Niranjan Kumar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Niranjan Kumar has a total of 279 co-authors. Here are the top co-authors by number of shared publications:
S. Dash
58 shared publicationsA.K. Tyagi
41 shared publications- Kalpataru Panda
Inst for Basic Sci Korea, Ctr Nanomat & Chem React, Daejeon 34141, South Korea
22 shared publications - Thoguluva Ramamoorthy Ravindran
HBNI, Materials Science Group, Indira Gandhi Centre for Atomic Research, Kalpakkam 603102, India
22 shared publications Baldev Raj
Surface and Nanoscience Division, Indira Gandhi Centre for Atomic Research, Kalpakkam, INDIA
18 shared publicationsI-Nan Lin
Tamkang Univ, Dept Phys, Tamsui, Taiwan
14 shared publications
Latest Publications
- 26 January 2026
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 28 (8) , 5303-5326
Phonon and magnon modes in preferentially oriented epitaxial α-Fe 2 O 3 thin films investigated by Raman spectroscopy
In monocrystalline α-Fe 2 O 3 , spin–phonon coupling was spectroscopically observed via phonon renormalization across the Morin magnetic transition.
- 26 January 2026
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 28 (8) , 5303-5326
Phonon and magnon modes in preferentially oriented epitaxial α-Fe 2 O 3 thin films investigated by Raman spectroscopy
In monocrystalline α-Fe 2 O 3 , spin–phonon coupling was spectroscopically observed via phonon renormalization across the Morin magnetic transition.
- 7 October 2025
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 43 (6)
Microstructure of the subsurface layer formed in monocrystalline silicon during etching with Xe+ ions investigation
Monocrystalline silicon (c-Si) (110) sputtering by Xe+ ions with different energies is studied. The microstructure and depth of the subsurface damaged layer arising during ion beam etching have been studied using Raman scattering spectroscopy with excitation by visible and ultraviolet lasers, small-angle x-ray diffraction, and transmission electron microscopy. A threshold dependence of the effect of Xe+ ions energy on the surface roughness during etching has been found. It is shown that ion beam etching induced the intensity enhancement of a broad spectrum around 490–492 cm−1 originated from the optical mode of phonon near the surface region of c-Si. The origin of this mode was associated with quasi-amorphous Si (q-Si) determined by a shorter correlation length of phonons due to confinement. The roughness of the surface of the c-Si was found to be dependent upon the contribution of the q-Si phase. The depth of the damaged subsurface layer was about 12 nm for etching by Xe+ ions with an energy of 1000 eV, and at an ion energy of 600 eV, the nucleation of a quasi-amorphous phase was observed at a depth of 5–6 nm with preservation of crystallinity below the surface and in volume.
- 7 October 2025
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 43 (6)
Microstructure of the subsurface layer formed in monocrystalline silicon during etching with Xe+ ions investigation
Monocrystalline silicon (c-Si) (110) sputtering by Xe+ ions with different energies is studied. The microstructure and depth of the subsurface damaged layer arising during ion beam etching have been studied using Raman scattering spectroscopy with excitation by visible and ultraviolet lasers, small-angle x-ray diffraction, and transmission electron microscopy. A threshold dependence of the effect of Xe+ ions energy on the surface roughness during etching has been found. It is shown that ion beam etching induced the intensity enhancement of a broad spectrum around 490–492 cm−1 originated from the optical mode of phonon near the surface region of c-Si. The origin of this mode was associated with quasi-amorphous Si (q-Si) determined by a shorter correlation length of phonons due to confinement. The roughness of the surface of the c-Si was found to be dependent upon the contribution of the q-Si phase. The depth of the damaged subsurface layer was about 12 nm for etching by Xe+ ions with an energy of 1000 eV, and at an ion energy of 600 eV, the nucleation of a quasi-amorphous phase was observed at a depth of 5–6 nm with preservation of crystallinity below the surface and in volume.
- 2 June 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (22)
Surface Fermi level tuning in thin epitaxial BiySb2−yTe3−xSex/Si(111) films
The effects of chemical treatment and aging of BiySb2−yTe3−xSex 3D topological insulator (TI) thin films on the surface electronic structure, morphology, and transport properties have been studied. The surface conditions significantly affect the separation between the Dirac point (DP) and the Fermi level, which is evident in both photoemission and magnetotransport measurements and is explained by the band bending. Depending on the Fermi level's position relative to the DP, the contribution of topological surface states to the nonlinear Hall effect can be solely controlled by the antilocalization effect or enhanced by the effect of gap opening. The wide tuning of the surface Fermi level by the surface/interface modification could be utilized in metal–insulator–semiconductor structures based on a TI thin films.
