Yun Huang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yun Huang has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Arumugam Manthiram
Materials Science and Engineering Program and Walker Department of Mechanical Engineering The University of Texas at Austin Austin Texas USA
1 shared publication - Christian Lücke
Department of Diagnostic and Interventional Radiology, Heart Center Leipzig , Leipzig
1 shared publication - Dezhu Chen
Department of Emergency and Critical Care Medicine, ShunDe Hospital of Guangzhou University of Chinese Medicine, Foshan, People’s Republic of China
1 shared publication Donglei (Emma) Fan
1 shared publication- Donglei Emma Fan
Materials Science and Engineering Program, Texas Materials Institute, The University of Texas at Austin, Austin, TX 78712, USA
1 shared publication - Gunter Fischer
Max Planck Research Unit for Enzymology of Protein Folding, Weinbergweg 22, 06120 Halle/Saale (Germany), Fax: (+49) 345-5511972
1 shared publication
Latest Publications
- 3 November 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (18)
Scalable, non-contact determination of electric properties of nanostructures via electro-rotation in water solution
Breakthroughs in nanotechnology have enabled the large-scale fabrication of nanoparticles with varied compositions and structures. Yet, evaluating their electrical conductivities remains challenging due to high volume and individual variability. We report a rapid, non-contact, and parallel method to characterize longitudinal nanostructures, including insulators, semiconductors, and conducting metal oxides by using MoO3, MoS2/MoO2, and MoS2 nanoribbons, produced at different fabrication stages, as a model system. Leveraging our semi-quantitative model based on Maxwell–Wagner and electrical double-layer polarization, electric conductivities of various nanoparticles are determined from their distinct electro-rotation behaviors in water, spanning six orders of magnitude. The results agree well with standard four-probe measurements. The technique, measuring multiple nanoparticles at once, without the use of electrical contact, can be easily scaled up for parallel determination of particles' electric conductivities. These findings highlight a nondestructive, rapid, and simple characterization method promising to bring nanomaterials closer to practical applications in electronics, optics, sensing, catalysis, and robotics.
- 3 November 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (18)
Scalable, non-contact determination of electric properties of nanostructures via electro-rotation in water solution
Breakthroughs in nanotechnology have enabled the large-scale fabrication of nanoparticles with varied compositions and structures. Yet, evaluating their electrical conductivities remains challenging due to high volume and individual variability. We report a rapid, non-contact, and parallel method to characterize longitudinal nanostructures, including insulators, semiconductors, and conducting metal oxides by using MoO3, MoS2/MoO2, and MoS2 nanoribbons, produced at different fabrication stages, as a model system. Leveraging our semi-quantitative model based on Maxwell–Wagner and electrical double-layer polarization, electric conductivities of various nanoparticles are determined from their distinct electro-rotation behaviors in water, spanning six orders of magnitude. The results agree well with standard four-probe measurements. The technique, measuring multiple nanoparticles at once, without the use of electrical contact, can be easily scaled up for parallel determination of particles' electric conductivities. These findings highlight a nondestructive, rapid, and simple characterization method promising to bring nanomaterials closer to practical applications in electronics, optics, sensing, catalysis, and robotics.
- 1 April 2025
- Published by Termedia Sp. z.o.o. in Archives of Medical Science
Global health implications of urticaria burden (1990–2021): a comprehensive analysis of trends across nations and regions
Introduction: Urticaria is a widespread dermatological disorder that substantially affects patients’ quality of life. Current data on its worldwide impact are crucial for healthcare planning and resource distribution. By analyzing the Global Burden of Disease (GBD) Study 2021, we evaluated the burden of urticaria across global, regional, and national levels.Material and methods: A comprehensive analysis was performed using data from the GBD 2021 study. Key metrics included prevalence, incidence, and age-standardized rates, all calculated per 100,000 people. The results were analyzed across demographic factors including age groups, gender, and geographical locations.Results: From 1990 to 2021, global urticaria metrics demonstrated relative stability, with female patients consistently reporting higher rates. During this period, the number of prevalent cases increased from approximately 48 million to 66.5 million, with the age-standardized prevalence rate (ASPR) showing a slight rise from 866 to 868 per 100,000 population. The number of incident cases increased from about 85 million to 117 million, while the age-standardized incidence rate (ASIR) showed a marginal increase from 1,529 to 1,534 per 100,000. The global age-standardized DALY rate reached 52.1 per 100,000 in 2021, ranging from 27.7 in Portugal to 88.4 in Nepal. The disease burden was most pronounced in low-middle SDI regions and lowest in high SDI areas. At the country level, Nepal recorded the highest burden across all metrics, while Portugal showed the lowest.Conclusions: Our analysis spanning three decades revealed that while the overall global burden of urticaria has remained relatively stable, there has been a modest upward trend in both prevalence and incidence. Notable disparities have emerged, with disproportionate impacts observed across different populations: females experience higher rates of the condition, and low-middle SDI regions shoulder a greater disease burden. These patterns highlight the importance of developing focused healthcare strategies and optimizing resource distribution, particularly in heavily affected regions. Given the inherent limitations of GBD data, these findings should be interpreted with appropriate caution.
