Zhichao Sun
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Zhichao Sun has a total of 75 co-authors. Here are the top co-authors by number of shared publications:
- Ying-Ya Liu
State Key Laboratory of Fine Chemicals, School of Chemical Engineering, Dalian University of Technology, Dalian 116024, P. R. China
21 shared publications - Anjie Wang
State Key Laboratory of Fine Chemicals, School of Chemical Engineering, Dalian University of Technology, Dalian 116024, P. R. China
18 shared publications - Yao Wang
State Key Laboratory of Fine Chemicals, School of Chemical Engineering
15 shared publications - Chong Peng
Dalian University of Technology
9 shared publications Wei Wang
School of Chemical and Biological Engineering
4 shared publicationsZhiquan Yu
School of Chemical Engineering, State Key Laboratory of Fine Chemicals, and Liaoning Key Laboratory of Petrochemical Technology and Equipments, Dalian University of Technology, Dalian, 116024, P. R. China
4 shared publications
Latest Publications
- 15 September 2026
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 62 (72) , 17938-17942
Boosting furfural selective hydrogenation over Pt/MIL-100 via solvent-driven wettability modulation
Solvent-driven wettability in Pt@MIL-100 enriches furfural at confined Pt sites, enabling fast, selective room-temperature hydrogenation to furfuryl alcohol without structural modification.
- 15 September 2026
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 62 (72) , 17938-17942
Boosting furfural selective hydrogenation over Pt/MIL-100 via solvent-driven wettability modulation
Solvent-driven wettability in Pt@MIL-100 enriches furfural at confined Pt sites, enabling fast, selective room-temperature hydrogenation to furfuryl alcohol without structural modification.
- 21 August 2026
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
Self-Bound Hierarchical Beta Zeolite Catalysts: Engineering Intracrystalline Mesopores for High-Efficiency Tetralin Hydrocracking
Beta zeolite is widely used for the deep conversion of heavy oils (e.g., hydrocracking) owing to its strong acidity and suitable pore architecture; however, its purely microporous channels impose severe diffusion limitations for bulky molecules, restricting industrial performance. Herein, a predominantly crystalline shaped Beta zeolite catalyst with a tunable hierarchical pore network is developed by coupling TEAOH-induced secondary crystallization with a surfactant-assisted soft-templating strategy. This synergistic approach enables in situ binder-to-zeolite transformation while generating intracrystalline mesopores, yielding shaped bodies with high mechanical strength, tunable acidity, and interconnected micro-mesoporous pathways. A dual-template strategy is further developed, enabling fine-tuning of the mesoporosity. The superiority of pore engineering of shaped zeolite is further demonstrated in tetralin hydrocracking as a model reaction. The optimized 70BSi-0.6T-C catalyst achieves significantly enhanced performance, with a tetralin conversion of 94.9% and a high BTX yield of 28.5% at 380 °C and a high weight hourly space velocity of 8.0 h–1, markedly outperforming the untreated counterpart. The improved catalytic behavior is attributed to the synergistic effects of binder-to-zeolite transformation, restoration of Brønsted acidity, and enhanced mass transport enabled by intracrystalline mesopores. This work provides a general and scalable strategy for constructing industrially relevant hierarchical zeolite catalysts, offering improved activity and selectivity for the hydroconversion of bulky molecules.
- 21 August 2026
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
Self-Bound Hierarchical Beta Zeolite Catalysts: Engineering Intracrystalline Mesopores for High-Efficiency Tetralin Hydrocracking
Beta zeolite is widely used for the deep conversion of heavy oils (e.g., hydrocracking) owing to its strong acidity and suitable pore architecture; however, its purely microporous channels impose severe diffusion limitations for bulky molecules, restricting industrial performance. Herein, a predominantly crystalline shaped Beta zeolite catalyst with a tunable hierarchical pore network is developed by coupling TEAOH-induced secondary crystallization with a surfactant-assisted soft-templating strategy. This synergistic approach enables in situ binder-to-zeolite transformation while generating intracrystalline mesopores, yielding shaped bodies with high mechanical strength, tunable acidity, and interconnected micro-mesoporous pathways. A dual-template strategy is further developed, enabling fine-tuning of the mesoporosity. The superiority of pore engineering of shaped zeolite is further demonstrated in tetralin hydrocracking as a model reaction. The optimized 70BSi-0.6T-C catalyst achieves significantly enhanced performance, with a tetralin conversion of 94.9% and a high BTX yield of 28.5% at 380 °C and a high weight hourly space velocity of 8.0 h–1, markedly outperforming the untreated counterpart. The improved catalytic behavior is attributed to the synergistic effects of binder-to-zeolite transformation, restoration of Brønsted acidity, and enhanced mass transport enabled by intracrystalline mesopores. This work provides a general and scalable strategy for constructing industrially relevant hierarchical zeolite catalysts, offering improved activity and selectivity for the hydroconversion of bulky molecules.
