Michal Cerveny
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Michal Cerveny has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Kenneth Lee Ford
University of Sheffield
2 shared publications - Pavel Hazdra
Department of Electromagnetic Field, Faculty of Electrical Engineering, Czech Technical University in Prague, Prague, Czech Republic
2 shared publications Alan Tennant
Department of Electronic and Electrical Engineering, The University of Sheffield, Sheffield, UK
1 shared publication- Alan Tennant
The University of Sheffield,Department of Electronic and Electrical Engineering,Sheffield,United Kingdom
1 shared publication
Latest Publications
- Open Access
- 14 November 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Antennas and Propagation
- Vol. 6 (1) , 274-282
Compact Uplink Circularly Polarized 2.4GHz Short Backfire Antenna for Geostationary Amateur Radio Satellite Es’Hail-2 (QO-100)
This paper describes a compact circularly polarized antenna designed for the 2.4GHz band with a gain of 15dBic designed for communication (uplink) with a geostationary amateur radio satellite Es’Hail-2 (QO-100). The proposed antenna upgrades a standard short backfire antenna (SBA) by utilizing two metasurfaces with the first acting as a high-impedance surface (HIS) allowing for a reduction of the distance between the sub-reflector and main reflector and the second enhancing the sub-reflector while functioning both as a tunable polarization divider and phase shifter to form the circular polarization. This novel concept enables the use of a simple, linearly polarized patch antenna as a feeder with no complex feeding networks. The proposed antenna was simulated, manufactured, measured and tested with the QO-100 transponder located on the Es’Hail-2 geostationary satellite. This antenna is suitable for situations where compactness, portability, a rigid construction, and a simple change of direction of the circular polarization are required.
- 14 November 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Antennas and Propagation
- Vol. 6 (1) , 274-282
Open AccessCompact Uplink Circularly Polarized 2.4GHz Short Backfire Antenna for Geostationary Amateur Radio Satellite Es’Hail-2 (QO-100)
This paper describes a compact circularly polarized antenna designed for the 2.4GHz band with a gain of 15dBic designed for communication (uplink) with a geostationary amateur radio satellite Es’Hail-2 (QO-100). The proposed antenna upgrades a standard short backfire antenna (SBA) by utilizing two metasurfaces with the first acting as a high-impedance surface (HIS) allowing for a reduction of the distance between the sub-reflector and main reflector and the second enhancing the sub-reflector while functioning both as a tunable polarization divider and phase shifter to form the circular polarization. This novel concept enables the use of a simple, linearly polarized patch antenna as a feeder with no complex feeding networks. The proposed antenna was simulated, manufactured, measured and tested with the QO-100 transponder located on the Es’Hail-2 geostationary satellite. This antenna is suitable for situations where compactness, portability, a rigid construction, and a simple change of direction of the circular polarization are required.
- 26 March 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
An Experimental System for the Measurement of Electromagnetic Propagation on Curved Surfaces
Practical measurements of electromagnetic propagation around the circumference of large cylinders are difficult due to the dimensions of the configuration. This paper presents a new measurement approach where a large cylinder was replaced with a small section of a curved surface, whilst maintaining the large radius. Two unconventional wideband horn antennas were designed and manufactured and to mitigate the unwanted edge effects, a time domain gating technique was used. This setup allows for the measurement of different types of materials, such as metamaterials, that can either support or reduce propagation along a curved surface. The entire setup was modelled using a full-wave electromagnetic simulator and experimentally verified.
- 26 March 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
An Experimental System for the Measurement of Electromagnetic Propagation on Curved Surfaces
Practical measurements of electromagnetic propagation around the circumference of large cylinders are difficult due to the dimensions of the configuration. This paper presents a new measurement approach where a large cylinder was replaced with a small section of a curved surface, whilst maintaining the large radius. Two unconventional wideband horn antennas were designed and manufactured and to mitigate the unwanted edge effects, a time domain gating technique was used. This setup allows for the measurement of different types of materials, such as metamaterials, that can either support or reduce propagation along a curved surface. The entire setup was modelled using a full-wave electromagnetic simulator and experimentally verified.
- 1 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 69 (3) , 1483-1492
Reflective Switchable Polarization Rotator Based on Metasurface With PIN Diodes
A planar metasurface that rotates the polarisation of reflected signals by 90° is presented in this article. The surface also permits the relative phase of the rotated, reflected signal to be controlled. The metasurface rotator uses a square printed patch element mounted above a conducting ground plane. The addition of PIN diode controlled VIAs (Vertical Interconnect Access) at the corners of each square patch provide the ability to modify the scattering properties of the surface. In particular, the surface can be programmed to shift the phase of the rotated waveform by +/-90°. The polarisation rotator was manufactured, measured and compared against numerical simulations and the maximum measured bandwidth was 25% (4.8-6.2 GHz) for co-polarised attenuation of 10 dB. The proposed surface can be adopted for practical applications such as circularly polarised antennas.
- 1 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 69 (3) , 1483-1492
Reflective Switchable Polarization Rotator Based on Metasurface With PIN Diodes
A planar metasurface that rotates the polarisation of reflected signals by 90° is presented in this article. The surface also permits the relative phase of the rotated, reflected signal to be controlled. The metasurface rotator uses a square printed patch element mounted above a conducting ground plane. The addition of PIN diode controlled VIAs (Vertical Interconnect Access) at the corners of each square patch provide the ability to modify the scattering properties of the surface. In particular, the surface can be programmed to shift the phase of the rotated waveform by +/-90°. The polarisation rotator was manufactured, measured and compared against numerical simulations and the maximum measured bandwidth was 25% (4.8-6.2 GHz) for co-polarised attenuation of 10 dB. The proposed surface can be adopted for practical applications such as circularly polarised antennas.
- 4 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 19 (10) , 1674-1678
GNSS Sector Antenna for Interference Mitigation and Localization Using a High-Impedance Reflector
There are many applications where the reception of global navigation satellite system signals is crucial. In such cases, the capability to reduce the interference (both unintentional or hostile) is critical. The proposed sector antenna offers a stable radiation pattern with no beam steering across the frequency band and good impedance matching. It also benefits from a high impedance reflector, which allows the antenna to provide broadband operation and low-profile compact geometry. Furthermore, seven of these sector antennas were placed in a heptagonal shape and combined with a broadband crossed dipole. As a result, the designed antenna system can reduce verticallypolarised interference by approximately 45 dB in the required directions.
- 4 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 19 (10) , 1674-1678
GNSS Sector Antenna for Interference Mitigation and Localization Using a High-Impedance Reflector
There are many applications where the reception of global navigation satellite system signals is crucial. In such cases, the capability to reduce the interference (both unintentional or hostile) is critical. The proposed sector antenna offers a stable radiation pattern with no beam steering across the frequency band and good impedance matching. It also benefits from a high impedance reflector, which allows the antenna to provide broadband operation and low-profile compact geometry. Furthermore, seven of these sector antennas were placed in a heptagonal shape and combined with a broadband crossed dipole. As a result, the designed antenna system can reduce verticallypolarised interference by approximately 45 dB in the required directions.