Valérie Desauziers
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Valérie Desauziers has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
- Herve Plaisance
IPREM, IMT Mines Ales, Université de Pau Et Des Pays de L’Adour, CNRS, Pau, France
4 shared publications Hervé Plaisance
3 shared publicationsBarbara Le Bot
2 shared publications- Benoit Schmitt
Scientific and Technical Center for Building (CSTB), Health and Comfort Department, Saint-Martin-d'Hères, 38400, France; IPREM, IMT Mines Alès, Universite de Pau et des Pays de l'Adour, CNRS, Pau, 64000, France
2 shared publications Clemence Rawas
2 shared publicationsEmilie Bossanne
2 shared publications
Latest Publications
- Open Access
- 7 February 2026
- Published by Elsevier in Building and Environment
- Vol. 293
Characterization of volatile and semi-volatile organic compounds in the air of sports facilities
- 7 February 2026
- Published by Elsevier in Building and Environment
- Vol. 293
Open AccessCharacterization of volatile and semi-volatile organic compounds in the air of sports facilities
- Open Access
- 4 February 2026
- Published by Elsevier in Atmospheric Environment
- Vol. 371
Equilibrium partition coefficients of semi-volatile organic compounds (SVOCs) between indoor surfaces and air assessed using two experimental methods
- 4 February 2026
- Published by Elsevier in Atmospheric Environment
- Vol. 371
Open AccessEquilibrium partition coefficients of semi-volatile organic compounds (SVOCs) between indoor surfaces and air assessed using two experimental methods
- 17 July 2025
- Published by Elsevier in Chemosphere
- Vol. 385, 144564
Development of measurement method for estimating gas-phase concentration of SVOCs in equilibrium with the source material surface at any temperature
- 17 July 2025
- Published by Elsevier in Chemosphere
- Vol. 385, 144564
Development of measurement method for estimating gas-phase concentration of SVOCs in equilibrium with the source material surface at any temperature
- Open Access
- 15 July 2025
- Published by Elsevier in Building and Environment
- Vol. 284
Carbon dioxide sorption in earthen plasters and its impact on Indoor Air Quality
- 15 July 2025
- Published by Elsevier in Building and Environment
- Vol. 284
Open AccessCarbon dioxide sorption in earthen plasters and its impact on Indoor Air Quality
- 8 November 2024
- Published by Elsevier in Building and Environment
- Vol. 267
Kinetic analysis of TCPP emission from fireproofed upholstered furniture under realistic indoor conditions
- 8 November 2024
- Published by Elsevier in Building and Environment
- Vol. 267
Kinetic analysis of TCPP emission from fireproofed upholstered furniture under realistic indoor conditions
- Open Access
- 12 August 2019
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 26 (29) , 29679-29686
Evidence of indoor sinks for formaldehyde through the field measurements using passive flux sampler and mass balance
A measurement campaign was conducted in 24 student rooms where formaldehyde emissions from all the indoor surfaces were measured using a passive flux sampler (PFS) parallel to monitoring of indoor and outdoor concentrations as well as the assessment of air exchange rate. Two mass balance models were used to predict indoor concentrations basing on input data recorded during this measurement campaign. The first model only takes into account the total emission from the indoor sources and the incoming and outgoing flows of compound brought by the air exchange rate. The second model added to these terms a further component related to the overall rate of removal processes (or “indoor sinks”) which was assessed in these same rooms during a previous field test campaign. A good agreement was found between the concentrations calculated by the model with the component relative to indoor removal processes and the measured concentrations. On the other hand, the predicted concentrations with a first model tend to highly overestimate the measured concentrations by a factor 1.9 on average. Apportionment of formaldehyde inputs and losses in the rooms was estimated and discussed. The results highlighted that indoor removal processes are a component to consider for formaldehyde budget indoors.