- 1 April 2025
- Published by Termedia Sp. z.o.o. in Archives of Medical Science
Global health implications of urticaria burden (1990–2021): a comprehensive analysis of trends across nations and regions
Introduction: Urticaria is a widespread dermatological disorder that substantially affects patients’ quality of life. Current data on its worldwide impact are crucial for healthcare planning and resource distribution. By analyzing the Global Burden of Disease (GBD) Study 2021, we evaluated the burden of urticaria across global, regional, and national levels.Material and methods: A comprehensive analysis was performed using data from the GBD 2021 study. Key metrics included prevalence, incidence, and age-standardized rates, all calculated per 100,000 people. The results were analyzed across demographic factors including age groups, gender, and geographical locations.Results: From 1990 to 2021, global urticaria metrics demonstrated relative stability, with female patients consistently reporting higher rates. During this period, the number of prevalent cases increased from approximately 48 million to 66.5 million, with the age-standardized prevalence rate (ASPR) showing a slight rise from 866 to 868 per 100,000 population. The number of incident cases increased from about 85 million to 117 million, while the age-standardized incidence rate (ASIR) showed a marginal increase from 1,529 to 1,534 per 100,000. The global age-standardized DALY rate reached 52.1 per 100,000 in 2021, ranging from 27.7 in Portugal to 88.4 in Nepal. The disease burden was most pronounced in low-middle SDI regions and lowest in high SDI areas. At the country level, Nepal recorded the highest burden across all metrics, while Portugal showed the lowest.Conclusions: Our analysis spanning three decades revealed that while the overall global burden of urticaria has remained relatively stable, there has been a modest upward trend in both prevalence and incidence. Notable disparities have emerged, with disproportionate impacts observed across different populations: females experience higher rates of the condition, and low-middle SDI regions shoulder a greater disease burden. These patterns highlight the importance of developing focused healthcare strategies and optimizing resource distribution, particularly in heavily affected regions. Given the inherent limitations of GBD data, these findings should be interpreted with appropriate caution.
- 1 January 2021
- Published by Elsevier in Electrochimica Acta
- Vol. 367
Self-supported MoO2/MoS2 nano-sheets embedded in a carbon cloth as a binder-free substrate for high-energy lithium–sulfur batteries
- 1 January 2021
- Published by Elsevier in Electrochimica Acta
- Vol. 367
Self-supported MoO2/MoS2 nano-sheets embedded in a carbon cloth as a binder-free substrate for high-energy lithium–sulfur batteries
Plasmonic Metasurfaces Based on Nanopin-Cavity Resonator for Quantitative Colorimetric Ricin Sensing
In view of the toxic potential of a bioweapon threat, rapid visual recognition and sensing of ricin has been of considerable interest while remaining a challenging task up to date. In this study, a gold nanopin-based colorimetric sensor is developed realizing a multicolor variation for ricin qualitative recognition and analysis. It is revealed that such plasmonic metasurfaces based on nanopin-cavity resonator exhibit reflective color appearance, due to the excitation of standing-wave resonances of narrow bandwidth in visible region. This clear color variation is a consequence of the reflective color mixing defined by different resonant wavelengths. In addition, the colored metasurfaces appear sharp color difference in a narrow refractive index range, which makes them especially well-suited for sensing applications. Therefore, this antibody-functionalized nanopin-cavity biosensor features high sensitivity and fast response, allowing for visual quantitative ricin detection within the range of 10–120 ng mL−1 (0.15 × 10−9–1.8 × 10−9 m), a limit of detection of 10 ng mL−1, and the typical measurement time of less than 10 min. The on-chip integration of such nanopin metasurfaces to portable colorimetric microfluidic device may be envisaged for the quantitative studies of a variety of biochemical molecules.
