Soo-Min Hong
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Soo-Min Hong has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Saro Lee
Principal Researcher, Geoscience Data Research Department, Korea Institute of Geoscience and Mineral Resources, Daejeon, Republic of Korea
3 shared publications - Hyung-Sup Jung
Department of Geoinformatics, University of Seoul, Seoul, Republic of Korea
2 shared publications Hyun-Joo Oh
Geo-Environmental Hazards & Quaternary Geology Research Center, Korea Institute of Geoscience and Mineral Resources (KIGAM), 124 Gwahang-no, Yuseong-gu, Daejeon 305-350, Republic of Korea
1 shared publicationHyung-Sup Jung
Department of Geoinformatics, The University of Seoul, Dongdaemun-gu, Seoul, Korea
1 shared publication
Latest Publications
- Open Access
- 16 November 2017
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 12 (11) , e0188286
Mapping three-dimensional surface deformation caused by the 2010 Haiti earthquake using advanced satellite radar interferometry
Mapping three-dimensional (3D) surface deformation caused by an earthquake is very important for the environmental, cultural, economic and social sustainability of human beings. Synthetic aperture radar (SAR) systems made it possible to measure precise 3D deformations by combining SAR interferometry (InSAR) and multiple aperture interferometry (MAI). In this paper, we retrieve the 3D surface deformation field of the 2010 Haiti earthquake which occurred on January 12, 2010 by a magnitude 7.0 Mw by using the advanced interferometric technique that integrates InSAR and MAI data. The surface deformation has been observed by previous researchers using the InSAR and GPS method, but 3D deformation has not been measured yet due to low interferometric coherence. The combination of InSAR and MAI were applied to the ALOS PALSAR ascending and descending pairs, and were validated with the GPS in-situ measurements. The archived measurement accuracy was as little as 1.85, 5.49 and 3.08 cm in the east, north and up directions, respectively. This result indicates that the InSAR/MAI-derived 3D deformations are well matched with the GPS deformations. The 3D deformations are expected to allow us to improve estimation of the area affected by the 2010 Haiti earthquake.
- 16 November 2017
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 12 (11) , e0188286
Open AccessMapping three-dimensional surface deformation caused by the 2010 Haiti earthquake using advanced satellite radar interferometry
Mapping three-dimensional (3D) surface deformation caused by an earthquake is very important for the environmental, cultural, economic and social sustainability of human beings. Synthetic aperture radar (SAR) systems made it possible to measure precise 3D deformations by combining SAR interferometry (InSAR) and multiple aperture interferometry (MAI). In this paper, we retrieve the 3D surface deformation field of the 2010 Haiti earthquake which occurred on January 12, 2010 by a magnitude 7.0 Mw by using the advanced interferometric technique that integrates InSAR and MAI data. The surface deformation has been observed by previous researchers using the InSAR and GPS method, but 3D deformation has not been measured yet due to low interferometric coherence. The combination of InSAR and MAI were applied to the ALOS PALSAR ascending and descending pairs, and were validated with the GPS in-situ measurements. The archived measurement accuracy was as little as 1.85, 5.49 and 3.08 cm in the east, north and up directions, respectively. This result indicates that the InSAR/MAI-derived 3D deformations are well matched with the GPS deformations. The 3D deformations are expected to allow us to improve estimation of the area affected by the 2010 Haiti earthquake.
- Open Access
- 6 September 2017
- Published by Wiley in Journal of Sensors
- Vol. 2017, 1-21
Landslide Susceptibility Assessment Using Frequency Ratio Technique with Iterative Random Sampling
This paper assesses the performance of the landslide susceptibility analysis using frequency ratio (FR) with an iterative random sampling. A pair of before-and-after digital aerial photographs with 50 cm spatial resolution was used to detect landslide occurrences in Yongin area, Korea. Iterative random sampling was run ten times in total and each time it was applied to the training and validation datasets. Thirteen landslide causative factors were derived from the topographic, soil, forest, and geological maps. The FR scores were calculated from the causative factors and training occurrences repeatedly ten times. The ten landslide susceptibility maps were obtained from the integration of causative factors that assigned FR scores. The landslide susceptibility maps were validated by using each validation dataset. The FR method achieved susceptibility accuracies from 89.48% to 93.21%. And the landslide susceptibility accuracy of the FR method is higher than 89%. Moreover, the ten times iterative FR modeling may contribute to a better understanding of a regularized relationship between the causative factors and landslide susceptibility. This makes it possible to incorporate knowledge-driven considerations of the causative factors into the landslide susceptibility analysis and also be extensively used to other areas.
- 6 September 2017
- Published by Wiley in Journal of Sensors
- Vol. 2017, 1-21
Open AccessLandslide Susceptibility Assessment Using Frequency Ratio Technique with Iterative Random Sampling
This paper assesses the performance of the landslide susceptibility analysis using frequency ratio (FR) with an iterative random sampling. A pair of before-and-after digital aerial photographs with 50 cm spatial resolution was used to detect landslide occurrences in Yongin area, Korea. Iterative random sampling was run ten times in total and each time it was applied to the training and validation datasets. Thirteen landslide causative factors were derived from the topographic, soil, forest, and geological maps. The FR scores were calculated from the causative factors and training occurrences repeatedly ten times. The ten landslide susceptibility maps were obtained from the integration of causative factors that assigned FR scores. The landslide susceptibility maps were validated by using each validation dataset. The FR method achieved susceptibility accuracies from 89.48% to 93.21%. And the landslide susceptibility accuracy of the FR method is higher than 89%. Moreover, the ten times iterative FR modeling may contribute to a better understanding of a regularized relationship between the causative factors and landslide susceptibility. This makes it possible to incorporate knowledge-driven considerations of the causative factors into the landslide susceptibility analysis and also be extensively used to other areas.