- 2 June 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (22)
Surface Fermi level tuning in thin epitaxial BiySb2−yTe3−xSex/Si(111) films
The effects of chemical treatment and aging of BiySb2−yTe3−xSex 3D topological insulator (TI) thin films on the surface electronic structure, morphology, and transport properties have been studied. The surface conditions significantly affect the separation between the Dirac point (DP) and the Fermi level, which is evident in both photoemission and magnetotransport measurements and is explained by the band bending. Depending on the Fermi level's position relative to the DP, the contribution of topological surface states to the nonlinear Hall effect can be solely controlled by the antilocalization effect or enhanced by the effect of gap opening. The wide tuning of the surface Fermi level by the surface/interface modification could be utilized in metal–insulator–semiconductor structures based on a TI thin films.
- 12 April 2024
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 26 (17) , 13497-13505
Raman scattering spectroscopy of MBE grown thin film topological insulator Bi 2− x Sb x Te 3− y Se y
The sum of relative ratios of peak widths of A g and E g modes of BSTS film grown on Si substrate was lower which indicated more ordered structure with lower contribution of localized defects compared to SiC/graphene substrate.
- 12 April 2024
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 26 (17) , 13497-13505
Raman scattering spectroscopy of MBE grown thin film topological insulator Bi 2− x Sb x Te 3− y Se y
The sum of relative ratios of peak widths of A g and E g modes of BSTS film grown on Si substrate was lower which indicated more ordered structure with lower contribution of localized defects compared to SiC/graphene substrate.
- 8 December 2023
- Published by Pleiades Publishing Ltd in Journal of Surface Investigation: X-Ray, Synchrotron and Neutron Techniques
- Vol. 17 (6) , 1319-1322
Study of the Reflectivity and Microstructure of Mo/Be Multilayer Mirrors
The reflection coefficient and microstructure of Mo/Be multilayer mirrors are studied as functions of Γ, i.e., the ratio of the Mo-layer thickness to the period dp. The thickness and period of the layers are studied using X-ray diffraction (wavelength 0.154 nm). Clearly defined high-intensity Bragg-reflection peaks indicate good reproducibility of the layer thicknesses over the depth of the multilayer structure and the high quality of interfaces. The reflectivity of the mirror at a wavelength of 11.4 nm is maximum 62% at Γ = 0.42. It sharply decreases at higher and lower values of Γ. Both Mo and Be layers at Γ = 0.42 are polycrystals, which are studied using X-ray diffraction and Raman spectroscopy, respectively. It is also found that the sizes of crystallites almost coincide with the thicknesses of Be and Mo layers in the period.
- 8 December 2023
- Published by Pleiades Publishing Ltd in Journal of Surface Investigation: X-Ray, Synchrotron and Neutron Techniques
- Vol. 17 (6) , 1319-1322
Study of the Reflectivity and Microstructure of Mo/Be Multilayer Mirrors
The reflection coefficient and microstructure of Mo/Be multilayer mirrors are studied as functions of Γ, i.e., the ratio of the Mo-layer thickness to the period dp. The thickness and period of the layers are studied using X-ray diffraction (wavelength 0.154 nm). Clearly defined high-intensity Bragg-reflection peaks indicate good reproducibility of the layer thicknesses over the depth of the multilayer structure and the high quality of interfaces. The reflectivity of the mirror at a wavelength of 11.4 nm is maximum 62% at Γ = 0.42. It sharply decreases at higher and lower values of Γ. Both Mo and Be layers at Γ = 0.42 are polycrystals, which are studied using X-ray diffraction and Raman spectroscopy, respectively. It is also found that the sizes of crystallites almost coincide with the thicknesses of Be and Mo layers in the period.
