CMConor J. McCluskey

Conor J. McCluskey

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Conor J. McCluskey has a total of 56 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Chiral Phonon–Driven Ultrafast Spin Currents in a Non‐Magnetic Ferroelectric

    by Thomas B. Gill, Ahmet Yagmur, Matthew Rogers, Luke Benson, Nathan Fox, Ben Muggleton, Zabeada Aslam, Conor McCluskey, Phoenix Robinson, Oscar Cespedes, et al.

    The discovery that fundamental lattice vibrations can carry angular momentum allows non‐magnetic materials to exhibit properties that until now have only been observable in magnetic materials. However, the role of these specific vibrations, commonly known as chiral phonons, in driving ultrafast spin dynamics has not yet been explored experimentally. Here, using broadband terahertz emission spectroscopy, we demonstrate that the non‐magnetic ferroelectric generates signals consistent with a ultrafast spin current after excitation with an ultrafast laser pulse, which we attribute to a chiral phonon–induced spin Seebeck effect. We suggest that the transient heating creates an non‐equilibrium phonon distribution, resulting in a net angular momentum and magnetization perpendicular to the thermal gradient, which is converted into a terahertz electromagnetic pulse via an inverse spin‐Hall effect in a thin metal overlayer. The emitted field reverses sign upon flipping the sample orientation or replacing Pt with W, consistent with spin‐current generation. Polarization‐resolved measurements reveal controllable terahertz ellipticity, indicating an additional polarization‐dependent ultrafast response. Our results establish chiral phonons as a route for generating ultrafast spin currents in non‐magnetic materials as well as providing a pathway toward terahertz sources with switchable handedness.

  • Open Access

    Probing frustrated metallomolecular spin Kondo lattice interfaces through anomalous Nernst effect

    by Servet Ozdemir, Matthew Rogers, Conor J. McCluskey, Raymond G. McQuaid, Zachariah Parkin, Mannan Ali, Gavin Burnell, Joseph Barker, B. J. Hickey, Oscar Cespedes

    Frustrated Kondo spin-lattice systems away from the antiferromagnetic ground state have been found to display strange metal behavior. In two dimensions (2D), where deviations from bulk systems are expected, the emergence of Kondo spin lattices has recently been observed in van der Waals systems. Metallomolecular interfaces of supramolecular lattices have also been suggested as an alternative 2D Kondo spin-lattice system where a single-ion Kondo effect, as well as an inter-spin-site Ruderman-Kittel-Kasuya-Yosida coupling, has been demonstrated in scanning tunneling microscopy studies. Here, going beyond ultrahigh-vacuum STS studies in metallomolecular interfaces, we report a metastable frustrated antiferromagnetic state, with ultrahigh spin-freezing temperatures T f ranging from 240 to 300 K on the interfaces of highly textured Pt(111) and Pt(111)/Co films with organic molecules grown in an ultrahigh vacuum of approximately 10 − 10 mbar . A signature of the expected strange metal behavior in correlated systems is a large Nernst response. In the vicinity of the spin-freezing transition, we measure a large anomalous Nernst effect in the Pt/Co/molecule heterostructures that we attribute to the frustrated 2D Kondo spin lattice interface, with an anomalous Nernst coefficient of at least 3 µ V / K .

  • Open Access

    Perspective: Domain wall nanoelectronics

    by C. J. McCluskey, K. M. Holsgrove, J. M. Gregg

    Ferroelectric domain walls are two-dimensional interface structures with electrical conductivities that can be many orders of magnitude greater than the matrix they surround. They can be p- or n-type, metallic, and even superconducting. They necessarily exist in networks, where each wall must terminate either at another wall or at a bounding surface. In that sense, they form ready-made electrical circuits, only needing external contacts and connections to power sources. Crucially, walls can be created, moved, and annihilated by externally applied fields and, thus, wall networks are completely reconfigurable. This microstructural malleability suggests exciting possibilities for dynamic domain wall circuitry, which can be configured for one purpose in one instant, only to be completely reconfigured for a different purpose in the next. In this Perspective article, we will summarize the physics responsible for domain wall conduction, focusing on the effects of apparent polar divergence. We will present progress made to date, in the site-specific injection and controlled motion of domain walls, and discuss the kinds of devices realized so far (such as binary memory, memristors, p–n junctions, diodes, transistors, logic gates, and artificial synapses) that either rely on domain wall conducting conduits or can be made by controlling wall morphology. Challenges and needs for developing meaningful technology, based on domain walls, will also be explored.


