expected that biofiltration pretreatment will be of particular interest for small and/or isolated systems where a higher initial capital cost may be acceptable because of operational simplicity and reduced chemical requirements.