Stanislav Bartoň
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Stanislav Bartoň has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
- Magdalena Daria Vaverková
Warsaw University of Life Sciences – SGGW
5 shared publications - Dana Adamcová
Department of Applied and Landscape Ecology, Faculty of AgriSciences, Mendel University in Brno, Zemědělská 1, 613 00 Brno, Czech Republic
4 shared publications - Maja Radziemska
Institute of Environmental Engineering, Warsaw University of Life Sciences, Nowoursynowska 159, 02-776 Warsaw, Poland
3 shared publications - Eugeniusz Koda
Warsaw University of Life Sciences – SGGW
2 shared publications - Jakub Elbl
Department of Agrosystems and Bioclimatology, Faculty of AgriSciences, Mendel University in Brno, Zemědělská 1, 613 00 Brno, Czech Republic
2 shared publications Jindřich Kynický
Mendel University in Brno, Faculty of Forestry and Wood Technology, Department of Geology and Pedology, Zemědělská 3, 613 00 Brno, Czech Republic
2 shared publications
Latest Publications
- Open Access
- 15 May 2025
- Published by Institute of Mathematics, Czech Academy of Sciences
- p. 7-15
Aerodynamic deceleration at velocities near the escape velocity
This article presents basic procedures for calculating the trajectory of a spaceship that uses only the Earth's atmosphere to reduce its speed, allowing it to land on the Earth's surface successfully. The first flight of the {\tt ARTEMIS} program, which took place from November 16 to December 11 2022, was used as a template for the calculations. All calculations are performed in the symbolic algebra program Maple. To simplify the calculations, forces that have a less significant impact on the shape of the trajectory, such as the gravitational influence of the Sun and Moon, the rotation of the Earth, and its non-spherical shape, were neglected. To conserve space, only the essential components of the solution are shown, given the intensive calculations involved. The commands used to produce the graphics are not included.
- 15 May 2025
- Published by Institute of Mathematics, Czech Academy of Sciences
- p. 7-15
Open AccessAerodynamic deceleration at velocities near the escape velocity
This article presents basic procedures for calculating the trajectory of a spaceship that uses only the Earth's atmosphere to reduce its speed, allowing it to land on the Earth's surface successfully. The first flight of the {\tt ARTEMIS} program, which took place from November 16 to December 11 2022, was used as a template for the calculations. All calculations are performed in the symbolic algebra program Maple. To simplify the calculations, forces that have a less significant impact on the shape of the trajectory, such as the gravitational influence of the Sun and Moon, the rotation of the Earth, and its non-spherical shape, were neglected. To conserve space, only the essential components of the solution are shown, given the intensive calculations involved. The commands used to produce the graphics are not included.
- Open Access
- 24 April 2023
- Published by Institute of Mathematics, Czech Academy of Sciences
- p. 7-14
Visualisation of the electromagnetic vector fields
Modern computer algebra software can be used to visualize vector fields. One of the most used is the Maple program. This program is used to visualize two and three-dimensional vector fields. The possibilities of plotting direction vectors, lines of force, equipotential curves and the method of colouring the surface area for two-dimensional cases are shown step by step. For three-dimensional arrays, these methods are applied to various slices of three-dimensional space, such as a plane or a cylindrical surface. Finally, the temporal evolution of the vector fields is illustrated by animations based on the above methods. In contrast to the publication [2], which deals only with the problem of colouring vector fields, the present paper makes a completely comprehensive study of the problem, including the representation of vectors in a predefined network, the computation of the shape of power lines, and the animation of time changes, including the animation of the coloured vector fields.
- 24 April 2023
- Published by Institute of Mathematics, Czech Academy of Sciences
- p. 7-14
Open AccessVisualisation of the electromagnetic vector fields
Modern computer algebra software can be used to visualize vector fields. One of the most used is the Maple program. This program is used to visualize two and three-dimensional vector fields. The possibilities of plotting direction vectors, lines of force, equipotential curves and the method of colouring the surface area for two-dimensional cases are shown step by step. For three-dimensional arrays, these methods are applied to various slices of three-dimensional space, such as a plane or a cylindrical surface. Finally, the temporal evolution of the vector fields is illustrated by animations based on the above methods. In contrast to the publication [2], which deals only with the problem of colouring vector fields, the present paper makes a completely comprehensive study of the problem, including the representation of vectors in a predefined network, the computation of the shape of power lines, and the animation of time changes, including the animation of the coloured vector fields.
