James Molson
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
James Molson has a total of 1000 co-authors. Here are the top co-authors by number of shared publications:
R. Bruce
CERN, Geneva, Switzerland
7 shared publicationsS. Redaelli
CERN, Geneva, Switzerland
6 shared publicationsA. Abramov
Royal Holloway University (RHUL)
5 shared publicationsA. Lechner
CERN, Geneva, Switzerland
5 shared publicationsB. Goddard
European Organization for Nuclear Research (CERN)
5 shared publicationsE. Skordis
CERN, Geneva, Switzerland
5 shared publications
Latest Publications
- 1 February 2022
- Published by Elsevier in Computer Physics Communications
- Vol. 271
Merlin++, a flexible and feature-rich accelerator physics and particle tracking library
- 1 February 2022
- Published by Elsevier in Computer Physics Communications
- Vol. 271
Merlin++, a flexible and feature-rich accelerator physics and particle tracking library
- Open Access
- 6 November 2020
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 23 (11) , 111002
Simulations of heavy-ion halo collimation at the CERN Large Hadron Collider: Benchmark with measurements and cleaning performance evaluation
Protons and heavy-ion beams at unprecedented energies are brought into collisions in the CERN Large Hadron Collider (LHC) for high-energy experiments. The LHC multistage collimation system is designed to provide protection against regular and abnormal losses in order to reduce the risk of quenches of the superconducting magnets as well as keeping background in the experiments under control. Compared to protons, beam collimation in the heavy-ion runs is more challenging despite the lower stored beam energies, because the efficiency of cleaning with heavy ions has been observed to be 2 orders of magnitude worse. This is due to the differences in the interaction mechanisms between the beams and the collimators. Ion beams experience fragmentation and electromagnetic dissociation at the collimators that result in a substantial flux of off-rigidity particles that escape the collimation system. These out-scattered nuclei might be lost around the ring, eventually imposing a limit on the maximum achievable stored beam energy. The more stringent limit comes from potential quenches of superconducting magnets. Accurate simulation tools are crucial in order to understand and control these losses. A new simulation framework has been developed for heavy-ion collimation based on the coupling of the SixTrack tracking code, which has been extended to track arbitrary heavy-ion species, and the fluka Monte Carlo code that models the electromagnetic and nuclear interactions of the heavy ions with the nuclei of the collimator material. In this paper, the functionality of the new simulation tool is described. Furthermore, SixTrack-fluka coupling simulations are presented and compared with measurements done with ions in the LHC. The agreement between simulations and measurements is discussed and the results are used to understand and optimize losses. The simulation tool is also applied to predict the performance of the collimation system for the high-luminosity LHC. Based on the simulation results and the experience gained in past heavy-ion runs, some conclusions are presented.- 6 November 2020
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 23 (11) , 111002
Open AccessSimulations of heavy-ion halo collimation at the CERN Large Hadron Collider: Benchmark with measurements and cleaning performance evaluation
Protons and heavy-ion beams at unprecedented energies are brought into collisions in the CERN Large Hadron Collider (LHC) for high-energy experiments. The LHC multistage collimation system is designed to provide protection against regular and abnormal losses in order to reduce the risk of quenches of the superconducting magnets as well as keeping background in the experiments under control. Compared to protons, beam collimation in the heavy-ion runs is more challenging despite the lower stored beam energies, because the efficiency of cleaning with heavy ions has been observed to be 2 orders of magnitude worse. This is due to the differences in the interaction mechanisms between the beams and the collimators. Ion beams experience fragmentation and electromagnetic dissociation at the collimators that result in a substantial flux of off-rigidity particles that escape the collimation system. These out-scattered nuclei might be lost around the ring, eventually imposing a limit on the maximum achievable stored beam energy. The more stringent limit comes from potential quenches of superconducting magnets. Accurate simulation tools are crucial in order to understand and control these losses. A new simulation framework has been developed for heavy-ion collimation based on the coupling of the SixTrack tracking code, which has been extended to track arbitrary heavy-ion species, and the fluka Monte Carlo code that models the electromagnetic and nuclear interactions of the heavy ions with the nuclei of the collimator material. In this paper, the functionality of the new simulation tool is described. Furthermore, SixTrack-fluka coupling simulations are presented and compared with measurements done with ions in the LHC. The agreement between simulations and measurements is discussed and the results are used to understand and optimize losses. The simulation tool is also applied to predict the performance of the collimation system for the high-luminosity LHC. Based on the simulation results and the experience gained in past heavy-ion runs, some conclusions are presented. - Open Access
- 23 October 2020
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 23 (10) , 101002
Collimation of partially stripped ions in the CERN Large Hadron Collider
In the scope of the Physics Beyond Colliders studies, the gamma-factory initiative proposes the use of partially stripped ions as a driver of a new type of high-intensity photon source in CERN Large Hadron Collider (LHC). In 2018, the LHC accelerated and stored partially stripped ions for the first time. The collimation system efficiency recorded during this test was found to be prohibitively low, so that only a very low-intensity beam could be stored without the risk of triggering a beam dump when regular, minor beam losses occur. The worst losses were localized in the dispersion suppressor of the betatron-cleaning insertion. This article presents an analysis to understand in detail the source of these losses. Based on this understanding, possible mitigation measures that could significantly improve the cleaning efficiency and enable regular operation with partially stripped ions in the future are developed.- 23 October 2020
