Jothirathinam Subramani
Jothirathinam Subramani has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
Anbuselvam
Department of Electrical and Electronics Engineering, Saveetha School of Engineering, SIMATS, Chennai 600077, India
1 shared publication- Balasubramanian Kalidasan
Sunway Centre for Electrochemical Energy and Sustainable Technology (SCEEST), Faculty of Engineering and Technology, Sunway University, Selangor, Malaysia
1 shared publication - Natarajan Anbuselvan
Vemu Institute of Technology
1 shared publication - Natarajan Prabaharan
School of Electrical & Electronics Engineering, SASTRA Deemed University, Thanjavur, India
1 shared publication P. Sevvel
Department of Mechanical Engineering, S.A. Engineering College, Affiliated to Anna University, Chennai 600077, India
1 shared publicationS.A. Srinivasan
R&D Department, Fluidtherm Technologies Pvt. Ltd., Chennai 600058, India
1 shared publication
Latest Publications
- Open Access
- 3 September 2021
- Published by MDPI AG in Sustainability
- Vol. 13 (17) , 9918
Investigation on the Optical Design and Performance of a Single-Axis-Tracking Solar Parabolic trough Collector with a Secondary Reflector
The design of solar concentrating collectors for the effective utilization of solar energy is a challenging condition due to tracking errors leading to different divergences of the solar incidence angle. To enhance the optical performance of solar parabolic trough collectors (SPTC) under a diverged solar incidence angle, an additional compound parabolic concentrator (CPC) is introduced as a secondary reflector. SPTC with CPC is designed and modeled for a single axis-tracking concentrating collector based on the local ambient conditions. In this work, the optical performance of the novel SPTC system with and without a secondary reflector is investigated using MATLAB and TRACEPRO software simulations for various tracking errors. The significance parameters such as the solar incidence angle, aperture length, receiver tube diameter, rim angle, concentration ratio, solar radiation, and absorbed flux are analyzed. The simulation results show that the rate of the absorbed flux on the receiver tube is significantly improved by providing the secondary reflector, which enhances the optical efficiency of the collector. It is found that the optical efficiency of the SPTC with a secondary reflector is 20% higher than the conventional collector system for a solar incidence angle of 2°. This work can effectively direct the choice of optimal secondary reflectors for SPTC under different design and operating conditions.
- 3 September 2021
- Published by MDPI AG in Sustainability
- Vol. 13 (17) , 9918
Open AccessInvestigation on the Optical Design and Performance of a Single-Axis-Tracking Solar Parabolic trough Collector with a Secondary Reflector
The design of solar concentrating collectors for the effective utilization of solar energy is a challenging condition due to tracking errors leading to different divergences of the solar incidence angle. To enhance the optical performance of solar parabolic trough collectors (SPTC) under a diverged solar incidence angle, an additional compound parabolic concentrator (CPC) is introduced as a secondary reflector. SPTC with CPC is designed and modeled for a single axis-tracking concentrating collector based on the local ambient conditions. In this work, the optical performance of the novel SPTC system with and without a secondary reflector is investigated using MATLAB and TRACEPRO software simulations for various tracking errors. The significance parameters such as the solar incidence angle, aperture length, receiver tube diameter, rim angle, concentration ratio, solar radiation, and absorbed flux are analyzed. The simulation results show that the rate of the absorbed flux on the receiver tube is significantly improved by providing the secondary reflector, which enhances the optical efficiency of the collector. It is found that the optical efficiency of the SPTC with a secondary reflector is 20% higher than the conventional collector system for a solar incidence angle of 2°. This work can effectively direct the choice of optimal secondary reflectors for SPTC under different design and operating conditions.
- 16 October 2020
- Published by Elsevier in Materials Today: Proceedings
- Vol. 45, 1857-1861
Influence of CNT coating on the efficiency of solar parabolic trough collector using AL2O3 nanofluids - a multiple regression approach
- 16 October 2020
- Published by Elsevier in Materials Today: Proceedings
- Vol. 45, 1857-1861
Influence of CNT coating on the efficiency of solar parabolic trough collector using AL2O3 nanofluids - a multiple regression approach