- 11 December 2021
- Published by Springer Nature
- p. 368-377
Mathematical Model of Multi-wave Pandemic COVID-19
- 11 December 2021
- Published by Springer Nature
- p. 368-377
Mathematical Model of Multi-wave Pandemic COVID-19
- Open Access
Analytical Modelling of MSW Landfill Surface Displacement Based on GNSS Monitoring
Displacements of landfills play an important role in the reclamation process and geotechnical safety improvement of such sites. Landfill settlements are defined as a vertical displacement of waste body due to compression, degradable nature of the waste, and creep phenomenon of the waste particles. Waste composition is more diverse than natural soil. Thus, it has to be properly placed and compacted since the landfill body will continuously settle down. Several models of the landfill displacement estimation have already been developed. The aim of the present study was: (i) to review the methods of landfill settlements computation and (ii) to propose the model allowing landfill body displacements simulation based on monitoring datasets applying a Global Navigation Satellite Systems (GNSS) measurement. The new model employs Gauss-Newton iteration and Runge-Kutta methods to estimate landfill surface displacements. The objectives were to analyse and mathematically describe the landfill body displacements. The GNSS geodetic survey and computations allowed concluding that the landfill body has been transformed over the years. The results revealed that the curves of waste displacement are in agreement with the measured total displacement of the landfill, and all curves corresponding to waste displacement are perpendicular to the active edge of the landfill. In the period of a maximum of 4.5 years after the waste deposition with a layer of up to 16.2 m thickness, the phenomenon of expansion was observed, which then disappears, and more settlement occurs due to the gravity of upper layers. The analysed landfill as a whole does not experience significant displacements. Neither of the slope failures are observed, even for large inclination.
Open AccessAnalytical Modelling of MSW Landfill Surface Displacement Based on GNSS Monitoring
Displacements of landfills play an important role in the reclamation process and geotechnical safety improvement of such sites. Landfill settlements are defined as a vertical displacement of waste body due to compression, degradable nature of the waste, and creep phenomenon of the waste particles. Waste composition is more diverse than natural soil. Thus, it has to be properly placed and compacted since the landfill body will continuously settle down. Several models of the landfill displacement estimation have already been developed. The aim of the present study was: (i) to review the methods of landfill settlements computation and (ii) to propose the model allowing landfill body displacements simulation based on monitoring datasets applying a Global Navigation Satellite Systems (GNSS) measurement. The new model employs Gauss-Newton iteration and Runge-Kutta methods to estimate landfill surface displacements. The objectives were to analyse and mathematically describe the landfill body displacements. The GNSS geodetic survey and computations allowed concluding that the landfill body has been transformed over the years. The results revealed that the curves of waste displacement are in agreement with the measured total displacement of the landfill, and all curves corresponding to waste displacement are perpendicular to the active edge of the landfill. In the period of a maximum of 4.5 years after the waste deposition with a layer of up to 16.2 m thickness, the phenomenon of expansion was observed, which then disappears, and more settlement occurs due to the gravity of upper layers. The analysed landfill as a whole does not experience significant displacements. Neither of the slope failures are observed, even for large inclination.
- Open Access
- 4 September 2019
- Published by IntechOpen
Optimization of Kinematics of Inclined Swinging Pin
The inclined swinging pin simply transforms the rotary motion into a rotational oscillation. It consists of three components, a rotating inclined tenon, a crossbeam, and a stirrup. The pitch angle of the inclined tenon relative to the x-axis of its rotation is decisive for the kinematics of this joint. Too small inclination angle will result in small amplitude of oscillation; too much inclination will lead to an impulse dynamic stress that can damage the pin. The optimal angle of inclination can be determined from the mathematical model, created in the Maple environment, which uses linear algebra resources to describe the behavior of the joint. Vectors of coordinates of the critical points are created for each joint component. Furthermore, transformation matrices are created which describe the behavior of the corresponding kinematic chain in relation to the inclination angle of the inclined tenon and time.
- 4 September 2019
- Published by IntechOpen
Open AccessOptimization of Kinematics of Inclined Swinging Pin
The inclined swinging pin simply transforms the rotary motion into a rotational oscillation. It consists of three components, a rotating inclined tenon, a crossbeam, and a stirrup. The pitch angle of the inclined tenon relative to the x-axis of its rotation is decisive for the kinematics of this joint. Too small inclination angle will result in small amplitude of oscillation; too much inclination will lead to an impulse dynamic stress that can damage the pin. The optimal angle of inclination can be determined from the mathematical model, created in the Maple environment, which uses linear algebra resources to describe the behavior of the joint. Vectors of coordinates of the critical points are created for each joint component. Furthermore, transformation matrices are created which describe the behavior of the corresponding kinematic chain in relation to the inclination angle of the inclined tenon and time.
- 20 April 2019
- Published by Institute of Mathematics, Czech Academy of Sciences
- p. 7-14
The dynamics of the drum mower blade
The drum mower blade is freely rotatable around the fastening pin. During the operation of the mower, the centrifugal force and the resistance of the mowing material act on it. The presented article studies the effect of these forces on the behavior of the blade, in particular its oscillation around the steady state, depending on the properties of the cut material.