- Top Cited Papers
- 20 March 2017
- Published by Taylor & Francis in Geocarto International
- Vol. 33 (8) , 847-861
GIS-based groundwater potential mapping using artificial neural network and support vector machine models: the case of Boryeong city in Korea
Groundwater productivity-potential (GPP) was analysed using the data mining models of an artificial neural network (ANN) and a support vector machine (SVM) in Boryeong city, Korea. The groundwater-productivity data with specific capacity (SPC) is strongly related to hydrogeological factors, and hence the relation may allow for groundwater potential mapping from hydrogeological factors through the ANN and SVM models. A back-propagation algorithm was used for the ANN model while a polynomial kernel was adopted for the SVM model. For the validation of the GPP maps generated from the ANN and SVM models, the area-under-the-curve analysis was performed using the SPC values of well data. The accuracies achieved from the ANN and SVM models are about 83.57 and 80.83%, respectively. It proves that the ANN and SVM models will be highly conducive to developing useful groundwater resources.
- 20 March 2017
- Published by Taylor & Francis in Geocarto International
- Vol. 33 (8) , 847-861
Top Cited PapersGIS-based groundwater potential mapping using artificial neural network and support vector machine models: the case of Boryeong city in Korea
Groundwater productivity-potential (GPP) was analysed using the data mining models of an artificial neural network (ANN) and a support vector machine (SVM) in Boryeong city, Korea. The groundwater-productivity data with specific capacity (SPC) is strongly related to hydrogeological factors, and hence the relation may allow for groundwater potential mapping from hydrogeological factors through the ANN and SVM models. A back-propagation algorithm was used for the ANN model while a polynomial kernel was adopted for the SVM model. For the validation of the GPP maps generated from the ANN and SVM models, the area-under-the-curve analysis was performed using the SPC values of well data. The accuracies achieved from the ANN and SVM models are about 83.57 and 80.83%, respectively. It proves that the ANN and SVM models will be highly conducive to developing useful groundwater resources.
- Top Cited PapersOpen Access
- 1 January 2017
- Published by MDPI AG in Sustainability
- Vol. 9 (1) , 48
A Support Vector Machine for Landslide Susceptibility Mapping in Gangwon Province, Korea
In this study, the support vector machine (SVM) was applied and validated by using the geographic information system (GIS) in order to map landslide susceptibility. In order to test the usefulness and effectiveness of the SVM, two study areas were carefully selected: the PyeongChang and Inje areas of Gangwon Province, Korea. This is because, not only did many landslides (2098 in PyeongChang and 2580 in Inje) occur in 2006 as a result of heavy rainfall, but the 2018 Winter Olympics will be held in these areas. A variety of spatial data, including landslides, geology, topography, forest, soil, and land cover, were identified and collected in the study areas. Following this, the spatial data were compiled in a GIS-based database through the use of aerial photographs. Using this database, 18 factors relating to topography, geology, soil, forest and land use, were extracted and applied to the SVM. Next, the detected landslide data were randomly divided into two sets; one for training and the other for validation of the model. Furthermore, a SVM, specifically a type of data-mining classification model, was applied by using radial basis function kernels. Finally, the estimated landslide susceptibility maps were validated. In order to validate the maps, sensitivity analyses were carried out through area-under-the-curve analysis. The achieved accuracies from the SVM were approximately 81.36% and 77.49% in the PyeongChang and Inje areas, respectively. Moreover, a sensitivity assessment of the factors was performed. It was found that all of the factors, except for soil topography, soil drainage, soil material, soil texture, timber diameter, timber age, and timber density for the PyeongChang area, and timber diameter, timber age, and timber density for the Inje area, had relatively positive effects on the landslide susceptibility maps. These results indicate that SVMs can be useful and effective for landslide susceptibility analysis.
- 1 January 2017
- Published by MDPI AG in Sustainability
- Vol. 9 (1) , 48
Top Cited PapersOpen AccessA Support Vector Machine for Landslide Susceptibility Mapping in Gangwon Province, Korea
In this study, the support vector machine (SVM) was applied and validated by using the geographic information system (GIS) in order to map landslide susceptibility. In order to test the usefulness and effectiveness of the SVM, two study areas were carefully selected: the PyeongChang and Inje areas of Gangwon Province, Korea. This is because, not only did many landslides (2098 in PyeongChang and 2580 in Inje) occur in 2006 as a result of heavy rainfall, but the 2018 Winter Olympics will be held in these areas. A variety of spatial data, including landslides, geology, topography, forest, soil, and land cover, were identified and collected in the study areas. Following this, the spatial data were compiled in a GIS-based database through the use of aerial photographs. Using this database, 18 factors relating to topography, geology, soil, forest and land use, were extracted and applied to the SVM. Next, the detected landslide data were randomly divided into two sets; one for training and the other for validation of the model. Furthermore, a SVM, specifically a type of data-mining classification model, was applied by using radial basis function kernels. Finally, the estimated landslide susceptibility maps were validated. In order to validate the maps, sensitivity analyses were carried out through area-under-the-curve analysis. The achieved accuracies from the SVM were approximately 81.36% and 77.49% in the PyeongChang and Inje areas, respectively. Moreover, a sensitivity assessment of the factors was performed. It was found that all of the factors, except for soil topography, soil drainage, soil material, soil texture, timber diameter, timber age, and timber density for the PyeongChang area, and timber diameter, timber age, and timber density for the Inje area, had relatively positive effects on the landslide susceptibility maps. These results indicate that SVMs can be useful and effective for landslide susceptibility analysis.