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 23 (10) , 101002
Open AccessCollimation of partially stripped ions in the CERN Large Hadron Collider
In the scope of the Physics Beyond Colliders studies, the gamma-factory initiative proposes the use of partially stripped ions as a driver of a new type of high-intensity photon source in CERN Large Hadron Collider (LHC). In 2018, the LHC accelerated and stored partially stripped ions for the first time. The collimation system efficiency recorded during this test was found to be prohibitively low, so that only a very low-intensity beam could be stored without the risk of triggering a beam dump when regular, minor beam losses occur. The worst losses were localized in the dispersion suppressor of the betatron-cleaning insertion. This article presents an analysis to understand in detail the source of these losses. Based on this understanding, possible mitigation measures that could significantly improve the cleaning efficiency and enable regular operation with partially stripped ions in the future are developed. - Open Access
- 20 October 2020
- Published by Sissa Medialab Srl
- Vol. 364, 020
Gamma Factory for CERN initiative - progress report
The Gamma Factory (GF) initiative proposes to use partially stripped ion (PSI) beams as drivers of a new type of high-intensity and high-energy (0.1–400 MeV) photon source. As part of the ongoing Physics Beyond Collider studies, initial beam tests were carried out in 2017 and 2018 at the SPS and LHC with partially stripped xenon and lead beams. This contribution discusses the results of these tests and the preparations for the next GF R&D step: the proof-of-principle experiment at the SPS to study interaction of PSI beams with the laser light
- 20 October 2020
- Published by Sissa Medialab Srl
- Vol. 364, 020
Open AccessGamma Factory for CERN initiative - progress report
The Gamma Factory (GF) initiative proposes to use partially stripped ion (PSI) beams as drivers of a new type of high-intensity and high-energy (0.1–400 MeV) photon source. As part of the ongoing Physics Beyond Collider studies, initial beam tests were carried out in 2017 and 2018 at the SPS and LHC with partially stripped xenon and lead beams. This contribution discusses the results of these tests and the preparations for the next GF R&D step: the proof-of-principle experiment at the SPS to study interaction of PSI beams with the laser light
- Open Access
- 16 July 2019
- Published by Springer Nature in The European Physical Journal Special Topics
- Vol. 228 (5) , 1109-1382
HE-LHC: The High-Energy Large Hadron Collider
- 16 July 2019
- Published by Springer Nature in The European Physical Journal Special Topics
- Vol. 228 (5) , 1109-1382
Open AccessHE-LHC: The High-Energy Large Hadron Collider
- Top Cited PapersOpen Access
- 5 July 2019
- Published by Springer Nature in The European Physical Journal Special Topics
- Vol. 228 (4) , 755-1107
FCC-hh: The Hadron Collider
- 5 July 2019
- Published by Springer Nature in The European Physical Journal Special Topics
- Vol. 228 (4) , 755-1107
Top Cited PapersOpen AccessFCC-hh: The Hadron Collider
- Open Access
- 5 June 2019
- Published by Springer Nature in The European Physical Journal C
- Vol. 79 (6)
FCC Physics Opportunities
- 5 June 2019
- Published by Springer Nature in The European Physical Journal C
- Vol. 79 (6)
Open AccessFCC Physics Opportunities
- Top Cited PapersOpen Access
- 4 June 2019
- Published by Springer Nature in The European Physical Journal Special Topics
- Vol. 228 (2) , 261-623
FCC-ee: The Lepton Collider
- 4 June 2019
- Published by Springer Nature in The European Physical Journal Special Topics
- Vol. 228 (2) , 261-623
Top Cited PapersOpen AccessFCC-ee: The Lepton Collider
- Open Access
- 1 January 2019
- Published by Jagiellonian University in Acta Physica Polonica B
- Vol. 50 (6) , 1191-1203
Gamma Factory at CERN --- Novel Research Tools Made of Light
- 1 January 2019
- Published by Jagiellonian University in Acta Physica Polonica B
- Vol. 50 (6) , 1191-1203
Open AccessGamma Factory at CERN --- Novel Research Tools Made of Light
- Open Access
- 29 December 2017
- Published by Walter de Gruyter GmbH in Open Engineering
- Vol. 7 (1) , 379-393
LHC@Home: a BOINC-based volunteer computing infrastructure for physics studies at CERN
The LHC@Home BOINC project has provided computing capacity for numerical simulations to researchers at CERN since 2004, and has since 2011 been expanded with a wider range of applications. The traditional CERN accelerator physics simulation code SixTrack enjoys continuing volunteers support, and thanks to virtualisation a number of applications from the LHC experiment collaborations and particle theory groups have joined the consolidated LHC@Home BOINC project. This paper addresses the challenges related to traditional and virtualized applications in the BOINC environment, and how volunteer computing has been integrated into the overall computing strategy of the laboratory through the consolidated LHC@Home service. Thanks to the computing power provided by volunteers joining LHC@Home, numerous accelerator beam physics studies have been carried out, yielding an improved understanding of charged particle dynamics in the CERN Large Hadron Collider (LHC) and its future upgrades. The main results are highlighted in this paper.
- 29 December 2017
- Published by Walter de Gruyter GmbH in Open Engineering
- Vol. 7 (1) , 379-393
Open AccessLHC@Home: a BOINC-based volunteer computing infrastructure for physics studies at CERN
The LHC@Home BOINC project has provided computing capacity for numerical simulations to researchers at CERN since 2004, and has since 2011 been expanded with a wider range of applications. The traditional CERN accelerator physics simulation code SixTrack enjoys continuing volunteers support, and thanks to virtualisation a number of applications from the LHC experiment collaborations and particle theory groups have joined the consolidated LHC@Home BOINC project. This paper addresses the challenges related to traditional and virtualized applications in the BOINC environment, and how volunteer computing has been integrated into the overall computing strategy of the laboratory through the consolidated LHC@Home service. Thanks to the computing power provided by volunteers joining LHC@Home, numerous accelerator beam physics studies have been carried out, yielding an improved understanding of charged particle dynamics in the CERN Large Hadron Collider (LHC) and its future upgrades. The main results are highlighted in this paper.