Jie Hu
Jie Hu has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Benoit Bakeroot
IMEC, Leuven, Belgium
4 shared publications - Guido Groeseneken
ESAT Department, Katholieke Universiteit Leuven, Leuven, Belgium
4 shared publications R. Venegas
Imec 2 , Kapeldreef 75, 3001 Leuven, Belgium
2 shared publicationsS. Decoutere
Imec 2 , Kapeldreef 75, 3001 Leuven, Belgium
2 shared publicationsS. Lenci
Imec 2 , Kapeldreef 75, 3001 Leuven, Belgium
2 shared publicationsS. Stoffels
Imec 2 , Kapeldreef 75, 3001 Leuven, Belgium
2 shared publications
Latest Publications
- Open Access
- 20 July 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 63 (9) , 3451-3458
Statistical Analysis of the Impact of Anode Recess on the Electrical Characteristics of AlGaN/GaN Schottky Diodes With Gated Edge Termination
In this paper, we have extensively investigated the impact of anode recess on the reverse leakage current, forward voltage ( ${V}_{F}$ ), and dynamic characteristics of Au-free AlGaN/GaN Schottky barrier diodes with a gated edge termination (GET-SBDs) on 200-mm silicon substrates. By increasing the number of atomic layer etching (ALE) cycles for anode recessing, we have found that: 1) the reverse leakage current is strongly suppressed due to a better electrostatic control for pinching off the channel in the GET region; a median leakage current of $\sim 1$ nA/mm and an ${I}_{\mathrm{\scriptscriptstyle ON}}/{I}_{\mathrm{\scriptscriptstyle OFF}}$ ratio higher than $10^{8}$ have been achieved in GET-SBDs with six ALE cycles; 2) the forward voltage ( $\sim 1.3$ V) is almost independent of the ALE cycles, taking into account its statistical distribution across the wafers; 3) when the remaining AlGaN barrier starts to be very thin (in the case of six ALE cycles), a spread of the ON-resistance, mainly attributed to the GET region, can occur due to the difficult control of the remaining AlGaN thickness and surface quality; and 4) the dynamic forward voltage of GET-SBDs shows a mild dependence on the ALE process in pulsed $I$ – $V$ characterization, and a more ALE-dependent dynamic ON-resistance is observed.
- 20 July 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 63 (9) , 3451-3458
Open AccessStatistical Analysis of the Impact of Anode Recess on the Electrical Characteristics of AlGaN/GaN Schottky Diodes With Gated Edge Termination
In this paper, we have extensively investigated the impact of anode recess on the reverse leakage current, forward voltage ( ${V}_{F}$ ), and dynamic characteristics of Au-free AlGaN/GaN Schottky barrier diodes with a gated edge termination (GET-SBDs) on 200-mm silicon substrates. By increasing the number of atomic layer etching (ALE) cycles for anode recessing, we have found that: 1) the reverse leakage current is strongly suppressed due to a better electrostatic control for pinching off the channel in the GET region; a median leakage current of $\sim 1$ nA/mm and an ${I}_{\mathrm{\scriptscriptstyle ON}}/{I}_{\mathrm{\scriptscriptstyle OFF}}$ ratio higher than $10^{8}$ have been achieved in GET-SBDs with six ALE cycles; 2) the forward voltage ( $\sim 1.3$ V) is almost independent of the ALE cycles, taking into account its statistical distribution across the wafers; 3) when the remaining AlGaN barrier starts to be very thin (in the case of six ALE cycles), a spread of the ON-resistance, mainly attributed to the GET region, can occur due to the difficult control of the remaining AlGaN thickness and surface quality; and 4) the dynamic forward voltage of GET-SBDs shows a mild dependence on the ALE process in pulsed $I$ – $V$ characterization, and a more ALE-dependent dynamic ON-resistance is observed.
- 2 May 2016
- Published by Wiley in Physica Status Solidi (a)
- Vol. 213 (5) , 1229-1235
Leakage and trapping characteristics in Au‐free AlGaN/GaN Schottky barrier diodes fabricated on C‐doped buffer layers
We investigate the DC and dynamic characteristics of AlGaN/GaN Schottky barrier diodes (SBDs) and the diodes with a gated edge termination (GET‐SBD) fabricated on unintentional doped (UID) and carbon‐doped AlGaN buffers. The off‐state characteristics of diodes fabricated on UID buffer are dominated by buffer leakage and buffer breakdown voltage (BV) at higher reverse voltage (larger than 300 V). An improvement in diode leakage and BV can be obtained by fabricating the GET‐SBDs on C‐doped buffers. A pronounceddegradation of the AlGaN/GaN SBDs and GET‐SBDs on carbon‐doped buffers was observed by dynamic pulsedcharacterization. This dynamicdegradation causes a clear forward current reduction for the AlGaN/GaN GET‐SBDs. From combined off‐state stress and current transient measurements on AlGaN/GaN SBDs, the collapsed current is recoverable and thedegradation is due to a temporary trapping mechanism occurring in the buffer. A distinct trap level of 0.57 eV from trap spectra has been extracted for the diode fabricated on C‐doped buffer, and the value was implemented in a TCAD simulator. The simulated results confirm a bulk trapping in the buffer layer for the SBD and show an additional trapping region in the GET‐SBD architecture.