  • Open Access

    Current Flow Mapping in Conducting Ferroelectric Domain Walls Using Scanning NV‐Magnetometry

    by Conor J. McCluskey, James Dalzell, Amit Kumar, J. Marty Gregg

    The electrical conductivity of parallel plate capacitors, with ferroelectric lithium niobate as the dielectric layer, can be extensively and progressively modified by the controlled injection of conducting domain walls. Domain wall‐based memristor devices result. Microstructures, developed as a result of partial switching, are complex, and so simple models of equivalent circuits, based on the collective action of all conducting domain wall channels acting identically and in parallel, may not be appropriate. Here, the current density in ferroelectric domain wall memristors is directly mapped in situ by mapping Oersted fields, using nitrogen vacancy center microscopy. Current density maps are found to directly correlate with the domain microstructure, revealing that a strikingly small fraction of the total domain wall network is responsible for the majority of the current flow. This insight forces a two order of magnitude correction to the carrier densities, previously inferred from standard scanning probe or macroscopic electrical characterization.


  • States of shear wander

    by Conor J. McCluskey, John Marty Gregg

  • Equivalent-circuit model that quantitatively describes domain-wall conductivity in ferroelectric LiNbO3

    by Manuel Zahn, Elke Beyreuther, Iuliia Kiseleva, Ahmed Samir Lotfy, Conor J. McCluskey, Jesi R. Maguire, Ahmet Suna, Michael Rüsing, J. Marty Gregg, Lukas M. Eng

    Ferroelectric domain wall (DW) conductivity (DWC) can be attributed to two separate mechanisms: (a) the injection/ejection of charge carriers across the Schottky barrier formed at the (metal-)electrode-DW junction and (b) the transport of those charge carriers along the DW. Current-voltage (I-U) characteristics, recorded at variable temperatures from LiNbO3 (LNO) DWs, are clearly able to differentiate between these two contributions. Practically, they allow us to directly quantify the physical parameters relevant to the two mechanisms (a) and (b) mentioned above. These are, for example, the resistance of the DW, the saturation current, the ideality factor, and the Schottky barrier height of the electrode-DW junction. Furthermore, the activation energies needed to initiate the thermally activated electronic transport along the DWs can be extracted. In addition, we show that electronic transport along LNO DWs can be elegantly viewed and interpreted in an adapted semiconductor picture based on a double-diode, double-resistor equivalent-circuit model, the R2D2 model. Finally, our R2D2 model was checked for its universality by successfully fitting the I-U curves of not only z-cut LNO bulk DWs, but equally of z-cut thin-film LNO DWs, and of x-cut thin-film DWs as reported in literature.


  • Open Access

    R2D2 -- An equivalent-circuit model that quantitatively describes domain wall conductivity in ferroelectric LiNbO$_3$

    by Manuel Zahn, Elke Beyreuther, Iuliia Kiseleva, Ahmed Samir Lotfy, Conor J. McCluskey, Jesi R. Maguire, Ahmet Suna, Michael Rüsing, J. Marty Gregg, Lukas M. Eng

    Ferroelectric domain wall (DW) conductivity (DWC) can be attributed to two separate mechanisms: (a) the injection/ejection of charge carriers across the Schottky barrier formed at the (metal-) electrode-DW junction and (b) the transport of those charge carriers along the DW. Current-voltage (IU) characteristics, recorded at variable temperatures from LiNbO$_3$ (LNO) DWs, are clearly able to differentiate between these two contributions. Practically, they allow us here to directly quantify the physical parameters relevant for the two mechanisms (a) and (b) mentioned above. These are, e.g., the resistance of the DW, the saturation current, the ideality factor, and the Schottky barrier height of the electrode/DW junction. Furthermore, the activation energies needed to initiate the thermally-activated electronic transport along the DWs, can be extracted. In addition, we show that electronic transport along LiNbO$_3$ DWs can be elegantly viewed and interpreted in an adapted semiconductor picture based on a double-diode/double-resistor equivalent circuit model, the R2D2 model. Finally, our R2D2 model was checked for its universality by fitting the DWC data not only to z-cut LNO bulk DWs, but equally to z-cut thin-film LNO DWs, and DWC from x-cut DWs as reported in literature.