- 28 July 2026
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 65 (31) , 16548-16556
Pt–Ni Bimetallic Catalysts with High Catalytic Activity for the Hydrogenation of Dibenzyltoluene
Liquid organic hydrogen carriers (LOHCs) have attracted increasing attention in recent years for their hydrogen-storage potential; among them, dibenzyltoluene (DBT) is one of the most promising candidates. Supported Pt catalysts have been widely used for DBT hydrogenation, yet the high Pt loading required becomes a major cost barrier to its scale-up. Herein, we report an Al2O3-supported Pt–Ni bimetallic catalyst containing only 0.5 wt % Pt that, under mild conditions (120 °C, 2.5 MPa), delivers 100% DBT conversion with 99.4% selectivity. Comprehensive characterizations (transmission electron microscope (TEM), X-ray photoelectron spectroscopy (XPS), H2 temperature-programmed desorption (H2-TPD), and in situ diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS)) reveal that the enhanced activity originates from (i) electron transfer from Pt species to Ni, which modifies the electronic structure of the Ni sites and strengthen the Ni–H bonds; (ii) the formation of smaller and highly dispersed Ni nanoparticles (NPs), promoted by Pt introduction; and (iii) suppressed desorption of reaction intermediates upon Pt incorporation, together with accelerated hydrogen spillover that facilitates the migration of active H* species and improves DBT conversion efficiency. Consequently, the catalyst maintains superior hydrogenation performance, offering a practical route toward low-cost DBT-based hydrogen storage.
- 28 July 2026
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 65 (31) , 16548-16556
Pt–Ni Bimetallic Catalysts with High Catalytic Activity for the Hydrogenation of Dibenzyltoluene
Liquid organic hydrogen carriers (LOHCs) have attracted increasing attention in recent years for their hydrogen-storage potential; among them, dibenzyltoluene (DBT) is one of the most promising candidates. Supported Pt catalysts have been widely used for DBT hydrogenation, yet the high Pt loading required becomes a major cost barrier to its scale-up. Herein, we report an Al2O3-supported Pt–Ni bimetallic catalyst containing only 0.5 wt % Pt that, under mild conditions (120 °C, 2.5 MPa), delivers 100% DBT conversion with 99.4% selectivity. Comprehensive characterizations (transmission electron microscope (TEM), X-ray photoelectron spectroscopy (XPS), H2 temperature-programmed desorption (H2-TPD), and in situ diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS)) reveal that the enhanced activity originates from (i) electron transfer from Pt species to Ni, which modifies the electronic structure of the Ni sites and strengthen the Ni–H bonds; (ii) the formation of smaller and highly dispersed Ni nanoparticles (NPs), promoted by Pt introduction; and (iii) suppressed desorption of reaction intermediates upon Pt incorporation, together with accelerated hydrogen spillover that facilitates the migration of active H* species and improves DBT conversion efficiency. Consequently, the catalyst maintains superior hydrogenation performance, offering a practical route toward low-cost DBT-based hydrogen storage.
- 5 May 2026
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 65 (19) , 9909-9920
Optimized Fabrication of Ni–Mo/USY@SBA-15 Core–Shell Catalysts via Acid-Tailored Synthesis for Enhanced Naphthalene Hydrocracking
- 5 May 2026
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 65 (19) , 9909-9920
Optimized Fabrication of Ni–Mo/USY@SBA-15 Core–Shell Catalysts via Acid-Tailored Synthesis for Enhanced Naphthalene Hydrocracking
- 27 February 2026
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 16 (7) , 6708-6719
Revealing the Synergetic Effect of a Ce-Modified MoP Triphasic Composite in Naphthalene Hydrogenation
- 27 February 2026
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 16 (7) , 6708-6719
Revealing the Synergetic Effect of a Ce-Modified MoP Triphasic Composite in Naphthalene Hydrogenation
- 25 November 2025
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 198
ZIF-on-COF derived Co-NC heterostructure with enhanced HER performance
- 25 November 2025
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 198
ZIF-on-COF derived Co-NC heterostructure with enhanced HER performance
- 25 November 2025
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 54 (46) , 17311-17321
Pd-loaded modulated MOF-808: a bifunctional solid-acid catalyst for one-pot oxidation–acetalization
Pd-supported modulated MOF-808 (defect MOF-808) with tunable acidity enables highly selective one-pot oxidation–acetalization of benzyl alcohol, outperforming conventional catalysts.
- 25 November 2025
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 54 (46) , 17311-17321
Pd-loaded modulated MOF-808: a bifunctional solid-acid catalyst for one-pot oxidation–acetalization
Pd-supported modulated MOF-808 (defect MOF-808) with tunable acidity enables highly selective one-pot oxidation–acetalization of benzyl alcohol, outperforming conventional catalysts.
- 30 September 2025
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 39 (40) , 19411-19421
Rational Design of Self-Supported Ni3Fe–Ni3P/NF Electrocatalyst for pH-Universal Hydrogen Evolution Reaction
- 30 September 2025
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 39 (40) , 19411-19421
Rational Design of Self-Supported Ni3Fe–Ni3P/NF Electrocatalyst for pH-Universal Hydrogen Evolution Reaction
- 24 January 2025
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 64 (5) , 2730-2744
Highly Efficient Phenol Hydrogenation to Cyclohexanone over Pd/MIL-100 in Aqueous Phase: Promotion of Lewis Acidity
- 24 January 2025
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 64 (5) , 2730-2744
Highly Efficient Phenol Hydrogenation to Cyclohexanone over Pd/MIL-100 in Aqueous Phase: Promotion of Lewis Acidity