- 12 August 2019
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 26 (29) , 29679-29686
Open AccessEvidence of indoor sinks for formaldehyde through the field measurements using passive flux sampler and mass balance
A measurement campaign was conducted in 24 student rooms where formaldehyde emissions from all the indoor surfaces were measured using a passive flux sampler (PFS) parallel to monitoring of indoor and outdoor concentrations as well as the assessment of air exchange rate. Two mass balance models were used to predict indoor concentrations basing on input data recorded during this measurement campaign. The first model only takes into account the total emission from the indoor sources and the incoming and outgoing flows of compound brought by the air exchange rate. The second model added to these terms a further component related to the overall rate of removal processes (or “indoor sinks”) which was assessed in these same rooms during a previous field test campaign. A good agreement was found between the concentrations calculated by the model with the component relative to indoor removal processes and the measured concentrations. On the other hand, the predicted concentrations with a first model tend to highly overestimate the measured concentrations by a factor 1.9 on average. Apportionment of formaldehyde inputs and losses in the rooms was estimated and discussed. The results highlighted that indoor removal processes are a component to consider for formaldehyde budget indoors.
- 22 March 2017
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Processes & Impacts
- Vol. 19 (5) , 696-710
Volatile organic compounds concentrations during the construction process in newly-built timber-frame houses: source identification and emission kinetics
Building and furniture materials are known to be major sources of volatile organic compounds (VOCs) indoors. During the construction process, an introduced material can have a more or less long-term impact on the indoor air quality according to the building characteristics. In this study, field measurements were carried out at six construction stages in three energy-efficient timber-frame houses. Data analysis focused on the ten most abundant compounds found among an initial list of fifteen target VOCs, namely formaldehyde, acetaldehyde, hexanal, toluene, m/p-xylenes, ethylbenzene, styrene, α-pinene, 3-carene and D-limonene. The chemical compositions and concentration variation patterns were recorded. The results showed a high pollution count, with m/p-xylenes and ethylbenzene concentrations ranging from 1900 to 5100 μg m−3 occurring at the time of the structural work (representing more than 88% of the sum of the target VOCs). Emission tests done on a large number of materials used in the construction revealed that this pollution is due to the emissions from the polyurethane adhesive mastic used as a sealing material. The emission kinetics of polyurethane adhesive mastic was assessed alone and also within a material assembly reconstituting a room wall. The results showed that the superposition of materials led to a slowing down of the VOC emission process from polyurethane adhesive mastic, which explains the concentration decays recorded in houses during the construction process. At the final construction stage, the concentration levels were low for all compounds (the sums of the target VOCs were between 18 and 32 μg m−3), with the aldehydes (formaldehyde, acetaldehyde and hexanal) now becoming the major fraction in the chemical composition in the last stages of construction (representing 50–70% of the sum of the target VOCs). This is in agreement with the fact that the sources of aldehydes are the most numerous among the materials and have rather slow emission kinetics.
- 22 March 2017
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Processes & Impacts
- Vol. 19 (5) , 696-710
Volatile organic compounds concentrations during the construction process in newly-built timber-frame houses: source identification and emission kinetics
Building and furniture materials are known to be major sources of volatile organic compounds (VOCs) indoors. During the construction process, an introduced material can have a more or less long-term impact on the indoor air quality according to the building characteristics. In this study, field measurements were carried out at six construction stages in three energy-efficient timber-frame houses. Data analysis focused on the ten most abundant compounds found among an initial list of fifteen target VOCs, namely formaldehyde, acetaldehyde, hexanal, toluene, m/p-xylenes, ethylbenzene, styrene, α-pinene, 3-carene and D-limonene. The chemical compositions and concentration variation patterns were recorded. The results showed a high pollution count, with m/p-xylenes and ethylbenzene concentrations ranging from 1900 to 5100 μg m−3 occurring at the time of the structural work (representing more than 88% of the sum of the target VOCs). Emission tests done on a large number of materials used in the construction revealed that this pollution is due to the emissions from the polyurethane adhesive mastic used as a sealing material. The emission kinetics of polyurethane adhesive mastic was assessed alone and also within a material assembly reconstituting a room wall. The results showed that the superposition of materials led to a slowing down of the VOC emission process from polyurethane adhesive mastic, which explains the concentration decays recorded in houses during the construction process. At the final construction stage, the concentration levels were low for all compounds (the sums of the target VOCs were between 18 and 32 μg m−3), with the aldehydes (formaldehyde, acetaldehyde and hexanal) now becoming the major fraction in the chemical composition in the last stages of construction (representing 50–70% of the sum of the target VOCs). This is in agreement with the fact that the sources of aldehydes are the most numerous among the materials and have rather slow emission kinetics.