Athanasios K. Karamalidis
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Athanasios K. Karamalidis has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
Evangelos A. Voudrias
Department of Environmental Engineering, Democritus University of Thrace, GR 671 00 Xanthi, Greece
3 shared publicationsA.C. Evangelou
1 shared publicationA.I. Koukkou
1 shared publicationC. Drainas
1 shared publicationE Voudrias
1 shared publicationE. Karabika
1 shared publication
Latest Publications
- 1 August 2010
- Published by Elsevier in Bioresource Technology
- Vol. 101 (16) , 6545-6552
Laboratory scale bioremediation of petroleum-contaminated soil by indigenous microorganisms and added Pseudomonas aeruginosa strain Spet
- 1 August 2010
- Published by Elsevier in Bioresource Technology
- Vol. 101 (16) , 6545-6552
Laboratory scale bioremediation of petroleum-contaminated soil by indigenous microorganisms and added Pseudomonas aeruginosa strain Spet
- 9 July 2008
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 42 (16) , 6124-6130
Anion Leaching from Refinery Oily Sludge and Ash from Incineration of Oily Sludge Stabilized/Solidified with Cement. Part II. Modeling
This paper presents the modeling of anion leaching (SO42− and CrO42−) from refinery oily sludge and ash produced by incineration of oily sludge, stabilized/solidified (s/s) with two types of cement, I42.5 and II42.5. Anion leaching was examined using a sequential toxicity characteristic leaching procedure (TCLP) test. To elucidate the mechanisms of sulfate and chromate leaching, we employed Visual MINTEQ, incorporating a multiple-problem setup. Specifically, 10−14 different problems, depending on the pH range of the leachates, were connected together in the same run. Each problem corresponded to one pH value of the leachate and the model run covered the pH range of the five sequential TCLP extractions. This modeling approach was tested using chemical equilibrium with or without sorption onto ferrihydrite. Good agreement between experimental and modeling results was obtained for sulfate leaching from solidified oily sludge and ash, considering surface complexation onto ferrihydrite on top of chemical equilibrium controlled by gypsum at pH 11. Chromate leaching was described by chemical equilibrium, controlled by CaCrO4(s) (at pH 11).
- 9 July 2008
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 42 (16) , 6124-6130
Anion Leaching from Refinery Oily Sludge and Ash from Incineration of Oily Sludge Stabilized/Solidified with Cement. Part II. Modeling
This paper presents the modeling of anion leaching (SO42− and CrO42−) from refinery oily sludge and ash produced by incineration of oily sludge, stabilized/solidified (s/s) with two types of cement, I42.5 and II42.5. Anion leaching was examined using a sequential toxicity characteristic leaching procedure (TCLP) test. To elucidate the mechanisms of sulfate and chromate leaching, we employed Visual MINTEQ, incorporating a multiple-problem setup. Specifically, 10−14 different problems, depending on the pH range of the leachates, were connected together in the same run. Each problem corresponded to one pH value of the leachate and the model run covered the pH range of the five sequential TCLP extractions. This modeling approach was tested using chemical equilibrium with or without sorption onto ferrihydrite. Good agreement between experimental and modeling results was obtained for sulfate leaching from solidified oily sludge and ash, considering surface complexation onto ferrihydrite on top of chemical equilibrium controlled by gypsum at pH 11. Chromate leaching was described by chemical equilibrium, controlled by CaCrO4(s) (at pH 11).
- 4 July 2008
- Published by Taylor & Francis in Journal of Environmental Science and Health, Part A
- Vol. 43 (10) , 1144-1156
Characterization of stabilized/solidified refinery oily sludge and incinerated refinery sludge with cement using XRD, SEM and EXAFS
Solidification/stabilization (S/S) of refinery oily sludge and incinerated oily sludge (ash) with cement type I42.5 and II42.5 was investigated using, X-Ray Diffraction (XRD), Scanning Electron Microscopy (SEM) combined with Energy Dispersive Spectroscopy (EDS) and Extended X-ray Absorption Fine Structure (EXAFS). The results showed that delayed ettringite formation (DEF) and major cement hydration reactions occurred. XRD analysis of S/S oily sludge samples revealed cement-bearing solid phases, such as portlandite, calcite, C3S, C2S and C4AF. SEM analysis, confirmed ettringite at solidified oily sludge samples. Solidified ash samples contained ettringite substituted by chromates. However, solid phases found in solidified ash samples with I42.5 cement showed minor variation in type and structure compared to those observed in solidified ash samples with II42.5 cement. Fe K edge EXAFS analysis revealed the presence of iron oxides in both S/S wastes. The comparison between spectra of the S/S resulting materials and the ones of their original components, showed that the first sphere Fe–O distances were longer than in the pure iron oxide thereby providing evidence that the resulting materials were not simple mixtures, but products of a reaction that modified the local environment of iron.
