Kei Sugimoto
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Kei Sugimoto has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
Hiroshi Kawabe
2 shared publications- Masayoshi Oka
National Maritime Research Institute, Tokyo 181-0004, Japan
2 shared publications - Yusuke Fukumoto
Class NK
2 shared publications - Atsuo Maki
Osaka University, Suita, Japan
1 shared publication - Benjamin Bouscasse
École Centrale de Nantes, LHEEA Laboratory, 44000 Nantes, France
1 shared publication - Binyang Xie1 shared publication
Latest Publications
- Open Access
- 2 November 2026
- Published by Elsevier in Ocean Engineering
- Vol. 370
A physics-based two-dimensional reduced order model for hydro-elastoplastic response of panel under bow flare slamming impact: Validation and application
- 2 November 2026
- Published by Elsevier in Ocean Engineering
- Vol. 370
Open AccessA physics-based two-dimensional reduced order model for hydro-elastoplastic response of panel under bow flare slamming impact: Validation and application
- Open Access
- 2 March 2026
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 14 (5) , 481
Vertical Bending Moment in Extreme Regular Waves—Benchmarking of Numerical Codes Against Model Tests
A benchmark study of 10 different numerical methods for ship motion and load assessment is presented. Pitch motions and midship vertical bending moments are compared to model test results for a containership at zero speed in head regular waves. The wave steepness is varied from 2.1% to 10.5%. The model tests show that pitch and the vertical bending moment (VBM) display nonlinear behavior even for low-steepness waves. It is demonstrated that computational fluid dynamics (CFD) methods can reproduce the ship responses with good accuracy, even in very steep waves, involving green water and parts of the ship going in and out of water. Weakly nonlinear potential-theory methods tend to overestimate the pitch motions and the sagging moments as the wave steepness increases. For the vertical bending moment in steep waves, the 3D panel methods did not give significantly better results than those obtained with the nonlinear strip theories.
- 2 March 2026
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 14 (5) , 481
Open AccessVertical Bending Moment in Extreme Regular Waves—Benchmarking of Numerical Codes Against Model Tests
A benchmark study of 10 different numerical methods for ship motion and load assessment is presented. Pitch motions and midship vertical bending moments are compared to model test results for a containership at zero speed in head regular waves. The wave steepness is varied from 2.1% to 10.5%. The model tests show that pitch and the vertical bending moment (VBM) display nonlinear behavior even for low-steepness waves. It is demonstrated that computational fluid dynamics (CFD) methods can reproduce the ship responses with good accuracy, even in very steep waves, involving green water and parts of the ship going in and out of water. Weakly nonlinear potential-theory methods tend to overestimate the pitch motions and the sagging moments as the wave steepness increases. For the vertical bending moment in steep waves, the 3D panel methods did not give significantly better results than those obtained with the nonlinear strip theories.
- 29 March 2023
- Published by Springer Nature
- p. 143-156
Study on Short-Term Prediction of Roll in Beam Sea
- 29 March 2023
- Published by Springer Nature
- p. 143-156
Study on Short-Term Prediction of Roll in Beam Sea
- Open Access
- 16 July 2021
- Published by ASME International
Non Linear Effect on Wave-Induced Loads for Hull Structural Design -Vehicles Carrier, Bulk Carrier, Container Carrier-
In order to ensure a ship’s structural safety, the most severe sea states she is expected to encounter throughout her service life need to be considered, and the loads corresponding to these sea states, i.e. maximum loads, are specified in the classification society’s structural rules such as the IACS Common Structural Rules (hereinafter, referred to as “CSR”). These maximum loads
- 16 July 2021
- Published by ASME International
Open AccessNon Linear Effect on Wave-Induced Loads for Hull Structural Design -Vehicles Carrier, Bulk Carrier, Container Carrier-
In order to ensure a ship’s structural safety, the most severe sea states she is expected to encounter throughout her service life need to be considered, and the loads corresponding to these sea states, i.e. maximum loads, are specified in the classification society’s structural rules such as the IACS Common Structural Rules (hereinafter, referred to as “CSR”). These maximum loads
- Open Access
- 16 July 2021
- Published by ASME International
Development of Closed Formula of Wave Load Based Upon Long-Term Prediction \u2013 Heave Acceleration and Pitch Angle
In order to ensure the structural safety of a ship, the most severe sea states she is expected to encounter throughout her service life need to be given consideration. This is the reason why the loads (i.e. maximum loads) corresponding to such sea states are typically specified in classification society structural rules such as the Common Structural Rules (CSR) of the
- 16 July 2021
- Published by ASME International
Open AccessDevelopment of Closed Formula of Wave Load Based Upon Long-Term Prediction \u2013 Heave Acceleration and Pitch Angle
In order to ensure the structural safety of a ship, the most severe sea states she is expected to encounter throughout her service life need to be given consideration. This is the reason why the loads (i.e. maximum loads) corresponding to such sea states are typically specified in classification society structural rules such as the Common Structural Rules (CSR) of the
- 6 October 2020
- Published by Springer Nature
- p. 770-789
Non-linear Effect on Wave-Induced Loads in Vehicles Carrier for Hull Design
- 6 October 2020
- Published by Springer Nature
- p. 770-789
Non-linear Effect on Wave-Induced Loads in Vehicles Carrier for Hull Design