Abdelaziz Ait Addi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Abdelaziz Ait Addi has a total of 47 co-authors. Here are the top co-authors by number of shared publications:
- Hassan Ouachtak
Laboratory of Organic Chemistry and Physical Chemistry, Faculty of Science, Ibnou Zohr University, PB 8106, Agadir, Morocco
4 shared publications J. Douch
Univ Ibn Zohr, Fac Sci Agadir, Lab Electrochim & Catalyse & Environm, Agadir, Morocco
4 shared publications- Amane Jada
Institute of Materials Science of Mulhouse (IS2M), High Alsace University, Mulhouse, 68100, France
3 shared publications M. Hamdani
3 shared publicationsMohamed Hamdani
Faculty of Science, Ibn Zohr University, Agadir, Morocco
3 shared publicationsSiham Akhouairi
Université Ibn Zohr
3 shared publications
Latest Publications
- 5 October 2020
- Published by Taylor & Francis in Journal of Adhesion Science and Technology
- Vol. 35 (8) , 856-872
Comparative electrochemical and spectroscopic analysis of the inhibition effect of molybdates and boiled red onion extract on the corrosion of tin in acidic solution
The corrosion inhibition efficiency (η%) and its passivation mechanisms of tin in 0.2 M malic acid by two different types of potential inhibitors, boiled red onion skin extracts (BROE) and molybdate (MoO42−), were examined and compared. The influence of the two inhibitors was evaluated by using the electrochemical polarization and the electrochemical impedance spectroscopy (EIS) methods. The electrode surface coverage was analyzed employing scanning electron microscopy (SEM) and energy-dispersive X-ray spectroscopy (EDX). The electrochemical polarization curves revealed that increasing inhibitor concentration led to a significant reduction of the tin corrosion rate. The presence of BROE and molybdates produced inhibition efficiency (η%) values of 93 and 87%, respectively. Electrochemical measurements and surface analysis have shown satisfactory agreement, that both inhibitor compounds effectively inhibited tin corrosion in 0.2 M maleic acid by forming protective inhibiting deposits that hindered the active electrochemical corrosion sites on the tin surface. Comprehensive insights into the corrosion inhibition mechanism of these compounds in a 0.2-M maleic acid environment, through the suggested equivalent circuits, are also provided.
- 5 October 2020
- Published by Taylor & Francis in Journal of Adhesion Science and Technology
- Vol. 35 (8) , 856-872
Comparative electrochemical and spectroscopic analysis of the inhibition effect of molybdates and boiled red onion extract on the corrosion of tin in acidic solution
The corrosion inhibition efficiency (η%) and its passivation mechanisms of tin in 0.2 M malic acid by two different types of potential inhibitors, boiled red onion skin extracts (BROE) and molybdate (MoO42−), were examined and compared. The influence of the two inhibitors was evaluated by using the electrochemical polarization and the electrochemical impedance spectroscopy (EIS) methods. The electrode surface coverage was analyzed employing scanning electron microscopy (SEM) and energy-dispersive X-ray spectroscopy (EDX). The electrochemical polarization curves revealed that increasing inhibitor concentration led to a significant reduction of the tin corrosion rate. The presence of BROE and molybdates produced inhibition efficiency (η%) values of 93 and 87%, respectively. Electrochemical measurements and surface analysis have shown satisfactory agreement, that both inhibitor compounds effectively inhibited tin corrosion in 0.2 M maleic acid by forming protective inhibiting deposits that hindered the active electrochemical corrosion sites on the tin surface. Comprehensive insights into the corrosion inhibition mechanism of these compounds in a 0.2-M maleic acid environment, through the suggested equivalent circuits, are also provided.
- 1 April 2020
- Published by Elsevier in Separation and Purification Technology
- Vol. 236
Application of Density Functional Theory computation (DFT) and Process Capability Study for performance evaluation of Orthophosphate removal process using Polyaniline@Hematite-titaniferous sand composite (PANI@HTS) as a substrate
- 1 April 2020
- Published by Elsevier in Separation and Purification Technology
- Vol. 236
Application of Density Functional Theory computation (DFT) and Process Capability Study for performance evaluation of Orthophosphate removal process using Polyaniline@Hematite-titaniferous sand composite (PANI@HTS) as a substrate
- 25 July 2019
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 230 (8) , 181
Natural Sawdust as Adsorbent for the Eriochrome Black T Dye Removal from Aqueous Solution
- 25 July 2019
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 230 (8) , 181
Natural Sawdust as Adsorbent for the Eriochrome Black T Dye Removal from Aqueous Solution
- 11 May 2019
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 26 (19) , 19615-19631
Efficient removal of p-nitrophenol from water using montmorillonite clay: insights into the adsorption mechanism, process optimization, and regeneration
The present research highlights the use of a montmorillonite clay to remove p-nitrophenol (PNP) from aqueous solution. The montmorillonite clay was characterized using powder X-ray diffraction, Fourier-transformed infrared spectroscopy, scanning electron microscopy, X-ray fluorescence, Brunauer-Emmett-Teller analyses, and zero point charge in order to establish the adsorption behavior-properties relationship. The physiochemical parameters like pH, initial PNP concentration, and adsorbent dose as well as their binary interaction effects on the PNP adsorption yield were statistically optimized using response surface methodology. As a result, 99.5% removal of PNP was obtained under the optimal conditions of pH 2, adsorbent dose of 2 g/l, and PNP concentration of 20 mg/l. The interaction between adsorbent dose and initial concentration was the most influencing interaction on the PNP removal efficiency. The mass transfer of PNP at the solution/adsorbent interface was described using pseudo-first-order and intraparticle diffusion. Langmuir isotherm well fitted the experimental equilibrium data with a satisfactory maximum adsorption capacity of 122.09 mg/g. The PNP adsorption process was thermodynamically spontaneous and endothermic. The regeneration study showed that the montmorillonite clay exhibited an excellent recycling capability. Overall, the montmorillonite clay is very attractive as an efficient, low-cost, eco-friendly, and recyclable adsorbent for the remediation of hazardous phenolic compounds in industrial effluents.