- 4 July 2008
- Published by Taylor & Francis in Journal of Environmental Science and Health, Part A
- Vol. 43 (10) , 1144-1156
Characterization of stabilized/solidified refinery oily sludge and incinerated refinery sludge with cement using XRD, SEM and EXAFS
Solidification/stabilization (S/S) of refinery oily sludge and incinerated oily sludge (ash) with cement type I42.5 and II42.5 was investigated using, X-Ray Diffraction (XRD), Scanning Electron Microscopy (SEM) combined with Energy Dispersive Spectroscopy (EDS) and Extended X-ray Absorption Fine Structure (EXAFS). The results showed that delayed ettringite formation (DEF) and major cement hydration reactions occurred. XRD analysis of S/S oily sludge samples revealed cement-bearing solid phases, such as portlandite, calcite, C3S, C2S and C4AF. SEM analysis, confirmed ettringite at solidified oily sludge samples. Solidified ash samples contained ettringite substituted by chromates. However, solid phases found in solidified ash samples with I42.5 cement showed minor variation in type and structure compared to those observed in solidified ash samples with II42.5 cement. Fe K edge EXAFS analysis revealed the presence of iron oxides in both S/S wastes. The comparison between spectra of the S/S resulting materials and the ones of their original components, showed that the first sphere Fe–O distances were longer than in the pure iron oxide thereby providing evidence that the resulting materials were not simple mixtures, but products of a reaction that modified the local environment of iron.
- 1 June 2008
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 134 (6) , 493-504
Leaching Behavior of Metals Released from Cement-Stabilized/Solidified Refinery Oily Sludge by Means of Sequential Toxicity Characteristic Leaching Procedure
In this study, stabilization/solidification (S/S) of refinery oily sludge was applied using two types of cement (I and II), in cement-to-waste ratio from 0.1 to 0.7. The leaching behavior of heavy metals was investigated, by means of a five-point sequential toxicity characteristic leaching procedure (TCLP) test. Sequential TCLP was used to provide an improved assessment of long-term contaminant potential leachability, because the acidic leachant is renewed, whereas in the single TCLP, contaminant leachability is limited by the pH neutralization of the alkaline binder. Cement-based S/S of real refinery oily sludge resulted in very low leachability of heavy metals. Pb and Cd were not detected in any TCLP leachate. The maximum leachability of Fe, Zn, and Ni occurred in the pH range between 5.5 and 6.5. The leachability of Cu and Cr increased with increasing pH. Maximum cumulative percentage of Fe, Ni, and Zn leaching after five consecutive TCLP extractions (for worst case conditions, i.e., 10% II42.5) were 0...
- 1 June 2008
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 134 (6) , 493-504
Leaching Behavior of Metals Released from Cement-Stabilized/Solidified Refinery Oily Sludge by Means of Sequential Toxicity Characteristic Leaching Procedure
In this study, stabilization/solidification (S/S) of refinery oily sludge was applied using two types of cement (I and II), in cement-to-waste ratio from 0.1 to 0.7. The leaching behavior of heavy metals was investigated, by means of a five-point sequential toxicity characteristic leaching procedure (TCLP) test. Sequential TCLP was used to provide an improved assessment of long-term contaminant potential leachability, because the acidic leachant is renewed, whereas in the single TCLP, contaminant leachability is limited by the pH neutralization of the alkaline binder. Cement-based S/S of real refinery oily sludge resulted in very low leachability of heavy metals. Pb and Cd were not detected in any TCLP leachate. The maximum leachability of Fe, Zn, and Ni occurred in the pH range between 5.5 and 6.5. The leachability of Cu and Cr increased with increasing pH. Maximum cumulative percentage of Fe, Ni, and Zn leaching after five consecutive TCLP extractions (for worst case conditions, i.e., 10% II42.5) were 0...
- 1 September 2007
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 148 (1-2) , 122-135
Cement-based stabilization/solidification of oil refinery sludge: Leaching behavior of alkanes and PAHs
- 1 September 2007
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 148 (1-2) , 122-135
Cement-based stabilization/solidification of oil refinery sludge: Leaching behavior of alkanes and PAHs
- 22 March 2007
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 141 (3) , 591-606
Release of Zn, Ni, Cu, SO42− and CrO42− as a function of pH from cement-based stabilized/solidified refinery oily sludge and ash from incineration of oily sludge
- 22 March 2007
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 141 (3) , 591-606
Release of Zn, Ni, Cu, SO42− and CrO42− as a function of pH from cement-based stabilized/solidified refinery oily sludge and ash from incineration of oily sludge