Kiyoshi Shimamura
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Kiyoshi Shimamura has a total of 48 co-authors. Here are the top co-authors by number of shared publications:
- Kenji Kitamura
Kanazawa University
3 shared publications Encarnacion G. Villora
Optronic Materials Center, National Institute for Materials Science, Tsukuba, Ibaraki 305-0044, Japan
2 shared publications- Encarnación G. Víllora
National Institute for Materials Science
2 shared publications - Huarong Zeng
Optronic Materials Center, National Institute for Materials Science, Tsukuba, Ibaraki 305-0044, Japan
2 shared publications Shunji Takekawa
Optronic Materials Center, National Institute for Materials Science, Tsukuba, Ibaraki 305-0044, Japan
2 shared publicationsAkiharu Funaki
Fujikura Ltd., 1440 Mutsuzaki, Sakura, Chiba, 285-8550, Japan
1 shared publication
Latest Publications
- Open Access
- 24 October 2025
- Published by Elsevier in Optical Materials
- Vol. 169
Bulk and surface-scattering loss measurements of CeF3 crystals at 532 nm via cavity ring down spectroscopy
- 24 October 2025
- Published by Elsevier in Optical Materials
- Vol. 169
Open AccessBulk and surface-scattering loss measurements of CeF3 crystals at 532 nm via cavity ring down spectroscopy
- Open Access
- 1 January 2023
- Published by Elsevier in SSRN Electronic Journal
High-Performance Knn Piezoelectric Ceramics with High Reproducibility and Chemical Stability. Part Ii: Innovative Melt-Reaction Route
In the first part, a means to synthesize high-density homogeneous KNN ceramics with high piezoelectric performance and chemical stability at low temperature was found. However, these properties could not be obtained reproducibly, thus this second part is focused on solving this issue. Here, instead of doing a fine pulverization of raw materials prior to reaction, the raw materials are ultimately mixed in the molten state and quenched to keep a single stoichiometry. Additionally, the ground KNN powders are pre-annealed before fine pulverization to preserve their high crystallinity. This innovative procedure prevents the formation of parasitic phases, leading with it to high-performance ceramics achieving both high reproducibility and chemical stability for the first time.
- 1 January 2023
- Published by Elsevier in SSRN Electronic Journal
Open AccessHigh-Performance Knn Piezoelectric Ceramics with High Reproducibility and Chemical Stability. Part Ii: Innovative Melt-Reaction Route
In the first part, a means to synthesize high-density homogeneous KNN ceramics with high piezoelectric performance and chemical stability at low temperature was found. However, these properties could not be obtained reproducibly, thus this second part is focused on solving this issue. Here, instead of doing a fine pulverization of raw materials prior to reaction, the raw materials are ultimately mixed in the molten state and quenched to keep a single stoichiometry. Additionally, the ground KNN powders are pre-annealed before fine pulverization to preserve their high crystallinity. This innovative procedure prevents the formation of parasitic phases, leading with it to high-performance ceramics achieving both high reproducibility and chemical stability for the first time.
- Open Access
- 1 November 2020
- Published by AIP Publishing in AIP Advances
- Vol. 10 (11) , 115011
Development of a flux-film-coated sputtering (FFC-sputtering) method for fabricating c-axis oriented AlN film
In this study, we developed a novel growth method named “Flux-Film-Coated (FFC) sputtering.” In this method, nitrogen radicals were supplied to the Al–Sn flux at around 600 °C followed by the deposition of an Al–Sn metal film on a sapphire substrate as flux, which resulted in the growth of high-quality AlN films. The nitrogen radical, which is the source of nitrogen for the growth of AlN, was generated by the radio frequency plasma in a nitrogen atmosphere. Using a zirconia target in the plasma generation process, nitrogen radicals were easily generated because the zirconia was not etched in a pure nitrogen atmosphere, which enabled us to fabricate the AlN film using the flux method in the sputtering chamber in a single step. The crystallinity of the synthesized AlN determined using the FFC-sputtering method was remarkably improved when compared with that of the AlN film deposited using the reactive sputtering method.
- 1 November 2020
- Published by AIP Publishing in AIP Advances
- Vol. 10 (11) , 115011
Open AccessDevelopment of a flux-film-coated sputtering (FFC-sputtering) method for fabricating c-axis oriented AlN film
In this study, we developed a novel growth method named “Flux-Film-Coated (FFC) sputtering.” In this method, nitrogen radicals were supplied to the Al–Sn flux at around 600 °C followed by the deposition of an Al–Sn metal film on a sapphire substrate as flux, which resulted in the growth of high-quality AlN films. The nitrogen radical, which is the source of nitrogen for the growth of AlN, was generated by the radio frequency plasma in a nitrogen atmosphere. Using a zirconia target in the plasma generation process, nitrogen radicals were easily generated because the zirconia was not etched in a pure nitrogen atmosphere, which enabled us to fabricate the AlN film using the flux method in the sputtering chamber in a single step. The crystallinity of the synthesized AlN determined using the FFC-sputtering method was remarkably improved when compared with that of the AlN film deposited using the reactive sputtering method.
- 1 October 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Large-scale garnet single crystal with high transparency in fiber laser operation wavelength
A novel garnet single crystal with a composition of Tb3(Sc, Lu)2Al3O12 (TSLAG) is designed and fabricated to realize a large-scale crystal boule. 50 mm-diameter single crystal boule is grown by Czochralski (CZ) method without macro cracks. High optical transparency in the wavelength range of 400-1100 nm, and relatively high Verdet constant compared with Tb3Ga5O12 (TGG) are confirmed for TSLAG(111) bulk crystal. An optical isolator module using the TSLAG is also demonstrated to apply fiber lasers.
