Ali El Yaakoubi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ali El Yaakoubi has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
Adel Asselman
Optics & Photonics Team, Faculty of Sciences, Abdelmalek Essaadi University, Tétouan, Morocco
8 shared publications- Lahcen Amhaimar
Modeling and Simulation of Intelligent Industrial Systems Laboratory, Design, Information Technology and Artificial Intelligence Team, ENSAD, ENSET, Hassan II University of Casablanca, Casablanca 28830, Morocco
4 shared publications A. Asselman
3 shared publicationsK. Attari
3 shared publicationsKamal Attari
3 shared publications- Kamal Attari
Optics & Photonics Team, Faculty of Sciences, Abdelmalek Essaadi University, Tétouan, Morocco
3 shared publications
Latest Publications
- 8 April 2023
- Published by Elsevier in Ocean Engineering
- Vol. 278
Wind turbines dynamics loads alleviation: Overview of the active controls and the corresponding strategies
- 8 April 2023
- Published by Elsevier in Ocean Engineering
- Vol. 278
Wind turbines dynamics loads alleviation: Overview of the active controls and the corresponding strategies
- Open Access
- 15 April 2020
- Published by IntechOpen
Wind Energy Conversion System Modeling toward Different Approaches
The main focus of this chapter is to modeling the different parts of the wind energy conversion system (WECS) and reviewing the different approaches used in this context. The chapter starts with the aerodynamic and the structural modeling of the wind turbines (WTs), and a description of the steps used to derive a linear time invariant (LTI) model. Thereafter, the chapter introduces models of the electrical actuators in the three phases (abc) and park phases (dq) reference frames, and recalls the assumptions considered. The chapter finishes by presenting the pulse width modulation (PWM) control strategy, the power converters and the pitch actuator models.
- 15 April 2020
- Published by IntechOpen
Open AccessWind Energy Conversion System Modeling toward Different Approaches
The main focus of this chapter is to modeling the different parts of the wind energy conversion system (WECS) and reviewing the different approaches used in this context. The chapter starts with the aerodynamic and the structural modeling of the wind turbines (WTs), and a description of the steps used to derive a linear time invariant (LTI) model. Thereafter, the chapter introduces models of the electrical actuators in the three phases (abc) and park phases (dq) reference frames, and recalls the assumptions considered. The chapter finishes by presenting the pulse width modulation (PWM) control strategy, the power converters and the pitch actuator models.
- Open Access
- 1 November 2019
- Published by Elsevier in Energy Reports
- Vol. 5, 545-554
Non-linear and intelligent maximum power point tracking strategies for small size wind turbines: Performance analysis and comparison
- 1 November 2019
- Published by Elsevier in Energy Reports
- Vol. 5, 545-554
Open AccessNon-linear and intelligent maximum power point tracking strategies for small size wind turbines: Performance analysis and comparison
- Open Access
- 10 October 2018
- Published by Association for Computing Machinery (ACM)
- p. 1-5
Advanced control strategies of SCIG based wind turbines for MPPT
- 10 October 2018
- Published by Association for Computing Machinery (ACM)
- p. 1-5
Open AccessAdvanced control strategies of SCIG based wind turbines for MPPT
- Open Access
- 3 September 2018
- Published by Wiley in Journal of Electrical and Computer Engineering
- Vol. 2018, 1-11
PAPR Reduction Using Fireworks Search Optimization Algorithm in MIMO-OFDM Systems
The transceiver combination technology, of orthogonal frequency division multiplexing (OFDM) with multiple-input multiple-output (MIMO), provides a viable alternative to enhance the quality of service and simultaneously to achieve high spectral efficiency and data rate for wireless mobile communication systems. However, the high peak-to-average power ratio (PAPR) is the main concern that should be taken into consideration in the MIMO-OFDM system. Partial transmit sequences (PTSs) is a promising scheme and straightforward method, able to achieve an effective PAPR reduction performance, but it requires an exhaustive search to find the optimum phase factors, which causes high computational complexity increased with the number of subblocks. In this paper, a reduced computational complexity PTS scheme is proposed, based on a novel swarm intelligence algorithm, called fireworks algorithm (FWA). Simulation results confirmed the adequacy and the effectiveness of the proposed method which can effectively reduce the computation complexity while keeping good PAPR reduction. Moreover, it turns out from the results that the proposed PTS scheme-based FWA clearly outperforms the hottest and most important evolutionary algorithm in the literature like simulated annealing (SA), particle swarm optimization (PSO), and genetic algorithm (GA).
