Beata Plesiewicz
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Beata Plesiewicz has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Jan Wiszniowski
Institute of Geophysics Polish Academy of Sciences, Warsaw, Poland
5 shared publications - Grzegorz Lizurek
Institute of Geophysics, Polish Academy of Sciences, 01-452 Warsaw, Poland
3 shared publications - Dinh Quoc Van
Institute of Earth Sciences, Vietnam Academy of Science and Technology (IGS, VAST), No. 68 Huynh Thuc Khang, Lang Ward, Hanoi 100000, Vietnam
2 shared publications - Andrzej Kijko
Natural Hazard Centre, Pretoria University, Pretoria, South Africa
1 shared publication - Anna Tymińska
Institute of Geophysics, Polish Academy of Sciences, Warsaw, Poland
1 shared publication - Bui Van Duan
Institute of Earth Sciences, Vietnam Academy of Science and Technology (IGS, VAST), No. 68 Huynh Thuc Khang, Lang Ward, Hanoi 100000, Vietnam
1 shared publication
Latest Publications
- Open Access
The Influence of Lai Chau Reservoir Impoundment on Seismicity in the Area of Lai Chau (Vietnam)
The accumulation of water in large reservoirs can affect seismic activity due to changes in stress and pore pressure in the bedrock. This paper presents the results of a study on the influence of accumulation of the Lai Chau reservoir in northern Vietnam on local seismic activity. The reservoir was filled in June 2015. It was observed that although seismicity rates and b-values differed markedly in the months immediately following impoundment, the longer-term seismicity around the Lai Chau reservoir before and after its impoundment is broadly similar. The spatial distribution of earthquakes and stress changes induced by water loading and increased pore pressure were investigated. The load-induced stress field was computed from the pre-impoundment bathymetry of the valley and resolved without assuming any orientation of the regional stress field. Pore pressure diffusion was evaluated for three end-member scenarios of fault zone permeability and classified by the actual hypocentral depth of each event, thereby allowing the triggered subset to be bracketed in the absence of in situ hydraulic data. It was found that this influence was limited to the immediate vicinity of the reservoir, where the stress level reached values that allowed for the initiation of an earthquake. The highest seismicity was observed in the southeastern part of the lake, in the area of positive changes in Coulomb stress. The results suggest that hydraulic operations can trigger local seismic events where pre-existing faults close to failure lie within a few kilometers of the shoreline and at shallow depth. However, tectonic processes remain the dominant cause of seismicity in the region.
Open AccessThe Influence of Lai Chau Reservoir Impoundment on Seismicity in the Area of Lai Chau (Vietnam)
The accumulation of water in large reservoirs can affect seismic activity due to changes in stress and pore pressure in the bedrock. This paper presents the results of a study on the influence of accumulation of the Lai Chau reservoir in northern Vietnam on local seismic activity. The reservoir was filled in June 2015. It was observed that although seismicity rates and b-values differed markedly in the months immediately following impoundment, the longer-term seismicity around the Lai Chau reservoir before and after its impoundment is broadly similar. The spatial distribution of earthquakes and stress changes induced by water loading and increased pore pressure were investigated. The load-induced stress field was computed from the pre-impoundment bathymetry of the valley and resolved without assuming any orientation of the regional stress field. Pore pressure diffusion was evaluated for three end-member scenarios of fault zone permeability and classified by the actual hypocentral depth of each event, thereby allowing the triggered subset to be bracketed in the absence of in situ hydraulic data. It was found that this influence was limited to the immediate vicinity of the reservoir, where the stress level reached values that allowed for the initiation of an earthquake. The highest seismicity was observed in the southeastern part of the lake, in the area of positive changes in Coulomb stress. The results suggest that hydraulic operations can trigger local seismic events where pre-existing faults close to failure lie within a few kilometers of the shoreline and at shallow depth. However, tectonic processes remain the dominant cause of seismicity in the region.
