Lei Tang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Lei Tang has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Chris Dames
Department of Mechanical Engineering, University of California, Berkeley, USA
2 shared publications Chris Dames
1 shared publication- Haiping Xia
Shenzhen Grubbs Institute, Department of Chemistry, Southern University of Science and Technology, Shenzhen 518055, China
1 shared publication - Haochuan Jiang
Xian Jiaotong-Liverpool University, Suzhou, China
1 shared publication Jiangtao Peng Jiangtao Peng
Ningbo University
1 shared publication- Lívia Mantuano Corrêa
The University of Utah
1 shared publication
Latest Publications
- 17 April 2024
- Published by Springer Nature in Nature
- Vol. 629 (8010) , 67-73
Corner- and edge-mode enhancement of near-field radiative heat transfer
It is well established that near-field radiative heat transfer (NFRHT) can exceed Planck’s blackbody limit1 by orders of magnitude owing to the tunnelling of evanescent electromagnetic frustrated and surface modes2,3,4, as has been demonstrated experimentally for NFRHT between two large parallel surfaces5,6,7 and between two subwavelength membranes8,9. However, although nanostructures can also sustain a much richer variety of localized electromagnetic modes at their corners and edges10,11, the contributions of such additional modes to further enhancing NFRHT remain unexplored. Here we demonstrate both theoretically and experimentally a physical mechanism of NFRHT mediated by the corner and edge modes, and show that it can dominate the NFRHT in the ‘dual nanoscale regime’ in which both the thickness of the emitter and receiver, and their gap spacing, are much smaller than the thermal photon wavelengths. For two coplanar 20-nm-thick silicon carbide membranes separated by a 100-nm vacuum gap, the NFRHT coefficient at room temperature is both predicted and measured to be 830 W m−2 K−1, which is 5.5 times larger than that for two infinite silicon carbide surfaces separated by the same gap, and 1,400 times larger than the corresponding blackbody limit accounting for the geometric view factor between two coplanar membranes. This enhancement is dominated by the electromagnetic corner and edge modes, which account for 81% of the NFRHT between the silicon carbide membranes. These findings are important for future NFRHT applications in thermal management and energy conversion.
- 17 April 2024
- Published by Springer Nature in Nature
- Vol. 629 (8010) , 67-73
Corner- and edge-mode enhancement of near-field radiative heat transfer
It is well established that near-field radiative heat transfer (NFRHT) can exceed Planck’s blackbody limit1 by orders of magnitude owing to the tunnelling of evanescent electromagnetic frustrated and surface modes2,3,4, as has been demonstrated experimentally for NFRHT between two large parallel surfaces5,6,7 and between two subwavelength membranes8,9. However, although nanostructures can also sustain a much richer variety of localized electromagnetic modes at their corners and edges10,11, the contributions of such additional modes to further enhancing NFRHT remain unexplored. Here we demonstrate both theoretically and experimentally a physical mechanism of NFRHT mediated by the corner and edge modes, and show that it can dominate the NFRHT in the ‘dual nanoscale regime’ in which both the thickness of the emitter and receiver, and their gap spacing, are much smaller than the thermal photon wavelengths. For two coplanar 20-nm-thick silicon carbide membranes separated by a 100-nm vacuum gap, the NFRHT coefficient at room temperature is both predicted and measured to be 830 W m−2 K−1, which is 5.5 times larger than that for two infinite silicon carbide surfaces separated by the same gap, and 1,400 times larger than the corresponding blackbody limit accounting for the geometric view factor between two coplanar membranes. This enhancement is dominated by the electromagnetic corner and edge modes, which account for 81% of the NFRHT between the silicon carbide membranes. These findings are important for future NFRHT applications in thermal management and energy conversion.
