GCGilmar Freire da Costa

Gilmar Freire da Costa

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Gilmar Freire da Costa has a total of 31 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Development of Reduced‐Sodium Cooked Ham Using NaCl Substitutes: Impact on Instrumental and Sensory Properties

    by Simoni Cristina Mendes Cardim, Gilmar Freire da Costa, Marise Aparecida Rodrigues Pollonio, Jorge Herman Behrens, Juliano Lemos Bicas

    This study aimed to develop cooked ham with less than 600 mg sodium/100 g through partial replacement of NaCl by combinations of potassium chloride (KCl), commercial meat seasoning, and transglutaminase. Eight formulations were produced and evaluated for physicochemical, technological, microbiological, and sensory characteristics. Sodium content was reduced by approximately 30%, decreasing from 863 mg/100 g in the standard formulation to 581–734 mg/100 g in the reformulated products. The reduced‐sodium control exhibited higher cooking loss (8.8%) than the standard formulation (5.2%), whereas formulations containing meat seasoning and transglutaminase reduced cooking loss to values as low as 3.7%. Texture profile analysis showed that transglutaminase increased product firmness, with chewiness increasing from 177.6 N in the reduced‐sodium control to 590.5 N in formulation F5. In relation to sensory evaluation, the standard formulation showed the highest acceptance, followed by formulations F6 and F5, although all reformulated products achieved mean acceptance scores above 6.0 on the 9‐point hedonic scale. Formulations containing 0.35% KCl, 0.25% meat seasoning, and transglutaminase provided the best balance between technological performance and consumer acceptance. Despite the technological improvements, lower saltiness, rubbery texture, and paler pink color remained the main sensory limitations of the reduced‐sodium products. This could be further improved in future trials by fine‐tuning commercial meat flavoring and transglutaminase levels. Practical Applications: This study shows that the meat industry can produce cooked ham with reduced sodium content using salt substitutes, resulting in healthier and technologically viable products. For consumers, this may provide lower‐sodium alternatives with potential health benefits, if formulation adjustments maintain or improve flavor, texture, and color.

  • Open Access

    Application of Xylo-Oligosaccharide-Rich Gel Emulsion as a Fat Replacer in Sausages

    by João L. F. Paschoa, Patrícia F. Ávila, Gilmar F. da Costa, Ana Paula B. Ribeiro, Renato Grimaldi, Rosiane L. da Cunha, Marise A. R. Pollonio, Rosana Goldbeck

    Xylo-oligosaccharides (XOS) are functional oligosaccharides obtained from xylan present in lignocellulosic material. This study investigated the effects of replacing pork fat with functional xylo-oligosaccharide gel emulsion (XGE) on the chemical and physical structure of developed meat products. The product’s centesimal composition, energy value, pH, color parameters, and microstructure were analyzed. The results showed that replacing pork fat with XGE reduced the total lipid content by approximately 30%, and provided a desirable lipidic profile with reduced thrombogenicity and atherogenicity indices. A microstructure analysis showed that products with partial and full pork fat replacement presented a more compact structure than the control formulation. Thus, XGE is a viable alternative to replace pork fat in meat products since it maintains similar physicochemical and technological properties to the original products and contributes to the development of healthier meat products with prebiotic properties, lower fat content, and, consequently, lower energetic value.


  • Physico-Chemical and Microbiological Quality of Sausages with Reduced Fat and Sodium Chloride Formulated with Inulin and Oregano Essential Oil

    by Chimenes Darlan Leal de Araujo, Gilmar Freire da Costa, Fernando Luiz Nunes de Oliveira, Geiza Alves Azeredo de Oliveira

    This work aimed to evaluate the physical-chemical and microbiological quality of meat sausages formulated with inulin and oregano essential oil as substitutes for fat and sodium chloride. Two treatments were used: T1 – Control and T2–200 g inulin and 10 g oregano essential oil. The addition of inulin provided an increase (p < 0.05) of carbohydrates and a decrease in the fat content of the meat product. This reduction influenced cooking weight loss and emulsion stability. However, moisture, water activity, and pH were not altered. Regarding the microbiological quality of the sausages, all treatments (T1 and T2) showed counts below Coliforms at 45 ºC and Coagulase-positive staphylococci and Clostridium perfringens. In addition, both treatments showed absence of Salmonella sp. Therefore, inulin and essential oregano oil can be used in the reformulation of healthier emulsified meat products without significant changes in physicochemical properties and with microbiological safety.


  • Collagen films, cassava starch and their blends: Physical–chemical, thermal and microstructure properties

    by Gilmar Freire da Costa, Cristiani Viegas Brandão Grisi, Bruno Raniere Lins de Albuquerque Meireles, Solange de Sousa, Angela Maria Tribuzy de Magalhães Cordeiro

    Collagen‐based films from Tilapia skin, cassava starch and their blends were prepared using the casting technique. Five treatments were prepared, where T1 represents the film containing 6% collagen, T2—film containing 6% cassava starch, T3—film containing 3%/3% blend of collagen/cassava starch, T4—film containing the 4.5%/1.5% blend of collagen/cassava starch and T5—film containing the blend of 1.5%/4.5% collagen/cassava starch. The physical, mechanical, thermal and morphological properties of each film were evaluated. The results indicated that T1 and T4 treatments improved film water resistance (p < 0.05). T3–T5 treatments provided higher values (p < 0.05) of lightness (L*). The scanning electron micrographs showed a smooth and homogeneous surface for the T1 and T2 films and a slightly roughened surface for the T3–T5 films. The T1 film had the highest (p < 0.05) tensile strength and elongation at break compared to the other films. Furthermore, X‐ray diffraction (XRD) indicated that the structures of the T1, T3, T4 and T5 films were predominantly amorphous. In general, T1 and T4 films were the ideal formulations. They have potential for being used as edible packaging for food, soluble sachets, containers for oils and/or capsules for the delivery of bioactive compounds.


