Syed Mamun R. Rasid
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Syed Mamun R. Rasid has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
Aron Michael
2 shared publications- Aron Michael
School of EE&T, UNSW Sydney, Sydney, NSW, Australia
2 shared publications Hemanshu Roy Pota
2 shared publications- Hemanshu Roy Pota
University of New South Wales
2 shared publications - Ssu-Han Chen
School of Electrical Engineering and Telecommunications, University of New South Wales, Sydney, NSW, Australia
2 shared publications Chee Yee Kwok
School of Electrical Engineering and Telecommunications, University of New South Wales, Sydney, NSW, Australia
1 shared publication
Latest Publications
- 1 September 2026
- Published by IOP Publishing in Engineering Research Express
- Vol. 8 (17) , 175504
A six-axis vibration isolation Stewart platform based on displacement cancellation technique
A six-axis active vibration isolation system based on Stewart platform mechanism is developed and its performance is investigated in this study. The developed system comprises an end effector, referred to a Stewart platform, which is suspended by six identical active isolation units arranged in a mutually orthogonal configuration. Each individual unit consists of two magnetic suspension modules connected in series and independently controlled using a novel approach called the displacement cancellation technique. Consequently, each unit functions as a single-axis vibration isolation system. The efficacy of the end effector in achieving six-axis vibration isolation is evaluated by experimental investigations of its static and dynamic performance. Since the overall behavior of the isolation platform depends on the characteristics of individual unit, the detailed theoretical and experimental analyses of a single unit are carried out as well in this paper. Both theoretical predictions and experimental results demonstrate that the proposed system is effective to isolate both direct disturbances and ground-induced vibrations.
- 1 September 2026
- Published by IOP Publishing in Engineering Research Express
- Vol. 8 (17) , 175504
A six-axis vibration isolation Stewart platform based on displacement cancellation technique
A six-axis active vibration isolation system based on Stewart platform mechanism is developed and its performance is investigated in this study. The developed system comprises an end effector, referred to a Stewart platform, which is suspended by six identical active isolation units arranged in a mutually orthogonal configuration. Each individual unit consists of two magnetic suspension modules connected in series and independently controlled using a novel approach called the displacement cancellation technique. Consequently, each unit functions as a single-axis vibration isolation system. The efficacy of the end effector in achieving six-axis vibration isolation is evaluated by experimental investigations of its static and dynamic performance. Since the overall behavior of the isolation platform depends on the characteristics of individual unit, the detailed theoretical and experimental analyses of a single unit are carried out as well in this paper. Both theoretical predictions and experimental results demonstrate that the proposed system is effective to isolate both direct disturbances and ground-induced vibrations.
- 10 April 2023
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 356
Dynamic modeling of a piezoelectric micro-lens actuator with experimental validation
- 10 April 2023
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 356
Dynamic modeling of a piezoelectric micro-lens actuator with experimental validation
- 5 April 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 23 (10) , 10275-10284
On-Chip Self-Sensing Piezoelectric Micro-Lens Actuator With Feedback Control
High-speed micro-lens actuators are required for fast auto-focusing in miniaturized cameras. The speed can be enhanced by adding damping at the resonance frequency through feedback control. Previous approaches to implement the feedback control were based on expensive off-chip bulky laser sensors that are not suitable for miniaturized cameras. In this paper, using an on-chip self-sensing piezoelectric sensor with a novel readout circuit, a passive resonant controller is designed, implemented, and tested. The stability of the closed-loop micro-lens actuator is guaranteed through the use of mixed negative-imaginary and passivity theory in the controller design. The performance of the controller with the on-chip self-sensing piezoelectric sensor and readout circuit is compared to that off-chip laser sensor, and results show comparable performance. The closed-loop micro-lens actuator with the on-chip piezoelectric sensor damps the fundamental resonance mode by 20.6 dB, which is similar to the 21.9 dB reduction obtained using the off-chip laser sensor. The settling time for the closed-loop actuator using the on-chip self-sensing piezoelectric sensor is less than 10 ms, which is also comparable to the 8 ms obtained with the off-chip laser sensor. The signal-to-noise ratios for the on-chip self-sensing piezoelectric sensor and off-chip laser sensor are 108 dB and 118 dB, respectively. These results show that the piezoelectric micro-lens actuator using the on-chip self-sensing piezoelectric sensor can replace the bulky and expensive off-chip laser sensor without sacrificing performance, making it more appealing for portable micro-optics devices.
