Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Mokgadi F. Bopape has a total of 23 co-authors. Here are the top co-authors by number of shared publications:

  • Maurice S. Onyango

    Department of Chemical, Metallurgical and Materials Engineering Tshwane University of Technology Pretoria 0001 South Africa

    2 shared publications
  • Opeyemi Alice Oyewo

    Department of Chemical and Materials Engineering, College of Science, Engineering and Technology, University of South Africa, South Africa

    2 shared publications
  • Abhishek Dutta

    Department of Chemical Engineering, Izmir Institute of Technology, Urla 35430, Izmir, Türkiye

    1 shared publication
  • Alseno Kagiso Mosai

    Department of Chemistry, Faculty of Natural and Agricultural Sciences, University of Pretoria, Lynnwood Road, Pretoria 0002, South Africa

    1 shared publication
  • Amber R. Solangi

    National Centre of Excellence in Analytical Chemistry, University of Sindh, Jamshoro, 76080, Pakistan

    1 shared publication
  • Amos Adeniyi

    Department of Chemical, Metallurgical and Materials Engineering, Tshwane University of Technology, Pretoria 0001, South Africa

    1 shared publication

Latest Publications

  • Top Cited Papers
    Open Access

    Unseen threats in aquatic and terrestrial ecosystems: Nanoparticle persistence, transport and toxicity in natural environments

    by Lebea N. Nthunya, Alseno K. Mosai, Eduardo Alberto López-Maldonado, Mokgadi Bopape, Subhendu Dhibar, Yannick Nuapia, Timothy O. Ajiboye, Jamil A. Buledi, Amber R. Solangi, Syed Tufail H. Sherazi, et al.


  • Open Access

    Numerical Modelling Assisted Design of a Compact Ultrafiltration (UF) Flat Sheet Membrane Module

    by Mokgadi F Bopape, Tim Van Geel, Abhishek Dutta, Bart Van der Bruggen, Maurice Stephen Onyango

    The increasing adoption of ultra-low pressure (ULP) membrane systems for drinking water treatment in small rural communities is currently hindered by a limited number of studies on module design. Detailed knowledge on both intrinsic membrane transport properties and fluid hydrodynamics within the module is essential in understanding ULP performance prediction, mass transfer analysis for scaling-up between lab-scale and industrial scale research. In comparison to hollow fiber membranes, flat sheet membranes present certain advantages such as simple manufacture, sheet replacement for cleaning, moderate packing density and low to moderate energy usage. In the present case study, a numerical model using computational fluid dynamics (CFD) of a novel custom flat sheet membrane module has been designed in 3D to predict fluid flow conditions. The permeate flux through the membrane decreased with an increase in spacer curviness from 2.81 L/m2h for no (0%) curviness to 2.73 L/m2h for full (100%) curviness. A parametric analysis on configuration variables was carried out to determine the optimum design variables and no significant influence of spacer inflow or outflow thickness on the fluid flow were observed. The numerical model provides the necessary information on the role of geometrical and operating parameters for fabricating a module prototype where access to technical expertise is limited.


  • Open Access

    Facile synthesis and application of cellulosic coagulant from banana peels in cadmium‐spiked water

    by Opeyemi A. Oyewo, Mokgadi F. Bopape, Maurice S. Onyango

    Cellulosic coagulant with low crystallinity and surface charge of −19.2 mV were extracted from wet banana peels (WBE) using kitchen‐blending method. Functionalization with ferric chloride and aluminium chloride yielded higher surface charge of −23.8 mV (mWBE). Both WBE and mWBE coagulants were used to target cadmium ions from aqueous solution. Coagulants and the floccules (WBEA and mWBEA) were characterized by XRD, FT‐IR, zeta sizer nano series, and SEM/EDs. The amount of cadmium ion coagulated was determined using ICP‐OES. The FTIR analysis revealed the functional groups involved in the coordination and subsequent removal of the metals ions around 1634 cm −1 , ascribed to the C = O vibrational band of carbonyl group. Microscopic analysis revealed that the mWBE is porous and exhibited microfibers with rod‐like morphology. The effects of parameters such as the initial concentration, coagulant dosage and solution pH were investigated. Coagulation results showed that 10 mg of WBE and mWBE could remove about 80% and 90% of the Cd 2+ ions respectively. However; the difference in the performance of both materials does not justify the essence of surface modification. Therefore, WBE is considered more efficient and environmentally friendly. Notwithstanding, the performance of these coagulants in real environmental samples will confirm their robustness.


  • Heavy metal mobility in surface water and soil, climate change, and soil interactions

    by Opeyemi A. Oyewo, Amos Adeniyi, Mokgadi F. Bopape, Maurice S. Onyango


  • Open Access

    Sorption of Pb(II) and Cu(II) by low-cost magnetic eggshells-Fe3O4 powder

    by Jianwei Ren, Mokgadi Bopape, Katlego Setshedi, Jacob Kitinya, Maurice Onyango

    This study explored the feasibility of using magnetic eggshell-Fe3O4 powder as adsorbent for the removal of Pb(II) and Cu(II) ions from aqueous solution. The metal ionsadsorption media interaction was characterized using XRD and FTIR. The effects of contact time, initial concentrations, temperature, solution pH and reusability of the adsorption media were investigated. The metal ions adsorption was fast and the amount of metal ions adsorbed increased with an increase in temperature, suggesting an endothermic adsorption. The kinetic data showed that the adsorption process followed the pseudo-second-order kinetic model. The optimal adsorption pH value was around 5.5 at which condition the equilibrium capacity was 263.2 mg/g for Pb(II) and 250.0 for Cu(II). The adsorption equilibrium data fitted very well to the Langmuir and Freundlich adsorption isotherm models. The thermodynamics of Pb(II) and Cu(II) adsorption onto the magnetic eggshell-Fe3O4 powder indicated that the adsorption was spontaneous. The reusability study has proven that magnetic eggshell-Fe3O4 powder can be employed as a low-cost and easy to separate adsorbent.