ZPZhehao Pei

Zhehao Pei

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Zhehao Pei has a total of 46 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Negative discharge characteristics in a long air gap triggered by femtosecond laser filaments

    by Zhehao Pei, Zeru Niu, Xing Fan, Zhenyu Liu, Shengxin Huang, Nianwen Xiang, Qiaogen Zhang, Weijiang Chen

    Femtosecond laser filamentation is a promising approach for active lightning protection, laser-triggered switches, and high-voltage gas discharges. For negative-polarity lightning, which dominates natural cloud-to-ground lightning, the strong stochasticity of negative-discharge inception and propagation remains a major obstacle to validating this approach. In this study, negative discharges in long air gaps were generated using a 4.8 MV impulse-voltage source, and the effects of gap geometry, laser peak power, and filament focal position were systematically investigated. The filament lowered the inception-voltage threshold of the large-curvature electrode ( r = 200 mm) by more than 70% and narrowed its distribution. The observed voltage reduction supports an effective ‘virtual-tip’ interpretation. Increasing P peak reduced the breakdown voltage and increased the guided discharge length and discharge probability. At 0.8 and 1.0 TW, the guided discharge lengths and discharge probabilities were comparable, indicating reduced sensitivity to laser peak power in the upper part of the tested range. The reduction in breakdown voltage also depended on gap distance because the unguided region constituted a larger fraction of longer gaps. Finally, varying the focal position revealed distinct spatial optima for the measured discharge characteristics. A focal position of d f–e = 0.3 m yielded the lowest breakdown voltage and the highest discharge probability, whereas d f–e = 0.7 m produced the longest guided discharge channel in the 2.5 m gap. These results characterize laser-guided negative discharges across coupled geometrical and laser conditions and provide reference data for active laser-induced lightning protection and laser-triggered switching.

  • Open Access

    Electromagnetic Sensors

    by Xing Fan, Zhehao Pei, Qingrong Peng

    This chapter introduces various types of sensors used to detect electromagnetic fields, detailing their mechanisms and applications. The discussed sensors include widely used electric and magnetic field sensors based on electromagnetic induction principles, rapidly advancing sensors based on optical effects, and newly proposed quantum-based sensors. A significant focus is placed on sensors utilizing optical effects, which have seen rapid development and practical application thanks to advancements in laser and crystal material technologies. Recent findings from our research team are also presented. Optical effect sensors, characterized by their compact size and full insulation, are particularly suitable for measuring electromagnetic fields in harsh electromagnetic environments and confined spaces. Meanwhile, quantum effect sensors offer extremely high sensitivity and can perform absolute electric field measurements, making them promising for applications such as electric field calibration and monitoring of extremely weak electric fields.

  • Discharge modes evolution characteristics of metal particle on the spacer surface in AC gas insulated switchgear

    by Jiayi Nie, Xing Fan, Zhehao Pei, Dong Ge, Yuan Xu, Nianwen Xiang, Weijiang Chen

    Flashover faults on gas insulated switchgear (GIS) insulators induced by metal particles occur frequently. Previous studies have obtained the characteristics of partial discharges (PDs) induced by metal particles on spacer surfaces, but these characteristics cannot explain the detection failure of ultra-high frequency (UHF) online monitoring. To enable further study of the PD characteristics induced by surface metal particles, the space electric field and a very-high-sensitivity pulse current (PC) measurement system were established. The electric field and PC characteristics of a PD induced by metal particle on the spacer surface of a 126 kV GIS were obtained. Two PD modes were found to be induced by surface metal particles. In addition to the typical pulse discharge (TP), there is a micro-discharge group (MG) mode with low apparent charge and long duration. The average apparent charge of the MG mode is approximately one-tenth of that of the TP at 0.4 pC. Its duration may extend to the millisecond level, causing significant distortion of the spatial electric field while hardly producing UHF signals. Moreover, increasing the applied voltage will increase the proportion of the MG within the total discharge, where this proportion can reach more than 90% before flashover, and the proportion of the discharge pulses that generates UHF signals is as low as 1%. The MG generation mechanism is analysed, the ion group stranded on the spacer surface by the TP changes the local electric field at the tip of the metal particle, which reduces the development length and apparent charge of the MG. Low apparent charge is cleared easily by the background electric field and thus the discharge interval is very short. This paper can provide an important basis for revealing the mechanism of GIS spacer surface discharge induced by metal particles and solving the effectiveness of PD monitoring devices.


  • Mechanism Analysis of Thermal-Induced Periodic Fluctuations in Electro-Optic Sensor

    by Yang Xiao, Xing Fan, Zhehao Pei, Weijiang Chen, Qiaogen Zhang

    Electro-optic (EO) sensors have a wide range of applications in power systems, but their output stability is significantly affected by temperature, limiting their practical performance. To understand the temperature stability of EO sensors, this article experimentally studies the stability of Bi4Ge3O12 (BGO) and ${z}$ -axis light-transmitting LiNbO3 (LN) sensors at different temperatures. It is found that both the static working point and the EO modulation signal of the sensors fluctuate periodically with temperature changes. The temperature period and fluctuation amplitude of the two sensors are different. We propose a mechanism for the periodic fluctuations in EO sensors. The EO crystal can be regarded as an optical resonator. The laser undergoes multiple reflections and transmissions at the two light-transmitting interfaces of the crystal, resulting in the actual output light being formed by multilevel transmission light interference. The optical thickness of the crystal resonator changes due to the thermo-optic effect and the thermal expansion effect under temperature changes, leading to periodic fluctuations in output light intensity. A mathematical model of sensor thermal periodic fluctuation is established. The calculation results agree well with experimental data.