- 11 May 2019
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 26 (19) , 19615-19631
Efficient removal of p-nitrophenol from water using montmorillonite clay: insights into the adsorption mechanism, process optimization, and regeneration
The present research highlights the use of a montmorillonite clay to remove p-nitrophenol (PNP) from aqueous solution. The montmorillonite clay was characterized using powder X-ray diffraction, Fourier-transformed infrared spectroscopy, scanning electron microscopy, X-ray fluorescence, Brunauer-Emmett-Teller analyses, and zero point charge in order to establish the adsorption behavior-properties relationship. The physiochemical parameters like pH, initial PNP concentration, and adsorbent dose as well as their binary interaction effects on the PNP adsorption yield were statistically optimized using response surface methodology. As a result, 99.5% removal of PNP was obtained under the optimal conditions of pH 2, adsorbent dose of 2 g/l, and PNP concentration of 20 mg/l. The interaction between adsorbent dose and initial concentration was the most influencing interaction on the PNP removal efficiency. The mass transfer of PNP at the solution/adsorbent interface was described using pseudo-first-order and intraparticle diffusion. Langmuir isotherm well fitted the experimental equilibrium data with a satisfactory maximum adsorption capacity of 122.09 mg/g. The PNP adsorption process was thermodynamically spontaneous and endothermic. The regeneration study showed that the montmorillonite clay exhibited an excellent recycling capability. Overall, the montmorillonite clay is very attractive as an efficient, low-cost, eco-friendly, and recyclable adsorbent for the remediation of hazardous phenolic compounds in industrial effluents.
- 1 April 2019
- Published by Elsevier in Journal of Water Process Engineering
- Vol. 28, 214-221
Treatment of textile industry wastewater by electrocoagulation coupled with electrochemical advanced oxidation process
- 1 April 2019
- Published by Elsevier in Journal of Water Process Engineering
- Vol. 28, 214-221
Treatment of textile industry wastewater by electrocoagulation coupled with electrochemical advanced oxidation process
- 1 June 2018
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 546, 9-19
Mobility and retention of phenolic acids through a goethite-coated quartz sand column
- 1 June 2018
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 546, 9-19
Mobility and retention of phenolic acids through a goethite-coated quartz sand column
- Open Access
- 1 April 2018
- Published by Elsevier in Desalination and Water Treatment
- Vol. 112, 207-217
Humic acid covered alumina as adsorbent for the removal of organic dye from coloured effluents
- 1 April 2018
- Published by Elsevier in Desalination and Water Treatment
- Vol. 112, 207-217
Open AccessHumic acid covered alumina as adsorbent for the removal of organic dye from coloured effluents
- Open Access
- 1 January 2018
- Published by Elsevier in International Journal of Electrochemical Science
- Vol. 13 (1) , 29-44
Evaluation of the Corrosion of AZ31 Magnesium Alloy Used as Sacrificial Anode for Cathodic Protection of Hot-Water Tank Storage Containing Chloride
- 1 January 2018
- Published by Elsevier in International Journal of Electrochemical Science
- Vol. 13 (1) , 29-44
Open AccessEvaluation of the Corrosion of AZ31 Magnesium Alloy Used as Sacrificial Anode for Cathodic Protection of Hot-Water Tank Storage Containing Chloride
- 1 January 2015
- Published by Elsevier in Corrosion Science
- Vol. 90, 522-528
Inhibition of the pitting corrosion of 304 stainless steel in 0.5 M hydrochloric acid solution by heptamolybdate ions
- 1 January 2015
- Published by Elsevier in Corrosion Science
- Vol. 90, 522-528
Inhibition of the pitting corrosion of 304 stainless steel in 0.5 M hydrochloric acid solution by heptamolybdate ions