Sue Alston
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Sue Alston has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Cris Arnold
College of Engineering Swansea University Fabian Way Swansea UK
3 shared publications A. T. Al-Dhafeeri
Water Research Centre, Kuwait Institute for Scientific Research, P.O. Box 24885, Safat 13109, Kuwait
1 shared publication- Abdul Rehman Khan
Department of Metallurgy and Materials Engineering, Pakistan Institute of Engineering and Applied Sciences, P. O. Nilore, Islamabad 45650, Pakistan
1 shared publication - Brajendra Kumar Sharma
Eastern Regional Research Center, Agricultural Research Service, U.S. Department of Agriculture, 600 E. Mermaid Lane, Wyndmoor, PA 19038, USA
1 shared publication Corinne Stone
Defence Science and Technology Laboratory Porton Down, Salisbury, Wiltshire UK
1 shared publication- Corinne Stone
Defence Science and Technology Laboratory, Salisbury, UK
1 shared publication
Latest Publications
- Open Access
- 24 May 2021
- Published by Wiley in Polymer Composites
- Vol. 42 (7) , 3550-3561
A source‐sink model for water diffusion in an activated carbon fiber/phenolic composite
The moisture absorption behavior of a composite comprising phenolic resin and activated carbon fibers was characterized. The resin starts with a water content from curing and the active fibers both adsorb water on their surface and absorb water in sub‐surface pores, acting as a sink or source of water. Measured data showed that the dependence of this water uptake on the surrounding relative humidity was highly nonlinear, and that the effective diffusion rate through the composite was very dependent on the starting and end conditions. A physically based model has been successfully developed to simulate this behavior. Diffusion was assumed to be Fickian and entirely through the resin, with a linear dependence of resin water content on external humidity. Water movement between resin and fibers was determined so as to maintain equilibrium, based on measured steady‐state water uptake curves across a range of relative humidities. This meant that in mid‐range humidities, most water movement was between fibers and resin rather than through the resin, giving low effective diffusion rates. This model and a simple Arrhenius expression for the diffusion coefficient through the resin enabled measured composite diffusion behavior to be accurately predicted over a range of temperatures and humidity changes.
- 24 May 2021
- Published by Wiley in Polymer Composites
- Vol. 42 (7) , 3550-3561
Open AccessA source‐sink model for water diffusion in an activated carbon fiber/phenolic composite
The moisture absorption behavior of a composite comprising phenolic resin and activated carbon fibers was characterized. The resin starts with a water content from curing and the active fibers both adsorb water on their surface and absorb water in sub‐surface pores, acting as a sink or source of water. Measured data showed that the dependence of this water uptake on the surrounding relative humidity was highly nonlinear, and that the effective diffusion rate through the composite was very dependent on the starting and end conditions. A physically based model has been successfully developed to simulate this behavior. Diffusion was assumed to be Fickian and entirely through the resin, with a linear dependence of resin water content on external humidity. Water movement between resin and fibers was determined so as to maintain equilibrium, based on measured steady‐state water uptake curves across a range of relative humidities. This meant that in mid‐range humidities, most water movement was between fibers and resin rather than through the resin, giving low effective diffusion rates. This model and a simple Arrhenius expression for the diffusion coefficient through the resin enabled measured composite diffusion behavior to be accurately predicted over a range of temperatures and humidity changes.
- Open Access
- 6 October 2020
- Published by Springer Nature in Applied Magnetic Resonance
- Vol. 52 (2) , 99-115
The Use of Single-Sided NMR to Study Moisture Behaviour in an Activated Carbon Fibre/Phenolic Composite
Nuclear Magnetic Resonance (NMR) has been shown to be a useful technique to study the form and content of water in polymer composites. Composites using activated carbon fibres with phenolic resin have complex water absorption behaviour which would benefit from such investigation; however, the presence of the conductive fibres can make NMR problematic. In this study, single-sided NMR has been successfully used on such material by developing a method for sample-to-sample compensation for the effect of conductivity. Transverse relaxation curves showed water to be primarily in two states in the resin, corresponding to "bound" and "mobile" molecules. In addition, two much less bound states were identified in the composite, associated firstly with water adsorbed on to the fibre surface and secondly with clusters of water molecules moving more freely within the fibre pores.
- 6 October 2020
- Published by Springer Nature in Applied Magnetic Resonance
- Vol. 52 (2) , 99-115
Open AccessThe Use of Single-Sided NMR to Study Moisture Behaviour in an Activated Carbon Fibre/Phenolic Composite
Nuclear Magnetic Resonance (NMR) has been shown to be a useful technique to study the form and content of water in polymer composites. Composites using activated carbon fibres with phenolic resin have complex water absorption behaviour which would benefit from such investigation; however, the presence of the conductive fibres can make NMR problematic. In this study, single-sided NMR has been successfully used on such material by developing a method for sample-to-sample compensation for the effect of conductivity. Transverse relaxation curves showed water to be primarily in two states in the resin, corresponding to "bound" and "mobile" molecules. In addition, two much less bound states were identified in the composite, associated firstly with water adsorbed on to the fibre surface and secondly with clusters of water molecules moving more freely within the fibre pores.
- 26 April 2017
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 56 (18) , 5210-5220
Thermal Degradation Kinetics of Virgin Polypropylene (PP) and PP with Starch Blends Exposed to Natural Weathering
- 26 April 2017
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 56 (18) , 5210-5220
Thermal Degradation Kinetics of Virgin Polypropylene (PP) and PP with Starch Blends Exposed to Natural Weathering