Zhenzhong Yuan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Zhenzhong Yuan has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Dong Wang
Department of Pharmaceutical Sciences, College of Pharmacy, University of Nebraska Medical Center, Omaha, NE 68198-6125, USA
1 shared publication Ronghai Guo
Military Representative Office of the Army in Nanchang
1 shared publication- Xiangyi Kong
The 58th Research Institute of China Electronics Technology Group Corporation, Wuxi 214063, China
1 shared publication - Yang Zhao
School of Integrated Circuits, Shanghai Jiao Tong University, Shanghai, China
1 shared publication Yingdan Jiang
China Electronics Technology Group Corporation No.58 Research Institute
1 shared publication- Yingdan Jiang
The 58th Research Institute of China Electronic Technology Group Corporation (CETC), Wuxi 214072, China
1 shared publication
Latest Publications
- Open Access
A High-Precision Fully Integrated Hall-Effect Angle Sensor with 0.087° Noise Floor in 0.35 μm CMOS Technology
Hall-effect sensors are pervasive in magnetic-field measurement applications, including current sensing and position detection, owing to their excellent compatibility with standard CMOS processes. However, the inherent offset and temperature drift of silicon-based Hall elements remain a paramount obstacle to achieve high precision. This paper presents a fully integrated angle sensor chip that addresses this challenge. Implemented in a 0.35 μm CMOS process, the sensor incorporates four cross-shaped Hall elements arranged in an orthogonal array as a non-contact Hall-permanent magnet configuration, which enables absolute angular encoding across a full 0–360° range. Experimental characterisation demonstrates a low noise floor of 0.087° (3σ), validating the effectiveness of the proposed architecture for high-accuracy angular measurement.
Open AccessA High-Precision Fully Integrated Hall-Effect Angle Sensor with 0.087° Noise Floor in 0.35 μm CMOS Technology
Hall-effect sensors are pervasive in magnetic-field measurement applications, including current sensing and position detection, owing to their excellent compatibility with standard CMOS processes. However, the inherent offset and temperature drift of silicon-based Hall elements remain a paramount obstacle to achieve high precision. This paper presents a fully integrated angle sensor chip that addresses this challenge. Implemented in a 0.35 μm CMOS process, the sensor incorporates four cross-shaped Hall elements arranged in an orthogonal array as a non-contact Hall-permanent magnet configuration, which enables absolute angular encoding across a full 0–360° range. Experimental characterisation demonstrates a low noise floor of 0.087° (3σ), validating the effectiveness of the proposed architecture for high-accuracy angular measurement.
- Open Access
- 14 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 150665-150671
Research on the Orthogonal Fundamental Mode Fluxgate Sensor Circuit
Currently, magnetic fluxgate circuits used for magnetic field measurements mostly adopt parallel excitation second harmonic generation. The magnetic fluxgate developed by this method cannot possess both low noise and high bandwidth at the same time. The orthogonal fundamental mode fluxgate is used in this paper: the excitation magnetic field is orthogonal to the magnetic field to be measured, and the external magnetic field is detected by measuring the voltage signal in the pick-up coil. The excitation magnetic field changes with the parallel excitation second harmonic method while the direction of the excitation magnetic field does not change in the orthogonal fundamental mode scheme, which can effectively reduce the influence of Barkhausen noise. The magnetic fluxgate circuit is designed based on the orthogonal fundamental mode scheme and its performance indexes are tested. The range of the magnetic fluxgate is ±100000 nT, the sensitivity is 100 μV/nT, the output noise is 8.9 pT/rt(Hz)@1 Hz, and the bandwidth is DC-15 kHz. The orthogonal fundamental mode fluxgate improves the bandwidth performance while enabling low-noise magnetic field measurements in practical applications.
- 14 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 150665-150671
Open AccessResearch on the Orthogonal Fundamental Mode Fluxgate Sensor Circuit
Currently, magnetic fluxgate circuits used for magnetic field measurements mostly adopt parallel excitation second harmonic generation. The magnetic fluxgate developed by this method cannot possess both low noise and high bandwidth at the same time. The orthogonal fundamental mode fluxgate is used in this paper: the excitation magnetic field is orthogonal to the magnetic field to be measured, and the external magnetic field is detected by measuring the voltage signal in the pick-up coil. The excitation magnetic field changes with the parallel excitation second harmonic method while the direction of the excitation magnetic field does not change in the orthogonal fundamental mode scheme, which can effectively reduce the influence of Barkhausen noise. The magnetic fluxgate circuit is designed based on the orthogonal fundamental mode scheme and its performance indexes are tested. The range of the magnetic fluxgate is ±100000 nT, the sensitivity is 100 μV/nT, the output noise is 8.9 pT/rt(Hz)@1 Hz, and the bandwidth is DC-15 kHz. The orthogonal fundamental mode fluxgate improves the bandwidth performance while enabling low-noise magnetic field measurements in practical applications.