Mohsen Pirmohammadi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Mohsen Pirmohammadi has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
A. Salehi-Shabestari
Mechanical Rotating Equipment Department, Niroo Research Institute, Tehran, Iran
2 shared publicationsA. M. M. Al-Obaidi
Department of Mechanical Engineering, South Tehran Branch, Islamic Azad University, Tehran, Iran
1 shared publicationH. Heidary
Department of Energy Engineering, Qom University of Technology, Qom, Iran
1 shared publicationM. R. Habibi
Res Inst Petr Ind RIPI, Energy Technol Res Div, Tehran, Iran
1 shared publicationR. Sharafodini
Islamic Azad Univ, Dept Mech Engn, Tehran Gharb Branch, Tehran, Iran
1 shared publication
Latest Publications
- 1 September 2023
- Published by Pleiades Publishing Ltd in Journal of Engineering Thermophysics
- Vol. 32 (3) , 521-531
Experimental and Numerical Investigation of Al2O3 Nanofluids Based Crude Oil in Shell and Tube Heat Exchanger
Numerical investigation of heat transfer augmentation with Al2O3 nanofluids-based crude oil in a shell and tube heat exchanger. This paper presents numerical and experimental investigations to study the effect of using Al2O3 nanofluids based crude oil on heat transfer enhancement in a turbulent regime with mass flow rate of (4 to 18 kg/s) in the shell and tube heat exchanger. The investigation concentrates on the effects of the Al2O3 based crude oil nanofluids on friction factor, flow characteristics and heat transfer, through shell and tube heat exchanger. The results show that the thermal conductivity as well as the viscosity of Al2O3 nanofluid based crude oil increased with increasing nanoparticles volume fraction and decreased with increasing the temperature. The outcomes revealed that the Nusselt number improved with increasing mass flow rate and also the friction factor increases dramatically using nanofluid this because of increment in nanofluid viscosity comparing to the base fluid (crude oil), additionally the results illustrate a constant pattern along the heat exchanger.
- 1 September 2023
- Published by Pleiades Publishing Ltd in Journal of Engineering Thermophysics
- Vol. 32 (3) , 521-531
Experimental and Numerical Investigation of Al2O3 Nanofluids Based Crude Oil in Shell and Tube Heat Exchanger
Numerical investigation of heat transfer augmentation with Al2O3 nanofluids-based crude oil in a shell and tube heat exchanger. This paper presents numerical and experimental investigations to study the effect of using Al2O3 nanofluids based crude oil on heat transfer enhancement in a turbulent regime with mass flow rate of (4 to 18 kg/s) in the shell and tube heat exchanger. The investigation concentrates on the effects of the Al2O3 based crude oil nanofluids on friction factor, flow characteristics and heat transfer, through shell and tube heat exchanger. The results show that the thermal conductivity as well as the viscosity of Al2O3 nanofluid based crude oil increased with increasing nanoparticles volume fraction and decreased with increasing the temperature. The outcomes revealed that the Nusselt number improved with increasing mass flow rate and also the friction factor increases dramatically using nanofluid this because of increment in nanofluid viscosity comparing to the base fluid (crude oil), additionally the results illustrate a constant pattern along the heat exchanger.
- 27 July 2022
- Published by Pleiades Publishing Ltd in Journal of Engineering Thermophysics
- Vol. 31 (3) , 489-505
Effect of Nano-Particles on Natural Convection in Corrugated-Wall Enclosure
The heat transfer and fluid flow in a corrugated square cavity filled with nanofluid are investigated numerically. The opposite vertical walls are taken as having different temperatures, while the horizontal walls are considered as adiabatic. The nanofluid is copper-water, and three different shapes of corrugated boundaries are investigated here: wavy, triangular, and rectangular. The governing equations are solved with application of the SIMPLE algorithm, based on the control volume approach. This study investigates the effect of several parameters on the heat transfer: the boundary shape, Rayleigh number, nano-particle volume fraction, nano-particle diameter, cycle number, and triangle wave amplitude. The results show that corrugated boundaries reduce the heat transfer. In addition, it is found out that a nanofluid with \(\phi\) of about 0.02 has the highest value of heat transfer enhancement.- 27 July 2022
- Published by Pleiades Publishing Ltd in Journal of Engineering Thermophysics
- Vol. 31 (3) , 489-505
Effect of Nano-Particles on Natural Convection in Corrugated-Wall Enclosure
The heat transfer and fluid flow in a corrugated square cavity filled with nanofluid are investigated numerically. The opposite vertical walls are taken as having different temperatures, while the horizontal walls are considered as adiabatic. The nanofluid is copper-water, and three different shapes of corrugated boundaries are investigated here: wavy, triangular, and rectangular. The governing equations are solved with application of the SIMPLE algorithm, based on the control volume approach. This study investigates the effect of several parameters on the heat transfer: the boundary shape, Rayleigh number, nano-particle volume fraction, nano-particle diameter, cycle number, and triangle wave amplitude. The results show that corrugated boundaries reduce the heat transfer. In addition, it is found out that a nanofluid with \(\phi\) of about 0.02 has the highest value of heat transfer enhancement.- 1 September 2020
- Published by Springer Nature in Journal of Engineering Physics and Thermophysics
- Vol. 93 (5) , 1255-1265
PARAMETRIC STUDY OF NATURAL CONVECTION INSIDE A PARTITIONED CAVITY IN THE PRESENCE OF A MAGNETIC FIELD
- 1 September 2020
- Published by Springer Nature in Journal of Engineering Physics and Thermophysics
- Vol. 93 (5) , 1255-1265
PARAMETRIC STUDY OF NATURAL CONVECTION INSIDE A PARTITIONED CAVITY IN THE PRESENCE OF A MAGNETIC FIELD
- 1 May 2020
- Published by Pleiades Publishing Ltd in Thermophysics and Aeromechanics
- Vol. 27 (3) , 371-379
Magneto-convection inside a tilted enclosure
In this study, laminar magneto-convection flow of a viscous fluid in an inclined enclosure is considered. The temperature gradient is applied on two opposing walls while the other two walls are maintained adiabatic. In order to solve the governing non-linear differential equations, an in-house developed code based on the finite volume method is utilized. The fluid of interest is molten sodium whose thermal and electrical properties such as heat capacity, thermal and electrical conductivity are temperature dependent. Representative results illustrating the effects of the enclosure inclination angle on the contour maps of the streamlines and temperature are reported and discussed. In addition, results for the midsection velocity profile and the average Nusselt number at the hot wall of the enclosure are presented and discussed for various inclination angles and Hartmann numbers. It is observed that for Hartmann number of 600, an increase in the inclination angle leads to the growth of the number of vortices in the enclosure.