- 1 October 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Large-scale garnet single crystal with high transparency in fiber laser operation wavelength
A novel garnet single crystal with a composition of Tb3(Sc, Lu)2Al3O12 (TSLAG) is designed and fabricated to realize a large-scale crystal boule. 50 mm-diameter single crystal boule is grown by Czochralski (CZ) method without macro cracks. High optical transparency in the wavelength range of 400-1100 nm, and relatively high Verdet constant compared with Tb3Ga5O12 (TGG) are confirmed for TSLAG(111) bulk crystal. An optical isolator module using the TSLAG is also demonstrated to apply fiber lasers.
- Open Access
- 4 June 2012
- Published by The Electrochemical Society in ECS Meeting Abstracts
- Vol. MA2012-02 (27) , 2442
UV-Visible Faraday Rotators Based on Rare-Earth Fluoride Single Crystals: LiREF4 (RE=Tb, Dy, Ho, Er and Yb), PrF3 and CeF3
- 4 June 2012
- Published by The Electrochemical Society in ECS Meeting Abstracts
- Vol. MA2012-02 (27) , 2442
Open AccessUV-Visible Faraday Rotators Based on Rare-Earth Fluoride Single Crystals: LiREF4 (RE=Tb, Dy, Ho, Er and Yb), PrF3 and CeF3
- 1 April 2007
- Published by Springer Nature in Journal of Materials Research
- Vol. 22 (4) , 1072-1076
Reversed domain configuration behavior in BaMgF4 ferroelectric crystal
Piezoresponse mode atomic force microscopy was used to induce a dynamic polarization reversal process and to characterize domain configuration behavior in BaMgF4 single crystal. Triangular reversed domains observed on the polar and non-polar surface demonstrate a sideways domain wall motion mechanism prevailing in the switching process of the bulk BaMgF4 crystal. The domain wall bowing phenomenon due to the strong pinning of the crystal defects was first visualized in the piezoresponse image of the engineering domain pattern in BaMgF4 crystal.
- 1 April 2007
- Published by Springer Nature in Journal of Materials Research
- Vol. 22 (4) , 1072-1076
Reversed domain configuration behavior in BaMgF4 ferroelectric crystal
Piezoresponse mode atomic force microscopy was used to induce a dynamic polarization reversal process and to characterize domain configuration behavior in BaMgF4 single crystal. Triangular reversed domains observed on the polar and non-polar surface demonstrate a sideways domain wall motion mechanism prevailing in the switching process of the bulk BaMgF4 crystal. The domain wall bowing phenomenon due to the strong pinning of the crystal defects was first visualized in the piezoresponse image of the engineering domain pattern in BaMgF4 crystal.
- 1 December 2006
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 426 (1-2) , 304-307
Boron nonstoichiometry, hardness and oxidation resistance of perovskite-type CeRh3Bx (x=0–1)
- 1 December 2006
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 426 (1-2) , 304-307
Boron nonstoichiometry, hardness and oxidation resistance of perovskite-type CeRh3Bx (x=0–1)
- Open Access
- 9 November 2006
- Published by Wiley in Physica Status Solidi (RRL) – Rapid Research Letters
- Vol. 1 (2) , R62-R64
Piezoresponse imaging and local characterization of ferroelectric domains in Pb(Zn1/3Nb2/3)O3–7%PbTiO3 single crystals
Ferroelectric domain structures of (001)‐oriented Pb(Zn1/3Nb2/3)O3–7%PbTiO3 (PZN‐7%PT) single crystals were visualized and characterized by piezoresponse force microscopy (PFM). Locally regular domain configurations are found to be possibly related to the stable macroscopic properties in the PZN‐7%PT single crystals. Nanoscale piezoresponse hysteresis loops measured by PFM tip revealed no evidence of local domain switching behavior in the PZN‐7%PT single crystal.
- 9 November 2006
- Published by Wiley in Physica Status Solidi (RRL) – Rapid Research Letters
- Vol. 1 (2) , R62-R64
Open AccessPiezoresponse imaging and local characterization of ferroelectric domains in Pb(Zn1/3Nb2/3)O3–7%PbTiO3 single crystals
Ferroelectric domain structures of (001)‐oriented Pb(Zn1/3Nb2/3)O3–7%PbTiO3 (PZN‐7%PT) single crystals were visualized and characterized by piezoresponse force microscopy (PFM). Locally regular domain configurations are found to be possibly related to the stable macroscopic properties in the PZN‐7%PT single crystals. Nanoscale piezoresponse hysteresis loops measured by PFM tip revealed no evidence of local domain switching behavior in the PZN‐7%PT single crystal.
- 1 September 2006
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 45 (9R) , 6996-7001
Isolated Domain Structure and Its Polar–Surface Asymmetry of Ferroelectric BaMgF4 Single Crystals
- 1 September 2006
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 45 (9R) , 6996-7001
Isolated Domain Structure and Its Polar–Surface Asymmetry of Ferroelectric BaMgF4 Single Crystals
- Open Access
- 1 January 1998
- Published by Japan Institute of Metals in Materia Japan
- Vol. 37 (1) , 55-60
Micro Single Crystal.
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。
- 1 January 1998
- Published by Japan Institute of Metals in Materia Japan
- Vol. 37 (1) , 55-60
Open AccessMicro Single Crystal.
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。