- Open Access
- 24 October 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 134 (16)
Effects of thermal annealing on thermal conductivity of LPCVD silicon carbide thin films
The thermal conductivity (k) of polycrystalline SiC thin films is relevant for thermal management in emerging SiC applications like microelectromechanical and optoelectronic devices. In such films, k can be substantially reduced by microstructure features including grain boundaries, thin film surfaces, and porosity, although these microstructural effects can also be manipulated through thermal annealing. Here, we investigate these effects by using microfabricated suspended devices to measure the thermal conductivities of nine low-pressure chemical vapor deposition SiC films of varying thicknesses (from 120 to 300 nm) and annealing conditions (as-grown and annealed at 950 and 1100 °C for 2 h, and in one case 17 h). Fourier-transform infrared spectroscopy, x-ray diffraction spectra, and density measurements are also used to characterize the effects of annealing on the microstructure of selected samples. Compared to as-deposited films, annealing at 1100 °C typically increases the estimated grain size from 5.5 to 6.6 nm while decreasing the porosity from around 6.5% to practically fully dense. This corresponds to a 34% increase in the measured thin film thermal conductivity near room temperature from 5.8 to 7.8 W/m K. These thermal conductivity measurements show good agreement of better than 3% with fits using a simple theoretical model based on the kinetic theory combined with a Maxwell–Garnett porosity correction. Grain boundary scattering plays the dominant role in reducing the thermal conductivity of these films compared to bulk single-crystal values, while both grain size increase and porosity decrease play important roles in the partial k recovery of the films upon annealing. This work demonstrates the effects of modifying the microstructure and, thus, the thermal conductivity of SiC thin films by thermal annealing.
- 24 October 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 134 (16)
Open AccessEffects of thermal annealing on thermal conductivity of LPCVD silicon carbide thin films
The thermal conductivity (k) of polycrystalline SiC thin films is relevant for thermal management in emerging SiC applications like microelectromechanical and optoelectronic devices. In such films, k can be substantially reduced by microstructure features including grain boundaries, thin film surfaces, and porosity, although these microstructural effects can also be manipulated through thermal annealing. Here, we investigate these effects by using microfabricated suspended devices to measure the thermal conductivities of nine low-pressure chemical vapor deposition SiC films of varying thicknesses (from 120 to 300 nm) and annealing conditions (as-grown and annealed at 950 and 1100 °C for 2 h, and in one case 17 h). Fourier-transform infrared spectroscopy, x-ray diffraction spectra, and density measurements are also used to characterize the effects of annealing on the microstructure of selected samples. Compared to as-deposited films, annealing at 1100 °C typically increases the estimated grain size from 5.5 to 6.6 nm while decreasing the porosity from around 6.5% to practically fully dense. This corresponds to a 34% increase in the measured thin film thermal conductivity near room temperature from 5.8 to 7.8 W/m K. These thermal conductivity measurements show good agreement of better than 3% with fits using a simple theoretical model based on the kinetic theory combined with a Maxwell–Garnett porosity correction. Grain boundary scattering plays the dominant role in reducing the thermal conductivity of these films compared to bulk single-crystal values, while both grain size increase and porosity decrease play important roles in the partial k recovery of the films upon annealing. This work demonstrates the effects of modifying the microstructure and, thus, the thermal conductivity of SiC thin films by thermal annealing.
- Open Access
- 1 January 2013
- Published by Shanghai Institute of Optics and Fine Mechanics in Chinese Optics Letters
- Vol. 11 (6) , 061603-61606
Dy3+-doped LiYF4 crystals for UV-excited white light-emitting diodes
A Dy3+-doped LiYF4 single crystal capable of generating white light by simultaneous blue and yellow light emission of phosphorescent centers is produced. Chromaticity coordinates and photoluminescence intensity vary with excitation wavelength. Under 350, 365, and 388 nm excitation, the crystal shows excellent white light emission. The most efficient wavelength for white light is 388 nm. The CIE coordinates are x=0.316 and y =0.321, and the color temperature (Tc) is 6 368 K. These results indicate that the studied crystal is a potential candidate for ultraviolet light-excited white light-emitting diodes.
- 1 January 2013
- Published by Shanghai Institute of Optics and Fine Mechanics in Chinese Optics Letters
- Vol. 11 (6) , 061603-61606
Open AccessDy3+-doped LiYF4 crystals for UV-excited white light-emitting diodes
A Dy3+-doped LiYF4 single crystal capable of generating white light by simultaneous blue and yellow light emission of phosphorescent centers is produced. Chromaticity coordinates and photoluminescence intensity vary with excitation wavelength. Under 350, 365, and 388 nm excitation, the crystal shows excellent white light emission. The most efficient wavelength for white light is 388 nm. The CIE coordinates are x=0.316 and y =0.321, and the color temperature (Tc) is 6 368 K. These results indicate that the studied crystal is a potential candidate for ultraviolet light-excited white light-emitting diodes.