- Open Access
Application of Neural Network Automatic Event Detection for Reservoir-Triggered Seismicity Monitoring Networks
This study examines reservoir-triggered seismicity (RTS) in Poland and Vietnam. The current state of individual RTS seismic networks necessitates detecting earthquakes from only a few stations. The number of P waves is often inadequate for phase association and event location, which underscores the importance of identifying S waves. Given that individual RTS cases may consist of only hundreds of events, it is crucial for algorithms to be trained on small datasets or to detect effectively using external, global training data. To evaluate this, we compared the efficiency of a deep learning global detection model, transfer learning to the RTS database, a specialized neural network designed for RTS, and manual detection of seismic signals. Transfer learning efficiency was database dependent. Additional interpretation and parametrization of detection results are assumed. Therefore, the emphasis is on phase detection, rather than phase picking accuracy, and detection sensitivity is more important than its specificity. Phase association plays a vital role in detecting seismic signals, facilitating the elimination of most false picks. As a result, the comparisons of detections were based on parameters related to the location of seismic events. The findings indicate that neither the automatic signal detection methods nor the manual methods alone are sufficient. However, their combination significantly enhances detectability. The final catalogs cover up to 30% more events compared to the previous manual. It fulfills the main aim of applying a neural network detector, which is to increase the number of seismic events in the catalog. It may also be further utilized in the research of the triggering process, such as identifying fluid paths and determining fault geometry.
Open AccessApplication of Neural Network Automatic Event Detection for Reservoir-Triggered Seismicity Monitoring Networks
This study examines reservoir-triggered seismicity (RTS) in Poland and Vietnam. The current state of individual RTS seismic networks necessitates detecting earthquakes from only a few stations. The number of P waves is often inadequate for phase association and event location, which underscores the importance of identifying S waves. Given that individual RTS cases may consist of only hundreds of events, it is crucial for algorithms to be trained on small datasets or to detect effectively using external, global training data. To evaluate this, we compared the efficiency of a deep learning global detection model, transfer learning to the RTS database, a specialized neural network designed for RTS, and manual detection of seismic signals. Transfer learning efficiency was database dependent. Additional interpretation and parametrization of detection results are assumed. Therefore, the emphasis is on phase detection, rather than phase picking accuracy, and detection sensitivity is more important than its specificity. Phase association plays a vital role in detecting seismic signals, facilitating the elimination of most false picks. As a result, the comparisons of detections were based on parameters related to the location of seismic events. The findings indicate that neither the automatic signal detection methods nor the manual methods alone are sufficient. However, their combination significantly enhances detectability. The final catalogs cover up to 30% more events compared to the previous manual. It fulfills the main aim of applying a neural network detector, which is to increase the number of seismic events in the catalog. It may also be further utilized in the research of the triggering process, such as identifying fluid paths and determining fault geometry.
- Open Access
- 10 December 2024
- Published by Springer Nature in Acta Geophysica
- Vol. 73 (3) , 2153-2169
Seismic hazard assessment in the Podhale region, Poland—zone and smoothed seismicity approach
Poland is characterised by weak natural seismicity. However, the last analysis of the natural seismic hazard in the country was carried out 24 years ago. Therefore, a significant fraction of the recorded seismicity is not included in the hazard estimates currently used, either because recent observations are not taken into account or because of improved seismic network capabilities. Furthermore, Podhale, in the Tatra Mountains, is the only region with recorded permanent natural seismicity. This study aims to create new seismic hazard maps of the Podhale region from a newly compiled database containing information on historical events and two complete instrumental catalogues (regional and local), each at a different level of completeness. The local catalogue was recorded over the last few years. Two seismic hazard assessment techniques were applied, namely the conventional (zone-based) (Cornell in Bull Seismol Soc Am 58(5): 1583–1606, 1968) and the smoothed seismicity model, based on the spatial distribution of seismicity. The earthquake recurrence parameters were estimated using the methodology developed by Kijko et al. (Bull Seismol Soc Am 106: 1210–1222, 2016). The new seismic hazard model incorporates several improvements, such as a comprehensive logic tree and a new set of ground motion models. The new maps provide a more detailed assessment of the seismic hazards of the investigated area. Moreover, they predict higher PGA than previous seismic hazard maps covering Podhale, like global European Seismic Hazard Maps 2013 and 2020.