- 20 April 2019
- Published by Institute of Mathematics, Czech Academy of Sciences
- p. 7-14
The dynamics of the drum mower blade
The drum mower blade is freely rotatable around the fastening pin. During the operation of the mower, the centrifugal force and the resistance of the mowing material act on it. The presented article studies the effect of these forces on the behavior of the blade, in particular its oscillation around the steady state, depending on the properties of the cut material.
- 1 October 2018
- Published by Elsevier in Chemosphere
- Vol. 208, 569-578
Environmental risk assessment and consequences of municipal solid waste disposal
- 1 October 2018
- Published by Elsevier in Chemosphere
- Vol. 208, 569-578
Environmental risk assessment and consequences of municipal solid waste disposal
- 14 August 2018
- Published by Wiley in Land Degradation & Development
- Vol. 29 (10) , 3674-3680
The use of vegetation as a natural strategy for landfill restoration
It is well‐known that the disposal of municipal solid waste in landfills has adverse effects on the environment and human health. Restoration of closed landfills is essential to compensate for disturbances in the ecosystem, minimize negative impact on the environment, and ensure safety in further use. It was hypothesized that specific plant succession knowledge can present nature‐based solutions to restore and rehabilitate degraded ecosystems at municipal solid waste landfills. The goal of the 8‐year study was to identify restoration strategies based on vegetation succession. For the vegetation survey, we recorded the vegetation over the period 2007–2015. The study was carried out on the surface of the landfill site. We also used four mathematical models to analyze the increase of plant species over time. During the study period, 195 vascular plant species were recorded. There was a progressive change in plant communities and an increase in biodiversity. What is more, the growth prediction models show that the diversity of plant species over time at the landfill site has an increasing tendency, which has beneficial implications for landfill restoration. During the vegetation survey period, there was no evidence to suggest that the landfill site had a significant impact on the biotic composition of the environment. We can conclude that the health status of plants occurring in the landfill was good. Plants both contributed to and indicated the health of the landfill site and were found to be a convenient and natural component of landfill restoration.
- 14 August 2018
- Published by Wiley in Land Degradation & Development
- Vol. 29 (10) , 3674-3680
The use of vegetation as a natural strategy for landfill restoration
It is well‐known that the disposal of municipal solid waste in landfills has adverse effects on the environment and human health. Restoration of closed landfills is essential to compensate for disturbances in the ecosystem, minimize negative impact on the environment, and ensure safety in further use. It was hypothesized that specific plant succession knowledge can present nature‐based solutions to restore and rehabilitate degraded ecosystems at municipal solid waste landfills. The goal of the 8‐year study was to identify restoration strategies based on vegetation succession. For the vegetation survey, we recorded the vegetation over the period 2007–2015. The study was carried out on the surface of the landfill site. We also used four mathematical models to analyze the increase of plant species over time. During the study period, 195 vascular plant species were recorded. There was a progressive change in plant communities and an increase in biodiversity. What is more, the growth prediction models show that the diversity of plant species over time at the landfill site has an increasing tendency, which has beneficial implications for landfill restoration. During the vegetation survey period, there was no evidence to suggest that the landfill site had a significant impact on the biotic composition of the environment. We can conclude that the health status of plants occurring in the landfill was good. Plants both contributed to and indicated the health of the landfill site and were found to be a convenient and natural component of landfill restoration.
- 1 October 2017
- Published by Elsevier in Chemosphere
- Vol. 185, 1011-1018
Environmental assessment of the effects of a municipal landfill on the content and distribution of heavy metals in Tanacetum vulgare L.
- 1 October 2017
- Published by Elsevier in Chemosphere
- Vol. 185, 1011-1018
Environmental assessment of the effects of a municipal landfill on the content and distribution of heavy metals in Tanacetum vulgare L.
- Open Access
- 1 September 2017
- Published by Mendel University Press in Acta Universitatis Agriculturae et Silviculturae Mendelianae Brunensis
- Vol. 65 (4) , 1113-1119
Stability Modelling of Boom Mover by the Maple Program
Acta Universitatis Agriculturae et Silviculturae Mendelianae Brunensis, the scientific journal of the Mendel University in Brno, Czech Republic
- 1 September 2017
- Published by Mendel University Press in Acta Universitatis Agriculturae et Silviculturae Mendelianae Brunensis
- Vol. 65 (4) , 1113-1119
Open AccessStability Modelling of Boom Mover by the Maple Program
Acta Universitatis Agriculturae et Silviculturae Mendelianae Brunensis, the scientific journal of the Mendel University in Brno, Czech Republic