Conor McGeough
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Conor McGeough has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Alessandro Rossi
Department of Physics, SUPA, University of Strathclyde, Glasgow G4 0NG, United Kingdom
2 shared publications - Megan Powell
University of Strathclyde
2 shared publications Alexander Zotov
Department of Physics, SUPA, University of Strathclyde, Glasgow G4 0NG, United Kingdom
1 shared publication- Alexander Zotov
University of Strathclyde
1 shared publication Ali Esmailiyan
Equal1 Labs, Nexus UCD Dublin Ireland
1 shared publicationAndrii Sokolov
Equal1 Labs, Nexus UCD Dublin Ireland
1 shared publication
Latest Publications
- Open Access
- 19 November 2026
- Published by IOP Publishing in Quantum Science and Technology
Radio-frequency reflectometry in silicon carbide large-area transistors
Radio-frequency (RF) reflectometry is widely used for high-bandwidth readout of semiconductor quantum devices at cryogenic temperatures, but its application has mainly been limited to nanoscale structures with relatively small capacitances. Here, we investigate RF readout in a different regime by applying gate-based reflectometry to a large-area silicon carbide transistor with parasitic capacitances orders of magnitude larger than those of typical quantum devices, conditions normally expected to hinder RF readout. We observe a gate-dependent RF response which degrades and eventually becomes unresolved as temperature is lowered, although DC transport measurements continue to provide evidence of channel formation down to deep cryogenic temperatures. We attribute this behavior to impedance changes introduced by carrier freeze-out in the transistor drift region, and examine a modified circuit configuration designed to recover sensitivity to changes in channel resistance under these conditions. These results establish how parasitic pathways and device geometry can limit RF readout, providing insight into the design of scalable cryogenic-CMOS quantum systems.
- 19 November 2026
- Published by IOP Publishing in Quantum Science and Technology
Open AccessRadio-frequency reflectometry in silicon carbide large-area transistors
Radio-frequency (RF) reflectometry is widely used for high-bandwidth readout of semiconductor quantum devices at cryogenic temperatures, but its application has mainly been limited to nanoscale structures with relatively small capacitances. Here, we investigate RF readout in a different regime by applying gate-based reflectometry to a large-area silicon carbide transistor with parasitic capacitances orders of magnitude larger than those of typical quantum devices, conditions normally expected to hinder RF readout. We observe a gate-dependent RF response which degrades and eventually becomes unresolved as temperature is lowered, although DC transport measurements continue to provide evidence of channel formation down to deep cryogenic temperatures. We attribute this behavior to impedance changes introduced by carrier freeze-out in the transistor drift region, and examine a modified circuit configuration designed to recover sensitivity to changes in channel resistance under these conditions. These results establish how parasitic pathways and device geometry can limit RF readout, providing insight into the design of scalable cryogenic-CMOS quantum systems.
- Open Access
- 29 April 2026
- Published by IOP Publishing in Materials for Quantum Technology
- Vol. 6 (2) , 026201
Reproducibility and variability in commercial SiC MOSFETs at deep-cryogenic temperatures
Silicon carbide is a wide-bandgap semiconductor with an emerging complementary metal-oxide-semiconductor (CMOS) technology platform and it is widely deployed in high power and harsh environment electronics. This material is also attracting interest for quantum technologies through its crystal defects, which can act as spin-based qubits or single-photon sources. In this work, we assess the cryogenic performance of commercial power metal oxide semiconductor field effect transistors to evaluate their suitability for CMOS-compatible quantum electronics. We perform a statistical study of threshold voltage and subthreshold swing from 300 K down to 650 mK, focusing on reproducibility and variability. Our results show significant performance degradation at low temperatures, including large gate hysteresis, threshold voltage shifts, and subthreshold swing deterioration. These effects suggest instability in electrostatic control, likely due to carrier freeze-out and high interface trap density, which may pose challenges for the reliable use of this transistor technology towards the realisation of quantum devices or cryo-CMOS electronics.
- 29 April 2026
- Published by IOP Publishing in Materials for Quantum Technology
- Vol. 6 (2) , 026201
Open AccessReproducibility and variability in commercial SiC MOSFETs at deep-cryogenic temperatures
Silicon carbide is a wide-bandgap semiconductor with an emerging complementary metal-oxide-semiconductor (CMOS) technology platform and it is widely deployed in high power and harsh environment electronics. This material is also attracting interest for quantum technologies through its crystal defects, which can act as spin-based qubits or single-photon sources. In this work, we assess the cryogenic performance of commercial power metal oxide semiconductor field effect transistors to evaluate their suitability for CMOS-compatible quantum electronics. We perform a statistical study of threshold voltage and subthreshold swing from 300 K down to 650 mK, focusing on reproducibility and variability. Our results show significant performance degradation at low temperatures, including large gate hysteresis, threshold voltage shifts, and subthreshold swing deterioration. These effects suggest instability in electrostatic control, likely due to carrier freeze-out and high interface trap density, which may pose challenges for the reliable use of this transistor technology towards the realisation of quantum devices or cryo-CMOS electronics.