- 10 December 2024
- Published by Springer Nature in Acta Geophysica
- Vol. 73 (3) , 2153-2169
Open AccessSeismic hazard assessment in the Podhale region, Poland—zone and smoothed seismicity approach
Poland is characterised by weak natural seismicity. However, the last analysis of the natural seismic hazard in the country was carried out 24 years ago. Therefore, a significant fraction of the recorded seismicity is not included in the hazard estimates currently used, either because recent observations are not taken into account or because of improved seismic network capabilities. Furthermore, Podhale, in the Tatra Mountains, is the only region with recorded permanent natural seismicity. This study aims to create new seismic hazard maps of the Podhale region from a newly compiled database containing information on historical events and two complete instrumental catalogues (regional and local), each at a different level of completeness. The local catalogue was recorded over the last few years. Two seismic hazard assessment techniques were applied, namely the conventional (zone-based) (Cornell in Bull Seismol Soc Am 58(5): 1583–1606, 1968) and the smoothed seismicity model, based on the spatial distribution of seismicity. The earthquake recurrence parameters were estimated using the methodology developed by Kijko et al. (Bull Seismol Soc Am 106: 1210–1222, 2016). The new seismic hazard model incorporates several improvements, such as a comprehensive logic tree and a new set of ground motion models. The new maps provide a more detailed assessment of the seismic hazards of the investigated area. Moreover, they predict higher PGA than previous seismic hazard maps covering Podhale, like global European Seismic Hazard Maps 2013 and 2020.
- 26 September 2017
- Published by Seismological Society of America (SSA) in Bulletin of the Seismological Society of America
- Vol. 107 (6) , 2636-2648
Clustering and Stress Inversion in the Song Tranh 2 Reservoir, Vietnam
The seismicity in the vicinity of the Song Tranh 2 reservoir that commenced in late 2010 is an example of reservoir‐induced seismicity. Moment tensor (MT) solutions are mostly normal‐faulting mechanisms with shearing as the main component of full MT, which suggest reservoir exploitation stress field changes as a triggering origin of this seismicity. However, the local tectonic stress field plays a role in the seismogenic process, which is accelerated by the reservoir exploitation. Two main orientations of discontinuities reactivated by reservoir exploitation are identified, with clustering of events located in two main areas: northern and southern. In addition to the northern cluster (NC) and southern cluster (SC), further smaller clusters are distinguishable, assuming both clustering of epicenters and similarity of focal mechanisms as the clustering criteria. Maximum seismic activities in clusters appear in different periods, with high seismicity in the SC preceding that in the NC. The results indicate significant differences between the NC and SC. It is shown that the SC is an example of rapid triggering, whereas the NC is a delayed triggering type. Also, magnitude distribution differs between the NC () and SC ().- 26 September 2017
- Published by Seismological Society of America (SSA) in Bulletin of the Seismological Society of America
- Vol. 107 (6) , 2636-2648
Clustering and Stress Inversion in the Song Tranh 2 Reservoir, Vietnam
The seismicity in the vicinity of the Song Tranh 2 reservoir that commenced in late 2010 is an example of reservoir‐induced seismicity. Moment tensor (MT) solutions are mostly normal‐faulting mechanisms with shearing as the main component of full MT, which suggest reservoir exploitation stress field changes as a triggering origin of this seismicity. However, the local tectonic stress field plays a role in the seismogenic process, which is accelerated by the reservoir exploitation. Two main orientations of discontinuities reactivated by reservoir exploitation are identified, with clustering of events located in two main areas: northern and southern. In addition to the northern cluster (NC) and southern cluster (SC), further smaller clusters are distinguishable, assuming both clustering of epicenters and similarity of focal mechanisms as the clustering criteria. Maximum seismic activities in clusters appear in different periods, with high seismicity in the SC preceding that in the NC. The results indicate significant differences between the NC and SC. It is shown that the SC is an example of rapid triggering, whereas the NC is a delayed triggering type. Also, magnitude distribution differs between the NC () and SC ().- 22 March 2015
- Published by Springer Nature
- p. 103-118
Seismicity of Polish Part of the Western Carpathians in the Light of Recent Data
- 22 March 2015
- Published by Springer Nature
- p. 103-118
Seismicity of Polish Part of the Western Carpathians in the Light of Recent Data