Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Hitoshi Haga has a total of 31 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Integrated Dual Inverter for PMSM Drive Systems Under Single-Phase AC Power Supply

    by Taiju Sakurai, Hitoshi Haga

    This paper proposes a single-phase ac power supplied dual inverter integrated with a rectifier to enhance the output voltage of motor drive systems. The proposed dual inverter combines the topology of a dual inverter with a common dc bus and a four-leg inverter. The proposed configuration achieves a higher output voltage than conventional motor drive systems under an ac power supply while requiring fewer power devices than conventional dual inverters. In addition, a phase control method is introduced to suppress the modulation index at specific electrical frequencies. The proposed control method maintains a constant phase difference between the input voltage phase and the electrical angle of the motor by slightly adjusting the rotor speed reference. Experimental results show that the proposed dual inverter performs both rectification and motor drive operations, achieving a source power factor of 99.6% while controlling the rotor speed to 1700 rpm. The proposed phase control reduces the amplitude of the voltage reference by up to 55.0 % when the electrical frequency is equal to the source frequency; however, the proposed control method increases the torque ripple by 40 %. Consequently, the proposed dual inverter improves the inverter output voltage in single-phase ac power-supplied motor drive systems.


  • Open Access

    Reduction of Torque Vibration in Integrated On-board Chargers Using Stator Windings of an IPMSM

    by Yosuke Ito, Hitoshi Haga

    This study proposed a control method to reduce the torque ripple vibration of an integrated on-board charger using the windings of an interior permanent magnet synchronous motor (IPMSM). During a battery-charging operation, stopping the motor results in noise, as well as damage to the motor and other components from the torque vibration caused by the charging current. In the proposed control method, the generated torque was estimated using a back-electromotive force table, and the phase current was controlled to eliminate the torque. The proposed method can suppress torque vibration, irrespective of the angle of the rotor in the IPMSM. The effectiveness of the proposed method was verified experimentally, with the torque vibration suppressed by 94% compared with that of the conventional control method.


  • Open Access

    Comparison of Interleaved Boost Converter and Two-Phase Boost Converter Characteristics for Three-Level Inverters

    by Eiichi Sakasegawa, Rin Chishiki, Rintarou Sedutsu, Takumi Soeda, Hitoshi Haga, Ralph Mario Kennel

    A boost converter is used in various applications to obtain a higher voltage than the input voltage. One of the current main circuit systems for hybrid electric vehicles (HEVs) is a combination of a two-phase boost converter (parallel circuit) and a three-phase two-level inverter. In this study, we focus on the boost converter to achieve even higher efficiency and propose an interleaving scheme for a boost converter suitable for a three-level inverter (series circuit). The series circuit has two capacitors connected in series and makes it suitable as a power supply for a three-level inverter. We analyze the input current ripple of the series and parallel circuit in order to show the superiority of the series circuit. Furthermore, we propose a novel output voltage control strategy using an optimal regulator, namely a Linear Quadratic Regulator (LQR), for the series circuit. As a result, we found the input current ripple of the series circuit is smaller than the parallel circuit and demonstrated the superiority of the series circuit. The simulation and experimental results show the effectiveness of the proposed interleaving scheme and optimal regulator.


  • Variable State of Charge-based Power Leveling Method using Multiple Energy Storage Systems

    by Hiromi Morita, Hitoshi Haga, Yoichi Ito, Kenji Arimatsu

    This paper proposes a power-leveling method in which a lithium-ion battery and a flywheel energy storage are installed in a photovoltaic power generation plant. The proposed method is a division method that focuses on the amplitude component of the compensating power required to level the generated power of photovoltaic power generation. Furthermore, by adding the flywheel state-of-charge automatic adjustment method to the proposed method, the coverage period of the flywheel is improved. The effectiveness of the proposed method is verified on an actual 40 kW plant.


  • High-Efficiency Wide Range AC/DC Converter using Mode Transition of Six-Arm LLC

    by Hisashi Sekine, Hitoshi Haga, Yousuke Orii

    This paper proposes an LLC type AC/DC converter to achieve high efficiency for wide input voltage range. The proposed converter has four operating modes with different voltage gain characteristics depending on the ON/OFF state of the six switches. The proposed system achieves a wide range of voltage gain by switching between different operating modes. Consequently, the proposed system reduces the magnetizing current by designing a narrow voltage gain in each operating mode. Moreover, the proposed control method achieves power factor correction control of the input current and smooth transition between different operating modes. This paper analyzes the operation and voltage gain characteristics of the proposed converter. A design method to reduce the magnetizing current and the mode transition method is also explained. Based on the experimental results on a 200 W prototype, the basic operation of the proposed system is confirmed in the input voltage range of 100 V to 240 V. Furthermore, the total harmonic distortion (THD) of the input current up to the 40th order of the fundamental frequency is less than 5 % across the entire input voltage range. The efficiency of the proposed system is more than 92.5 % across the entire input voltage range.