- Open Access
- 10 November 2024
- Published by Wiley in International Journal of Circuit Theory and Applications
- Vol. 53 (7) , 3902-3911
Monolithically Integrated Quantum Dots in a 22‐nm Fully Depleted Silicon‐on‐Insulator Process Operating at 3 K
Quantum computers comprising large‐scale arrays of qubits will enable complex algorithms to be executed to provide a quantum advantage for practical applications. A prerequisite for this milestone is a power‐efficient qubit control and detection system operating at cryogenic temperatures. Implementing such systems in complementary metal‐oxide‐semiconductor (CMOS) technology offers clear advantages in terms of scalability. Here, we present a fully integrated quantum dot array in which silicon quantum wells are co‐located with control and detection circuitry on the same die in a commercial 22‐nm fully depleted silicon‐on‐insulator (FDSOI) process. Our system comprises a two‐dimensional quantum dot array, integrated with 8 detectors and 32 injectors, operating at 3 K inside a cryo‐cooler. The power consumption of the control and detection circuitry is 2.5 mW per qubit without body biasing. The design utilizes 0.8‐V nominal devices. The setup allows us to verify discrete charge injection control and detection at the quantum dot array and demonstrate the feasibility of this architecture for scaling up the existing quantum core to hundreds and thousands of physical qubits.
- 10 November 2024
- Published by Wiley in International Journal of Circuit Theory and Applications
- Vol. 53 (7) , 3902-3911
Open AccessMonolithically Integrated Quantum Dots in a 22‐nm Fully Depleted Silicon‐on‐Insulator Process Operating at 3 K
Quantum computers comprising large‐scale arrays of qubits will enable complex algorithms to be executed to provide a quantum advantage for practical applications. A prerequisite for this milestone is a power‐efficient qubit control and detection system operating at cryogenic temperatures. Implementing such systems in complementary metal‐oxide‐semiconductor (CMOS) technology offers clear advantages in terms of scalability. Here, we present a fully integrated quantum dot array in which silicon quantum wells are co‐located with control and detection circuitry on the same die in a commercial 22‐nm fully depleted silicon‐on‐insulator (FDSOI) process. Our system comprises a two‐dimensional quantum dot array, integrated with 8 detectors and 32 injectors, operating at 3 K inside a cryo‐cooler. The power consumption of the control and detection circuitry is 2.5 mW per qubit without body biasing. The design utilizes 0.8‐V nominal devices. The setup allows us to verify discrete charge injection control and detection at the quantum dot array and demonstrate the feasibility of this architecture for scaling up the existing quantum core to hundreds and thousands of physical qubits.
- 27 September 2016
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 120 (12) , 125102
Air sensitivity of MoS2, MoSe2, MoTe2, HfS2, and HfSe2
A surface sensitivity study was performed on different transition-metal dichalcogenides (TMDs) under ambient conditions in order to understand which material is the most suitable for future device applications. Initially, Atomic Force Microscopy and Scanning Electron Microscopy studies were carried out over a period of 27 days on mechanically exfoliated flakes of 5 different TMDs, namely, MoS2, MoSe2, MoTe2, HfS2, and HfSe2. The most reactive were MoTe2 and HfSe2. HfSe2, in particular, showed surface protrusions after ambient exposure, reaching a height and width of approximately 60 nm after a single day. This study was later supplemented by Transmission Electron Microscopy (TEM) cross-sectional analysis, which showed hemispherical-shaped surface blisters that are amorphous in nature, approximately 180–240 nm tall and 420–540 nm wide, after 5 months of air exposure, as well as surface deformation in regions between these structures, related to surface oxidation. An X-ray photoelectron spectroscopy study of atmosphere exposed HfSe2 was conducted over various time scales, which indicated that the Hf undergoes a preferential reaction with oxygen as compared to the Se. Energy-Dispersive X-Ray Spectroscopy showed that the blisters are Se-rich; thus, it is theorised that HfO2 forms when the HfSe2 reacts in ambient, which in turn causes the Se atoms to be aggregated at the surface in the form of blisters. Overall, it is evident that air contact drastically affects the structural properties of TMD materials. This issue poses one of the biggest challenges for future TMD-based devices and technologies.
- 27 September 2016
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 120 (12) , 125102
Air sensitivity of MoS2, MoSe2, MoTe2, HfS2, and HfSe2
A surface sensitivity study was performed on different transition-metal dichalcogenides (TMDs) under ambient conditions in order to understand which material is the most suitable for future device applications. Initially, Atomic Force Microscopy and Scanning Electron Microscopy studies were carried out over a period of 27 days on mechanically exfoliated flakes of 5 different TMDs, namely, MoS2, MoSe2, MoTe2, HfS2, and HfSe2. The most reactive were MoTe2 and HfSe2. HfSe2, in particular, showed surface protrusions after ambient exposure, reaching a height and width of approximately 60 nm after a single day. This study was later supplemented by Transmission Electron Microscopy (TEM) cross-sectional analysis, which showed hemispherical-shaped surface blisters that are amorphous in nature, approximately 180–240 nm tall and 420–540 nm wide, after 5 months of air exposure, as well as surface deformation in regions between these structures, related to surface oxidation. An X-ray photoelectron spectroscopy study of atmosphere exposed HfSe2 was conducted over various time scales, which indicated that the Hf undergoes a preferential reaction with oxygen as compared to the Se. Energy-Dispersive X-Ray Spectroscopy showed that the blisters are Se-rich; thus, it is theorised that HfO2 forms when the HfSe2 reacts in ambient, which in turn causes the Se atoms to be aggregated at the surface in the form of blisters. Overall, it is evident that air contact drastically affects the structural properties of TMD materials. This issue poses one of the biggest challenges for future TMD-based devices and technologies.