  • Osmotic dehydration as a pre-treatment for jackfruit berries (Artocarpus heterophyllus): effect on physico-chemical properties, shelf life and sensory acceptability

    by Raquel Alves Evaristo, Gilmar Freire da Costa, Cristiani Viegas Brandão Grisi, Solange de Sousa

    The aim of the study was to evaluate the effect of osmo-convective dehydration using two drying temperatures (50 and 60°C) on the physico-chemical properties, shelf life and sensory acceptability of jackfruit berries. Four treatments were used as follows: T1 – Jackfruit berries dried in an oven at 50°C; T2 – Jackfruit berries dried in an oven at 60°C; T3 – Jackfruit berries pre-treated with an osmotic-sucrose solution (60 Brix concentration) and oven-dried at 50°C and T4 – Jackfruit berries pretreated with osmotic solution (60 Brix concentration) and oven-dried at 60°C. Berries' shelf life was monitored by moisture analysis, water activity (Wa) and microbiological analysis. The influence of treatments on physico-chemical properties and sensory quality was also investigated. Osmo-convective dehydration at 50 and 60 C significantly (p = 0.001) reduced moisture content and Wa. All treatments increased the shelf life of jackfruit berries within 30 days of storage. Regarding sensory analysis, the T3 treatment was significantly (p = 0.001) the most preferred by the tasters. In general, the results indicated that osmo-convective dehydration at 50 C has great potential to be a maid in the processing of minimally processed jackfruit berries, as, in addition to providing the product with high stability, it was the one with the greatest acceptability by the tasters.


  • Open Access

    Elaboração de salsichas de frango com redução de gordura e adição de inulina

    by Chimenes Darlan Leal de Araujo, Gilmar Freire da Costa, Fernando Luiz Nunes de Oliveira, Geíza Alves Azerêdo

    Resumo Objetivou-se com este trabalho determinar os efeitos da substituição parcial e total da gordura por inulina nos parâmetros de qualidade de salsichas de frango. Três formulações foram desenvolvidas: Controle (F1) e dois níveis de inclusão de inulina: 2,5% (F2) e 5% (F3). Parâmetros de umidade, cinzas, proteínas, lipídeos, carboidratos, pH, atividade de água e cor (L*, a* e b*) foram analisados. O perfil tecnológico também foi analisado por meio da estabilidade da emulsão, perda de peso por cozimento, perda de peso por exsudação e força de cisalhamento. Os atributos sensoriais pesquisados foram cor, aparência, textura, sabor, aceitação geral, bem como teste de intenção de compra. A adição de 2,5% de inulina na formulação F2 verificou-se uma redução na perda de água durante o cozimento, perda de peso por exsudação, bem como aumento da estabilidade da emulsão comparada às demais formulações. A formulação com 5% de inulina apresentou baixo teor de gordura, baixa força de cisalhamento e elevados teores de cinzas e carboidratos comparativamente à formulação controle. Não houve alterações no pH e na atividade de água. Em relação à cor, a inclusão de inulina teve efeito significativo (p < 0,05) para a luminosidade (L*) na superfície interna das salsichas. O valor de b* também foi significativo (p < 0,05) na formulação (F3) para a superfície interna e na formulação F1 na superfície externa. A adição de inulina, em especial na formulação (F3), resultou em valores mais altos nas avaliações de aparência, textura e sabor em relação às demais formulações, o que refletiu na maior intenção de compra. Sendo assim, pode-se afirmar que foi possível a redução de 50% e 100% de gordura com a adição de 2,5% e 5% de inulina, sem redução na qualidade das salsichas.


  • Pre‐emulsioned linseed oil as animal fat replacement in sheep meat sausages: Microstructure and physicochemical properties

    by Thamirys Lorranne Santos Lima, Gilmar Freire da Costa, Íris Braz da Silva Araújo, George Rodrigo Beltrão da Cruz, Neila Lidiany Ribeiro, Edvaldo Mesquita Beltrão Filho, Rubén Domínguez, Jose M. Lorenzo


  • Open Access

    The feasibility of use of sweet potato (ipomoea potatoes l.) flour in the preparation of bakery products

    by Aliou Toro Lafia, Tankpinou Richard Ketounou, Gilmar Freire da Costa, Semako Ibrahim Bonou, David Santos Rodrigues, Solange de Sousa

    Sweet potatoes are one of the most consumed vegetables in Brazil and in the world, as they are cheap, easy to buy and healthy food. The objective of this work was to prepare sweet potato flour, bread with the addition of sweet potato flour and evaluate its effect. Four bread formulations were prepared: P0% (standard) and the others added potato flour of 8% (P8%), 16% (P16%) and 24% (P24%). The microbiological, physical-chemical, sensory parameters and the color of flour and bread were evaluated. A statistical analysis was performed with the averages by the Tukey test at 5%. The result of the microbiological analysis was in accordance with the legislation. In potato flour, components such as carbohydrates and proteins stood out. Bread samples showed a significant difference (<0, 05) in relation to the physical-chemical parameters with the exception of moisture and crude fibers. All formulations showed good acceptance in all attributes, presenting scores higher than 6 and a good purchase intention with more than 50% of the products with the exception of the P24% sample.