  • Open Access

    Control Strategy for Reducing Ripple Current in DC-Link Capacitor of Single-Phase UPS

    by Takato Yamamoto, Hitoshi Haga

    This letter proposes a control strategy for reducing a ripple current in DC-link capacitor of single-phase uninterruptible power supplies (UPS). The proposed method aims to reduce the capacitor current by reducing the difference between the input and output instantaneous power. The input current waveform should satisfy harmonic current regulation and be as close as possible to the load current. Therefore, an auxiliary buck chopper was added to compensate to the ripple current in DC-link capacitor. Experimental result confirm that the proposed method reduces the RMS value of the DC-link ripple current by 27.9%.


  • Control Method of Electrolytic Capacitor-Less Dual Inverter-Fed IPMSM under Periodic Load Torque Fluctuations

    by Taiju Sakurai, Yuuki Ohno, Hitoshi Haga

    This paper proposes a control method for an electrolytic capacitor-less dual inverter for compressors. Single-phase motor drive systems are required to minimize vibrations, maintain a high power factor, and meet the limit for harmonic current emissions. The proposed control method achieves the harmonic reduction of the dq-axis currents, a high power factor, and a low grid current THD under periodic load torque fluctuations. The effectiveness of the proposed method is demonstrated via experimental results, using an open-end winding IPMSM and an electrolytic capacitor-less dual inverter. The proposed method reduced the 100 Hz harmonic components of dq-axis currents up to 98% under periodic load torque fluctuations compared with an electrolytic capacitor-less single inverter. The results of FFT analysis of the input current show that the power factor and input current THD of the proposed method are equivalent to or superior to those of conventional methods. Therefore, the proposed control method can effectively achieve vibration reduction, a high power factor, and a reduction in the input current THD under periodic load torque fluctuations.


  • Reducing DC-Link Current Harmonics in Dual-Inverter Fed Induction Motor with Lower-Voltage Rating Inverter

    by Akihito Mizukoshi, Hitoshi Haga

    This letter proposes a control method to reduce the high-order harmonics caused by pulse-width modulation (PWM) in the DC-link current in a dual inverter with a floating capacitor topology, which has the same voltage ratings in two inverters. The proposed control method reduces the high-order harmonic current through a six-step operation at the primary inverter. The secondary inverter supplies a sinusoidal voltage to the motor using a low-rated voltage. The validity of the proposed control method is confirmed through an experiment using an open-end winding induction motor. Furthermore, the floating capacitor voltage dependencies of the input current harmonics are analyzed.


  • Voltage Harmonic Analysis of Typical PWM Strategies in a Dual Inverter with Floating Capacitor in the Partial-Load Condition

    by Akihito Mizukoshi, Hitoshi Haga

    This study aims to reduce the voltage harmonics, caused by pulse width modulation (PWM) in a dual inverter with a floating capacitor topology in the partial-load condition. This work provides an analysis strategy for the output voltage harmonics, which depend on the fundamental voltage, power factor angle, and PWM strategies. Herein, sinusoidal PWM (SPWM), third harmonic injection PWM (THIPWM), and discontinuous PWM (DPWM) are used as the conventional carrier-based modulation techniques, and space vector PWM (SVPWM) and near-state PWM (NSPWM) with reduced number of commutations are used as the proposed modulation methods. The validity of the theoretical analysis is then confirmed by experiments using an open-end winding induction motor. The voltage total harmonic distortion (THD) is reduced by maximizing the modulation indices of both inverters in each modulation method; the experimental results show that voltage THD reductions of 10.9% with NSPWM and 17.3% with SVPWM can be obtained compared with that of SPWM. The total efficiency, including the inverter and motor efficiencies, is improved by up to 2.6% in the low load region (at a torque of 0.5 Nm and fundamental frequency of 10 Hz) when using the SVPWM.


  • Control Method of Electrolytic Capacitorless Dual Inverter for Harmonic Compensation Under Distorted Grid Voltage

    by Yuuki Ohno, Hitoshi Haga

    This paper proposes a harmonic compensation method using an open-end winding IPMSM driven by an electrolytic capacitor-less dual inverter under grid disturbances. In a conventional electrolytic capacitor-less single inverter, harmonic currents are superimposed on the output current of the inverter owing to the increase in the DC-link voltage ripple caused by grid disturbances. Consequently, the reliability of the motor drive system is reduced, and the torque ripple causes mechanical vibrations. The proposed harmonic compensation method estimates the harmonic voltage and outputs it using a compensating inverter. The experimental results show that peak-to-peak of the motor current and the 150 Hz component of the shaft torque are reduced by 10.3 and 92.4 %, respectively, compared to the conventional system under unbalanced input voltage. Therefore, the improvement of reliability of a motor drive system and reduction of the torque ripple are achieved without an energy buffer under grid disturbances.