Stefano Papa
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Stefano Papa has a total of 46 co-authors. Here are the top co-authors by number of shared publications:
- Domenico Speranza
University of Cassino and Southern Lazio
4 shared publications - Romolo Di Bernardo
University of Cassino and Southern Lazio
4 shared publications - Claudio Pensa
Università degli Studi di Napoli “Federico II
3 shared publications - Fabrizio Renno
University of Naples Federico II
3 shared publications - Antonio Gloria
Department of Industrial Engineering, University of Naples Federico II, Naples, Italy
2 shared publications - Domenico Marzullo
University of Trieste
2 shared publications
Latest Publications
- Open Access
- 31 March 2026
- Published by IOP Publishing in Journal of Neural Engineering
- Vol. 23 (2)
A novel neurophysiological approach to evaluate the impact of virtual training on skills acquisition
Objective: Objective evaluation of operational training is challenging, especially when comparing physical training with virtual reality (VR). Behavioural and subjective measures capture performance and workload but provide limited insight into neurocognitive adaptation. We propose and validate an EEG-derived Cognitive Training Index (CTI) integrating multiple training-sensitive neurometrics to (i) track training progression and (ii) compare VR- versus physical-based training during subsequent real-environment execution. Approach: Participants performed three repetitions of a realistic confined-space industrial maintenance procedure with Entrance, Rolling shutter, and Pipe replacement phases. Execution time, procedural errors, and NASA-TLX were collected after each trial. Wearable EEG was recorded continuously; six neurometrics were computed from cleaned EEG using band-specific Global Field Power over predefined electrode sets. CTI was obtained via Principal Component Analysis at trial level, then analysed segment-wise. Temporal specificity was tested with phase-randomized surrogate analyses. Main results: Execution time decreased across trials (F = 14.82, p < .001, η²p = 0.35), errors decreased (F = 10.31, p < .001, η²p = 0.27), and NASA-TLX declined (F = 11.94, p < .001, η²p = 0.30). CTI increased with training (F = 18.21, p < .001, η²p = 0.39) and was higher in learning-relevant phases (Entrance and Pipe replacement) while remaining near baseline in Rolling shutter; surrogate analyses confirmed CTI exceeded null expectations. Repeated-measures correlations linked higher CTI to fewer errors (R = −0.42, p < .01) and lower NASA-TLX (R = −0.38, p < .01), with no association with execution time (R = 0.18, p = .12). Significance: CTI provides a psychologically grounded, multivariate EEG marker that tracks training progression and aligns with operationally meaningful outcomes (accuracy and perceived workload) rather than speed, enabling objective comparison of cognitive adaptation across training modalities.
- 31 March 2026
- Published by IOP Publishing in Journal of Neural Engineering
- Vol. 23 (2)
Open AccessA novel neurophysiological approach to evaluate the impact of virtual training on skills acquisition
Objective: Objective evaluation of operational training is challenging, especially when comparing physical training with virtual reality (VR). Behavioural and subjective measures capture performance and workload but provide limited insight into neurocognitive adaptation. We propose and validate an EEG-derived Cognitive Training Index (CTI) integrating multiple training-sensitive neurometrics to (i) track training progression and (ii) compare VR- versus physical-based training during subsequent real-environment execution. Approach: Participants performed three repetitions of a realistic confined-space industrial maintenance procedure with Entrance, Rolling shutter, and Pipe replacement phases. Execution time, procedural errors, and NASA-TLX were collected after each trial. Wearable EEG was recorded continuously; six neurometrics were computed from cleaned EEG using band-specific Global Field Power over predefined electrode sets. CTI was obtained via Principal Component Analysis at trial level, then analysed segment-wise. Temporal specificity was tested with phase-randomized surrogate analyses. Main results: Execution time decreased across trials (F = 14.82, p < .001, η²p = 0.35), errors decreased (F = 10.31, p < .001, η²p = 0.27), and NASA-TLX declined (F = 11.94, p < .001, η²p = 0.30). CTI increased with training (F = 18.21, p < .001, η²p = 0.39) and was higher in learning-relevant phases (Entrance and Pipe replacement) while remaining near baseline in Rolling shutter; surrogate analyses confirmed CTI exceeded null expectations. Repeated-measures correlations linked higher CTI to fewer errors (R = −0.42, p < .01) and lower NASA-TLX (R = −0.38, p < .01), with no association with execution time (R = 0.18, p = .12). Significance: CTI provides a psychologically grounded, multivariate EEG marker that tracks training progression and aligns with operationally meaningful outcomes (accuracy and perceived workload) rather than speed, enabling objective comparison of cognitive adaptation across training modalities.