- 1 May 2020
- Published by Pleiades Publishing Ltd in Thermophysics and Aeromechanics
- Vol. 27 (3) , 371-379
Magneto-convection inside a tilted enclosure
In this study, laminar magneto-convection flow of a viscous fluid in an inclined enclosure is considered. The temperature gradient is applied on two opposing walls while the other two walls are maintained adiabatic. In order to solve the governing non-linear differential equations, an in-house developed code based on the finite volume method is utilized. The fluid of interest is molten sodium whose thermal and electrical properties such as heat capacity, thermal and electrical conductivity are temperature dependent. Representative results illustrating the effects of the enclosure inclination angle on the contour maps of the streamlines and temperature are reported and discussed. In addition, results for the midsection velocity profile and the average Nusselt number at the hot wall of the enclosure are presented and discussed for various inclination angles and Hartmann numbers. It is observed that for Hartmann number of 600, an increase in the inclination angle leads to the growth of the number of vortices in the enclosure.
- 1 May 2020
- Published by Academic World Research in Journal of Applied Fluid Mechanics
- Vol. 13 (3) , 1047-1054
Numerical Study of Water Vapor Injection in the Combustion Chamber to Reduce Gas Turbine Fuel Consumption
- 1 May 2020
- Published by Academic World Research in Journal of Applied Fluid Mechanics
- Vol. 13 (3) , 1047-1054
Numerical Study of Water Vapor Injection in the Combustion Chamber to Reduce Gas Turbine Fuel Consumption
- Open Access
- 1 February 2019
- Vol. 6 (2) , 133-141
Numerical Study of turbulent free convection of liquid metal with constant and variable properties in the presence of magnetic field
- 1 February 2019
- Vol. 6 (2) , 133-141
Open AccessNumerical Study of turbulent free convection of liquid metal with constant and variable properties in the presence of magnetic field
- Open Access
- 1 January 2019
- Published by National Library of Serbia in Thermal Science
- Vol. 23 (6 Part A) , 3443-3454
Numerical study of turbulent magnetohydrodynamic convection of molten sodium with variable properties in a square cavity
In this study, the finite volume method is used to simulate the turbulent natural convection in a square partitioned cavity. In this paper a fluid flow with Pr = 0.01 and Rayleigh numbers Ra = 106 and 107 in the presence of a magnetic field is investigated. The fluid properties are function of temperature. A parametric study is carried out using following parameters: non-dimensional different partition position from 0.2 to 0.6, non-dimensional different partition height from 0.1 to 0.4 and different Hartmann numbers from 0 to 200. It is found that Nusselt number is a decreasing function of partition height (Hp) and Hartmann number and the non-dimensional position of partitions (Dp) affects on streamlines and isotherms. It is observed that at Ra=106 and Dp=0.6 the Nusselt number is maximum and as Ha increases the Nusselt number tends to a constant number. Also at Ra=107 and Dp=0.4 the variation of mean Nusselt number for different partition heights is more different than the other cases. Also the Nusselt number at Hp=0.4 is nearly half for Dp=0.4 in comparison with the other cases.
- 1 January 2019
- Published by National Library of Serbia in Thermal Science
- Vol. 23 (6 Part A) , 3443-3454
Open AccessNumerical study of turbulent magnetohydrodynamic convection of molten sodium with variable properties in a square cavity
In this study, the finite volume method is used to simulate the turbulent natural convection in a square partitioned cavity. In this paper a fluid flow with Pr = 0.01 and Rayleigh numbers Ra = 106 and 107 in the presence of a magnetic field is investigated. The fluid properties are function of temperature. A parametric study is carried out using following parameters: non-dimensional different partition position from 0.2 to 0.6, non-dimensional different partition height from 0.1 to 0.4 and different Hartmann numbers from 0 to 200. It is found that Nusselt number is a decreasing function of partition height (Hp) and Hartmann number and the non-dimensional position of partitions (Dp) affects on streamlines and isotherms. It is observed that at Ra=106 and Dp=0.6 the Nusselt number is maximum and as Ha increases the Nusselt number tends to a constant number. Also at Ra=107 and Dp=0.4 the variation of mean Nusselt number for different partition heights is more different than the other cases. Also the Nusselt number at Hp=0.4 is nearly half for Dp=0.4 in comparison with the other cases.
- Open Access
- 1 October 2017
- Vol. 4 (2) , 149-155
Effect of Magnetic Reynolds Number Variation on Magnetic Field Distribution of Electrically Conducting Fluid in MHD Natural Convection
- 1 October 2017
- Vol. 4 (2) , 149-155
Open AccessEffect of Magnetic Reynolds Number Variation on Magnetic Field Distribution of Electrically Conducting Fluid in MHD Natural Convection