Plasmonic Metasurfaces Based on Nanopin-Cavity Resonator for Quantitative Colorimetric Ricin Sensing
In view of the toxic potential of a bioweapon threat, rapid visual recognition and sensing of ricin has been of considerable interest while remaining a challenging task up to date. In this study, a gold nanopin-based colorimetric sensor is developed realizing a multicolor variation for ricin qualitative recognition and analysis. It is revealed that such plasmonic metasurfaces based on nanopin-cavity resonator exhibit reflective color appearance, due to the excitation of standing-wave resonances of narrow bandwidth in visible region. This clear color variation is a consequence of the reflective color mixing defined by different resonant wavelengths. In addition, the colored metasurfaces appear sharp color difference in a narrow refractive index range, which makes them especially well-suited for sensing applications. Therefore, this antibody-functionalized nanopin-cavity biosensor features high sensitivity and fast response, allowing for visual quantitative ricin detection within the range of 10–120 ng mL−1 (0.15 × 10−9–1.8 × 10−9 m), a limit of detection of 10 ng mL−1, and the typical measurement time of less than 10 min. The on-chip integration of such nanopin metasurfaces to portable colorimetric microfluidic device may be envisaged for the quantitative studies of a variety of biochemical molecules.
- 11 December 2012
- Published by Wiley in Chemistry – A European Journal
- Vol. 19 (4) , 1179-1183
Rapid Nitrogen Inversion Pathway in the cis/trans Isomerization of Selenoxo Peptide Bonds
- 11 December 2012
- Published by Wiley in Chemistry – A European Journal
- Vol. 19 (4) , 1179-1183
Rapid Nitrogen Inversion Pathway in the cis/trans Isomerization of Selenoxo Peptide Bonds
- 31 August 2009
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 79-82, 453-456
Fabrication and Optical Properties of Mn-Doped ZnO Nanowires
Mn-doped ZnO nanowires were successfully synthesized on silicon substrate by chemical vapor deposition method with Au catalyst. The X-ray diffraction (XRD) pattern indicates that the Mn-doped ZnO nanowires are hexagonal wurtzite structure and no second phase. The X-ray spectroscopy (EDX) and X-ray photoelectron spectrum (XPS) spectra exhibited the Mn ions were induced into the ZnO nanowires. Photoluminescence (PL) spectra were excited by 325 nm Xe lamp laser. Three peaks are observed in Mn-doped ZnO nanowires, two ultraviolet (UV) emissions at 370 nm and 386 nm, a visible emission at 405 nm. The emission at 405 nm is first found in Mn-doped ZnO nanowires that attributed to the electron transition from bottom of the conduction band to zinc vacancy defect energy level. The existence of Mn element changes the optical property of the ZnO nanowires.
- 31 August 2009
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 79-82, 453-456
Fabrication and Optical Properties of Mn-Doped ZnO Nanowires
Mn-doped ZnO nanowires were successfully synthesized on silicon substrate by chemical vapor deposition method with Au catalyst. The X-ray diffraction (XRD) pattern indicates that the Mn-doped ZnO nanowires are hexagonal wurtzite structure and no second phase. The X-ray spectroscopy (EDX) and X-ray photoelectron spectrum (XPS) spectra exhibited the Mn ions were induced into the ZnO nanowires. Photoluminescence (PL) spectra were excited by 325 nm Xe lamp laser. Three peaks are observed in Mn-doped ZnO nanowires, two ultraviolet (UV) emissions at 370 nm and 386 nm, a visible emission at 405 nm. The emission at 405 nm is first found in Mn-doped ZnO nanowires that attributed to the electron transition from bottom of the conduction band to zinc vacancy defect energy level. The existence of Mn element changes the optical property of the ZnO nanowires.