- 3 September 2018
- Published by Wiley in Journal of Electrical and Computer Engineering
- Vol. 2018, 1-11
Open AccessPAPR Reduction Using Fireworks Search Optimization Algorithm in MIMO-OFDM Systems
The transceiver combination technology, of orthogonal frequency division multiplexing (OFDM) with multiple-input multiple-output (MIMO), provides a viable alternative to enhance the quality of service and simultaneously to achieve high spectral efficiency and data rate for wireless mobile communication systems. However, the high peak-to-average power ratio (PAPR) is the main concern that should be taken into consideration in the MIMO-OFDM system. Partial transmit sequences (PTSs) is a promising scheme and straightforward method, able to achieve an effective PAPR reduction performance, but it requires an exhaustive search to find the optimum phase factors, which causes high computational complexity increased with the number of subblocks. In this paper, a reduced computational complexity PTS scheme is proposed, based on a novel swarm intelligence algorithm, called fireworks algorithm (FWA). Simulation results confirmed the adequacy and the effectiveness of the proposed method which can effectively reduce the computation complexity while keeping good PAPR reduction. Moreover, it turns out from the results that the proposed PTS scheme-based FWA clearly outperforms the hottest and most important evolutionary algorithm in the literature like simulated annealing (SA), particle swarm optimization (PSO), and genetic algorithm (GA).
- 31 July 2018
- Published by Praise Worthy Prize in International Review of Automatic Control (IREACO)
- Vol. 11 (4) , 174
Adaptive State Feedback Pitch Angle Control of Wind Turbines for Speed Regulation and Blades Loadings Alleviation
This research article presents an adaptive state feedback blades pitch control of wind turbines for speed regulation and structural blades loadings mitigation in high wind speeds. The proposed control is a combination of a state feedback control and an integrator. It enables to improve the generator speed tracking, as well as to reduce the flap-wise bending moment at the root of the blades. The motivation principal of the proposed controller is that its structure allows surpassing the trade-off between the control objectives. The control scheme is tested on the NREL’s FAST 5 MW baseline wind turbine model in MATLAB/Simulink under different wind speed profiles and its performances are compared with those of the baseline gain scheduling proportional integral (GSPI) control and the disturbance accommodation control (DAC). The simulation results enable to conclude that the proposed controller has good performances in term of generator speed tracking as well as blade root flap-wise bending moment fluctuations reduction. Moreover, the controller is tested to be robust under system uncertainties. Copyright © 2018 Praise Worthy Prize - All rights reserved.
- 31 July 2018
- Published by Praise Worthy Prize in International Review of Automatic Control (IREACO)
- Vol. 11 (4) , 174
Adaptive State Feedback Pitch Angle Control of Wind Turbines for Speed Regulation and Blades Loadings Alleviation
This research article presents an adaptive state feedback blades pitch control of wind turbines for speed regulation and structural blades loadings mitigation in high wind speeds. The proposed control is a combination of a state feedback control and an integrator. It enables to improve the generator speed tracking, as well as to reduce the flap-wise bending moment at the root of the blades. The motivation principal of the proposed controller is that its structure allows surpassing the trade-off between the control objectives. The control scheme is tested on the NREL’s FAST 5 MW baseline wind turbine model in MATLAB/Simulink under different wind speed profiles and its performances are compared with those of the baseline gain scheduling proportional integral (GSPI) control and the disturbance accommodation control (DAC). The simulation results enable to conclude that the proposed controller has good performances in term of generator speed tracking as well as blade root flap-wise bending moment fluctuations reduction. Moreover, the controller is tested to be robust under system uncertainties. Copyright © 2018 Praise Worthy Prize - All rights reserved.