- 7 April 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Oceanic Engineering
- Vol. 50 (3) , 1993-2004
A Comparative Study of Reverse Engineering Approaches Toward the Design and Analysis of 2-D High-Speed Hydrofoils
In recent years, maritime industries have focused their attention on hydrofoils as one of the main technologies for the development of eco-sustainable solutions in the field of boating. The aim of the current research was to analyze the front wing of a Kohlkida class hydrofoil and to describe the methodology employed for the reconstruction of the 2-D airfoils by means of photogrammetry. Considering the limitations of the photogrammetry methods, some sections were extracted from the model. The airfoils were properly scaled and first compared with the model obtained by means of a laser scanner. Under the operating condition of the hydrofoil and with the use of Reynolds-averaged Navier–Stokes simulations, the behavior of the airfoils was simulated, allowing us to verify how the geometric differences due to the photogrammetry approach affect the fluid dynamics, in comparison to the model obtained from laser scanning. The proposed methodology led to a geometry reconstruction with adequate accuracy for the identification of both the characteristic curves for the lift and drag coefficients with a maximum error of 6% in the angle-of-attack range investigated in the study, also highlighting fluid dynamics problems that characterize this type of airfoils with a flat bottom and a knife-sharp leading edge.
- 7 April 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Oceanic Engineering
- Vol. 50 (3) , 1993-2004
A Comparative Study of Reverse Engineering Approaches Toward the Design and Analysis of 2-D High-Speed Hydrofoils
In recent years, maritime industries have focused their attention on hydrofoils as one of the main technologies for the development of eco-sustainable solutions in the field of boating. The aim of the current research was to analyze the front wing of a Kohlkida class hydrofoil and to describe the methodology employed for the reconstruction of the 2-D airfoils by means of photogrammetry. Considering the limitations of the photogrammetry methods, some sections were extracted from the model. The airfoils were properly scaled and first compared with the model obtained by means of a laser scanner. Under the operating condition of the hydrofoil and with the use of Reynolds-averaged Navier–Stokes simulations, the behavior of the airfoils was simulated, allowing us to verify how the geometric differences due to the photogrammetry approach affect the fluid dynamics, in comparison to the model obtained from laser scanning. The proposed methodology led to a geometry reconstruction with adequate accuracy for the identification of both the characteristic curves for the lift and drag coefficients with a maximum error of 6% in the angle-of-attack range investigated in the study, also highlighting fluid dynamics problems that characterize this type of airfoils with a flat bottom and a knife-sharp leading edge.
- 2 April 2025
- Published by Springer Nature
- p. 65-73
A Visual Programming Approach to T Hydrofoil Design
- 7 February 2024
- Published by Springer Nature
- p. 339-346
Hydrofoil Technology: Current Applications and Future Developments for Sustainable Boating
- 7 February 2024
- Published by Springer Nature
- p. 339-346
Hydrofoil Technology: Current Applications and Future Developments for Sustainable Boating
- 25 September 2022
- Published by Springer Nature
- p. 1448-1459
Development of a Parametric Scene Editor of Serious Games for Safety in Workplaces
- 25 September 2022
- Published by Springer Nature
- p. 1448-1459
Development of a Parametric Scene Editor of Serious Games for Safety in Workplaces
- 25 September 2022
- Published by Springer Nature
- p. 122-134
Basic Design and Virtual Prototyping of a Hydrofoil Hybrid Daysailer
- 25 September 2022
- Published by Springer Nature
- p. 122-134
Basic Design and Virtual Prototyping of a Hydrofoil Hybrid Daysailer
- 1 December 2021
- Published by Springer Nature
- p. 668-674
Virtual Prototyping and FEM Analysis of the Crystal Eye Detector
- 1 December 2021
- Published by Springer Nature
- p. 668-674
Virtual Prototyping and FEM Analysis of the Crystal Eye Detector
- Open Access
- 12 October 2020
- Published by Springer Nature in International Journal on Interactive Design and Manufacturing (IJIDeM)
- Vol. 15 (1) , 81-84
Systems Engineering approach for the concept design of the Crystal Eye detector
Main targets of this activity research are the making and the optimization of new detectors by means of the Systems Engineering methods. With the observation of the gravitational wave event of August 17th, 2017 and then with those of the extragalactic neutrino of September 22nd, the Multimessenger Astrophysics era began. It is a new way of exploring the Universe, powered by globally coordinated observations of several experiments. So, new X and gamma rays’ detectors solutions are needed in order to provide competitive results in the energy range 10 keV–10 meV. Here is briefly described how the Systems Engineering can improve the development of the proposal of a new technique: The Crystal Eye, a wide field of view detector with a good spatial resolution obtained thanks to a high pixelation.
- 12 October 2020
- Published by Springer Nature in International Journal on Interactive Design and Manufacturing (IJIDeM)
- Vol. 15 (1) , 81-84
Open AccessSystems Engineering approach for the concept design of the Crystal Eye detector
Main targets of this activity research are the making and the optimization of new detectors by means of the Systems Engineering methods. With the observation of the gravitational wave event of August 17th, 2017 and then with those of the extragalactic neutrino of September 22nd, the Multimessenger Astrophysics era began. It is a new way of exploring the Universe, powered by globally coordinated observations of several experiments. So, new X and gamma rays’ detectors solutions are needed in order to provide competitive results in the energy range 10 keV–10 meV. Here is briefly described how the Systems Engineering can improve the development of the proposal of a new technique: The Crystal Eye, a wide field of view detector with a good spatial resolution obtained thanks to a high pixelation.