  • Optical Sensing Technology for Acoustic Detection of Partial Discharges: A Review

    by Zhicheng Wu, Yiran Guo, Junjie Zhou, Xing Fan, Zhehao Pei, Qiaogen Zhang

    Partial discharge (PD) causes different physical processes in different mediums, exciting acoustic signals with wide frequency distribution. And the attenuation and catadioptric process of the acoustic signal caused by the propagation medium weaken the acoustic signal and further complicate the characteristics. As a result, the characteristics of PD acoustic signals are closely related to the properties of insulating mediums. Therefore, it is necessary to select an appropriate acoustic sensor based on the characteristic of the PD acoustic signal. The optical acoustic sensing technology has high sensitivity, fast response speed and strong anti-interference ability, which is the most potential PD detection sensor, ensuring the safe and stable operation of power equipment. But the response characteristics of the sensor limited the accurate characteristic analysis of acoustic signals in the previous research. This paper reviewed the characteristics of PD acoustic signals in typical insulating mediums obtained by previous research, analyzed the optical acoustic sensor suitable for partial discharge detection, which aims at selecting the sensors suitable for PD detection of different types of power equipment based on the current sensor technology and prospecting the development direction of the optical acoustic sensor for PD detection.


  • The contribution of femtosecond laser filaments to positive and negative breakdown discharge in a long air gap

    by Zhehao Pei, Weijiang Chen, Xing Fan, Jianwei Gu, Shengxin Huang, Xiaosong Liu, Zhong Fu, Bin Du, Tiejun Wang, Rui Zhang, et al.

    Discharges of different polarities develop in different modes, resulting in different guiding effects by femtosecond laser filaments. Knowledge of the contribution of laser filaments to positive and negative discharges is the basis of the laser-guided long-air-gap discharge technique. This study presents a direct comparison of the inception, propagation, and breakdown characteristics of discharges of both polarities. Long-air-gap discharge experiments under the switching impulses of both polarities are carried out under the same experimental conditions. Discharge modes and phases are also considered. The statistical results show that positive discharge inception voltages are transformed from a Weibull distribution into an exponential distribution under the influence of laser filaments, but there is little effect on the negative discharge inception voltage. The guidance probability of a positive discharge reaches 15% at most during the dark period stage, leading to little effect on the breakdown discharge probability. However, for negative discharges, the guidance probability can exceed 95%. An investigation of the filament contributions to both polarity discharges shows that the different migration directions of photoelectrons lead to a difference in the effects of laser filaments on inception voltages, and the difference in the connection of the two discharge passages leads to a difference in the guidance probability. Through the results of a simulation model, it is speculated that the connection condition for positive discharges is that the positive leader overlaps with the laser filaments, and, for negative discharges, the rod electrode is connected to the laser filaments through bi-directional discharge propagation.


  • Observations of the Breakthrough Phase of Attachment Process in Laboratory Long Sparks

    by Yufei Fu, Weijiang Chen, Yushun Zhao, Lijian Ding, Zhong Fu, Nianwen Xiang, Xinjie Qiu, Jianwei Gu, Zhehao Pei, Zhiyuan Zhang, et al.

    High‐speed video frames and discharge current records of 34 long laboratory sparks were examined. Two consecutive frames of the breakthrough phase, depicting the evolution of the common streamer zone, were obtained in five events, all presented in this study. Two types of luminous structures were observed inside the common streamer zone just before the return stroke phase: the floating luminous segment and the luminous channel linking the opposite polarity leaders. The luminous structure served as a selected route for the return stroke channel. These results demonstrate that the transformation of high‐impedance common streamer zone into a hot plasma channel may involve two main features: the common streamer zone shrinking and the dominant development of the selected route.


  • On the Step Type of Continuous Propagating Positive Leader in Laboratory‐Scale Long Spark Discharges

    by Shengxin Huang, Weijiang Chen, Zhong Fu, Nianwen Xiang, Yujian Ding, Dengfeng Cheng, Jianwei Gu, Zhehao Pei

    Positive leader steps are currently not well understood. Many recent findings challenge the previous understanding of the positive leader steps occurring in continuous leader development. In this work, we investigate the stepping propagation of positive leaders in laboratory spark discharge by using a high‐speed video camera and a synchronized electrical parameter measurement system. Two types of steps were distinguished in the positive leader continuous development process based on the current pulse features. One type of step exhibits a bell‐shaped current pulse, while the other type of step exhibits a steep current rise. The former type vanishes when the rising rate of the ambient electric field increases, whereas the latter type, which could be led by a separate luminous structure, does not.