- Open Access
- 1 January 2018
- Published by Elsevier in Procedia Manufacturing
- Vol. 22, 667-674
Performance investigation of a PV system connected to the grid
- 1 January 2018
- Published by Elsevier in Procedia Manufacturing
- Vol. 22, 667-674
Open AccessPerformance investigation of a PV system connected to the grid
- Open Access
- 12 November 2017
- Published by Wiley in International Journal of Photoenergy
- Vol. 2017, 1-7
The Design and Optimization of GaAs Single Solar Cells Using the Genetic Algorithm and Silvaco ATLAS
Single-junction solar cells are the most available in the market and the most simple in terms of the realization and fabrication comparing to the other solar devices. However, these single-junction solar cells need more development and optimization for higher conversion efficiency. In addition to the doping densities and compromises between different layers and their best thickness value, the choice of the materials is also an important factor on improving the efficiency. In this paper, an efficient single-junction solar cell model of GaAs is presented and optimized. In the first step, an initial model was simulated and then the results were processed by an algorithm code. In this work, the proposed optimization method is a genetic search algorithm implemented in Matlab receiving ATLAS data to generate an optimum output power solar cell. Other performance parameters such as photogeneration rates, external quantum efficiency (EQE), and internal quantum efficiency (EQI) are also obtained. The simulation shows that the proposed method provides significant conversion efficiency improvement of 29.7% under AM1.5G illumination. The other results were Jsc = 34.79 mA/cm2, Voc = 1 V, and fill factor (FF) = 85%.
- 12 November 2017
- Published by Wiley in International Journal of Photoenergy
- Vol. 2017, 1-7
Open AccessThe Design and Optimization of GaAs Single Solar Cells Using the Genetic Algorithm and Silvaco ATLAS
Single-junction solar cells are the most available in the market and the most simple in terms of the realization and fabrication comparing to the other solar devices. However, these single-junction solar cells need more development and optimization for higher conversion efficiency. In addition to the doping densities and compromises between different layers and their best thickness value, the choice of the materials is also an important factor on improving the efficiency. In this paper, an efficient single-junction solar cell model of GaAs is presented and optimized. In the first step, an initial model was simulated and then the results were processed by an algorithm code. In this work, the proposed optimization method is a genetic search algorithm implemented in Matlab receiving ATLAS data to generate an optimum output power solar cell. Other performance parameters such as photogeneration rates, external quantum efficiency (EQE), and internal quantum efficiency (EQI) are also obtained. The simulation shows that the proposed method provides significant conversion efficiency improvement of 29.7% under AM1.5G illumination. The other results were Jsc = 34.79 mA/cm2, Voc = 1 V, and fill factor (FF) = 85%.
- 24 March 2017
- Published by Springer Nature in Frontiers in Energy
- Vol. 13 (4) , 742-756
Novel power capture optimization based sensorless maximum power point tracking strategy and internal model controller for wind turbines systems driven SCIG
- 24 March 2017
- Published by Springer Nature in Frontiers in Energy
- Vol. 13 (4) , 742-756
Novel power capture optimization based sensorless maximum power point tracking strategy and internal model controller for wind turbines systems driven SCIG
- Open Access
- 1 January 2017
- Published by Elsevier in Procedia Engineering
- Vol. 181, 810-817
Comparative Performance Investigation Between Photovoltaic Systems from two Different Cities
- 1 January 2017
- Published by Elsevier in Procedia Engineering
- Vol. 181, 810-817
Open AccessComparative Performance Investigation Between Photovoltaic Systems from two Different Cities