  • Open Access

    Ferroelectric Domain Wall p–n Junctions

    by Jesi R. Maguire, Conor J. McCluskey, Kristina M. Holsgrove, Ahmet Suna, Amit Kumar, Raymond G. P. McQuaid, J. Marty Gregg

    We have used high-voltage Kelvin probe force microscopy to map the spatial distribution of electrical potential, dropped along curved current-carrying conducting domain walls, in x-cut single-crystal ferroelectric lithium niobate thin films. We find that in-operando potential profiles and extracted electric fields, associated with p-n junctions contained within the walls, can be fully rationalized through expected variations in wall resistivity alone. There is no need to invoke additional physics (carrier depletion zones and space-charge fields) normally associated with extrinsically doped semiconductor p-n junctions. Indeed, we argue that this should not even be expected, as inherent Fermi level differences between p and n regions, at the core of conventional p-n junction behavior, cannot occur in domain walls that are surrounded by a common matrix. This is important for domain-wall nanoelectronics, as such in-wall junctions will neither act as diodes nor facilitate transistors in the same way as extrinsic semiconducting systems do.


  • Open Access

    Domain wall saddle point morphology in ferroelectric triglycine sulfate

    by C. J. McCluskey, A. Kumar, A. Gruverman, I. Luk'YAnchuk, J. M. Gregg

    Ferroelectric domain walls, across which there is a divergence in polarization, usually have enhanced electrical conductivity relative to bulk. However, in lead germanate, head-to-head and tail-to-tail walls are electrically insulating. Recent studies have shown that this is because, when oppositely oriented domains meet, polar divergence is obviated by a combination of domain bifurcation and suspected local dipolar rotation. To explore the uniqueness, or otherwise, of this microstructure, we have used tomographic piezoresponse force microscopy to map three-dimensional domain morphologies in another uniaxial ferroelectric system: triglycine sulfate. This mapping reveals an abundance of domain wall saddle points, which are characteristic of interlocking bifurcated domains. Conducting atomic force microscopy, performed close to the saddle points, showed no evidence for highly localized conducting domain wall sections, across which a divergence in polarization might be implied; this supports the notion that localized dipolar rotation occurs to minimize any potential polar discontinuity. Overall, our study, therefore, confirms that mutual domain bifurcation and suspected local dipolar rotation are not unique to lead germanate and instead may be widely present in other uniaxial ferroelectrics.


  • Open Access

    Ultrahigh Carrier Mobilities in Ferroelectric Domain Wall Corbino Cones at Room Temperature

    by Conor J. McCluskey, Matthew G. Colbear, James P. V. McConville, Shane J. McCartan, Jesi R. Maguire, Michele Conroy, Kalani Moore, Alan Harvey, Felix Trier, Ursel Bangert, et al.

    Recently, electrically conducting heterointerfaces between dissimilar band insulators (such as lanthanum aluminate and strontium titanate) have attracted considerable research interest. Charge transport and fundamental aspects of conduction have been thoroughly explored. Perhaps surprisingly, similar studies on conceptually much simpler conducting homointerfaces, such as domain walls, are not nearly so well developed. Addressing this disparity, magnetoresistance is herein reported in approximately conical 180° charged domain walls, in partially switched ferroelectric thin‐film single‐crystal lithium niobate. This system is ideal for such measurements: first, the conductivity difference between domains and domain walls is unusually large (a factor of 1013) and hence currents driven through the thin film, between planar top and bottom electrodes, are overwhelmingly channeled along the walls; second, when electrical contact is made to the top and bottom of the domain walls and a magnetic field is applied along their cone axes, then the test geometry mirrors that of a Corbino disk: a textbook arrangement for geometric magnetoresistance measurement. Data imply carriers with extremely high room‐temperature Hall mobilities of up to ≈3700 cm2 V−1 s−1. This is an unparalleled value for oxide interfaces (and for bulk oxides) comparable to mobilities in other systems seen at cryogenic, rather than at room, temperature.