- 2 May 2016
- Published by Wiley in Physica Status Solidi (a)
- Vol. 213 (5) , 1229-1235
Leakage and trapping characteristics in Au‐free AlGaN/GaN Schottky barrier diodes fabricated on C‐doped buffer layers
We investigate the DC and dynamic characteristics of AlGaN/GaN Schottky barrier diodes (SBDs) and the diodes with a gated edge termination (GET‐SBD) fabricated on unintentional doped (UID) and carbon‐doped AlGaN buffers. The off‐state characteristics of diodes fabricated on UID buffer are dominated by buffer leakage and buffer breakdown voltage (BV) at higher reverse voltage (larger than 300 V). An improvement in diode leakage and BV can be obtained by fabricating the GET‐SBDs on C‐doped buffers. A pronounceddegradation of the AlGaN/GaN SBDs and GET‐SBDs on carbon‐doped buffers was observed by dynamic pulsedcharacterization. This dynamicdegradation causes a clear forward current reduction for the AlGaN/GaN GET‐SBDs. From combined off‐state stress and current transient measurements on AlGaN/GaN SBDs, the collapsed current is recoverable and thedegradation is due to a temporary trapping mechanism occurring in the buffer. A distinct trap level of 0.57 eV from trap spectra has been extracted for the diode fabricated on C‐doped buffer, and the value was implemented in a TCAD simulator. The simulated results confirm a bulk trapping in the buffer layer for the SBD and show an additional trapping region in the GET‐SBD architecture.
- 23 February 2015
- Published by AIP Publishing in Applied Physics Letters
- Vol. 106 (8) , 083502
Current transient spectroscopy for trapping analysis on Au-free AlGaN/GaN Schottky barrier diode
This paper presents a combined technique of high voltage off-state stress and current transient measurements to investigate the trapping/de-trapping characteristics of Au-free AlGaN/GaN Schottky barrier diodes. The device features a symmetric three-terminal structure with a central anode contact surrounded by two separate cathodes. Under the diode off-state stress conditions, the two separate cathodes were electrically shorted. The de-trapping dynamics was studied by monitoring the recovery of the two-dimensional electron gas (2DEG) current at different temperatures by applying 0.5 V at cathode 2 while grounding cathode 1. During the recovery, the anode contact acts as a sensor of changes in diode leakage current. This leakage variation was found to be mainly due to the barrier height variation. With this method, the energy level and capture cross section of different traps in the AlGaN/GaN Schottky barrier diode can be extracted. Furthermore, the physical location of different trapping phenomena is indicated by studying the variation of the diode leakage current during the recovery. We have identified two distinct trapping mechanisms: (i) electron trapping at the AlGaN surface in the vicinity of the Schottky contact which results in the leakage reduction (barrier height increase) together with RON degradation; (ii) the electron trapping in the GaN channel layer which partially depletes the 2DEG. The physical origin of the two different traps is discussed in the text.- 23 February 2015
- Published by AIP Publishing in Applied Physics Letters
- Vol. 106 (8) , 083502
Current transient spectroscopy for trapping analysis on Au-free AlGaN/GaN Schottky barrier diode
This paper presents a combined technique of high voltage off-state stress and current transient measurements to investigate the trapping/de-trapping characteristics of Au-free AlGaN/GaN Schottky barrier diodes. The device features a symmetric three-terminal structure with a central anode contact surrounded by two separate cathodes. Under the diode off-state stress conditions, the two separate cathodes were electrically shorted. The de-trapping dynamics was studied by monitoring the recovery of the two-dimensional electron gas (2DEG) current at different temperatures by applying 0.5 V at cathode 2 while grounding cathode 1. During the recovery, the anode contact acts as a sensor of changes in diode leakage current. This leakage variation was found to be mainly due to the barrier height variation. With this method, the energy level and capture cross section of different traps in the AlGaN/GaN Schottky barrier diode can be extracted. Furthermore, the physical location of different trapping phenomena is indicated by studying the variation of the diode leakage current during the recovery. We have identified two distinct trapping mechanisms: (i) electron trapping at the AlGaN surface in the vicinity of the Schottky contact which results in the leakage reduction (barrier height increase) together with RON degradation; (ii) the electron trapping in the GaN channel layer which partially depletes the 2DEG. The physical origin of the two different traps is discussed in the text.- 20 August 2014
- Published by Elsevier in Microelectronics Reliability
- Vol. 54 (9-10) , 2196-2199
Physical origin of current collapse in Au-free AlGaN/GaN Schottky Barrier Diodes
- 20 August 2014
- Published by Elsevier in Microelectronics Reliability
- Vol. 54 (9-10) , 2196-2199
Physical origin of current collapse in Au-free AlGaN/GaN Schottky Barrier Diodes