- 5 April 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 23 (10) , 10275-10284
On-Chip Self-Sensing Piezoelectric Micro-Lens Actuator With Feedback Control
High-speed micro-lens actuators are required for fast auto-focusing in miniaturized cameras. The speed can be enhanced by adding damping at the resonance frequency through feedback control. Previous approaches to implement the feedback control were based on expensive off-chip bulky laser sensors that are not suitable for miniaturized cameras. In this paper, using an on-chip self-sensing piezoelectric sensor with a novel readout circuit, a passive resonant controller is designed, implemented, and tested. The stability of the closed-loop micro-lens actuator is guaranteed through the use of mixed negative-imaginary and passivity theory in the controller design. The performance of the controller with the on-chip self-sensing piezoelectric sensor and readout circuit is compared to that off-chip laser sensor, and results show comparable performance. The closed-loop micro-lens actuator with the on-chip piezoelectric sensor damps the fundamental resonance mode by 20.6 dB, which is similar to the 21.9 dB reduction obtained using the off-chip laser sensor. The settling time for the closed-loop actuator using the on-chip self-sensing piezoelectric sensor is less than 10 ms, which is also comparable to the 8 ms obtained with the off-chip laser sensor. The signal-to-noise ratios for the on-chip self-sensing piezoelectric sensor and off-chip laser sensor are 108 dB and 118 dB, respectively. These results show that the piezoelectric micro-lens actuator using the on-chip self-sensing piezoelectric sensor can replace the bulky and expensive off-chip laser sensor without sacrificing performance, making it more appealing for portable micro-optics devices.
- 3 August 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 31 (5) , 840-850
Design and Implementation of Robust Resonant Controller for Piezoelectrically Driven Micro-Lens Actuator
MEMS based piezoelectrically driven micro-lens actuator experiences resonance frequency shift with changing actuation voltage and exhibits low level of damping. In this paper, we present the design and experimental implementation of a resonant controller, robust against the variation in dynamics, to enhance the damping at the first resonance frequency. The controller is designed using an identified model of the micro-lens actuator from experimental frequency response data at a fixed actuating voltage. The closed-loop stability is guaranteed using the mixed negative-imaginary and small-gain approach. The experimental results demonstrate a damping of 21dB of the first resonance mode. The designed controller achieved the similar level of damping for the shift in resonance frequency due to the change in the actuation voltage. The settling time, due to a step change, of the piezoelectric micro-lens actuator is reduced to 7ms from 120ms. Such quick settling time is necessary for the fast auto-focusing functionality of the piezoelectrically driven micro-lens actuator in a miniaturized camera module.2022-0137
- 3 August 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 31 (5) , 840-850
Design and Implementation of Robust Resonant Controller for Piezoelectrically Driven Micro-Lens Actuator
MEMS based piezoelectrically driven micro-lens actuator experiences resonance frequency shift with changing actuation voltage and exhibits low level of damping. In this paper, we present the design and experimental implementation of a resonant controller, robust against the variation in dynamics, to enhance the damping at the first resonance frequency. The controller is designed using an identified model of the micro-lens actuator from experimental frequency response data at a fixed actuating voltage. The closed-loop stability is guaranteed using the mixed negative-imaginary and small-gain approach. The experimental results demonstrate a damping of 21dB of the first resonance mode. The designed controller achieved the similar level of damping for the shift in resonance frequency due to the change in the actuation voltage. The settling time, due to a step change, of the piezoelectric micro-lens actuator is reduced to 7ms from 120ms. Such quick settling time is necessary for the fast auto-focusing functionality of the piezoelectrically driven micro-lens actuator in a miniaturized camera module.2022-0137
- 27 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 29 (6) , 1418-1420
Dynamic Performance Improvement of Piezoelectrically Driven Micro-Lens Actuators
This letter presents experimental results showing significant enhancement in the dynamic performance of a novel piezoelectric micro-lens actuator using a robust feedback resonant controller. The design of the feedback controller is based on experimentally identified model of the micro-lens actuator. The stability of the closed-loop system is proven by the negative imaginary theory. The experimental results show that the resonance peak and the settling time of the actuator are reduced by 27 dB and to 2.5 ms from 119 ms, respectively. Such improvement demonstrates the capability of the piezoelectric micro-lens actuator for fast auto-focus application in miniaturized camera. The reported performance makes it the fastest micro-lens actuator compared to other previously reported micro-lens actuators.
- 27 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 29 (6) , 1418-1420
Dynamic Performance Improvement of Piezoelectrically Driven Micro-Lens Actuators
This letter presents experimental results showing significant enhancement in the dynamic performance of a novel piezoelectric micro-lens actuator using a robust feedback resonant controller. The design of the feedback controller is based on experimentally identified model of the micro-lens actuator. The stability of the closed-loop system is proven by the negative imaginary theory. The experimental results show that the resonance peak and the settling time of the actuator are reduced by 27 dB and to 2.5 ms from 119 ms, respectively. Such improvement demonstrates the capability of the piezoelectric micro-lens actuator for fast auto-focus application in miniaturized camera. The reported performance makes it the fastest micro-lens actuator compared to other previously reported micro-lens actuators.