- 1 December 2023
- Published by The Russian Academy of Sciences in Poverhnostʹ. Rentgenovskie, sinhrotronnye i nejtronnye issledovaniâ
- No. 12,p. 3-6
Study of Reflectivity and Microstructure of Mo/Be Multilayer Mirrors
Study of Reflectivity and Microstructure of Mo/Be Multilayer Mirrors Исследование отражательной способности и микроструктуры многослойных зеркал Mo/Be
- 1 December 2023
- Published by The Russian Academy of Sciences in Poverhnostʹ. Rentgenovskie, sinhrotronnye i nejtronnye issledovaniâ
- No. 12,p. 3-6
Study of Reflectivity and Microstructure of Mo/Be Multilayer Mirrors
Study of Reflectivity and Microstructure of Mo/Be Multilayer Mirrors Исследование отражательной способности и микроструктуры многослойных зеркал Mo/Be
- 16 September 2023
- Published by Elsevier in Surfaces and Interfaces
- Vol. 42, 103414
High thermal stability of the reflectivity of Be/Al multilayer mirrors designed for extreme ultraviolet wavelength
- 16 September 2023
- Published by Elsevier in Surfaces and Interfaces
- Vol. 42, 103414
High thermal stability of the reflectivity of Be/Al multilayer mirrors designed for extreme ultraviolet wavelength
- 6 June 2023
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 56 (25) , 255301
Raman scattering studies of Si/B4C periodic multilayer mirrors with an operating wavelength of 13.5 nm
In order to obtain mirrors with a minimum value of residual stress, periodic multilayer mirrors composed of Si/B4C were deposited by magnetron sputtering with change in pressure of sputtering Ar gas. The microstructure and phase of Si and B4C was manipulated by the pressure of Ar gas which overall affected the stress in the mirrors. The minimum stress was obtained at higher pressure of sputter Ar gas, which showed the formation of amorphous boron, amorphous B4C, free carbon atoms and amorphous carbon structure in the B4C layers, investigated by Raman scattering spectroscopy. In Raman spectroscopy, a transverse optical (TO) mode of amorphous Si was shifted to lower frequency with increase in Ar gas pressure, which indicated relaxation of stress, also confirmed by the curvature measurement of mirrors. However, in the case of high residual stress, the amorphous B4C was a prominent phase in this layer and the frequency of the TO mode of amorphous Si was blue-shifted. Microstructure and stress affected the interfaces and modulation of the periodicity of the Si/B4C mirrors, investigated by secondary ion mass spectroscopy, which influenced the reflectivity of the mirrors.
- 6 June 2023
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 56 (25) , 255301
Raman scattering studies of Si/B4C periodic multilayer mirrors with an operating wavelength of 13.5 nm
In order to obtain mirrors with a minimum value of residual stress, periodic multilayer mirrors composed of Si/B4C were deposited by magnetron sputtering with change in pressure of sputtering Ar gas. The microstructure and phase of Si and B4C was manipulated by the pressure of Ar gas which overall affected the stress in the mirrors. The minimum stress was obtained at higher pressure of sputter Ar gas, which showed the formation of amorphous boron, amorphous B4C, free carbon atoms and amorphous carbon structure in the B4C layers, investigated by Raman scattering spectroscopy. In Raman spectroscopy, a transverse optical (TO) mode of amorphous Si was shifted to lower frequency with increase in Ar gas pressure, which indicated relaxation of stress, also confirmed by the curvature measurement of mirrors. However, in the case of high residual stress, the amorphous B4C was a prominent phase in this layer and the frequency of the TO mode of amorphous Si was blue-shifted. Microstructure and stress affected the interfaces and modulation of the periodicity of the Si/B4C mirrors, investigated by secondary ion mass spectroscopy, which influenced the reflectivity of the mirrors.
- 13 May 2023
- Published by Springer Nature in Indian Journal of Physics
- Vol. 97 (14) , 4205-4209
Microstructural stability of silicon and beryllium nanofilms in periodic Si/Be multilayer mirrors investigated by Raman scattering spectroscopy
- 13 May 2023
- Published by Springer Nature in Indian Journal of Physics
- Vol. 97 (14) , 4205-4209
Microstructural stability of silicon and beryllium nanofilms in periodic Si/Be multilayer mirrors investigated by Raman scattering spectroscopy
- 31 January 2023
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 46 (1) , 1-15
Investigation of nanostructural and electronic properties of silicides intermetallic in Mo/Si interfaces of periodic multilayers and bilayer structures
- 31 January 2023
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 46 (1) , 1-15
Investigation of nanostructural and electronic properties of silicides intermetallic in Mo/Si interfaces of periodic multilayers and bilayer structures